DOE OSTI2018
As space programs increase in number and scope, there is an increasing need for radiation-hardened electronic devices and circuits. In particular, missions to high-radiation environments, such as Europa, would greatly benefit from improved radiation hardness in electronic devices. In pursuit of this goal, resistive memory (RRAM) devices were fabricated at SUNY Polytechnic Institute and evaluated for radiation hardness. Our objectives were to produce RRAM devices resistant to high levels of radiation damage and to demonstrate that these devices would improve mission lifetime in high-radiation environments. Furthermore, the underlying mechanisms of radiation were investigated to provide recommendations for radiation-hardening RRAM devices, which could be applied to any candidate RRAM devices being considered for space applications. Devices were fabricated using several fabrication approaches, including patterning by shadow mask, photolithography-based etching, and photolithography-based liftoff. In each of these cases, total ionizing dose (TID) effects and displacement damage dose (DDD) effects were measured. TID effects from exposure to a 60Co gamma source were not observed to cause changes in device resistance or switching parameters in any experiments, with each device tested to at least 20 Mrad(Si). DDD was measured as radiation-generated oxygen vacancies per cm 3 since oxygen vacancies are generally considered to be the active species involved in switching these devices. The lowest DDD level that caused a device to change resistance state was 10 21 vacancies per cm 3 , and most devices failed at 1022 vacancies per cm 3 . This is an extremely high DDD level, even for RRAM devices, which have been reported to fail in the range of 10 17 -10 20 vacancies per cm 3 . For comparison, an example flash memory device failed at 10 15 vacancies per cm 3 . Vendor-fabricated devices with a similar composition to our own were also tested against TID and DDD. The vendor-fabricated devices did not exhibit changes due to TID, up to the tested level of 30 Mrad(Si). Meanwhile, vendor devices exhibited resistance state changes at 10 21 vacancies per cm 3 , similar to our own devices. These results indicate that Ta0x-based RRAM devices may be particularly resilient to both TID and DDD effects. The very high tolerance to radiation effects is most likely due to the high intrinsic concentration of oxygen vacancies within our devices. Based on X-ray photoelectron spectroscopy (XPS) measurements, there are approximately 10 22 oxygen vacancies per cm 3 in our devices as deposited. Most devices failed when the radiation-induced vacancies reached this level, indicating suggesting that a high intrinsic vacancy concentration protects against lower levels of displacement damage. High vacancy concentration likely also protects against TID by facilitating leakage of trapped charge out of the oxide. The use of a thin switching oxide (25 nm Ta0 x , for our devices) is also expected to improve radiation hardness, as there is less room for charge trapping. Therefore, those wishing to produce very radiation-tolerant RRAM devices can probably achieve this by using a thin oxide that contains a high intrinsic concentration of oxygen vacancies. Our devices appear to be very tolerant of radiation effects, and would greatly increase the expected lifetime of a mission to Europa or another high-radiation target compared to flash memory devices. The similar radiation performance of vendor-fabricated devices is promising for adoption of RRAM devices as radiation-hardened memory devices for use in space. With continued commercial development of these devices, RRAM devices are strong candidates for next-generation memories that are inherently rad-hard.