Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STELLAR SYSTEMS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 685 records · Page 38

Chiron stellar occultation candidates: 1993-1996

A photographic search was conducted for stars that may be occulted by the unusual solar system object (2060) Chiron during the period from fall 1993 through summer 1996. 44 candidates were identified to a limiting V magnitude of 16, and for which the minimum appulse separation with Chiron is predicted to be less than 2.5 arcsec. The successful observation of a stellar occultation by Chiron would give a direct measure of its diameter (currently estimated to be between 60 and 300 km), and would help considerably in constraining Chiron's surface properties and volatile makeup. If at the time of the occultation, Chiron exhibits a significant coma, there is also the potential for measuring the optical-depth profile of the dust in its inner coma.

Bus, S. J.↗

Mass transfer in binary X-ray systems

The influence of X-ray heating on gas flows in binary X-ray systems is examined. A simple estimate is obtained for the evaporative wind flux from a stellar atmosphere due to X-ray heating which agrees with numerical calculations by Alme and Wilson (1974) but disagrees with calculations by Arons (1973) and by Basko and Sunyaev (1974) for the Her X-1/HZ Her system. The wind flux is sensitive to the soft X-ray spectrum. The self-excited wind mechanism does not work. Mass transfer in the Hercules system probably occurs by flow of the atmosphere of HZ Her through the gravitational saddle point of the system. The accretion gas stream is probably opaque with atomic density of not less than 10 to the 15th power per cu cm and is confined to a small fraction of 4(pi) steradians. Other binary X-ray systems are briefly discussed.

Mccray, R.↗

IUE observations of mass ejection by the close binary system AO Cassiopeiae

It is noted that 11 high-resolution spectra in the far-ultraviolet and two high-resolution spectra in the mid-ultraviolet were obtained. A high-velocity stellar wind exists as indicated by narrow shortward-displaced absorption features superposed on the P Cygni lines of N V, Si IV, and C IV. Absorption lines caused by N IV and C III are present and show nonorbital velocities of about -50 to -150 km/sec. Several weak photospheric lines of the primary star are detected. A few lines of Fe IV and Fe V are detectable near phase 0.50 and, less prominently, near phase 0.00. It is noted that the He II absorption line appears doubled except near phases 0.00 and 0.50 and that the weaker component appears to be attributable to the secondary component of the system. The mean velocity of the stellar wind is -1879 + or - 51(p.e.) km/sec and is nearly constant over the period of observation, although the absorption strength is found to vary.

Mccluskey, G. E.↗

Feasibility study of scanning celestial Attitude System (SCADS) for Earth Resources Technology Satellite (ERTS)

The feasibility of using the Scanning Celestial Attitude Determination System (SCADS) during Earth Resources Technology Satellite (ERTS) missions to compute an accurate spacecraft attitude by use of stellar measurements is considered. The spacecraft is local-vertical-stabilized. A heuristic discussion of the SCADS concept is first given. Two concepts are introduced: a passive system which contains no moving parts, and an active system in which the reticle is caused to rotate about the sensor's axis. A quite complete development of the equations of attitude motions is then given. These equations are used to generate the true attitude which in turn is used to compute the transit times of detectable stars and to determine the errors associated with the SCADS attitude. A more complete discussion of the analytical foundation of SCADS concept and its use for the geometries particular to this study, as well as salient design parameters for the passive and active systems are included.

Source record↗

The genesis of the ring galaxy Arp 144 (NGC 7828/29)

Multicolor near-infrared images have been obtained for the 'folded ring' galaxy Arp 144 (NGC 7828/29). About 10 to the 10th solar mass stellar nuclei associated with both NGC 7828 and NGC 7829 are found, indicating that this system is the result of an interaction between two similarly massive galaxies. The galaxy/intergalactic H I cloud collision model proposed by Freeman and de Vaucouleurs (1974) appears to be untenable, since it unequivocally predicts the existence of a single evolved stellar nucleus.

Joy, Marshall↗

Stellar populations in local group dwarf elliptical galaxies. I - NGC 147

A color-magnitude diagram of NGC 147 to an I magnitude of 23 is presented. The stellar population in the outer parts of this elliptical galaxy resembles that of the globular clusters of the Milky Way. Quantitative comparison of the giant branch with those of globular clusters yields a mean metallicity of -1.2 + or - 0.2, making NGC 147 a part of the general correlation between mass and metallicity seen in ellipticals. The giant branch appears to be broad, which suggests a metallicity dispersion. The absence of asymptotic giant branch stars at luminosities above that of the red giant branch tip sets an upper limit of 10 percent for the fraction of stars in this NGC 147 field that have ages less than 12 Gyr. This result contrasts with the situation in some of the related, but less massive, dwarf spheroidal systems. If the choice is made to assume, rather than determine the stellar content of NGC 147, a distance of 630 + or - 50 kpc is derived, similar to that of M31.

Mould, J. R.↗

On the detection of other planetary systems by astrometric techniques

A quantitative method for astrometrically detecting perturbations induced in a star's motion by the presence of a planetary object is described. A periodogram is defined, wherein signals observed from a star show exactly periodic variations, which can be extracted from observational data using purely statistical methods. A detection threshold is defined for the frequency of occurrence of some detectable signal, e.g., the Nyquist frequency. Possible effects of a stellar orbital eccentricity and multiple companions are discussed, noting that assumption of a circular orbit assures the spectral purity of the signal described. The periodogram technique was applied to 12 yr of astrometric data from the U.S. Naval Observatory for three stars with low mass stellar companions. Periodic perturbations were confirmed. A comparison of the accuracy of different astrometric systems shows that the detection accuracy of a system is determined by the measurement accuracy and the number of observations, although the detection efficiency can be maximized by minimizing the number of data points for the case when observational errors are proportional to the square root of the number of data points. It is suggested that a space-based astrometric telescope is best suited to take advantage of the method.

Black, D. C.↗

STRAP IV - High accuracy, low drift attitude control system.

The STRAP IV attitude control system was designed, tested, and successfully launched to provide stable high accuracy pointing at nontrackable X-ray sources. On its initial flight (May 19, 1972), the STRAP IV control system updated its high accuracy, rate integrating gyros on two successive stellar targets and then maneuvered the rocket body to point the experimental payload at two separate X-ray sources and an X-ray-free background location. The third axis, which remained under the control of a coarse free gyro, was updated by a technique of successive star-target coordinate transformation to ensure the correct fine-axis azimuth alignment for the high accuracy inertial maneuvers. Pointing accuracies of 4 arc min with limit cycle stability of less than 20 arc sec peak to peak were obtained on all targets.

Shrewsberry, D. J.↗

Star-Catalog Data Base

SKYMAP is collection of computer programs and utility software for creating and maintaining master star catalog and hierarchical set of derivative star catalogs. Developed to provide accurate stellar position and magnitude information for attitude-determination and analysis systems utilizing star sensor observations. Current master star catalog includes all documented stars with blue or visual magnitudes brighter than magnitude 9.0

Gotlieb, D.↗

Ultraviolet and X-ray detection of the 56 Peg system (KO 2p + WD)

Both IUE short and long wavelength exposures of the 56 Peg system are discussed. This mild barium star has an X-ray luminosity of 3 x 10 to the 31st power ergs/1, comparable to the rapidly rotating RS CVn binary systems, yet lies in a region of the HR diagram where stellar X-rays are generally not observed. This cool, bright giant is not a rapid rotator and the key to understanding its emission lies in the recent discovery of its white dwarf companion. Accretion onto the white dwarf of approximately 0.1% of the stellar wind of the primary is sufficient to power an X-ray source of the observed luminosity. Reprocessing of the X-rays in the cool dense stellar wind explains the origin of the UV emission line spectrum, and may explain the time varying asymmetry of the Mg 2 kappa line profile that is observed. Graphs which show observed fluxes and wavelengths are discussed.

Schindler, M.↗

A quadrant-CCD star tracker

The characteristics of a quadrant-CCD designed for pointing and tracking are discussed with reference to its use in an adaptive optics program. The quadrant-CCD is used to correct stellar image motion proceeding from atmospheric turbulence by means of a system in which a sensor measures the image offset and sends data to a high-speed tip/tilt mirror. The design and control of the device are detailed, including four 100-micron-square pixels, the quadrant architecture, controller electronics, and data acquisition computer and interface. The transfer function is set forth in the x and y directions, and transfer curves are shown. A laboratory simulation of random image motion was conducted to evaluate the performance of the quadrant-CCD as an image motion sensor, and the experimental results are presented. The suitability of the quadrant-CCD for space-based pointing and tracking uses is demonstrated by this test and two earlier theoretical studies. Some future developments which improve performance capabilities are mentioned.

Clampin, M.↗

On two-dimensional relativistic stellar winds

Stellar wind is of great interest, because many of the astrophysical systems possess wind like structures. For a long time only nonrelativistic winds have been studied. However, recently it was proposed by Kennel et al. that the relativistic pulsar wind with the plasma, consisting of electrons and positrons, can be responsible for the observed features of the Crab nebula. The study of Kennel et al. revealed the inconsistency of the assumption of the wind zero temperature with the observational data. It has been shown that only for high relativistic temperatures can high Mach numbers be reached, which allows the possibility of a shock formation. The analysis of Kennel et al. was extended into the 2-D case by using conventional magnetohydrodynamic equations for a relativistic plasma with an isotropic relativistic temperature. The state equation is assumed polytropic.

Gedalin, M. E.↗

The Astrometric Imaging Telescope - A space-based observatory for extra-solar planet detection

The paper describes the objectives, techniques, instrumentation, and mission of the planned Astrometric Imaging Telescope. This space-based observatory is designed to detect and characterize extra-solar planetary systems. Results will contribute to the understanding of the astrophysics of stellar and planetary formation and provide an impetus for the study of exobiology.

Pravdo, Steven H.↗

Origins of planetary systems: Observations and analysis

This cooperative agreement was established with the scientific goal of understanding the conditions of early solar-type planetary systems. We investigated two facets of young solar systems: The effects on planetary bodies of young solar-type stellar mass loss, and photo-production of various organic materials due to radiation under comet-like conditions.

Doyle, Laurance R.↗

Observations of Colliding Winds in O-Type Binaries

Stellar winds will collide in a bow shock in close binary systems of O-type stars. The presence of this boundary will truncate the full spatial extent of the two individual winds, and thus the spectral lines formed in the wind will appear differently when viewed from different orientations. Here I discuss the orbital variations of the UV wind lines in a large sample of O-binaries that have been observed with the International Ultraviolet Explorer Satellite (IUE). High density regions in the wind (near the photospheres and bow shock) will produce optical emission lines, and I describe the He emission properties of several systems. The physical characteristics of the component stars can now be better estimated through Doppler tomography, a numerical method to extract the individual primary and secondary spectra.

Gies, Douglas R.↗

Integrated inertial stellar attitude sensor

An integrated inertial stellar attitude sensor for an aerospace vehicle includes a star camera system, a gyroscope system, a controller system for synchronously integrating an output of said star camera system and an output of said gyroscope system into a stream of data, and a flight computer responsive to said stream of data for determining from the star camera system output and the gyroscope system output the attitude of the aerospace vehicle.

Brady, Tye M.↗

The Kepler End-to-End Model: Creating High-Fidelity Simulations to Test Kepler Ground Processing

The Kepler mission is designed to detect the transit of Earth-like planets around Sun-like stars by observing 100,000 stellar targets. Developing and testing the Kepler ground-segment processing system, in particular the data analysis pipeline, requires high-fidelity simulated data. This simulated data is provided by the Kepler End-to-End Model (ETEM). ETEM simulates the astrophysics of planetary transits and other phenomena, properties of the Kepler spacecraft and the format of the downlinked data. Major challenges addressed by ETEM include the rapid production of large amounts of simulated data, extensibility and maintainability.

Bryson, Stephen T.↗