Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Deltas”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Delta wing flutter based on doublet lattice method in NASTRAN

The subsonic doublet-lattice method (DLM) aeroelastic analysis in NASTRAN was successfully applied to produce subsonic flutter boundary data in parameter space for a large delta wing configuration. Computed flow velocity and flutter frequency values as functions of air density ratio, flow Mach number, and reduced frequency are tabulated. The relevance and the meaning of the calculated results are discussed. Several input-deck problems encountered and overcome are cited with the hope that they may be helpful to NASTRAN Rigid Format 45 users.

Jew, H.↗
NASA NTRS1975

A study of interstellar lines in the rocket spectrum of delta Scorpii

Ten interstellar lines in the vacuum UV spectrum of delta Sco are analyzed which were recorded on rocket spectrograms. Two cloud components are resolved which have Doppler widths of 1.55 km/sec (larger cloud) and 2.16 km/sec (smaller cloud). Column densities are derived for C I, C II, N I, O I, Al II, Si II, and Fe II, and abundances relative to atomic hydrogen are determined from them. Silicon and iron are found to be slightly overabundant relative to the solar abundances, while the other elements are underabundant by factors ranging from 1.8 to 8.6. Mean cloud densities of 250 and 150 per cu cm (for the larger and smaller clouds, respectively) are determined, and the average ratios of electron density to hydrogen-atom density are derived using the column densities of C I and C II. It is shown that the iron abundance can be decreased to less than the solar abundance by doubling the velocity dispersion of the iron ions.

Smith, A. M.↗
NASA NTRS1975

Aerodynamic characteristics of a hypersonic research airplane concept having a 70 degree swept double delta wing at Mach numbers from 1.50 to 2.86

An experimental investigation of the static longitudinal, lateral, and directional stability characteristics of a hypersonic research airplane concept having a 70 deg swept double-delta wing was conducted in the Langley unitary plan wind tunnel. The configuration variables included wing planform, tip fins, center fin, and scramjet engine modules. The investigation was conducted at Mach numbers from 1.50 to 2.86 and at a constant Reynolds number, based on fuselage length, of 3,330,000. Tests were conducted through an angle-of-attack range from about -4 deg to 24 deg with angles of sideslip of 0 deg and 3 deg and at elevon deflections of 0, -10, and -20 deg. The complete configuration was trimmable up to angles of attack of about 22 deg with the exception of regions at low angles of attack where positive elevon deflections should provide trim capability. The angle-of-attack range for which static longitudinal stability also exists was reduced at the higher Mach numbers due to the tendency of the complete configuration to pitch up at the higher angles of attack. The complete configuration was statically stable directionally up to trimmed angles of attack of at least 20 deg for all Mach numbers M with the exception of a region near 4 deg at M = 2.86 and exhibited positive effective dihedral at all positive trimmed angles of attack.

Penland, J. A.↗
NASA NTRS1976

Diffusion algorithms and data reduction routine for onsite real-time launch predictions for the transport of Delta-Thor exhaust effluents

The National Aeronautics and Space Administration/Marshall Space Flight Center multilayer diffusion algorithms have been specialized for the prediction of the surface impact for the dispersive transport of the exhaust effluents from the launch of a Delta-Thor vehicle. This specialization permits these transport predictions to be made at the launch range in real time so that the effluent monitoring teams can optimize their monitoring grids. Basically, the data reduction routine requires only the meteorology profiles for the thermodynamics and kinematics of the atmosphere as an input. These profiles are graphed along with the resulting exhaust cloud rise history, the centerline concentrations and dosages, and the hydrogen chloride isopleths.

Stephens, J. B.↗
NASA NTRS1976

Static force tests of a sharp leading edge delta-wing model at ambient and cryogenic temperatures with a description of the apparatus employed

A sharp leading edge delta-wing model was tested through an angle-of-attack range at Mach numbers of 0.75, 0.80, and 0.85 at both ambient and cryogenic temperatures in the Langley 1/3-meter transonic cryogenic tunnel. Total pressure was varied with total temperature in order to hold test Reynolds number constant at a given Mach number. Agreement between the aerodynamic data obtained at ambient and cryogenic temperatures indicates that flows with leading-edge vortex effects are duplicated properly at cryogenic temperatures. The test results demonstrate that accurate aerodynamic data can be obtained by using conventional force-testing techniques if suitable measures are taken to minimize temperature gradients across the balance and to keep the balance at ambient (warm) temperatures during cryogenic operation of the tunnel.

Kilgore, R. A.↗
NASA NTRS1976

Theoretical and experimental study of twisted and cambered delta wings designed for a Mach number of 3.5

Data are provided for the evaluation of the aerodynamic performance of a series of twisted and cambered delta wings designed for a Mach number of 3.5. Systematic force and pressure data are also presented for comparison with theory. Force tests were made at Mach numbers of 2.3, 3.0, 3.5, 4.0, and 4.6. Design lift coefficients of 0.0 and 0.1 were employed on the 55 deg and 68 deg sweep wings, and design lift coefficients of 0.0, 0.05, and 0.1 were employed on the 76 deg sweep wings. Pressure tests were conducted on the 55 deg and 76 deg sweep flat wings and on the 0.1 design lift coefficient 76 deg sweep wing. The results indicate that for the sweep angles tested, an increase in the zero-lift pitching-moment coefficient is the primary benefit of twist and camber at a Mach number of 3.5. Comparison of the experimental results with results obtained from several lift theories indicates that the Carlson-Middleton linear theory method gave the best overall agreement. The pressure data indicate, however, that there is a cancellation of error at high angle of attack where the lower surface pressures are significantly underpredicted over the inboard region of the wing and where the upper and lower surface pressures are overpredicted over the outboard region of the wing.

Sorrells, R. B., III↗
NASA NTRS1976

Transverse tensile and stress rupture properties of gamma/gamma prime-delta directionally solidified eutectic

Tensile and stress rupture properties were determined primarily at 760 C for specimens oriented at various angles (0 deg, 10 deg, 45 deg, and 90 deg) from the solidification direction of bars and/or slabs of the Ni-20Cb-6Cr-2.5A (gamma/gamma prime-delta) eutectic. Threaded-head specimens yielded longer rupture lives with significantly less scatter than did tapered-head specimens. Miniature specimens are suitable for determining traverse tensile and rupture properties of 1.2 centimeter diameter bar stock. The 300 hour rupture stress at 760 C for specimens oriented at 10 deg from the solidification direction was reduced from 740 to 460 MPa, and to 230 MPa for material oriented at either 45 deg or 90 deg.

Gray, H. H.↗
NASA NTRS1975

Hypersonic incipient separation on delta wing with trailing-edge flap

The paper reviews the experimental data on the incipient separation characteristics of planar delta wings of 75 degree sharp leading edges, with full-span trailing edge flap deflected into the windward flow. The local Reynolds number range for these investigations covered laminar, transitional and turbulent conditions. It is shown that, while turbulent boundary layer data correlates with two dimensional results, in the laminar and transitional cases, there is a nearly parallel shift to higher flap angles for incipient separation.

Rao, D. M.↗
NASA NTRS1976

Heat treating of a lamellar eutectic alloy /gamma/gamma prime + delta/

Eutectic superalloys are being developed at several laboratories for application as aircraft gas turbine airfoils. One such alloy gamma/gamma prime + delta was subjected to several heat treatments to determine if its mechanical properties could be improved. It was found that by partially dissolving the gamma prime at 1210 C and then aging at 900 C, the tensile strength can be increased about 12 per cent at temperatures up to 900 C. At 1040 C, no change in tensile strength was observed. Times to rupture were measured between 760 and 1040 C and were essentially the same or greater than for as-grown material. Tensile and rupture ductility of the alloy were reduced by heat treatment.

Tewari, S. N.↗
NASA NTRS1976

Flowfield in the plane of symmetry below a delta wing

The flowfield in the plane of symmetry of a thin lifting delta wing with supersonic leading edges is examined for wings with apex angles that are comparable to the Mach angle, as well as for the limiting case of a straight leading edge. For these two cases, a simplified treatment of the interaction between the plane expansion wave emanating from the trailing edge and the three-dimensional bow shock is presented. In the region unaffected by the wing tips, the shock decays inversely with distance from the wing.

Cramer, M. S.↗
NASA NTRS1976

Launch opportunity classification of VEGA and delta V-EGA trajectories to the outer planets

Two concepts in spacecraft trajectory design which have been proposed by Hollenbeck (1975) and Bender and Friedlander (1975) are considered. Both concepts are intended for planetary missions and require an earth reencounter created by either a Venus gravity assist (VEGA) or a large midcourse impulse (delta V-EGA). In the case of outer planet missions, the new concepts offer significantly lower launch energy requirements than the direct ballistic flight mode. However, at least an additional two years flight time is needed for geometry phasing to set up the earth reencounter. A description is given of the trajectory characteristics for the two concepts. Attention is also given to the method of analysis used for the studies, aspects of trajectory generation, payload calculations, and target opportunity data.

Stancati, M. L.↗
NASA NTRS1977

Assessment of existing analytic methods for prediction of high angle-of-attack loads on delta wings at supersonic speeds

An assessment of the applicability of four loading prediction methods to high angle-of-attack conditions for simplified wing-body configurations is provided. The methods are: The tangent wedge approximation, the linear theory methods of Middleton and Woodward, and a shock-fitting finite-difference technique. Estimates obtained by these methods were compared with experimental pressure data on delta wings to examine the effects of Mach number, camber, sweep angle, and angle of attack. Results indicate that all of the methods provided reasonable estimates at moderate angles of attack. At these moderate angles of attack, the methods of Middleton and Woodward provided good estimates at Mach numbers higher than those usually associated with linear theory. Only the finite-difference method provided reasonable load estimates at high angles of attack.

Landrum, E. J.↗
NASA NTRS1977

Carburization and heat treatment to cause carbide precipitation in gamma/gamma prime-delta eutectic alloys

In an attempt to improve their longitudinal shear strength, several directionally solidified eutectic alloy compositions with minor element modifications were pact, carburized, and heat treated to provide selective carbide precipitation at the cell and grain boundaries. The directionally solidified Ni-17.8 Nb-6Cr-2.5Al-3Ta (weight percent) alloy was selected for the shear strength evaluation because it showed the shallowest delta-denuded zone at the carburized surface. The carburization-carbide precipitation treatment, however, did not appear to improve the longitudinal shear strength of the alloy.

Tewari, S. N.↗
NASA NTRS1976

CO/d-3 Delta sub i to X-1 Sigma +/ fluorescence from photodissociation of CO2 by 923 A photons

Measurements of vacuum ultraviolet fluorescence from the photodissociation of CO2 by photons from a N IV line emission source at a wavelength of 923 A have revealed a second CO band system in addition to the expected emission bands. Spectra with time resolution were obtained and the fluorescence lifetime and the dependence of fluorescence intensity on CO2 pressure were measured. An analysis of this data has permitted the second band system to be identified as originating from CO(d-3 Delta sub i to X-1 Sigma +) transitions.

Phillips, E.↗
NASA NTRS1975

The realization of arithmetic processors for delta modulation encoded signals

The design and realization of digital devices which add or multiply delta modulation (DM) encoded signals are presented. These systems operate directly on the DM bit stream. It is shown that the devices can be constructed using standard digital hardware and that the hardware complexity needed to add or multiply the two DM encoded signals is equivalent to that needed for pulse code modulation (PCM) signals. Experimental results are presented showing the operation of these systems. The results obtained by adding or multiplying DM encoded signals are compared with those obtained using PCM encoded signals on the basis of signal-to-noise ratio (SNR). A spectral-analysis technique applicable to a DM encoded signal is developed to obtain SNR curves.

Locicero, J. L.↗
NASA NTRS1977

Nonlinear, unsteady aerodynamic loads on rectangular and delta wings

Nonlinear unsteady aerodynamic loads on rectangular and delta wings in an incompressible flow are calculated by using an unsteady vortex-lattice model. Examples include flows past fixed wings in unsteady uniform streams and flows past wings undergoing unsteady motions. The unsteadiness may be due to gusty winds or pitching oscillations. The present technique establishes a reliable approach which can be utilized in the analysis of problems associated with the dynamics and aeroelasticity of wings within a wide range of angles of attack.

Atta, E. H.↗
NASA NTRS1977

Solution to the Delta vehicle second stage pogo problem

A discussion of the pogo phenomenon observed on the Delta launch vehicle second stage is presented. The pressure-fed engine and the high frequency of the oscillation (125 Hz) required unique analysis and extensive testing to support analysis detail. In addition, the need to continue a one vehicle per month launch rate required both an immediate interim and a timely long-term solution to the problem. The development and implementation of a program involving analysis, ground test, and flight instrumentation is described. An analytical model was developed and used to investigate both structural and propulsion system modifications. The factors which influenced the final suppression system selection, the analytical predictions for that system, and flight data which validate that system's effectiveness are presented.

Markowitz, M.↗
NASA NTRS1977

Load distributions on slender delta wings having vortex flow

Results obtained through application of potential-flow theory based on a suction flow analogy for incompressible flow are compared to attached-flow theory and to experimental data acquired for sharp-edged delta wings. The error incurred in predicting structural loads on the basis of attached-flow theory is investigated. Force and moment coefficients and load distributions are used in the comparisons. The root bending moment can be estimated by assuming vortex lift concentrated at the wing leading edge. While this may entail some error at large angles of attack (owing to inboard movement of the center of vortex lift), it may furnish an upper bound in evaluating results based on other theories.

Kuhlman, J.↗