SEARCH · Engineering Papers

Results for “PENETRATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37

All sources NASA NTRS DOE OSTI

NASA NTRS1976

Corrosion of oxygen-doped tantalum by lithium

The increase in the penetration of tantalum by liquid lithium with increasing oxygen content of tantalum results from the ability of lithium to extract oxygen from tantalum oxides and/or from regions of high oxygen concentrations, accompanied by the creation of minute channels. At low oxygen concentration, oxides are present primarily at the grain boundaries and the lithium penetration is primarily intergranular. At high oxygen concentration, oxides and/or regions of high oxygen concentration are present both at the grain boundaries and within the grains; lithium penetration is both intergranular and transgranular. For a specific oxygen concentration, the severity of corrosion decreases with increasing temperature because (1) the oxygen solubility increases with temperature, decreasing the number of oxide particles and/or regions of high oxygen concentration, and (2) the diffusivity of oxygen in tantalum increases, allowing more rapid oxygen removal at the tantalum lithium interface.

Stecura, S.↗

NASA NTRS1978

Remote sensing of optical properties in continuously stratified waters

The radiative transfer equation is solved by Monte Carlo methods for natural waters in which the optical properties are distributed with depth. It is demonstrated that interpreting the reflectance of a continuously stratified ocean in terms of an equivalent homogeneous ocean yields the average of a particular combination of the water's optical properties over the dimensionless penetration depth. Although in general the dimensionless penetration depth cannot be remotely measured, a method is presented for estimating the actual penetration depth from the remote observations if the medium's absorption coefficient is known, independent of depth, and sufficiently large. The application of this to the remote measurement of the vertical distribution of suspended sediments is discussed in detail.

Gordon, H. R.↗

NASA NTRS1980

Verifying root fusion in electron-beam welds

Ultrasonic equipment and x-y recorder indicate where back side of joint is properly welded. Wire waveguide placed in groove at root of joint to be welded is fused when joint is adequately penetrated. Ultransonic signal moving down waveguide is reflected where guide is melted. Change in reflected-signal arrival time with change in weld-head position is nearly constant unless joint is incompletely penetrated. Method permits determination of penetration depth in preweld samples without opening vacuum chamber and sectioning weld. Technique is particularly valuable when back side of joint is inaccessible.

Becker, F. L.↗

NASA NTRS1980

Analytical and experimental spur gear tooth temperature as affected by operating variables

A gear tooth temperature analysis was performed using a finite element method combined with a calculated heat input, calculated oil jet impingement depth, and estimated heat transfer coefficients. Experimental measurements of gear tooth average surface temperatures and instanteous surface temperatures were made with a fast response infrared radiometric microscope. Increased oil jet pressure had a significant effect on both average and peak surface temperatures at both high load and speeds. Increasing the speed at constant load and increasing the load at constant speed causes a significant rise in average and peak surface temperatures of gear teeth. The oil jet pressure required for adequate cooling at high speed and load conditions must be high enough to get full depth penetration of the teeth. Calculated and experimental results were in good agreement with high oil jet penetration but showed poor agreement with low oil jet penetration depth.

Townsend, D. P.↗

NASA NTRS1980

Impact of Saturn ring particles on Pioneer 11

The detection of particles near the rings of Saturn by the meteoroid detection instrument on board Pioneer 11 is discussed. The instrument consists of 234 penetration detectors, distributed between two independent data channels each of which is designed to become inhibited for a period of 77 min after the registration of a penetration event in that channel. At least four particles penetrated the detectors in the 4.5 h period around Saturn periapsis at radial distances between 1.36 and 3.1 Saturn radii, a radial distribution inconsistent with the gravitational focusing of meteoroids. The detection of particles which may have been part of the E ring before the crossing of the ring plane suggests that this ring may be 1800 km thick, with an optical thickness greater than 10 to the -8th.

Humes, D. H.↗

NASA NTRS1980

Analytical and experimental spur gear tooth temperature as affected by operating variables

A gear tooth temperature analysis was performed using a finite element method combined with a calculated heat input, calculated oil jet impingement depth, and estimated heat transfer coefficients. Experimental measurements of gear tooth average surface temperatures and instantaneous surface temperatures were made with a fast response infrared radiometric microscope. Increased oil jet pressure had a significant effect on both average and peak surface temperatures at both high load and speeds. Increasing the speed at constant load and increasing the load at constant speed causes a significant rise in average and peak surface temperatures of gear teeth. The oil jet pressure required for adequate cooling at high speed and load conditions must be high enough to get full depth penetration of the teeth. Calculated and experimental results were in good agreement with high oil jet penetration but showed poor agreement with low oil jet penetration depth.

Townsend, D. P.↗

NASA NTRS1981

The effect of zirconium on the cyclic oxidation of NiCrAl alloys

This paper examines results with cyclic oxidation tests of Ni(9-20) Cr(15-30) Al-(x)Zr alloys carried out at 1100 C and 1200 C in static air. The concentration of zirconium varies from 0 to 0.63 atomic percent. Significant aluminum penetration is found in metallographic and electron microscopic examination of oxidized surfaces. Small amounts of zirconium lead to minimal penetration, and with increased zirconium content pronounced oxide penetration is observed.

Barrett, C. A.↗

NASA NTRS1980

Evidence for ice meteoroids beyond 2 AU

Processes controlling the population of particles of mass greater than 2 x 10 to the -9th g as observed by the Pioneer 10 meteoroid penetration data between 2 and 5 AU are discussed as evidence for the presence of ice meteoroids. Consideration is given to particle collisional lifetimes, Poynting-Robertson drag and the influence of Jupiter in controlling particle orbits, and it is noted that none of these mechanisms may be capable of accounting for the observed constant, or possibly increasing, particle density between 2 and 5 AU. It is shown, however, that ice particles with radii of about 15 microns and varying amounts of impurities could account for the observed distribution with thermal sublimation or solar wind sputtering possible mechanisms of particle destruction. It is concluded that meteoroids made of ice are probably responsible for most of the penetrations of the Pioneer 10 meteoroid penetration sensor beyond 2 AU.

Zook, H.↗

NASA NTRS1980

Dielectric discharge characteristics in a two-electron simulation environment

The results of a series of experiments in which flux levels representative of the space electron environment were used are presented and compared to the results of high flux tests. The simulation approach was to partition the space electron spectrum into two parts, those electrons which do not penetrate a material and therefore contribute to charging and those which completely penetrate the material. The nonpenetrating electrons were simulated using 25 keV electrons and the penetrating electrons by 350 keV electrons. The materials included in this investigation were Kapton, optical solar reflectors (OSRs), and a ground test satellite surface potential monitor which contained Kapton, astroquart, OSRs and teflon.

Treadaway, M.↗

NASA NTRS1981

Effect of wind turbine generator model and siting on wind power changes out of large WECS arrays

Methods of reducing the WECS generation change through selection of the wind turbine model for each site, selection of an appropriate siting configuration, and wind array controls are discussed. An analysis of wind generation change from an echelon and a farm for passage of a thunderstorm is presented. Reduction of the wind generation change over ten minutes is shown to reduce the increase in spinning reserve, unloadable generation and load following requirements on unit commitment when significant WECS generation is present and the farm penetration constraint is satisfied. Controls on the blade pitch angle of all wind turbines in an array or a battery control are shown to reduce both the wind generation change out of an array and the effective farm penetration in anticipation of a storm so that the farm penetration constraint may be satisfied.

Schleuter, R. A.↗

NASA NTRS1982

The magnetopause as sensed by energetic particles, magnetic field, and plasma measurements on November 20, 1977

The position of the trapping boundary for ions not less than 24 keV in the vicinity of the magnetopause was determined using energetic particle three-dimensional distributions observed by ISEE 1 and 2. For a short period of time on November 20, 1977, definite periods were observed when the subsolar magnetopause current and magnetosheath plasma penetration layers were not overlapping the trapping region for energetic particles whose outer edge is the trapping boundary. The trapping boundary was found to be in rapid continual motion, representing a sharp, well-defined boundary, and the penetration of the magnetosheath plasma inside this boundary can be limited to a distance comparable to the plasma ion gyroradius of not greater than about 100 km, although plasma penetration was seen up to 200 km earthward of the trapping boundary.

Fritz, T. A.↗

NASA NTRS1982

Satellite infrared imagery, rawinsonde data, and gravity wave remote sensing of severe convective storms

GOES digital infrared data during the time period between two hours before the touchdown of tornado and the tornado touchdown time were used in this study. Comparison between tornado-associated clouds and non-tornado-associated clouds indicates that the difference between overshooting cloud top temperature and the tropopause temperature, or how much the cloud has penetrated above the tropopause, rather than either the absolute temperature of penetrative cloud top or the height of the top of overshooting turret is significant for the possible formation of severe storms. The penetrative overshooting cloud top collapses about 15 to 30 minutes before the touchdown of tornado. Gravity waves were detected from the severe convective storms.

Hung, R. J.↗

NASA NTRS1983

Design and fabrication of realistic adhesively bonded joints

Eighteen bonded joint test specimens representing three different designs of a composite wing chordwise bonded splice were designed and fabricated using current aircraft industry practices. Three types of joints (full wing laminate penetration, two side stepped; midthickness penetration, one side stepped; and partial penetration, scarfed) were analyzed using state of the art elastic joint analysis modified for plastic behavior of the adhesive. The static tensile fail load at room temperature was predicted to be: (1) 1026 kN/m (5860 1b/in) for the two side stepped joint; (2) 925 kN/m (5287 1b/in) for the one side stepped joint; and (3) 1330 kN/m (7600 1b/in) for the scarfed joint. All joints were designed to fail in the adhesive.

Shyprykevich, P.↗

NASA NTRS1983

Space Shuttle ice suppression system validation, volume 3

The influence of nozzle size without wind, on wind penetration, the influence of nozzle pressure on wind penetration, wind velocity effects, nozzle pressure effects, nominal velocity, wind velocity effects on wind penetration, and nozzle azimuth angle effects are plotted.

Porteiro, J. L. F.↗

NASA NTRS1984

A review of micrometeoroid flux measurements and models for low orbital altitudes of the Space Station

A review of meteoroid flux measurements and models for low orbital altitudes of the Space Station has been made in order to provide information that may be useful in design studies and laboratory hypervelocity impact tests which simulate micrometeoroids in space for design of the main wall of the Space Station. This report deals with the meteoroid flux mass model, the defocusing and shielding factors that affect the model, the probability of meteoroid penetration of the main wall of a Space Station. Whipple (1947) suggested a meteoroid bumper, a thin shield around the spacecraft at some distance from the wall, as an effective device for reducing penetration, which has been discussed in this report. The equations of the probability of meteoroid penetration, the average annual cumulative total flux, and the equations for the thickness of the main wall and the bumper are presented in this report.

Susko, M.↗

NASA NTRS1985

Preliminary study of gaseous nitrogen-liquid oxygen mixing and self cleaning

The penetration of gaseous nitrogen into liquid oxygen at a pressure of 150 psi was determined by monitoring the composition of the evaporating liquid in a nitrogen analyzer. For pressurization times of about 1 hr the penetration depth varies between 0.0024 and 0.018 in. at an evaporation rate of about 1 gal/day. These are small compared to the penetration depth of 22.2 in. measured in the 7-inch high temperature tunnel at a pressure of 1500 psi, pressurization time of 5 min, and evaporation rate of 121 gal/day.

Zuckerwar, A. J.↗

NASA NTRS1986

Hubble Space Telescope meteoroid-debris protection analysis

A system level failure could occur if the Hubble Space Telescope's (ST) capability to operate as a facility on-orbit is critically reduced or when a significant reduction in the quality of science data is registered. Failure could occur if a meteoroid/debris impact damages a component of a major support subsystem or if a meteoroid/debris penetration causes straylight contamination in the light shield, forward shell, aft shroud, or through the aperture door. The ST was analyzed to find the probability of no critical penetration. This probability value was found to be 92.25% for a two-year service life. A straylight leakage repair technique was recommended for the aft shroud, the region found most likely to be critically penetrated. Fozar tape and multilayer insulation blankets are suggested as posible repair materials.

Horn, J.↗

NASA NTRS1985

Erosion of aluminum 6061-T6 under cavitation attack in mineral oil and water

Studies of the erosion of aluminum 6061-T6 under cavitation attack in distilled water, ordinary tap water and a viscous mineral oil are presented. The mean depth of penetration for the mineral oil was about 40 percent of that for water at the end of a 40 min test. The mean depth of penetration and its rate did not differ significantly for distilled and tap water. The mean depth of penetration rate for both distilled and tap water increased to a maximum and then decreased with test duration, while that for mineral oil had a maximum during the initial period. The ratio h/2a of the pit depth h to the pit diameter 2a varied from 0.04 to 0.13 in water and from 0.06 to 0.20 in mineral oil. Scanning electron microscopy indicates that the pits are initially formed over the grain boundaries and precipitates while the surface grains are deformed under cavitation attack.

Rao, B. C. S.↗