Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Comparative Study”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 667 records · Page 37

Dual-Doppler lidar measurement of winds in the JAWS experiment

The use of coherent Doppler lidar measurements for analysis of wind fields near airports was investigated during the Joint Airport Weather Studies (JAWS) project of NASA and NOAA. Periodic lidar scans were made with two 10.6-micron CO2-pulsed Doppler lidars spaced 15 km apart in order to calculate the Cartesian wind fields near Marshall Space Flight Center (MSFC). Analyses were also carried out for the flow behind gust fronts, with the desired flow fields corresponding both to surface winds measured by a Portable Automated Mesonet (PAM), and numerical models of Great Plains thunderstorm outflows. Comparison of low elevation scans carried out using the lidar instruments and a CP-4 Doppler radar showed distinct differences due to a bias toward weaker velocities in the radar measurements. The rms difference between the radar and the lidar measurements was 3.1 m/s. The experimental results were consistent with those of a previous study comparing Wave Propagation Laboratory (WPL) lidar with the CP-3 5.5-cm radar operated by the National Center for Atmospheric Research (NCAR).

Rothermel, J.↗

Modeling techniques for transonic airfoils

In the present comparative study of computer codes for the modeling of two-dimensional, single element airfoil sections for various section geometry classes, two of the codes use vortex singularities methods to obtain the potential flow solution while the remainder solve the full inviscid potential flow equations by means of finite differencing techniques that allow results to be obtained for transonic flow about an airfoil which includes weak shocks. Computational results are presented for a symmetrical airfoil section, a conventional section, and a supercritical one. Icing condition applications of the models are noted. The model codes' range of applicability and agreement with each other and experimental results, as well as their computer run times and memory requirements, are noted.

Petrie, S. L.↗

Investigation of potential driver modules and transmission lines for a high frequency power system on the space station

The objective was to assess the feasibility of using the Series Resonant inverter as the driver module for the high frequency power system on the Space Station. This study evaluates the performance of the Series Resonant driver when it was operated with a dc input voltage and run through a series of tests to determine its start-up performance, response to load changes, load regulation, and efficiency. Also, this study compares the Series Resonant driver to another kind of driver that uses a Power Transistor snubber. An investigation of the various types of transmission lines is initiated. In particular, a simplified approach is utilized to describe the optimal transmission line.

Brush, H. T.↗

Cryogenic wind tunnels: Problems of continuous operation at low temperatures

The design of a cryogenic wind tunnel which operates continuously, and is capable of attaining transonic speeds at generating pressures of about 3 bars is described. Its stainless steel construction with inside insulation allows for very rapid temperature variations promoted by rapid changes in the liquid nitrogen flow. A comparative study of temperature measuring probes shows a good reliability of thin sheet thermocouples. To measure fluctuations, only a cold wire makes it possible to record frequencies of about 300 Hz. The use of an integral computer method makes it possible to determine the impact of the wall temperature ratio to the adiabatic wall temperature for the various parameters characterizing the boundary layer. These cases are processed with positive and negative pressure gradients.

Faulmann, D.↗

A comparison of the structureborne and airborne paths for propfan interior noise

In the present comparative study of aircraft interior noise levels due to airborne and structureborne paths for a given propeller source, a structure model is used that treats the fuselage interior as a rectangular cavity with five rigid walls; the sixth, or fuselage sidewall, is a stiffened panel. The wing is modeled as a simple beam carried into the fuselage by a large, discrete stiffener representing the carry-through structure. Comparisons are made on the basis of interior noise over a range of propeller rotational frequencies at a fixed thrust. It is found that the relative importance of the structural and airborne paths is highly dependent on the structural parameters.

Eversman, W.↗

Feasibility experiments on time-resolved fluorosensing applied to oil slicks

The introduction of time resolved observations can provide a very penetrating tool in the practice of laser fluorosensing. The investigations have demonstrated a relevance of multispectral, time resolved analysis for oil fingerprinting. By comparative studies on a variety of crude oils and their most significant fractions, it was found that the process of time decay in a composite oil is characterized by a few steps, which are associated with specific components in the medium light range. The average decay times of these pure fractions are markedly differentiated as to absolute values and spectral spread; as a consequence, the corresponding parameters in the resultant crude are quite sensitive to the particular mixture of these components. Measurements of the time response give then a finer discrimination between oil classes, depending on the relative content of certain fractions. Experiments were pursued with an improved fluorosensor facility, in order to test the application of time resolved fluorosensing to remote samples on water.

Camagni, P.↗

Some observations on the behavior of the Langley model rotor blade

The design of the model rotor and the comparative study of coupled beam theory and the finite element analysis performed earlier at the Aerostructures Directorate by Robert Hodges and Mark Nixon is examined. Attention is focused upon two matters: (1) an examination of the small discrepancies between twist angle predictions under pure torque and radial loading, and (2) an assessment of nonclassical effects in bending behavior. The primary objective is understanding, particularly with regard to cause and effect relationships. Understanding, together with the simple, affordable nature of the coupled beam analysis, provides a sound basis for design.

Rehfield, L. W.↗

A comparison between IMSC, PI and MIMSC methods in controlling the vibration of flexible systems

A comparative study is presented between three active control algorithms which have proven to be successful in controlling the vibrations of large flexible systems. These algorithms are: the Independent Modal Space Control (IMSC), the Pseudo-inverse (PI), and the Modified Independent Modal Space Control (MIMSC). Emphasis is placed on demonstrating the effectiveness of the MIMSC method in controlling the vibration of large systems with small number of actuators by using an efficient time sharing strategy. Such a strategy favors the MIMSC over the IMSC method, which requires a large number of actuators to control equal number of modes, and also over the PI method which attempts to control large number of modes with smaller number of actuators through the use of an in-exact statistical realization of a modal controller. Numerical examples are presented to illustrate the main features of the three algorithms and the merits of the MIMSC method.

Baz, A.↗

Temperature dependence of association of diatomic ions in diatomic gases

The present study compares the experimental rate coefficient temperature dependences for the association of diatomic ions in diatomic gases with the results of model calculations in which it is assumed that the stabilization of the initially formed unstable association complex occurs through the formation of a 'supercomplex'. The acceptable degree of agreement obtained between model and experimental data for the cases of four sample reactions, on the basis of a minimum of plausible assumptions, indicates that earlier theoretical models furnishing an accurate description of the formation and destruction of the association complex, but failing to reproduce experimental data, inadequately treated the temperature dependence of the stabilization step.

Johnsen, R.↗

An unconditionally-stable central differencing scheme for high Reynolds number flows

The central difference scheme (CDS) is a second order accurate scheme which is free of numerical diffusion (in the second order sense) and is simple to implement: However, for grid Peclet numbers larger than 2, the CDS leads to over- and undershoots and is unstable. The present paper describes a method, called CONDIF, which retains the essential nature of the CDS but eliminates the over- and under-shoots. It leads to unconditionally positive coefficients and, in the limit, approaches the CDS for all values of grid Peclet numbers. The CONDIF modifies the CDS by introducing a controlled amount of numerical diffusion based on the local gradients. In the worst case the scheme yields results similar to those of the hybrid scheme. This paper reports the results obtained from CONDIF for a number of test problems which have been widely used for comparative study of numerical schemes in the published literature. For most of these problems, the CONDIF results are significantly more accurate than the hybrid scheme at high Peclet numbers. In particular, the CONDIF scheme depicts much lower level of numerical diffusion than the hybrid scheme even when the Peclet number is very high and the flow is at large angles to the grid.

Runchal, Akshai K.↗

Systems Analysis Of Advanced Coal-Based Power Plants

Report presents appraisal of integrated coal-gasification/fuel-cell power plants. Based on study comparing fuel-cell technologies with each other and with coal-based alternatives and recommends most promising ones for research and development. Evaluates capital cost, cost of electricity, fuel consumption, and conformance with environmental standards. Analyzes sensitivity of cost of electricity to changes in fuel cost, to economic assumptions, and to level of technology. Recommends further evaluation of integrated coal-gasification/fuel-cell integrated coal-gasification/combined-cycle, and pulverized-coal-fired plants. Concludes with appendixes detailing plant-performance models, subsystem-performance parameters, performance goals, cost bases, plant-cost data sheets, and plant sensitivity to fuel-cell performance.

Ferrall, Joseph F.↗

The VISTA spacecraft: Advantages of ICF (Inertial Confinement Fusion) for interplanetary fusions propulsion applications

Inertial Confinement Fusion (ICF) is an attractive engine power source for interplanetary manned spacecraft, especially for near-term missions requiring minimum flight duration, because ICF has inherent high power-to-mass ratios and high specific impulses. We have developed a new vehicle concept called VISTA that uses ICF and is capable of round-trip manned missions to Mars in 100 days using A.D. 2020 technology. We describe VISTA's engine operation, discuss associated plasma issues, and describe the advantages of DT fuel for near-term applications. Although ICF is potentially superior to non-fusion technologies for near-term interplanetary transport, the performance capabilities of VISTA cannot be meaningfully compared with those of magnetic-fusion systems because of the lack of a comparable study of the magnetic-fusion systems. We urge that such a study be conducted.

Orth, Charles D.↗

A flow visualization study of the leading edge separation bubble on a NACA 0012 airfoil with simulated glaze ice

As a part of an ongoing research in aircraft icing, the leading edge separation bubble on a NACA 0012 model with a 5 min simulated glaze ice was investigated. The flow visualization methods using oil, tuft, splitter plate, smoke, and liquid crystals were employed to get reattachment line data for the leading edge separation bubble on both surfaces of the airfoil. On the upper surface, the separation bubble was found to grow larger with increasing angles of attack and reduce in size with decreasing angle of attack. On the lower surface, the bubble was found to grow larger with increasing negative angles of attack and reduce in size with increasing angles of attack. The separated flow fails to reattach beyond 6° for the upper surface and -5° for the loser surface. Their results of this study compared well with those of other experiments and computational results.

Aircraft icing↗

A payload for investigating the influence of convection on GaAs crystal growth

A comparative study of the influence of buoyancy driven fluid flow on gallium arsenide (GaAs) crystal growth was undertaken. Crystals will be grown from melts with different degrees of convective flow including growth in the microgravity environment of space. The space growth of GaAs will be performed in a Get Away Special payload. A well insulated growth furnace was designed for both Earth-based and space-based experiments. The self contained payload will carry two such furnaces in addition to a large battery power source and a microprocessor-based control and data acquisition system for regulating the growth process with high precision. The microcomputer will also monitor the growth conditions and measure and record the acceleration in 3 axes.

Bellows, Alfred H.↗

Jacobi-Bessel analysis of reflector antennas with elliptical apertures

Although many reflector antennas possess circular projected apertures, there are recent satellite and ground antenna applications for which it is desirable to employ reflectors with elliptical apertures. Here a modification of the Jacobi-Bessel expansion is presented for the diffraction analysis of reflectors with elliptical apertures. A comparative study is also performed between this modified Jacobi-Bessel algorithm and the one which uses the Jacobi-Bessel expansion over a circumscribing circular region. Numerical results are presented for offset reflectors with elliptical and circular apertures and the improved convergence properties of the modified algorithm are highlighted.

Rahmat-Samii, Yahya↗

Ionization of K-shell electrons by highly relativistic protons

A comparative study of three theoretical formalisms by Anholt et al. (1976), Scofield (1978), and Becker et al. (1985) for K-shell ionization by highly relativistic protons has been carried out. The importance of the spin-flip mechanism is emphasized. It is concluded that in the analysis of such inner-shell ionization processes, an accurate description of the projectile-target interaction is of much more significance than the accuracy of the wave functions of the atomic electrons.

Rustgi, M. L.↗

Ion nitriding; Proceedings of the International Conference, Cleveland, OH, Sept. 15-17, 1986

The present conference discusses plasma-assisted surface coating/modification processes, the applications to date of ion nitriding, the effects of nitrogen on metal surfaces, ion nitriding mechanisms in Cr, Al and Cr + Al-containing 1040 steel, ion nitriding of Al and its alloys, life enhancement for forging dies, novel anode plasma nitriding developments, and a comparative study of the pulsed and dc ion-nitriding behavior in specimens with blind holes. Also discussed are the influence of heating method on ion nitriding, surface hardening of marage steels by ion nitriding without core hardness reduction, plasma nitriding of nodular cast iron sput gears, NbN composites for superconductors, the carburization of tungsten in a glow discharge methane plasma, economic considerations concerning plasma nitriding, and the corrosion properties obtained by ion nitriding.

Spalvins, T.↗

Comparison of vibration dissociation coupling and radiative heat transfer models for AOTV/AFE flowfields

A series of detailed studies comparing various vibration dissociation coupling models, reaction systems and rates, and radiative heating models has been conducted for the nonequilibrium stagnation region of an AFE/AOTV vehicle. Atomic and molecular nonequilibrium radiation correction factors have been developed and applied to various absorption coefficient step models, and a modified vibration dissociation coupling model has been shown to yield good vibration/electronic temperature and concentration profiles. While results indicate sensitivity to the choice of vibration dissociation coupling model and to the nitrogen electron impact ionization rate, by proper combinations accurate flowfield and radiative heating results can be obtained. These results indicate that nonequilibrium effects significantly affect the flowfield and the radiative heat transfer. However, additional work is needed in ionization chemistry and absorption coefficient modeling.

Carlson, Leland A.↗