Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Flow Improvers”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 685 records · Page 38

Retrofitting a 1960s Split-Level, Cold-Climate Home

National programs such as Home Performance with ENERGY STAR® and numerous other utility air-sealing programs have made homeowners aware of the benefits of energy-efficiency retrofits. Yet these programs tend to focus only on the low-hanging fruit: they recommend air sealing the thermal envelope and ductwork where accessible, switching to efficient lighting and low-flow fixtures, and improving the efficiency of mechanical systems (though insufficient funds or lack of knowledge to implement these improvements commonly prevent the implementation of these higher cost upgrades). At the other end of the spectrum, various utilities across the country are encouraging deep energy retrofit programs. Although deep energy retrofits typically seek 50% energy savings, they are often quite costly and are most applicable to gut-rehab projects. A significant potential for lowering energy use in existing homes lies between the lowhanging fruit and deep energy retrofit approaches—retrofits that save approximately 30% in energy compared to the pre-retrofit conditions. The energy-efficiency measures need to be nonintrusive so the retrofit projects can be accomplished in occupied homes.

1960 split level↗

Energy to Communities Program Short Introduction: Evaluation of Enhanced Geothermal System for Cornell District Heating [Slides]

Through the U.S. Department of Energy's Energy to Communities (E2C) program, NLR, other national laboratory experts, and select organizations provide Expert Match - free, short-term technical assistance to address near-term energy challenges and questions. Expert Match is for community stakeholders who have decision-making power or influence in their community but need access to additional energy expertise to inform key upcoming decisions. This Expert Match request supported Cornell University (Itaca, NY) community efforts in developing Enhanced Geothermal System (EGS) reservoir performance, by simulating fracture flow to estimate pressure drop, flow distribution, and heat extraction efficiency in fractured rock. Thermal drawdown modeling was used to assess long-term resource sustainability, while system optimization studies refined key parameters such as well configuration and flow rate to improve overall reservoir efficiency.

15 GEOTHERMAL ENERGY↗

State Estimation in Low-Observable Distribution Systems Using Matrix Completion: Preprint

The need for distribution system state estimation is on the rise because of the increased penetration of distributed energy resources and flexible load. To manage the distribution systems in real time, operators need to first overcome the challenge of low observability in distribution systems. Also, because of the amount of data present from smart meters, distributed generation measurements, switches, etc., the ideal distribution state estimation methods need to be able to process heterogeneous data. In this paper, an algorithm is developed for voltage phasor estimation in low-observability distribution systems. The algorithm is based on the matrix completion approach from signal processing. The traditional matrix completion formulation is augmented with power-flow constraints to improve results while requiring less data. This method can also use all types of measurements (voltage magnitude, voltage angle, real power, reactive power) to complete the state matrix.

24 POWER TRANSMISSION AND DISTRIBUTION↗

Development of inter-grid-cell lateral unsaturated and saturated flow model in the E3SM Land Model (v2.0)

Abstract. The lateral transport of water in the subsurface is important in modulating terrestrial water energy distribution. Although a few land surface models have recently included lateral saturated flow within and across grid cells, it is not a default configuration in the Climate Model Intercomparison Project version 6 experiments. In this work, we developed the lateral subsurface flow model within both unsaturated and saturated zones in the Energy Exascale Earth System Model (E3SM) Land Model version 2 (ELMv2.0). The new model, called ELMlat, was benchmarked against PFLOTRAN, a 3D subsurface flow and transport model, for three idealized hillslopes that included a convergent hillslope, divergent hillslope, and tilted V-shaped hillslope with variably saturated initial conditions. ELMlat showed comparable performance against PFLOTRAN in terms of capturing the dynamics of soil moisture and groundwater table for the three benchmark hillslope problems. Specifically, the mean absolute errors (MAEs) of the soil moisture in the top 10 layers between ELMlat and PFLOTRAN were within 1 %±3 %, and the MAEs of water table depth were within ±0.2 m. Next, ELMlat was applied to the Little Washita experimental watershed to assess its prediction of groundwater table, soil moisture, and soil temperature. The spatial pattern of simulated groundwater table depth agreed well with the global groundwater table benchmark dataset generated from a global model calibrated with long-term observations. The effects of lateral groundwater flow on the energy flux partitioning were more prominent in lowland areas with shallower groundwater tables, where the difference in simulated annual surface soil temperature could reach 0.3–0.4 ∘C between ELMv2.0 and ELMlat. Incorporating lateral subsurface flow in ELM improves the representation of the subsurface hydrology, which will provide a good basis for future large-scale applications.

58 GEOSCIENCES↗

A simplified theory of oscillating airfoils in transonic flow - Review and extension

Significant old and new results are presented to show to what extent a simplified theory for transonic flow may be used. Solutions are obtained by classical techniques and compared with experiment. Results are given for two-dimensional, steady and unsteady flow and three-dimensional, steady flow. The effects of flow separation and improvements in Bernoulli's equations and the surface boundary condition are also briefly discussed.

Dowell, E. H.↗

Propulsion/airframe integration considerations for high altitude hypersonic cruise vehicles

A study has been conducted to determine the implications of top-mounted inlet nacelles on propulsion performance and cruise range. The top-mounted nacelle would be less visible from ground-based radar below and ahead of the aircraft. For this study, the nacelle is integrated with a high altitude Mach 5 turbojet/ramjet-powered airplane concept requiring a large nacelle. Results of the study suggest nacelle installation advantages and improved inlet mass flow ratio for the top-mounted nacelle, but at the expense of a higher installed drag at transonic and supersonic speeds.

Weidner, J. P.↗

A simplified theory of oscillating aerofoils in transonic flow - Review and extension

A simplified theory of the dynamic motion of aerofoils of finite thickness in transonic flow is presented which excludes the effect of shock waves on the aerofoil itself and, thus, is restricted to free stream Mach numbers equal to unity or above. Numerical examples are analyzed for two-dimensional steady and unsteady (including transient) aerofoil motion and three-dimensional steady and unsteady flow over delta wings. The effects of flow separation and improvements in Bernoulli's equation and the surface boundary condition are briefly discussed.

Dowell, E. H.↗

Supercritical maneuvering fighter configuration. Wind-tunnel investigation at Mach numbers of 0.60 to 0.95

A wind tunnel investigation was conducted to study the application of supercritical technology to highly maneuverable combat aircraft. The configuration studied has a leading-edge sweep of 45 deg and an aspect ratio of 3.28. Two supercritical-wing shapes were tested at Mach numbers from 0.60 to 0.95 with angles of attack from -2 deg to 17 deg. On supercritical wing was designed to achieve a high level of transonic maneuver performance at a Mach number of 0.90; however, excessive flow separation developed on this wing at a Mach number of 0.85. A second supercritical wing was tested which had significantly reduced flow separation and improved drag characteristics at a Mach number of 0.85 and maintained the performance of the original wing at the higher Mach numbers. Leading-edge vortex generators did not improve the performance of the second wing; however, a sharp leading-edge flap produced sizable drag reductions at Mach numbers from 0.60 to 0.90.

Mann, M. J.↗

Evaluation of a wall-flow direction probe for measurements in separated flows

The upstream-downstream flow direction intermittency is an important parameter that can quantitatively describe the stages of flow separation. This paper gives an improved design for a wall-flow-direction probe. Intermittency measurements made using this modified probe show agreement within experimental uncertainties with direct measurements made using a LDV, although both the unmodified and modified probe designs produce results that are consistently higher than those for the LDV.

Shivaprasad, B. G.↗

Precision laser tracking for global and polar motion

This paper provides an overview of the Goddard Laser Tracking Network (GLTN). GLTN station locations, equipment, possible improvements, and data flow are discussed. Locations of the other major laser tracking networks and their present or expected performance are also provided. The material includes a listing of the Lunar Laser Ranging Stations (LLRSs) and their actual or expected performance.

Shawe, M. E.↗

Non-reflecting boundary conditions for the compressible Navier-Stokes equations

A small perturbation analysis, in the long wavelength regime, is used to obtain the downstream boundary condition for the pressure for the flow over a flat plate. The methodology is extendable to other geometries. Numerical results for high Reynolds number laminar flows show great improvement in convergence rate to steady state as well as the quality of the results.

Abarbanel, S.↗

Modification to the NASA Langley 4- by 7-meter tunnel for improved rotorcraft aerodynamics and acoustics

Investigations have been conducted with the aim of improving circuit mean flow characteristics and test section turbulence intensity in the NASA Langley 4 x 7-m wind tunnel. Flow deflectors were instaled to displace the airstream and provide more symmetrical velocity distributions. The periodic flow pulsations of the open test section configuration were addressed by modifications of either the test section entrance, using triangular vanes, or the test section exit, using an alternative flow collector geometry; the latter proved more effective.

Applin, Z. T.↗

Applications of a new wall function to turbulent flow computations

A new wall function approach is developed based on a wall law suitable for incompressible turbulent boundary layers under strong adverse pressure gradients. This wall law was derived from a one-dimensional analysis of the turbulent kinetic energy equation with gradient diffusion concept employed in modeling the near-wall shear stress gradient. Numerical testing cases for the present wall functions include turbulent separating flows around an airfoil and turbulent recirculating flows in several confined regions. Improvements on the predictions using the present wall functions are illustrated. For cases of internal recirculating flows, one modification factor for improving the performance of the k-epsilon turbulence model in the flow recirculation regions is also included.

Chen, Y. S.↗

Recent skin friction techniques for compressible flows

A brief review is given of developments over the last decade in techniques for the measurement of skin friction in compressible airflows. Emphasis is placed on mean measurements beneath turbulent boundary layers in the supersonic and hypersonic flow regimes. Recent improvements in existing techniques such as the skin friction balance, Preston tube, sublayer fence, and heat transfer analogy are discussed. New or potential techniques including optical and acoustic measurements are also treated. Finally, new results are presented on the adaptation of the recently-developed laser interferometer skin friction meter for use in high-speed wind tunnels.

Settles, G. S.↗

Mechanical behavior of thermal barrier coatings for gas turbine blades

Plasma-sprayed thermal barrier coatings (TBCs) will enable turbine components to operate at higher temperatures and lower cooling gas flow rates; thereby improving their efficiency. Future developments are limited by precise knowledge of the material properties and failure mechanisms of the coating system. Details of this nature are needed for realistic modeling of the coating system which will, in turn, promote advancements in coating technology. Complementary experiments and analytical modeling which were undertaken in order to define and measure the important failure processes for plasma-sprayed coatings are presented. The experimental portion includes two different tests which were developed to measure coating properties. These are termed tensile adhesion and acoustic emission tests. The analytical modeling section details a finite element method which was used to calculate the stress distribution in the coating system. Some preliminary results are presented.

Berndt, C. C.↗

Erosion-Resistant Water-Blast Nozzle

Design of nozzle reduces erosion of orifice by turbulent high-pressure water flowing through it. Improved performance and resistance to erosion achieved by giving interior nozzle surface long, gradual convergence before exit orifice abrupt divergence after orifice and by machining surface to smooth finish.

Roberts, Marion L.↗

The theoretical model for the annular jet instability - Revisited

The theoretical model of Lee and Wang (1986) for the instability of an annular jet, in which the jet's liquid layer is treated as a thin liquid sheet, is examined. It is suggested that the model should be altered so that when the envelope is closing its bottleneck during collapse, the new envelope experiences a sharp pressure pulse from its gaseous core, reversing the normal velocity of the sheet enough to maintain continuous constant gas flow. Using this improved version of the model, it is shown that if the liquid velocity is high enough and the gas velocity is greater than the liquid velocity, the bubble-formation frequency varies linearly with the difference between the two velocities, but not with their individual values.

Lee, C. P.↗