SEARCH · Engineering Papers

Results for “ROTORS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37

All sources NASA NTRS DOE OSTI

NASA NTRS1987

Main rotor broadband noise study in the DNW

An acoustics test of a 2/5 scale model BO-105 helicopter main rotor was conducted in the Duits-Nederlandse Windtunnel (DNW). A range of operating conditions was tested from hover to moderately high flight speeds for various climb and descent rates at different thrust settings. Diagnostic tests including rotor speed and blade geometry changes were made to better isolate and study particular broadband self noise sources. Acoustic data in the form of acoustic pressure time histories and power spectra are used to demonstrate the regions of importance of the different broadband noise sources and their sensitivity to operating conditions. To help interpret the data, comparisons are made to predictions of rotor broadband noise. The predictions are based on self noise data previously obtained from isolated airfoil sections and the use of the NASA ROTONET program to define rotor performance and to sum contributions of noise from individual blade segments. An important result herein is the identification and articulation of a previously unheralded rotor broadband noise source. This source is blade-turbulent wake interaction (BWI) noise which dominates the spectra in the mid-frequencies for off-peak blade-vortex interaction (BVI) noise flight conditions.

Brooks, Thomas F.↗

NASA NTRS1987

The hub wall boundary layer development and losses in an axial flow compressor rotor passage

The hub wall boundary layer development in a compressor stage including the rotor passage is experimentally investigated. A miniature five-hole probe was employed to measure the hub wall boundary layer inside the inlet guide vane passage, upstream and far downstream of the rotor. The hub wall boundary layer inside the rotor passage was acquired using a rotating miniature five-hole probe. The boundary layer is well behaved upstream and far downstream of the rotor. The migration of the hub wall boundary layer towards the suction surface corner is observed. The limiting streamline angles and static pressure distribution across the stage were also measured. The mean velocity profiles and the integral properties upstream, inside and downstream of the rotor, and the losses are presented and interpreted.

Murthy, K. N. S.↗

NASA NTRS1985

In-flight measurement of rotor hub drag using the RSRA - A feasibility demonstration

The Rotor Systems Research Aircraft (RSRA) is a compound helicopter that was test flown as a fixed-wing aircraft, with the main rotor blades removed and the rotor hub installed. An onboard rotor load-measurement system measured the resulting rotor hub drag and lift. Measured hub drag and lift are plotted for comparison to that predicted by full-scale and 1/6-scale model wind-tunnel tests. The success of the demonstration gives confidence that planned improvements to the RSRA will allow high-accuracy hub drag and lift measurements to be made in flight on a routine research basis.

Acree, C. W., Jr.↗

NASA NTRS1984

A 0.15-scale study of configuration effects on the aerodynamic interaction between main rotor and fuselage

Hover and forward flight tests were conducted to investigate the mutual aerodynamic interaction between the main motor and fuselage of a conventional helicopter configuration. A 0.15-scale Model 222 two-bladed teetering rotor was combined with a 0.15-scale model of the NASA Ames 40x80-foot wind tunnel 1500 horsepower test stand fairing. Configuration effects were studied by modifying the fairing to simulate a typical helicopter forebody. Separation distance between rotor and body were also investigated. Rotor and fuselage force and moment as well as pressure data are presented in graphical and tabular format. Data was taken over a range of thrust coefficients from 0.002 to 0.007. In forward flight speed ratio was varied from 0.1 to 0.3 with shaft angle varying from +4 to -12 deg. The data show that the rotors effect on the fuselage may be considerably more important to total aircraft performance than the effect of the fuselage on the rotor.

Trept, Ted↗

NASA NTRS1987

Results of the 1986 NASA/FAA/DFVLR main rotor test entry in the German-Dutch wind tunnel (DNW)

An acoustics test of a 40%-scale MBB BO-105 helicopter main rotor was conducted in the Deutsch-Niederlandischer Windkanal (DNW). The research, directed by NASA Langley Research Center, concentrated on the generation and radiation of broadband noise and impulsive blade-vortex interaction (BVI) noise over ranges of pertinent rotor operational envelopes. Both the broadband and BVI experimental phases are reviewed, along with highlights of major technical results. For the broadband portion, significant advancement is the demonstration of the accuracy of prediction methods being developed for broadband self noise, due to boundary layer turbulence. Another key result is the discovery of rotor blade-wake interaction (BWI) as an important contributor to mid frequency noise. Also the DNW data are used to determine for full scale helicopters the relative importance of the different discrete and broadband noise sources. For the BVI test portion, a comprehensive data base documents the BVI impulsive noise character and directionality as functions of rotor flight conditions. The directional mapping of BVI noise emitted from the advancing side as well as the retreating side of the rotor constitutes a major advancement in the understanding of this dominant discrete mechanism.

Brooks, Thomas F.↗

NASA NTRS1988

Euler solution of multiblade rotor flow

A numerical method for solving the Euler equations for multiblade rotors has been developed and some preliminary results reported. The numerical scheme is a combination of several recent methods and algorithm improvements, adapted to the particular requirements of rotor-body interactions. A cylindrical basic grid has been used to study conventional multiblade helicopter rotors. Test calculations have been made for two- and six-blade rotors in hover and for a two-blade rotor in forward flight, under transonic tip conditions but without lift. The results show good agreement with experimental data.

Chen, C. L.↗

NASA NTRS1986

An experimental investigation of the flap-lag-torsion aeroelastic stability of a small-scale hingeless helicopter rotor in hover

A small scale, 1.92 m diam, torsionally soft, hingeless helicopter rotor was investigated in hover to determine isolated rotor stability characteristics. The two-bladed, untwisted rotor was tested on a rigid test stand at tip speeds up to 101 m/sec. The rotor mode of interest is the lightly damped lead-lag mode. The dimensionless lead-lag frequency of the mode is approximately 1.5 at the highest tip speed. The hub was designed to allow variation in precone, blade droop, pitch control stiffness, and blade pitch angle. Measurements of modal frequency and damping were obtained for several combinations of these hub parameters at several values of rotor speed. Steady blade bending moments were also measured. The lead-lag damping measurements were found to agree well with theoretical predictions for low values of blade pitch angle. The test data confirmed the predicted effects of precone, droop, and pitch control stiffness parameters on lead-lag damping. The correlation between theory and experiment was found to be poor for the mid-to-high range of pitch angles where the theory substantially overpredicted the experimental lead-lag damping. The poor correlation in the mid-to-high blade pitch angle range is attributed to low Reynolds number nonlinear aerodynamics effects not included in the theory. The experimental results also revealed an asymmetry in lead-lag damping between positive and negative thrust conditions.

Sharpe, David L.↗

NASA NTRS1988

Improvements to tilt rotor performance through passive blade twist control

A passive blade twist control is presented in which the twist distribution of a tilt rotor blade is elastically changed as a function of rotor speed. The elastic twist deformation is used to achieve two different blade twist distributions corresponding to the two rotor speeds used on conventional tilt rotors in hover and forward flight. By changing the blade twist distribution, the aerodynamic performance can be improved in both modes of flight. The concept presented obtains a change in twist distribution with extension-twist-coupled composite blade structure. This investigation first determines the linear twists which are optimum for each flight mode. Based on the optimum linear twist distributions, three extension-twist-coupled blade designs are developed using coupled-beam and laminate analyses integrated with an optimization analysis. The designs are optimized for maximum twist deformation subject to material strength limitations. The aerodynamic performances of the final designs are determined which show that the passive blade twist control concept is viable, and can enhance conventional tilt rotor performance.

Nixon, Mark W.↗

NASA NTRS1988

Advancing-side directivity and retreating-side interactions of model rotor blade-vortex interaction noise

Acoustic data are presented from a 40 percent scale model of the four-bladed BO-105 helicopter main rotor, tested in a large aerodynamic wind tunnel. Rotor blade-vortex interaction (BVI) noise data in the low-speed flight range were acquired using a traversing in-flow microphone array. Acoustic results presented are used to assess the acoustic far field of BVI noise, to map the directivity and temporal characteristics of BVI impulsive noise, and to show the existence of retreating-side BVI signals. The characterics of the acoustic radiation patterns, which can often be strongly focused, are found to be very dependent on rotor operating condition. The acoustic signals exhibit multiple blade-vortex interactions per blade with broad impulsive content at lower speeds, while at higher speeds, they exhibit fewer interactions per blade, with much sharper, higher amplitude acoustic signals. Moderate-amplitude BVI acoustic signals measured under the aft retreating quadrant of the rotor are shown to originate from the retreating side of the rotor.

Martin, R. M.↗

NASA NTRS1988

Vibration and Control of Flexible Rotor Supported by Magnetic Bearings

Active vibration control of flexible rotors supported by magnetic bearings is discussed. Using a finite-element method for a mathematical model of the flexible rotor, the eigenvalue problem is formulated taking into account the interaction between a mechanical system of the flexible rotor and an electrical system of the magnetic bearings and the controller. However, for the sake of simplicity, gyroscopic effects are disregarded. It is possible to adapt this formulation to a general flexible rotor-magnetic bearing system. Controllability with and without collocation sensors and actuators located at the same distance along the rotor axis is discussed for the higher order flexible modes of the test rig. In conclusion, it is proposed that it is necessary to add new active control loops for the higher flexible modes even in the case of collocation. Then it is possible to stabilize for the case of uncollocation by means of this method.

Nonami, Kenzou↗

NASA NTRS1988

Helicopter main-rotor noise: Determination of source contributions using scaled model data

Acoustic data from a test of a 40 percent model MBB BO-105 helicopter main rotor are scaled to equivalent full-scale flyover cases. The test was conducted in the anechoic open test section of the German-Dutch Windtunnel (DNW). The measured data are in the form of acoustic pressure time histories and spectra from two out-of-flow microphones underneath and foward of the model. These are scaled to correspond to measurements made at locations 150 m below the flight path of a full-scale rotor. For the scaled data, a detailed analysis is given for the identification in the data of the noise contributions from different rotor noise sources. Key results include a component breakdown of the noise contributions, in terms of noise criteria calculations of a weighted sound pressure level (dBA) and perceived noise level (PNL), as functions of rotor advance ratio and descent angle. It is shown for the scaled rotor that, during descent, impulsive blade-vortex interaction (BVI) noise is the dominant contributor to the noise. In level flight and mild climb, broadband blade-turbulent wake interaction (BWI) noise is dominant due to the absence of BVI activity. At high climb angles, BWI is reduced and self-noise from blade boundary-layer turbulence becomes the most prominent.

Brooks, Thomas F.↗

NASA NTRS1988

The importance of steady and dynamic inflow on the stability of rotor-body systems

The induced flow field of a rotor responds in a dynamic fashion to oscillations in rotor lift. This was long known to affect the stability and control derivatives of the rotor. More recently, however, it was also shown that this dynamic inflow also affects rotor and rotor-body aeroelastic stability. Thus, both the steady and unsteady inflow have pronounced effects on air resonance. Recent theoretical developments were made in the modeling of dynamic inflow, and these were verified experimentally. Thus, there is now a simple, verified dynamic inflow model for use in dynamic analyses.

Peters, David A.↗

NASA NTRS1988

Effect of advanced rotorcraft airfoil sections on the hover performance of a small-scale rotor model

A hover test was conducted on a small scale rotor model for two sets of tapered rotor blades. The baseline rotor blade set used a NACA 0012 airfoil section, whereas the second rotor blade set had advanced rotorcraft airfoils distributed along the radius. The experiment was conducted for a range of thrust coefficients and tip speeds, and the data were compared to the predictions of three analytical methods. The data show the advantage of the advanced airfoils at the higher rotor thrust levels; two of the analyses predicted the correct data trends.

Althoff, Susan L.↗

NASA NTRS1989

The acoustics of a small-scale helicopter rotor in hover

A 2.1 m diameter, 1/6-scale model helicopter main rotor was tested in hover in the test section of the NASA Ames 40- by 80-foot wind tunnel. Performance and noise data on a small-scale rotor at various thrust coefficients and tip Mach numbers were obtained for comparison with existing data on similar full-scale helicopter rotors. These data form part of a data base to permit the estimation of scaling effects on various rotor noise mechanisms. Another objective was to contribute to a data base that will permit the estimation of facility effects on acoustic testing. Acoustic 1/3-octave-band spectra are presented, together with variations of overall acoustic levels with rotor performance, microphone distance, and directivity angle.

Kitaplioglu, Cahit↗

NASA NTRS1988

Comparisons of predicted and measured rotor performance in hover using a new free wake analysis

A new free-wake analysis has been developed to predict the performance of rotors in hover and axial flight. The analysis finds the rotor wake geometry using a novel influence coefficient/relaxation scheme. In this paper, the features of the analysis are reviewed, and the accuracy of the analysis is assessed for a wide range of rotor configurations in hover and vertical climb. The effects of variations in the analysis parameters are addressed, and recommendations for future development are presented. Generally good results were obtained for the predicted performance of a wide range of rotor geometries and operating conditions without any special 'tuning' of the analysis. The analysis also provides predictions of rotor performance in vertical climb that are substantially more accurate than momentum theory.

Felker, Fort F.↗

NASA NTRS1988

Euler solution of multiblade rotor flow

Chen, C. L.↗

NASA NTRS1989

Improved rotor response of the uprated high pressure oxygen turbopump for the Space Shuttle Main Engine

A means of eliminating the subsynchronous rotor whirl encountered during the development testing of the high-pressure oxygen turbopump of the Space Shuttle Main Engine is proposed. The rotor response is improved by reducing the pump end bearing loads and adding damping between the rotor and housing. In the present method, the impeller annular seals are converted into damping seals and the second rotor critical speed is increased due to the added stiffness of the seal conversion and the stiffening of the rotor shaft.

Beatty, R. F.↗

NASA NTRS1988

Experimental studies in system identification of helicopter rotor dynamics

Recent experiments investigating the system identification of helicopter rotor dynamics are described. The identification makes use of a two-pass procedure that estimates the rotor dynamic states prior to estimation of the dynamic equation parameters. Estimation of the rotor states is made possible through use of the predictive information contained in blade-mounted accelerometers combined with a specialized processing scheme utilizing these signals. Descriptions of the experimental hardware and the system identification technique are given, as well as implementation issues for using the procedure on other similarly instrumented rotor blades. Finally, comparisons with other identification techniques using the same data are presented. It is demonstrated that the approach is an attractive one for measurement of a helicopter rotor's dynamic behavior.

Mckillip, Robert, Jr.↗