Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “identity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Analytical method for calculation of navigational data for the position of a satellite

A method is described for calculating the position of a satellite at the instants when measurements are made on board. The initial conditions used were the mean orbital elements of the satellite and their time derivatives in one orbit. The results of the calculation are compared with those obtained by numerical integration, and it is found that results are identical at the beginning of an orbit, but change as the orbit progresses. The advantages and disadvantages of the analytical method are presented.

Lala, P.↗
NASA NTRS1975

Steady-state solutions of a diffusive energy-balance climate model and their stability

A diffusive energy-balance climate model, governed by a nonlinear parabolic partial differential equation, was studied. Three positive steady-state solutions of this equation are found; they correspond to three possible climates of our planet: an interglacial (nearly identical to the present climate), a glacial, and a completely ice-covered earth. Models similar to the main one are considered, and the number of their steady states was determined. All the models have albedo continuously varying with latitude and temperature, and entirely diffusive horizontal heat transfer. The stability under small perturbations of the main model's climates was investigated. A stability criterion is derived, and its application shows that the present climate and the deep freeze are stable, whereas the model's glacial is unstable. The dependence was examined of the number of steady states and of their stability on the average solar radiation.

Ghil, M.↗
NASA NTRS1975

Cold-air experimental investigation of a turbine with blade trailing edge coolant ejection. 1: Single-stage turbine

Tests were made on a 0.762-meter-tip-diameter research turbine to determine the effect of blade coolant flow on its aerodynamic performance. Both stator and rotor blades had trailing-edge slots for coolant ejection. The turbine was tested over a range of speed and pressure ratio. High primary efficiencies, calculated on the basis of primary air only, were obtained. The efficiency attained was identical to that reported for the turbine from a previous investigation were only slotted stator blades where incorporated in the turbine and tested. And it also compares with results for the turbine with solid blading. Independently varying the rotor coolant flow showed that rotor cooling imposed a severe penalty on turbine efficiency. The thermodynamic efficiency, which accounts for the ideal energies of both blade coolant flows, decreased linearly with rotor coolant at a rate of about 0.7 percent per percent rotor coolant fraction.

Schum, H. J.↗
NASA NTRS1975

Wind tunnel pressure signatures for a 0.0041-scale model of the space shuttle orbiter

Pressure signatures for a 0.0041-scale model of a space shuttle orbiter were measured in a wind tunnel at Mach numbers from 1.30 to 3.02. The model was tested at 10 deg and 25 deg angle of attack and roll angles were varied from 0 deg to 180 deg in 30 deg increments. Comparisons of sonic boom levels were made for a delta wing configuration and for the space shuttle orbiter which were assumed to have identical lengths and entry trajectories. The sonic boom levels for the orbiter were slightly higher than those for the delta wing orbiter. An example is presented showing that the existing data base for the delta wing orbiter can be used to predict the ground level sonic booms for the orbiter.

Mendoza, J. P.↗
NASA NTRS1975

A Life Study of Ausforged, Standard Forged and Standard Machined AISI M-50 Spur Gears

Tests were conducted at 350 K (170 F) with three groups of 8.9 cm (3.5 in.) pitch diameter spur gears made of vacuum induction melted (VIM) consumable-electrode vacuum-arc melted (VAR), AISI M-50 steel and one group of vacuum-arc remelted (VAR) AISI 9310 steel. The pitting fatigue life of the standard forged and ausforged gears was approximately five times that of the VAR AISI 9310 gears and ten times that of the bending fatigue life of the standard machined VIM-VAR AISI M-50 gears run under identical conditions. There was a slight decrease in the 10-percent life of the ausforged gears from that for the standard forged gears, but the difference is not statistically significant. The standard machined gears failed primarily by gear tooth fracture while the forged and ausforged VIM-VAR AISI M-50 and the VAR AISI 9310 gears failed primarily by surface pitting fatigue. The ausforged gears had a slightly greater tendency to fail by tooth fracture than the standard forged gears.

Townsend, D. P.↗
NASA NTRS1975

Relativistic astrophysics

The coordinate independence of gravitational radiation and the parameterized post-Newtonian approximation from which it is extended are described. The general consistency of the field equations with Bianchi identities, gauge conditions, and the Newtonian limit of the perfect fluid equations of hydrodynamics are studied. A technique of modification is indicated for application to vector-metric or double metric theories, as well as to scalar-tensor theories.

Smalley, L. L.↗
NASA NTRS1975

Results of tests of a Rockwell International space shuttle orbiter (-139 configuration) 0.0175-scale model (no. 29-0) in AEDC tunnel F to determine hypersonic heating effects (OH11)

Results from wind tunnel tests to determine hypersonic aerodynamic heating rates on a NASA/Rockwell Space Shuttle Orbiter are reported. The tests were to determine Mach number effects, if any, and to obtain overall heating rate data at high Mach numbers from 10.5 to 16. The model used was a 0.0175-scale model built to Rockwell Orbiter lines VL70-000139. The model identity number is 29-0. These tests, designated OH11, were conducted in the AEDC Tunnel F.

Quan, M.↗
NASA NTRS1975

Treatment of atomic and molecular line blanketing by opacity sampling

An opacity sampling (OS) technique for treating the radiative opacity of large numbers of atomic and molecular lines in cool stellar atmospheres is presented. Tests were conducted and results show that the structure of atmospheric models is accurately fixed by the use of 1000 frequency points, and 500 frequency points is often adequate. The effects of atomic and molecular lines are separately studied. A test model computed by using the OS method agrees very well with a model having identical atmospheric parameters computed by the giant line (opacity distribution function) method.

Johnson, H. R.↗
NASA NTRS1975

Selected Theoretical Studies Group contributions to the 14th International Cosmic Ray conference

The galactic distribution of H2 was studied through gamma radiation and through X-ray, optical, and infrared absorption measurements from SAS-2 and other sources. A comparison of the latitude distribution of gamma-ray intensity with reddening data shows reddening data to give the best estimate of interstellar gas in the solar vicinity. The distribution of galactic cosmic ray nucleons was determined and appears to be identical to the supernova remnant distribution. Interactions between ultrahigh energy cosmic-ray nuclei and intergalactic photon radiation fields were calculated, using the Monte Carlo method.

Source record↗
NASA NTRS1975

Comparison of pitting fatigue life of ausforged and standard forged AISI M-50 and AISI 9310 spur gears

Standard forged and ausforged spur gears made of vacuum-induction-melted, consumable-electrode, vacuum-arc-remelted AISI M-50 steel were tested under conditions that produced fatigue pitting. The gears were 8.89 cm (3.5 in.) in pitch diameter and had tip relief. The M-50 standard forged and ausforged test results were compared with each other. They were then compared with results for machined vacuum-arc-remelted AISI 9310 gears tested under identical conditions. Both types of M-50 gears had lives approximately five times that of the 9310 gears. The life at which 10 percent of the M-50 ausforged gears failed was slightly less than that at which the M-50 standard forged gears failed. The ausforged gears had a slightly greater tendency to fail by tooth fracture than did the standard forged gears, most likely because of the better forging and grain flow pattern of standard forged gears.

Townsend, D. P.↗
NASA NTRS1975

A vector-dyadic development of the equations of motion for N-coupled flexible bodies and point masses

The equations of motion for a system of coupled flexible bodies, rigid bodies, point masses, and symmetric wheels were derived. The equations were cast into a partitioned matrix form in which certain partitions became nontrivial when the effects of flexibility were treated. The equations are shown to contract to the coupled rigid body equations or expand to the coupled flexible body equations all within the same basic framework. Furthermore, the coefficient matrix always has the computationally desirable property of symmetry. Making use of the derived equations, a comparison was made between the equations which described a flexible body model and those which described a rigid body model of the same elastic appendage attached to an arbitrary coupled body system. From the comparison, equivalence relations were developed which defined how the two modeling approaches described identical dynamic effects.

Frisch, H. P.↗
NASA NTRS1975

Study of the application of hydrogen fuel to long-range subsonic transport aircraft, volume 2

The feasibility, practicability, and potential advantages/disadvantages of using liquid hydrogen as fuel in long range, subsonic transport aircraft of advanced design were studied. Both passenger and cargo-type aircraft were investigated. To provide a valid basis for comparison, conventional hydrocarbon (Jet A) fueled aircraft were designed to perform identical missions using the same advanced technology and meeting the same operational constraints. The liquid hydrogen and Jet A fueled aircraft were compared on the basis of weight, size, energy utilization, cost, noise, emissions, safety, and operational characteristics. A program of technology development was formulated.

Brewer, G. D.↗
NASA NTRS1975

High power ferrite microwave switch

A high power ferrite microwave switch was developed along with associated electronic driver circuits for operation in a spaceborne high power microwave transmitter in geostationary orbit. Three units were built and tested in a space environment to demonstrate conformance to the required performance characteristics. Each unit consisted of an input magic-tee hybrid, two non-reciprocal latching ferrite phase shifters, an out short-slot 3 db quadrature coupler, a dual driver electronic circuit, and input logic interface circuitry. The basic mode of operation of the high power ferrite microwave switch is identical to that of a four-port, differential phase shift, switchable circulator. By appropriately designing the phase shifters and electronic driver circuits to operate in the flux-transfer magnetization mode, power and temperature insensitive operation was achieved. A list of the realized characteristics of the developed units is given.

Bardash, I.↗
NASA NTRS1975

Some long, rate one-half, binary convolutional codes with an optimum distance profile and the systematic versus nonsystematic code question

A tabulation is given of long systematic and long quick-look-in (QLI) nonsystematic rate R = 1/2 binary convolutional codes with an optimum distance profile (ODP). These codes appear attractive for use with sequential decoders. Simulations for two of the new codes are reported and confirm Massey's conjecture that systematic and non-systematic codes of the same rate yield nearly identical computational and error probability performance with sequential decoding when the number of digits transmitted in the tail of the encoded frame is the same for both codes.

Johannesson, R.↗
NASA NTRS1975

The interplanetary acceleration of energetic nucleons

Co-rotating proton and electron streams are the dominant type of low-energy (0.1-10 MeV/nucleon) particle event observed at 1 A.U. The radial dependence of these events was studied between 1 and 4.6 A.U. using essentially identical low-energy detector systems on IMP 7, Pioneer 10 and Pioneer 11. It was expected that at a given energy, the intensity of these streams would decrease rapidly with heliocentric distance due to the effects of interplanetary adiabatic deceleration. Instead it was found that from event to event the intensity either remains roughly constant or increases significantly (more than an order of magnitude) between 1 and 3 A.U. It appears that interplanetary acceleration processes are the most plausible explanation. Several possible acceleration models are explored.

Mcdonald, F. B.↗
NASA NTRS1975

Dynamic substructure analysis of the International Ultraviolet Explorer (IUE) spacecraft

The results are presented of a steady state vibration analysis of the IUE spacecraft simulating its sinusoidal vibration test. The model of the spacecraft, including solar arrays and the scientific instrument, consisted of three separate substructure models one of which was used to represent the two identical solar arrays. Substructuring techniques were used since the large overall size of the problem precluded solving it utilizing a single model. The models used for each substructure are discussed, including reduction to an acceptable size for the combined dynamic analysis. The DMAP alters needed for performing the modal analysis and the subsequent modal frequency response and substructure data recovery are included. Comparison of the results with data obtained during vibration tests of the spacecraft are also included.

Case, W. R.↗
NASA NTRS1975

H-alpha synoptic charts of solar activity during the first year of solar cycle 20, October 1964 - August 1965

Solar activity during the period October 28, 1964 through August 27, 1965 is presented in the form of charts for each solar rotation constructed from observations made with the chromospheric H-alpha spectra line. These H-alpha synoptic charts are identical in format and method of construction to those published for the period of Skylab observations. The sunspot minimum marking the start of Solar Cycle 20 occurred in October, 1964; therefore, charts represent solar activity during the first year of this solar cycle.

Mcintosh, P. S.↗
NASA NTRS1975

A momentum analysis of helicopters and autogyros in inclined descent, with comments on operational restrictions

A momentum theory was developed for rotors in descending flight. Comparison with available experimental data indicates that the theory, when properly interpreted, yields the optimum performance of the rotor. Power settling can be explained on the basis of the theory. The reasons and the need for operational restrictions on descending flight are discussed. The maximum autorotative performance of a rotor is determined; the theory shows good agreement with flight measurements in autorotation. Similar equations were developed for a wing; it was shown that the ideal performance of an autorotating rotor is identical to that of a wing of equal aspect ratio. A limiting maximum wing lift coefficient which is confirmed by existing experimental data was obtained.

Heyson, H. H.↗