Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Optical computing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 631 records · Page 35
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Study of optical techniques for the Ames unitary wind tunnel: Digital image processing, part 6

A survey of digital image processing techniques and processing systems for aerodynamic images has been conducted. These images covered many types of flows and were generated by many types of flow diagnostics. These include laser vapor screens, infrared cameras, laser holographic interferometry, Schlieren, and luminescent paints. Some general digital image processing systems, imaging networks, optical sensors, and image computing chips were briefly reviewed. Possible digital imaging network systems for the Ames Unitary Wind Tunnel were explored.

Lee, George↗
NASA NTRS1994

Optoelectronic Receiver For Communication And Control

Many operational and diagnostic features integrated into circuit chip. GaAs-based integrated circuit designed to serve as optoelectronic interface in phased-array antenna. Intended function to receive digital control signals transmitted on optical fiber and to convert signals to electronic control signals, which then applied to monolithic microwave integrated circuit (MMIC). Also used in reception of high-rate optical digital communications within computers, between computers, and in signal-distribution systems in aircraft, automobiles, and ships. Interface circuit represents significant improvement over preexisting interface circuits in that its clock-signal-recovery subcircuit requires little or no preamble for immediate synchronization.

Kunath, Richard↗
NASA NTRS1994

Accretion disk coronae in high-luminosity systems

We present the results of self-consistent models of Compton-heated accretion disk coronae. The models are calculated using a new method for computing monochromatic radiative transfer n two dimensions. The method splits the radiation into direct and scattered components. The direct radiation is computed by calculating the optical depth along rays, while transfer of the scattered radiation is approximated by flux-limited diffusion. The resulting code agrees with more accurate treatments to within 50%, and is highly efficient, making it practical for use in large hydrodynamic simulations. The coronal models are used to confirm the results of earlier work, and to extend it to higher luminosities. In contrast to earlier work, which found the outer disks to be shadowed by the inner corona at high luminosities, we find our results to form an almost continuous extension of the models at lower luminosities. This is due to the presence of multiply scattered radiation, which acts to partially offset the loss of direct radiation from the central source. Although the analytic methods derived at lower luminosities cannot be used to derive the coronal structure for L/L(sub Edd) approx. greater than 0.1, the results of the models are amenable to semiempirical fits. We also discuss possible observational consequences of the results for coronal veiling and line fluorescence from the disk.

Murray, Stephen D.↗
NASA NTRS1996

Sensors for Environmental Control

Under a Kennedy Space Center Small Business Innovation Research contract, GEO-CENTERS, Inc. developed a sensing element or 'optrode,' which NASA needed for space life support research to measure a hydroponic culture's pH factor. The company then commercialized the technology in the PC Based pH Monitoring System. The system employs the optrode to enable long term continuous monitoring of the pH level of fluids in standing and flowing conditions, an optoelectronic board with light sensors and detectors that fits into a desktop computer, and a fiber optic cable that connects the two. The system is effective in monitoring the pH output of industries to maintain ranges acceptable to the Environmental Protection Agency.

Source record↗
NASA NTRS2003

Intersubband Transitions in InAs/AlSb Quantum Wells

We have studied intersubband transitions in InAs/AlSb quantum wells experimentally and theoretically. Experimentally, we performed polarization-resolved infrared absorption spectroscopy to measure intersubband absorption peak frequencies and linewidths as functions of temperature (from 4 K to room temperature) and quantum well width (from a few nm to 10 nm). To understand experimental results, we performed a self-consistent 8-band k-p band-structure calculation including spatial charge separation. Based on the calculated band structure, we developed a set of density matrix equations to compute TE and TM optical transitions self-consistently, including both interband and intersubband channels. This density matrix formalism is also ideal for the inclusion of various many-body effects, which are known to be important for intersubband transitions. Detailed comparison between experimental data and theoretical simulations is presented.

Li, J.↗
NASA NTRS2000

Eye height scaling of absolute size in immersive and nonimmersive displays

Eye-height (EH) scaling of absolute height was investigated in three experiments. In Experiment 1, standing observers viewed cubes in an immersive virtual environment. Observers' center of projection was placed at actual EH and at 0.7 times actual EH. Observers' size judgments revealed that the EH manipulation was 76.8% effective. In Experiment 2, seated observers viewed the same cubes on an interactive desktop display; however, no effect of EH was found in response to the simulated EH manipulation. Experiment 3 tested standing observers in the immersive environment with the field of view reduced to match that of the desktop. Comparable to Experiment 1, the effect of EH was 77%. These results suggest that EH scaling is not generally used when people view an interactive desktop display because the altitude of the center of projection is indeterminate. EH scaling is spontaneously evoked, however, in immersive environments.

NASA Discipline Space Human Factors↗
NASA NTRS2004

Optical Metrology for the Segmented Optics on the Constellation-X Spectroscopy X-Ray Telescope

We present the metrology requirements and metrology implementation necessary to prove out the reflector technology for the Constellation X(C-X) spectroscopy X-ray telescope (SXT). This segmented, 1.6m diameter highly nested Wolter-1 telescope presents many metrology and alignment challenges. In particular, these mirrors have a stringent imaging error budget as compared to their intrinsic stiffness; This is required for Constellation-X to have sufficient effective area with the weight requirement. This has implications for the metrology that can be used. A variety of contract and noncontact optical profiling and interferometric methods are combined to test the formed glass substrates before replication and the replicated reflector segments.The reflectors are tested both stand-alone and in-situ in an alignment tower.Some of these methods have not been used on prior X-ray telescopes and some are feasible only because of the segmented approach used on the SXT. Methods discussed include high precision coordinate measurement machines using very low force or optical probe axial interferometric profiling azimuthal circularity profiling and use of advanced null optics such as conical computer generated hologram (CGHs).

Content, David↗
NASA NTRS2005

Fast Whole-Engine Stirling Analysis

An experimentally validated approach is described for fast axisymmetric Stirling engine simulations. These simulations include the entire displacer interior and demonstrate it is possible to model a complete engine cycle in less than an hour. The focus of this effort was to demonstrate it is possible to produce useful Stirling engine performance results in a time-frame short enough to impact design decisions. The combination of utilizing the latest 64-bit Opteron computer processors, fiber-optical Myrinet communications, dynamic meshing, and across zone partitioning has enabled solution times at least 240 times faster than previous attempts at simulating the axisymmetric Stirling engine. A comparison of the multidimensional results, calibrated one-dimensional results, and known experimental results is shown. This preliminary comparison demonstrates that axisymmetric simulations can be very accurate, but more work remains to improve the simulations through such means as modifying the thermal equilibrium regenerator models, adding fluid-structure interactions, including radiation effects, and incorporating mechanodynamics.

Dyson, Rodger W.↗
NASA NTRS1998

An Examination of the Performance of Parallel Calculation of the Radiation Integral on a Beowulf-Class Computer

This paper uses the parallel calculation of the radiation integral for examination of performance and compiler issues on a Beowulf-class computer. This type of computer, built from mass-market, commodity, off-the-shelf components, has limited communications performance and therefore also has a limited regime of codes for which it is suitable.

Beowulf cluster pile of PCs parallel computation p↗
NASA NTRS2007

Fast Whole-Engine Stirling Analysis

An experimentally validated approach is described for fast axisymmetric Stirling engine simulations. These simulations include the entire displacer interior and demonstrate it is possible to model a complete engine cycle in less than an hour. The focus of this effort was to demonstrate it is possible to produce useful Stirling engine performance results in a time-frame short enough to impact design decisions. The combination of utilizing the latest 64-bit Opteron computer processors, fiber-optical Myrinet communications, dynamic meshing, and across zone partitioning has enabled solution times at least 240 times faster than previous attempts at simulating the axisymmetric Stirling engine. A comparison of the multidimensional results, calibrated one-dimensional results, and known experimental results is shown. This preliminary comparison demonstrates that axisymmetric simulations can be very accurate, but more work remains to improve the simulations through such means as modifying the thermal equilibrium regenerator models, adding fluid-structure interactions, including radiation effects, and incorporating mechanodynamics.

Dyson, Rodger W.↗
NASA NTRS2010

Wavefront Correction for Large, Flexible Antenna Reflector

A wavefront-correction system has been proposed as part of an outer-space radio communication system that would include a large, somewhat flexible main reflector antenna, a smaller subreflector antenna, and a small array feed at the focal plane of these two reflector antennas. Part of the wavefront-correction system would reside in the subreflector, which would be a planar patch-element reflectarray antenna in which the phase shifts of the patch antenna elements would be controlled via microelectromechanical systems (MEMS) radio -frequency (RF) switches. The system would include the following sensing-and-computing subsystems: a) An optical photogrammetric subsystem built around two cameras would estimate geometric distortions of the main reflector; b) A second subsystem would estimate wavefront distortions from amplitudes and phases of signals received by the array feed elements; and c) A third subsystem, built around small probes on the subreflector plane, would estimate wavefront distortions from differences among phases of signals received by the probes. The distortion estimates from the three subsystems would be processed to generate control signals to be fed to the MEMS RF switches to correct for the distortions, thereby enabling collimation and aiming of the received or transmitted radio beam to the required precision.

Imbriale, William A.↗
NASA NTRS2004

The StarLight Space Interferometer

Two papers describe the StarLight space interferometer a Michelson interferometer that would be implemented by two spacecraft flying in formation. The StarLight formation flying interferometer project has been testing and demonstrating engineering concepts for a new generation of space interferometers that would be employed in a search for extrasolar planets and in astrophysical investigations. As described in the papers, the original StarLight concept called for three spacecraft, and the main innovation embodied is a modification that makes it possible to reduce complexity by eliminating the third spacecraft. The main features of the modification are (1) introduction of an optical delay line on one spacecraft and (2) controlling the flying formation such that the two spacecraft are located at two points along a specified parabola so as to define the required baseline of specified length (which could be varied up to 125 m) perpendicular to the axis of the parabola. One of the papers presents a detailed description of the optical layout and discusses computational modeling of the performance; the other paper presents an overview of the requirements for operation and design, the overall architecture, and subsystems.

Folkner, William↗
NASA NTRS2017

Orion Exploration Flight Test Post-Flight Inspection and Analysis

The principal mechanism for developing orbital debris environment models, is to make observations of larger pieces of debris in the range of several centimeters and greater using radar and optical techniques. For particles that are smaller than this threshold, breakup and migration models of particles to returned surfaces in lower orbit are relied upon to quantify the flux. This reliance on models to derive spatial densities of particles that are of critical importance to spacecraft make the unique nature of the EFT-1's return surface a valuable metric. To this end detailed post-flight inspections have been performed of the returned EFT-1 backshell, and the inspections identified six candidate impact sites that were not present during the pre-flight inspections. This paper describes the post-flight analysis efforts to characterize the EFT-1 mission craters. This effort included ground based testing to understand small particle impact craters in the thermal protection material, the pre- and post-flight inspection, the crater analysis using optical, X-ray computed tomography (CT) and scanning electron microscope (SEM) techniques, and numerical simulations.

Miller, J. E.↗
NASA NTRS2003

Linear optics and projective measurements for fun and profit

The technique of projective measurements in linear optics can provide an apparent, efficient nonlinear interaction between photons, which is technically problematic otherwise. We present an application of such a technique to prepare large photon-number path entanglement.

linear↗
NASA NTRSDate not supplied

Surface and Atmospheric Shortwave Radiative Fluxes From ISCCP Data and Fu-Liou Algorithm at Higher Spatial and Vertical Resolution

NASA/GEWEX Surface Radiation Budget (SRB) has provided surface and TOA shortwave and longwave radiative fluxes using International Satellite Cloud Climatology data as the primary input. Release 4.0 came out in 2019, with data from July 1983 through June 2017, and improved validation stats relative to Release 3.0 (Stackhouse et al., 2012). Release 4.0 used the newly reprocessed ISCCP H data set. The shortwave algorithm for versions 3 and 4 has been based on the Pinker and Laszlo (1992) algorithm, which relies on the satellite-measured shortwave radiance to produce a TOA albedo. This background TOA albedo is made utilizing the background clear-sky visible radiance (called clear-sky composite radiance in the ISCCP data) and applying narrowband-to-broadband angular distribution models. Using a climatological aerosol assumption, the surface albedo is estimated using radiative transfer based (i.e., Fu/Liou radiative transfer model; Fu and Liou, 1993) look-up tables. Using this surface albedo and an instantaneous TOA albedo, the look-up tables are used to adjust both the aerosol optical depth (for clear sky) and cloud optical depth (for cloudy sky) for each scene. These properties and look up tables are then used to generate surface fluxes. While this has worked well to provide useful fluxes, it has occasionally resulted in inaccurate direct and diffuse surface SW fluxes due to the overreliance on aerosol optical depth. With increased computational power and storage now available, a more direct approach is now possible. Here we present a different approach for a future high resolution SRB Release 5.0. We replace the Pinker-Laszlo lookup table approach with a forward call to the Fu-Liou radiative transfer model as modified by the CERES team (Rose et al., 2006). In addition to being a proven radiation code, Fu-Liou allows the calculation of fluxes at different atmospheric levels and spectral bands, which will provide more insight into the surface radiation budget, its variability and attribution. It is expected that horizontal resolution will increase to at least 0.5°x0.5° from the current 1°x1°. Here we demonstrate a preliminary look at the next SRB, and show comparisons with the current release.

Earth Radiation Budget↗
NASA NTRS1977

Active optics simulation system

Set of three major computer program packages aids design of mirror control system for large telescopes. It can be used to evaluate merit of particular active optics control system (or component subsystem); and once system configuration is chosen, it can be used as design aid to optimize system parameters.

Source record↗