Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “flying”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 685 records · Page 38
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

XV-15 Tilt Rotor fly-by-wire collective control demonstrator development specifications

A fly by wire system in the collective control system for XV-15 Tilt Rotor Research Aircraft was evaluated. The collective control system was selected because it requires a system tracking accuracy between right and left rotors of approximately 0.1%. The performance characteristics of the collectors axel provide typical axis control response data. The demonstrator is bread boarded as a dual system instead of the triplex system.

Meuleners, R. J.↗
NASA NTRS1982

Flying qualities criteria for GA single pilot IFR operations

The flying qualities criteria in general aviation (GA) to decrease accidents are discussed. The following in-flight research is discussed: (1) identification of key aerodynamic configurations; (2) implementation of an in-flight simulator; (3) mission matrix design; (4) experimental systems; (5) data reduction; (6) optimal flight path reconstruction. Some of the accomplished work is reported: an integrated flight testing and flight path reconstruction methodology was developd, high accuracy in trajectory estimation was achieved with an experimental setup, and a part of the flight test series was flown.

Bar-Gill, A.↗
NASA NTRS1982

A ground-simulator investigation of helicopter longitudinal flying qualities for instrument approach

A ground-simulation experiment was conducted to investigate the direct and interactive influences of several longitudinal static and dynamic stability parameters on helicopter flying qualities during terminal-area operations in instrument conditions. Variations that were examined included five levels of static control-position gradients ranging from stable to unstable; two levels of dynamic stability for the long-period oscillation; two levels of the steady-state pitch speed gradient; two levels of angle-of-attack stability and pitch-rate damping; and two levels of stability and control augmentation. These variations were examined initially in calm air and thin in simulated light-to-moderate turbulence and wind shear. Five pilots performed a total of 223 evaluations of these parameters for a representative microwave landing system precision approach task conducted in a dual-pilot crew-loading situation.

Lebacqz, J. V.↗
NASA NTRS1982

Design of a horizonal liquid helium cryostat for refrigerating a flying superconducting magnet in a wind tunnel

The design of a horizontal liquid helium cryostat for refrigerating a flying superconducting magnet in a wind tunnel is presented. The basic principles of magnetic suspension theory are described and theoretical calculations of the superconducting magnet are provided. The experimental results of the boil-off of liquid nitrogen and liquid helium in the cryostat are reported.

Wu, Y. Y.↗
NASA NTRS1983

NASA/RAE collaboration on nonlinear control using the F-8C digital fly-by-wire aircraft

A cooperative advanced digital research experiment (CADRE) was established by the National Aeronautics and Space Administration (NASA) and the Royal Aircraft Establishment (RAE), in which nonlinear control algorithms developed by the RAE were tested on the F-8C digital fly-by-wire (DFBW) aircraft based at the Dryden Flight Research Facility. In the initial phase of the collaboration, some variable-gain algorithms, referred to collectively as variable integral control to optimize response (VICTOR) algorithms, were fight tested. With VICTOR, various measures available within the control system are used to vary gains and time-constants within the closed loop and thereby enhance the control capability of the system, while reducing the adverse effects of sensor noise on the control surfaces. A review of design procedures for VICTOR and results of preliminary flight tests are presented. the F-8C aircraft is operated in the remotely augmented vehicle (RAV) mode, with the control laws implemented as FORTRAN programs on a ground-based computer. Pilot commands and sensor information are telemetered to the ground, where the data are processed to form surface commands which are then telemetered to the ground, where the data are processed to form surface commands which are then telemetered back to the aircraft. The RAV mode represents a single-string (simplex) system and is therefore vulnerable to a hardover since comparison monitoring is not possible. Hence, extensive error checking is conducted on both the ground and airborne computers to prevent the development of potentially hazardous situations. Experience with the RAV monitoring and validation procedures is described.

Butler, G. F.↗
NASA NTRS1983

Flight-test results using nonlinear control with the F-8C digital fly-by-wire aircraft

The design and operation of the cooperative advanced digital research experiment (CADRE) to develop nonlinear pitch flight control algorithms is described, and the results of an in-flight evaluation using the F-8C digital fly-by-wire (DFBW) research aircraft are presented. The CADRE controller is described, including the initial filter, linear command prefilter, nonlinear command prefilter, and gain scheduling. The variable-integral control-to-optimize response of the controller is considered, and CADRE parameter combinations are addressed. The remotely-augmented-vehicle interface used in the DFBW aircraft experiment is discussed. The distanct-tracking and close-formation tracking evaluation tasks for the aircraft are described along with evaluation configurations, and the test results are presented and discussed. The latter indicate that a nonlinear adaptive controller is a feasible control system technique for the fighter tracking task.

Larson, R. R.↗
NASA NTRS1984

Space shuttle flying qualities criteria assessment, phase 3

The crucial flight data measurement and reduction techniques required for the experimental approach are explored. An overview of available flight data is presented, identification of the effective augmented vehicle and pilot models determined, a summary of flight data problems compiled, and further recommendations for the Orbiter Flying Qualities (OFQ) experiment provided.

Myers, T. T.↗
NASA NTRS1984

A proof-of-principle getaway special free-flying satellite demonstration

An air traffic control radar calibration satellite is described that will be used by the U.S. Federal Aviation Administration, U.S. military agencies and cooperating governments around the world to measure antenna patterns associated with the existing international air traffic control network. The satellite will employ three L-band receivers, a UHF command receiver, a VHF telemetry transmitter, associated antennas, a microprocessor, fixed solar arrays, and a power supply to acquire, store and forward signal strength data from some of the tracking radars. A second satellite is planned for launch in 1986 into a high altitude polar orbit with a lifetime of several years in order to provide a long-lived calibration service to the entire international air traffic control system. The initial satellite and associated ground station are being designed and built by a volunteer consortium of three educational institutions and more than a dozen aerospace companies. Following this initial demonstration of a free-flying Getaway Special satellite, a substantial number of organizations are contemplating commercial uses of the concept. Discussions are being held with NASA concerning the establishing of an appropriate fee for this new class of service.

Moore, R. G.↗
NASA NTRS1984

Flying qualities and control system characteristics for superaugmented aircraft

Aircraft-alone dynamics and superaugmented control system fundamental regulatory properties including stability and regulatory responses of the basic closed-loop systems; fundamental high and low frequency margins and governing factors; and sensitivity to aircraft and controller parameters are addressed. Alternative FCS mechanizations, and mechanizational side effects are also discussed. An overview of flying qualities considerations encompasses general pilot operations as a controller in unattended, intermittent and trim, and full-attention regulatory or command control; effective vehicle primary and secondary response properties to pilot inputs and disturbances; pilot control architectural possibilities; and comparison of superaugmented and conventional aircraft path responses for different forms of pilot control. Results of a simple experimental investigation into pilot dynamic behavior in attitude control of superaugmented aircraft configurations with high frequency time laps and time delays are presented.

Myers, T. T.↗
NASA NTRS1984

Quantification of Cross-coupling and Motion Feedthrough for Multiaxis Controllers Used in an Air Combat Flying Task

A real-time piloted simulation of an air-to-air combat flying task using a wings-level-turn aircraft and various novel controllers was conducted. One objective is to quantify how the pilot interacts with the controllers and control modes, including: (1) controller versus aircraft response; (2) proprioceptive cross-coupling among axes of the controllers; and (3) biodynamic cross-coupling between the aircraft motions and the controllers. In order to aid in identifying the items listed above, both the target aircraft and the large amplitude multimode aerospace research simulator (LAMARS) motion system were distributed with quasi-random sums-of-sinusoids. Since the disturbances were separated in frequency, spectral analysis techniques were used to identify the three items listed. The results of the spectral analysis of controller motions from the two-axis side stick, a twist grip mounted on the side stick, a thumb button mounted on the side stick, and conventional rudder pedals are presented. Conclusions and recommendations for further research are also presented.

Jewell, W. E.↗
NASA NTRS1983

Analytical redundancy management mechanization and flight data analysis for the F-8 digital fly-by-wire aircraft flight control sensors

The details are presented of an onboard digital computer algorithm designed to reliably detect and isolate the first failure in a duplex set of flight control sensors aboard the NASA F-8 digital fly-by-wire aircraft. The algorithm's successful flight test program is summarized, and specific examples are presented of algorithm behavior in response to software-induced signal faults, both with and without aircraft parameter modeling errors.

Deckert, J. C.↗
NASA NTRS1986

Loads and motions of an F-106B flying through thunderstorms

Data are presented on loads and motions of a NASA F-106B airplane flying inside thunderstorms. No significant differences in piloting techniques were observed among the three pilots involved. It is indicated that airliners in normal operations occasionally encounter turbulence almost as severe as those encountered in these thunderstorm flights.

Winebarger, R. M.↗
NASA NTRS1986

Validation of a new flying quality criterion for the landing task

A strong correlation has been found to exist between flight path angle peak overshoot and pilot ratings for the landing task. The use of flightpath overshoot as a flying quality metric for landing is validated by correlation with four different in-flight simulation programs and a ground simulation study. Configurations tested were primarily medium-weight generic transports. As a result of good correlation with this extensive data base, criterion boundaries are proposed for landing based on the flight path peak overshoot metric.

Berry, D. T.↗
NASA NTRS1986

Simulation of an aircraft flying through a ground station to satellite link

The effect of an aircraft which flies through a ground station-to-satellite link is determined. There are two aspects to the work reported here: (1) an aperture blockage theoretical solution developed by Rudduck and Lee was used to calculate the effect of a large aircraft (C5) for various satellite ground station antenna diameters, and (2) the compact range facility at the Ohio State University was used to measure various targets, including a 737 aircraft, and to validate the theoretical solution in item 1.

Rudduck, R. C.↗
NASA NTRS1986

Pilot interface with fly by wire control systems

Aircraft designers are rapidly moving toward full fly by wire control systems for transport aircraft. Aside from pilot interface considerations such as location of the control input device and its basic design such as side stick, there appears to be a desire to change the fundamental way in which a pilot applies manual control. A typical design would have the lowest order of manual control be a control wheel steering mode in which the pilot is controlling an autopilot. This deprives the pilot of the tactile sense of angle of attack which is inherent in present aircraft by virtue of certification requirements for static longitudinal stability whereby a pilot must either force the aircraft away from its trim angle of attack or trim to a new angle of attack. Whether or not an aircraft actually has positive stability, it can be made to feel to a pilot as though it does by artificial feel. Artificial feel systems which interpret pilot input as pitch rate or G rate with automatic trim have proven useful in certain military combat maneuvers, but their transposition to other more normal types of manual control may not be justified.

Melvin, W. W.↗
NASA NTRS1985

A preliminary study of the basic display/guidance requirements for flying near optimal trajectories

NASA has responded to the increased emphases on cost-efficient operation of today's airline fleet with an ongoing research program to investigate the requirements and benefits of using new airborne guidance and pilot procedures designed to yield cost-optimal flight profiles that are compatible with advanced air traffic control system concepts. A trajectory optimization algorithm has been incorporated into one of NASA Langley's fixed-based simulators to investigate the pilot/cockpit interface requirements. The trajectories that are generated by this algorithm differ from conventional profiles in that they are constantly varying in both flight path angle and airspeed. Considering the dynamic nature of these profiles, conventional guidance may be insufficient for practical use. This paper summarizes the results of an initial set of piloted simulation tests to investigate the basic guidance requirements for flying the near-optimal trajectories.

Vicroy, D. D.↗
NASA NTRS1986

Validation of a new flying quality criterion for the landing task

A strong correlation has been found to exist between flight path angle peak overshoot and pilot ratings for the landing task. The use of flight path overshoot as a flying quality metric for landing is validated by correlation with four different in-flight simulation programs and a ground simulation study. Configurations tested were primarily medium-weight generic transports. As a result of good correlation with this extensive data base, criterion boundaries are proposed for landing based on the flight path peak overshoot metric.

Berry, D. T.↗
NASA NTRS1986

Propulsion recommendations for space station free flying platforms

Propulsion system candidates have been defined for Space Station free flying platforms for the purpose of comparison and to understand the impact of the various mission requirements on the candidate designs. Recommendations for propulsion for each of the various platforms are given.

Redd, L. R.↗