Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Locking”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37

Turbulent burst control through phase-locked traveling surface depressions

The influence of a traveling, surface depression on turbulent pre-burst flow has been investigated both theoretically and experimentally. Two-dimensional calculations of a transverse vortex (representing a 'typical' eddy) embedded in a laminar boundary layer show that properly phased-wall motion can reduce vorticity and raise wall pressure beneath the convecting vortex. Experiments in low-speed air with an electromagnetically driven wall membrane show that a traveling wall depression can accelerate flow near the wall and reduce pre-burst Reynolds stress.

Wilkinson, S. P.↗

Acquisition times of carrier tracking sampled data phase-locked loops

Phase acquisition times of type II and III loops typical of the Advanced Receiver are studied by computer simulations when the loops are disturbed by gaussian noise. Reliable estimates are obtained by running 5000 trials for each combination of loop signal-to-noise ratio (SNR) and frequency offset. The probabilities of acquisition are shown versus time from start of acquisition for various loop SNRs and frequency offsets. For frequency offsets smaller than one-fourth of the loop bandwidth and for loop SNRs of 10 dB and higher, the loops acquire with probability 0.99 within 2.5 B sub L for type II loops and within 7/B sub L for type III loops.

Aguirre, S.↗

Direct analysis of gain-guided phase-locked semiconductor laser arrays

A method for analyzing arbitrary one-dimensional waveguides is described and applied to find the lateral modes of gain-guided laser arrays directly, without the need for a coupled-mode approximation. Detailed results are given for a four-element array for which experimental results are available, and the effect of varying device parameters on the relative gains of the modes is considered. The results show differences between gain-guided and real-index guided arrays which are not evident in prior analyses.

Marshall, W. K.↗

Double-Referenced, Pulsed, Phase-Locked Loop - DRP2L2

System allows precise measurement of phase shift between two toneburst signals initially derived from same periodic source but delayed by different amounts through either path-length differences, propagation velocity differences, or both. Used to measure accurately phase shift encountered by acoustic wave striking front and back surfaces of sample. Velocity known, resulting measurement is of sample thickness. Thickness known, measurement is of sound velocity. Technique applies to many sources of radiation and not limited to acoustics.

Heyman, J. S.↗

Injection Phase-Locked Laser-Diode Array

Phase-coherent emission with negligible far-field supermodes produced by proposed surface-emitting laser-diode array stimulated by holographically directed emission from single master diode. To achieve same coherence and output power, single laser diode requires high power density, which substantially reduces working lifetime. Proposed integrated optical array useful in communications

Lesh, James R.↗

Investigation of PTFE transfer films by infrared emission spectroscopy and phase-locked ellipsometry

When a PTFE sheet was rubbed unidirectionally over a smooth surface of stainless steel an essentially monomolecular transfer film was formed. By ellipsometric and emission infrared spectroscopic techniques it was shown that the film was 10 to 15 A thick and birefringent. From the intensity differences of infrared bands obtained with a polarizer passing radiation polarized in mutually perpendicular planes, it was possible to deduce transfer film orientation with the direction of rubbing. After standing in air for several weeks the transfer films apparently increased in thickness by as much as threefold. At the same time both the index of refraction and the absorption index decreased. Examination of the surfaces by optical and electron microscopies showed that the films had become porous and flaky. These observations were consistent with previous tribological measurements. The coefficients of friction decreased with the formation of the transfer film but increased again as the film developed breaks. The applicability of the ellipsometric and polarized infrared emission techniques to the identification of monomolecular tribological transfer films of polymers such as PTFE has been demonstrated.

Lauer, James L.↗

Dynamic characteristics of far-field radiation of current modulated phase-locked diode laser arrays

A versatile and powerful streak camera/frame grabber system for studying the evolution of the near and far field radiation patterns of diode lasers was assembled and tested. Software needed to analyze and display the data acquired with the steak camera/frame grabber system was written and the total package used to record and perform preliminary analyses on the behavior of two types of laser, a ten emitter gain guided array and a flared waveguide Y-coupled array. Examples of the information which can be gathered with this system are presented.

Elliott, R. A.↗

Diffraction-Coupled, Phase-Locked Semiconductor Laser Array

Stable, narrow far field produced. Array of lasers fabricated on single chip. Individual laser waveguides isolated from each other except in end portions, where diffraction coupling takes place. Radiation pattern far from laser array has single, sharp central lobe when all lasers operate in phase with each other. Shape of lobe does not vary appreciably with array current. Applications include recording, printing, and range finding.

Katz, Joseph↗

Phase-Locked Semiconductor Lasers With Separate Contacts

Individual current feeds enable better uniformity and flexible control. Separate contacts for lasers in array enable control of output radiation pattern and compensation of manufacturing nonuniformities among lasers. Concept of separate current control described for two-laser array in "Semiconductor Laser Phased Array" (NPO-15963).

Katz, Joseph↗

Phase-Length Optical Phase-Locked-Loop Sensor (PLOPS)

PLOPS system designed to provide high-resolution measurement of change in optical length from optical-system source to any optical reflector, including diffuse reflector. Serves as adjustable optical ruler, providing high resolution in measurements of small and large changes in distance to target. Use is broad and includes most measurement situations requiring information on length, vibration, and their derivatives. Applications include building dynamics, remote sensing of vibrations in such systems as turbine-based machinery, monitoring of structural dynamics, noncontacting sensing of surface contours, measurement of large strains as in earthquake monitoring, measurement of atmospheric dynamics and turbulence, high-resolution sensing of humidity, detection of surface acoustic waves by optical microscopy, and related areas.

Heyman, Joseph S.↗

Investigation of PTFE transfer films by infrared emission spectroscopy and phase-locked ellipsometry

When a PTFE sheet was rubbed unidirectionally over a smooth surface of stainless steel an essentially monomolecular transfer film was formed. by ellipsometric and emission infrared spectroscopic techniques it was shown that the film was 10 to 15 A thick and birefringent. From the intensity differences of infrared bands obtained with a polarizer passing radiation polarized in mutually perpendicular planes, it was possible to deduce transfer film orientation with the direction of rubbing. After standing in air for several weeks the transfer films apparently increased in thickness by as much as threefold. At the same time both the index of refraction and the absorption index decreased. Examination of the surfaces by optical and electron microscopies showed that the films had become porous and flaky. These observations were consistent with previous tribological measurements. The coefficients of friction decreased with the formation of the transfer film but increased again as the film developed breaks. The applicability of the ellipsometric and polarized infrared emission techniques to the identification of monomolecular tribological transfer films of polymers such as PTFE has been demonstrated.

Lauer, James L.↗

SUNLITE program. Sub-Hertz relative frequency stabilization of two diode laser pumped Nd:YAG lasers locked to a Fabry-Perot interferometer

Two laser pumped Nd:YAG lasers were frequency stabilized to a commercial 6.327 GHz free spectral range Fabry-Perot interferometer yielding a best case beatnote linewidth of 330 MHz. In addition, a Fabry-Perot interferometer with a free spectral range of 680 MHz, a linewidth of 25 kHz, and a finesse of 27,500 was built, and when it was substituted in place of the commercial interferometer, it produced a robust and easily repeatable beatnote linewidth of 700 MHz.

Byer, R. L.↗

Optical Phase-Locked Loop For Optical Communication

Experimental apparatus includes two diode-pumped solid-state lasers of non-planar-ring-oscillator type, one represents the transmitting oscillator, other local oscillator in receiver. Output of transmitting oscillator is amplitude-modulated with pulse-position-modulated data stream. Phase-error variance of less than 0.05 mrad(Sup 2) achieved with relatively-narrow-band loop. Applications include free-space and fiber-optic communications, navigation, and scientific instrumentation in which receivers are required to track phases of transmitted signals.

Win, Moe Z.↗

Sub-hertz relative frequency stabilization of two-diode laser-pumped Nd:YAG lasers locked to a Fabry-Perot interferometer

Two-diode laser-pumped Nd:YAG lasers have been frequency stabilized to a commercial 6.327-GHz free spectral range Fabry-Perot interferometer yielding a best-case beatnote linewidth of 330 mHz. In addition, a Fabry-Perot interferometer with a free spectral range of 680 MHz, a linewidth of 25 kHz, and a finesse of 27,500 has been built, and when substituted in place of the commercial interferometer produced a robust and easily repeatable beatnote linewidth of 700 MHz.

Day, Timothy↗

Constant frequency pulsed phase-locked loop measuring device

A measuring apparatus is presented that uses a fixed frequency oscillator to measure small changes in the phase velocity ultrasonic sound when a sample is exposed to environmental changes such as changes in pressure, temperature, etc. The invention automatically balances electrical phase shifts against the acoustical phase shifts in order to obtain an accurate measurement of electrical phase shifts.

Yost, William T.↗

Optical phase-locked loop (OPLL) for free-space laser communications with heterodyne detection

Several advantages of coherent free-space optical communications are outlined. Theoretical analysis is formulated for an OPLL disturbed by shot noise, modulation noise, and frequency noise consisting of a white component, a 1/f component, and a 1/f-squared component. Each of the noise components is characterized by its associated power spectral density. It is shown that the effect of modulation depends only on the ratio of loop bandwidth and data rate, and is negligible for an OPLL with loop bandwidth smaller than one fourth the data rate. Total phase error variance as a function of loop bandwidth is displayed for several values of carrier signal to noise ratio. Optimal loop bandwidth is also calculated as a function of carrier signal to noise ratio. An OPLL experiment is performed, where it is shown that the measured phase error variance closely matches the theoretical predictions.

Win, Moe Z.↗

A simple low loss technique for frequency locking lasers

We report the results of a novel method for frequency stabilizing laser diodes based on the resonant Faraday effects. A Faraday cell with crossed Brewster windows comprises the intracavity frequency selective element. In this arrangement a laser pull-in range of 4A was measured and the laser operated at a single frequency with a linewidth less than 6 Mhz.

Valdez, E. C.↗

Lock-up failure of a four-bar linkage deployment mechanism

A successful failure investigation of a four-bar linkage deployment mechanism has been performed. Possible failure causes such as the mismatch of material coefficient of thermal expansion (CTE), excessive hinge friction, limit switch interference, and thermal gradient induced resistive preload were investigated and are discussed. The final conclusions and corrective actions taken are described. Finally, valuable lessons learned during the investigation are discussed.

Zinn, Michael↗