Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “extrapolation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 685 records · Page 38

Open magnetic fields in active regions

Soft X-ray images and magnetograms of several active regions and coronal holes are examined which support the interpretation that some of the dark X-ray gaps seen between interconnecting loops and inner cores of active regions are foot points of open field lines inside the active regions. Characteristics of the investigated dark gaps are summarized. All the active regions with dark X-ray gaps at the proper place and with the correct polarity predicted by global potential extrapolation of photospheric magnetic fields are shown to be old active regions, indicating that field opening is accomplished only in a late phase of active-region development. It is noted that some of the observed dark gaps probably have nothing in common with open fields, but are either due to the decreased temperature in low-lying portions of interconnecting loops or are the roots of higher and less dense or cooler loops.

Svestka, Z.↗

Experimental studies of the Space Shuttle payload acoustic environment

Two series of experiments were conducted to reduce the uncertainties concerning the Space Shuttle payload bay acoustic environment. Tests using a one-fifth scale model showed large changes in level below 125 Hz with the introduction of typical payloads. The changes were associated with particular acoustic modal behavior and were sensitive to the type of acoustic excitation. Another series of experiments evaluated the noise reduction of the first orbiter vehicle (OV-101). The results showed consistently greater noise reduction for grazing excitation than for diffuse excitation. The results were extrapolated to OV-102 using mass law relations and acceleration measurements.

Piersol, A. G.↗

Heat pipes in space and on earth

The heat pipe is a closed tube whose inner surfaces are lined with a porous capillary wick. The wick is saturated with the liquid phase of a working fluid. The heat supplied at one end of the tube, the evaporator, causes evaporation of the working fluid. The vapor will pass to the other end of the tube, the condenser, where it will condense and release the latent heat of vaporization to a heat sink in that section of the pipe. Problems concerning a design of heat pipes for space applications are related to certain difficulties regarding the prediction of device performance under zero-g conditions. Heat pipes are usually tested on the ground under the influence of gravity, and then their performance is extrapolated to space. A description is presented of the approaches used to insure good heat pipe performance in space. Attention is given to an international heat pipe experiment conducted to accumulate zero-g performance data for several new and unique heat pipe designs, heat pipes for ATS-6, cryogenic heat pipes, and future activities.

Ollendorf, S.↗

The use of parabolic variations and the direct determination of stress intensity factors using the BIE method

Two advances in the numerical techniques of utilizing the BIE method are presented. The boundary unknowns are represented by parabolas over each interval which are integrated in closed form. These integrals are listed for easy use. For problems involving crack tip singularities, these singularities are included in the boundary integrals so that the stress intensity factor becomes just one more unknown in the set of boundary unknowns thus avoiding the uncertainties of plotting and extrapolating techniques. The method is applied to the problems of a notched beam in tension and bending, with excellent results.

Mendelson, A.↗

Spectral irradiance standard for the ultraviolet - The deuterium lamp

A set of deuterium lamps is calibrated as spectral irradiance standards in the 200-350-nm spectral region utilizing both a high accuracy tungsten spectral irradiance standard and a newly developed argon mini-arc spectral radiance standard. The method which enables a transfer from a spectral radiance to a spectral irradiance standard is described. The following characteristics of the deuterium lamp irradiance standard are determined: sensitivity to alignment; dependence on input power and solid angle; reproducibility; and stability. The absolute spectral radiance is also measured in the 167-330-nm region. Based upon these measurements, values of the spectral irradiance below 200 nm are obtained through extrapolation.

Saunders, R. D.↗

Accelerated step-temperature aging of Al/x/Ga/1-x/As heterojunction laser diodes

Double-heterojunction A2(0.3)Ga(0.7)As/Al(0.08)Ga(0.92)As lasers (oxide-striped and Al2O3 facet coated) were subjected to step-temperature aging from 60 to 100 C. The change in threshold current and spontaneous output was monitored at 22 C. The average time required for a 20% pulsed threshold current increase ranges from about 500 h, when operating at 100 C, to about 5000 h at a 70 C ambience. At 22 C, the extrapolated time is about 1 million h. The time needed for a 50% spontaneous emission reduction is of the same order of magnitude. The resulting activation energies are approximately 0.95 eV for laser degradation and approximately 1.1 eV for the spontaneous output decrease

Kressel, H.↗

EUV structure of a small flare

Observations of a small flare are presented using data from the Harvard spectroheliometer on Skylab. The event is discussed in terms of the magnetic structure of the active region as deduced from the EUV observations and from field line extrapolations. The role of emerging flux in the initial flare brightenings is emphasized. A detailed model of one loop is deduced using the EUV data. This self-consistent model indicates initial heating of the loop modeled near its top, and mass flow into the cool core of the loop, with matter preferentially concentrating in a few distinct knots along the loop. Implications for theories of the flare process are discussed.

Levine, R. H.↗

The epoch state navigation filter

The formulation of a recursive maximum likelihood navigation system employing reference position and velocity vectors as state variables is presented. Convenient forms of the required variational equations of motion are developed together with an explicit form of the associated state transition matrix needed to refer measurement data from the measurement time to the epoch time. Computational advantages accrue from this design in that the usual forward extrapolation of the covariance matrix of estimation errors can be avoided without incurring unacceptable system errors. Simulation data for earth orbiting satellites are provided to substantiate this assertion.

Battin, R. H.↗

Communication satellite services for special purpose users

The present study identifies potential satellite services, examines the technology necessary for efficient implementation of these services, and determines minimum service cost versus user network size. The generic satellite services evaluated comprise TV and radio distribution (for retransmission), video teleconferencing (interactive), audio/facsimile teleconferencing (interactive), multiplexed data/voice (point-to-point), and satellite-supported land mobile. Satellite costs are based on extrapolations from ongoing commercial satellite programs. Production methods, new technology, and effect of production quantities on present and future production costs are examined to provide information on earth station equipment cost versus the variable 'buy'. Six different launch vehicles from a Delta 2914 to a dedicated Shuttle and three frequency bands and both broadcast (no eclipse capability) and fixed service satellites are considered to assess the effect of satellite size on cost and performance. It is assumed that the user pays only for his prorata share of the space segment costs.

Wright, D. L.↗

Measurement of flow angle and mass flow rate in an unknown flow field using hot film and hot wire probes

A data reduction technique applicable to constant temperature hot film and hot wire probes is presented which is used to determine flow angle and mass flow rate in an unknown flow field over a wide range of flow conditions at supersonic and hypersonic velocities. The technique virtually eliminates the effect of Reynolds number on a probe's flow angle sensitivity. Methods for extrapolating a limited amount of mass flow rate calibration data to include the range of mass flow rate encountered in an experiment are also given. This technique has been applied to data obtained using a hot film probe during surveys in the leeside flow field of a space shuttle orbiter configuration.

Helms, V. T., III↗

Correlation of inert gas hollow cathode performance

A use of the inert gases argon and xenon as possible alternatives to mercury and cesium is being considered for electrical propulsion applications. Operation up to 200 hours has been demonstrated for hollow cathodes employing argon as propellant. A description is presented of an investigation which has been conducted to obtain basic information for an improvement of hollow cathode performance with inert gases. Neutralizer tests were conducted in a 1.2-m diameter vacuum tank, with a 15-cm multipole thruster. Progress was achieved towards the goal of a generalized description of hollow cathode performance. Extrapolation of the erosion based upon a 200-hour endurance test predicts an ultimate lifetime of 1400 to 10,000 hours.

Rehn, L.↗

A review of the Thermoelectronic Laser Energy Converter /TELEC/ Program at Lewis Research Center

The investigation of the Thermoelectronic Laser Energy Converter (TELEC) concept at the Lewis Research Center (LeRC) began with a feasibility study of a 1 megawatt sized TELEC system. The TELEC was to use either cesium vapor or hydrogen as the plasma medium. The cesium vapor TELEC appears to be the more practical device studied with an overall calculated conversion efficiency of greater than 48%. Following this study, a small TELEC cell was fabricated which demonstrated the conversion of a small amount of laser power to electrical power. The cell developed a short circuit current of 0.7 amperes and an open circuit voltage, as extrapolated from volt-ampere curves, of about 1.5 volts. Work is now in progress to construct and test a cesium vapor TELEC capable of absorbing 20% of an incident 10 kW, 10.6 micrometer beam, and converting 35% of this power to electrical power.

Alger, D. L.↗

Remote sensing R&D planning

A NASA method is described for forecasting remote sensing needs in the last decade of this century and for planning the necessary space system technology R&D. Five- and ten-year plans for earth observations in various disciplines are extrapolated forward to circa 1995 via a scenario which envisions major advances in remote sensing and information management. Space system studies identify the 'technology drivers', and development programs are initiated to develop the enabling technology. An example is given for a multipurpose large-aperture microwave radiometer spacecraft.

Keafer, L. S., Jr.↗

Application of higher-order numerical methods to the boundary-layer equations

A fourth-order method is presented for calculating numerical solutions to parabolic, partial differential equations in two variables or ordinary differential equations. The method is the natural extension of the second-order Keller Box Scheme to fourth order and is demonstrated with application to the incompressible, laminar and turbulent boundary-layer equations for both attached and separated flows. The efficiency of the present method is compared with other higher-order methods; namely, the Keller Box Scheme with Richardson extrapolation, the method of deferred corrections, the three-point spline methods, and a modified finite-element method. For equivalent accuracy, numerical results show the present method to be more efficient than the other higher-order methods for both laminar and turbulent flows.

Wornom, S. F.↗

Typhoon June /1975/ viewed by a scanning microwave spectrometer

Data were collected by the scanning microwave spectrometer onboard Nimbus 6 during the June 1975 typhoon in the Philippine Sea. The spectrometer was equipped with channels centered on 22.23 GHz (a water vapor band), 31.65 GHz (a transmittance window), and 52.85, 53.85, and 55.45 GHz (an oxygen band). Temperature maps, derived from oxygen band measurements, showed that the typhoon eye had a single peak varying in amplitude with time. Water line and window measurements were used to develop a coordinate system having mutually orthogonal atmospheric variables of column water-vapor content and cloud liquid-water content. Vapor measurements showed a maximum around the intensifying typhoon with a more developed structure during typhoon development. Values were extrapolated for surface wind speed and cloud liquid water vapor content by assuming the troposphere to be saturated with respect to the water vapor in the typhoon. Comparisons with infrared cloud imagery and aircraft flight data show different time variations, attributed to poor typhoon-eye resolution in the microwave images.

Rosenkranz, P. W.↗

Temperate zone sporadic-E maps /f/0/E/s/ greater than 7 MHz/

Three maps are presented of f(0) sporadic-E greater than 7 MHz for temperate zones. During map preparation it was assumed that: (1) the geographical area would be between plus and minus 60 deg geomagnetic latitude, excluding the equatorial zone, (2) the maps would be for f(0) sporadic-E greater than 7 MHz, (3) sunspot cycle variation would be ignored, (4) one map would represent the peak sporadic-E period with a discontinuity at the geographic equator, (5) one map would represent non-peak periods with a discontinuity at the geographic equator, (6) one map would represent all twelve months with no equatorial discontinuity, and (7) previously determined coefficients for median and upper decile f(0) sporadic-E would be extrapolated to 7 MHz.

Smith, E. K.↗

HEAO attitude reference design

The paper deals with the precision onboard attitude reference implemented as part of the attitude control and determination subsystem for the three High Energy Astronomy Observatories (HEAO-A, HEAO-B, and HEAO-C) in the HEAO scientific spacecraft program. The first observatory (HEAO-A, designated HEAO-1 when in orbit) was launched successfully into near-earth orbit on August 12, 1977. The HEAO attitude reference, analysis techniques for performance prediction, and flight results from the HEAO-1 observatory during its first months of operation. The HEAO-B design is specifically described and analyzed in terms of gyro processing, kinematic integration, ground update algorithm, and star tracker update algorithm. Attitude reference performance estimates are also discussed. It is shown that the orbital performance of the attitude reference correlates very well with the developmental predictions, thereby validating the analytical techniques used during the development. This validation provides a firm basis from which to extrapolate to other applications and related design concepts.

Hoffman, D. P.↗

Comparisons of measured and calculated potential magnetic fields

Photospheric line-of-sight and transverse-magnetic-field data obtained, with a vector magnetograph system for an isolated sunspot are described. A study of the linear polarization patterns and of the calculated transverse field lines indicates that the magnetic field of the region is very nearly potential. The H-alpha fibril structures of this region as seen in high-resolution photographs corroborate this conclusion. Consequently, a potential-field calculation is described using the measured line-of-sight fields together with assumed Neumann boundary conditions; both are necessary and sufficient for a unique solution. The computed transverse fields are then compared with the measured transverse fields to verify the potential-field model and assumed boundary values. The implications of these comparisons for the validity of magnetic-field extrapolations using potential theory are discussed.

Hagyard, M. J.↗