Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “rock”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 685 records · Page 38

The provenance of metal in anorthositic rocks

Calculated compositions for metal crystallized from anorthositic melt rocks or feldspathic basalts such as 14310, 68415, and 77017 are (1) meteoritic in the initial stages or if metal is the only phase crystallized, and (2) higher in Co than meteoritic metal as a result of fractional crystallization of metals and silicates. Metal in coarse anorthositic rocks 15415, 15455, 60015, 64435, and 78238 is not of meteoritic composition and has Co contents from 0 to 9% with a Ni/Co ratio of about 1. The formation of anorthosites and the composition of the earliest metal are discussed with attention to Ni concentrations and the Ni/Co ratio. It is shown that anorthositic hornfels and breccias contain metal of a composition not found in their source material, coarse anorthosite; it is suggested that the hornfels includes metal grains probably derived with little change in composition from ancient meteorites.

Hewins, R. H.↗

Microcrater investigations on lunar rock 12002

Relative ages of 26 submillimeter-sized pits from an equilibrium population in rock 12002 were measured by determining the densities of pits 0.7 microns in diameter and larger on the submillimeter-sized pits. Production rates for 0.7 micron diameter pits were determined from solar-flare track exposure age measurements, and the data for rock 12002 are consistent with previously obtained data for sample 15205 if a lower meteoroid flux prevailed in the past. Metal mounds or spherules within a microcrater pit glass were found to have a meteoritic composition, and an impact lining consisting of protruding crystals was observed. The crystals apparently developed during exposure to space immediately after the 200-micron diameter pit was formed by impact into an olivine grain.

Hartung, J. B.↗

Some correlation of rock exposure ages and regolith dynamics

Exposure age information on lunar rocks and regolith turnover rates are correlated. If plotted in a cumulative fashion, the distribution of spallogenic noble-gas exposure ages is remarkably parallel to the rate at which various fractions of the regolith surface are cratered and/or excavated. It appears that the rate at which lunar rocks are excavated from within the regolith is strongly controlled by the impact environment. Some suggestions for future refinement of regolith dynamics are presented.

Horz, F.↗

Petrographic and petrological studies of lunar rocks

Thin sections and polished electron probe mounts of Apollo 15 glasscoated breccias 15255, 15286, 15466, and 15505 were examined optically and analyzed by sem/microprobe. Sections from breccias 15465 and 15466 were examined in detail, and chemical and mineralogical analyses of several larger lithic clasts, green glass, and partly crystallized green glass spheres are presented. Area analyses of 33 clasts from the above breccias were also done using the SEM/EDS system. Mineralogical and bulk chemical analyses of clasts from the Apollo 15 glass-coated breccias reveal a diverse set of potential rock types, including plutonic and extrusive igneous rocks and impact melts. Examination of the chemistry of the clasts suggests that many of these clasts, like those found in 61175, are impact melts. Their variability suggests formation by several small local impacts rather than by a large basin-forming event.

Winzer, S. R.↗

Compositional-petrographic investigation of pristine nonmare rocks

Twenty-six highlands rocks and clasts are characterized petrographically and by determinations of major and trace elements, including key incompatibles and siderophiles. Most samples were selected in the hope that they would prove to be pristine, i.e., unremelted, monomict products of endogenous lunar magmatism. About 3/5 are almost certainly pristine, while about 1/4 are definitely non-pristine, and the remainder await further study before pristinity may be either proven or disproven. All of the major conclusions of Warren and Wasson (1977) about the significance of pristine nonmare rocks and the nature of the lunar crust still appear correct. Probably none, or virtually none, of the samples possessing the attributes by which 'pristinity' is judged formed as 'secondary differentiates' in giant impact melt pools, as Delano and Ringwood (1978) propose. Those which possess markedly plutonic textures (e.g., 62236) almost certainly did not.

Warren, P. H.↗

Miniregoliths. I - Dusty lunar rocks and lunar soil layers

A detailed Monte-Carlo model for rock surface evolution shows that erosion processes alone cannot account for the shapes of the solar flare particle track profiles generally observed at depths of about 100 microns and less in rocks. The observed profiles are easily explained by a steady accumulation of fine dust at a rate of 0.3 to 3 mm per m.y., depending on the micrometeoroid impact rate which controls the dust cover and results in maximum dust thicknesses on the order of 100 microns to 1 mm. The commonly used lunar soil track parameters are derived in terms of parameters characterizing the exposure of soil grains in the few-millimeter-thick surface mixing and maturation zone which is one form of miniregolith. Correlation plots permit determining the degree of mixing in soil samples and the amount of processing (maturation) in surface miniregoliths. It is shown that the sampling process often artificially mixes together finer distinct layers, and that ancient miniregolith layers on the order of a millimeter thick are probably common in the lunar soil.

Comstock, G. M.↗

Lunar and Planetary Science Conference, 10th, Houston, Tex., March 19-23, 1979, Proceedings. Volume 1 - Meteorites and lunar rocks

Papers are presented concerning studies of lunar basalts, highland rocks, and meteorites. Specific topics include the petrology and chemistry of basaltic fragments from Apollo 11 soil; the composition, magma types and petrogenesis of Apollo 17 high-Ti mare basalts; the chemistry and probable origin of Apollo 15 green glass; experimental studies of the partitioning of nickel and chromium into olivine from synthetic basaltic melts; the petrology and geochemistry of pristine highland rocks; the argon isotope age systematics of consortium breccia 73255; magnetite-sulfide-metal complexes in the Allende meteorite; the fractionation of refractory lithophile elements in chondritic meteorites; and the origin and relation to enstatite chondrites of aubrites.

Merrill, R. B.↗

Origin of impact melt rocks in the Bununu howardite

The Bununu howardite is a polymict regolith breccia which contains impact melt that is largely restricted to a 1-cm thick intrusion containing residual glass. As in Malvern, the melt rock contains melt with meteoritic Ni-Co contents. The cooling rate, interpreted for forming glass from this composition, is a few tenths of a degree per minute. The intrusive melts rock, which is a feature unique to Bununu, may indicate that Bununu was consolidated at the time of impact melting.

Klein, L. C.↗

Comparison of single crack propagation in lunar analogue glass and the failure strength of rocks

New data of crack propagation in lunar analogue glass provides important input for the construction of deformation maps (maps which delineate the rates and principal means of material deformation under various environmental conditions) applicable to the lunar crust. Comparison of single crack propagation data obtained on flat plates of glass and failure strength data obtained on fine grained rock samples show that single crack propagation velocities are directly related to the failure strength of rocks. The chemical reaction between water and silicon-oxygen bonds at the crack tip seems to be of first order. This greatly simplifies extrapolation to low partial pressures of H2O

Soga, N.↗

Lu-Hf total-rock isochron for the eucrite meteorites

The isotope Lu-176 (2.6% of natural lutetium) decays by beta(-) to Hf-176, with a long half life. The first Lu-Hf isochron is presented. The eucrite meteorites, a suite of planetary igneous rocks of known age, 4,550 Myr, define a 10-point total-rock isochron with a slope of 0.0934 + or - 40, leading to a value of 3.53 + or - 0.14 x 10 to the 10th yr for the beta(-) decay half life of Lu-176. The isochron intercept of 0.27973 + or - 12 gives the initial Hf-176/Hf-177 for the inner solar system at the time of accretion.

Patchett, P. J.↗

Detection of stopped solar flare helium in lunar rock 68815

Steep increases were detected in the concentration profiles of He-3 and possibly of Ne-21 in the near-surface layers of lunar rock 68815, which was exposed on the lunar surface for 2 Myr. The concentration profile of He-3 is inconsistent with either spallation or solar wind components, but it agrees with expected ranges of stopped solar flare particles. Although the He-3 retention in this rock is determined to be very low (approximately 3% at the surface), a long-term average solar flare ratio He-4/He-3 can be estimated at 12 to within a factor of about 3. This ratio is two orders of magnitude smaller than the same ratio observed in the solar wind, but it is consistent with solar flare data from recent satellite observations.

Yaniv, A.↗

On the constancy of solar particle fluxes from track, thermoluminescence and solar wind measurements in lunar rocks

Evidence contained within lunar rocks concerning possible variations in solar activity over the last 1 to 2 million years is reviewed. The effects of solar wind particles, which are implanted at shallow depths, solar flare protons, which produce thermoluminescence as well as stable and radionuclides, and solar flare heavy nuclei, which produce tracks, are considered, and the quality and limitations of nuclear tracks measurements as indicators of solar flare flux histories are discussed. Methods used for the determination of the solar flare track production rate, which must be known in order to measure lunar rock surface exposure times, are compared, and it is concluded that most of the evidence favors the rate obtained by Blanford et al. (1975). Information on the constancy of the solar flare particle flux obtained by comparison of the effects of different surface phenomena with solar particle effects is then illustrated for the cases of comparisons between solar flare tracks and microcrater densities, solar flare particle fluxes measured over different periods, and comparisons of the solar flare track production rate with the solar wind flux and microcratering rate. It is noted that these studies provide no evidence for a change in solar particle flux by more than a factor of two over the last 10,000 to 1 million years, or for a change in the solar flare Fe/H ratio in the last 2 million years.

Zinner, E.↗

Lunar rock surfaces as detectors of solar processes

Lunar rock surfaces exposed at or just below the lunar surface are considered as detectors of the solar wind, solar flares and solar-derived magnetic fields through their interactions with galactic cosmic rays. The degradation of the solar detector capabilities of lunar surface rocks by meteoroid impact erosion, accreta deposition, loose dust, and sputtering, amorphous layer formation and accelerated diffusion due to solar particles and illumination is discussed, and it is noted that the complex interactions of factors affecting the outer micron of exposed surface material has so far prevented the development of a satisfactory model for a particle detector on the submicron scale. Methods for the determination of surface exposure ages based on the accumulation of light solar wind noble gases, Fe and Mg, impact craters, solar flare tracks, and cosmogenic Kr isotopes are examined, and the systematic variations in the ages determined by the various clocks are discussed. It is concluded that a means of obtaining satisfactory quantitative rate or flux data has not yet been established.

Hartung, J. B.↗

Study project of intrusive rocks: States of Espirito Santo and Rio de Janeiro, south and east of Minas Gerais and southeast of the state of Sao Paulo

The feasibility of mapping intrusive rocks in polycyclic and polymetamorphic areas using the logic method for photointerpretation of LANDSAT and radar imagery was investigated. The resolution, scale and spectral characteristics of the imagery were considered. Spectral characteristics of the intrusive rock units mapped using image 100 were investigated. It was determined that identification of acidic and basic intrusive bodies and determination of their relationships with principal structural directions using the logic method was feasible. Tectonic compartments were subdivided into units according to their predominant lithographic types, ignoring stratigraphy. The principal directions of various foliations, faults, megafolds, and fractural systems were defined. Delineation of the boundaries of intrusive bodies mapped using the spectral characteristics of Image 100 imagery ws determined to be more accurate than visual analysis. A 1:500,000 scale map of intrusions in the areas studied was generated.

Dejesusparada, N.↗

Geochemical and spectral characterization of naturally altered rock surfaces

The possibility of using the visible-near infrared region for compositional analysis of remotely sensed rock surfaces is studied. This would allow mapping rock type both on the Earth's surface and on other planetary surfaces. Reflectance spectroscopy, economic geology, optical depth determination, and X-ray diffraction mineralogy are discussed.

Chang, L. L. Y.↗

Aspects of the history of 66095 based on trace elements in clasts and whole rock

Halogens, P, U and Na are reported in anorthositic and basaltic clasts and matrix from rusty rock 66095. Large fractions of Cl and Br associated with the separated phases from 66095 are soluble in H2O. Up to two orders of magnitude variation in concentrations of these elements in the breccia components and varying H2O-soluble Cl/Br ratios indicate different sources of volatiles. An approximately constant ratio of the H2O- to 0.1 M HNO3-soluble Br in the various components suggests no appreciable alteration in the original distributions of this element in the breccia forming processes. Up to 50% or more of the phosphorus and of the non-H2O-soluble Cl was dissolved from most of the breccia components by 0.1 M HNO3. Clast and matrix residues from the leaching steps contain, in most cases, the Cl/P2O5 ratio found in 66095 whole rock and in a number of other Apollo 16 samples. Evidence that phosphates are the major P-phases in the breccia is based on the 0.1 M acid solubility of Cl and P in the matrix sample and on elemental concentrations which are consistent with those of KREEP.

Jovanovic, S.↗

Geochemical studies of rocks from North Ray Crater, Apollo 16

The samples included in the study were all collected as individual specimens from Station 11 near the rim of North Ray Crater. Samples were selected to cover the entire range of rock types from anorthosites to subophitic impact melts, giving particular attention to the feldspathic breccias which predominate at the site. The chemical composition of North Ray Crater rocks is discussed along with the compositional variations among North Ray Crater samples, and the relationships between North Ray Crater and other Apollo 16 stations. It is pointed out that the primary objective in sampling the Apollo 16 site was to characterize materials from the Cayley Plains and Descartes Highlands.

Lindstrom, M. M.↗