SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A commercial based, foundry independent, compiler design tool (ChipCrafter) with custom radiation hardened library cells is described. A unique analysis approach allows low hardness risk for Application Specific IC's (ASIC's). Accomplishments, radiation test results, and applications are described.
The bristles of a 38.1-mm (1.5-in.) diameter brush seal were flexed by a tapered, 40-tooth rotor operating at 2600 rpm that provided sharp leading-edge impact of the bristles with hard rubbing of the rotor lands. Three separate tests were run with the same brush accumulating over 1.3 x 10(exp 9) flexure cycles while deteriorating 0.2 mm (0.008 in.) radially. In each, the test bristle incursion depth varied from 0.130 to 0.025 mm (0.005 to 0.001 in.) or less (start to stop), and in the third test the rotor was set 0.25 mm (0.010 in.) eccentric. Runout varied from 0.025 to 0.076 mm (0.001 to 0.003 in.) radially. The bristles wore but did not pull out, fracture, or fragment. Bristle and rotor wear debris were deposited as very fine, nearly amorphous, highly porous materials at the rotor groove leading edges and within the rotor grooves. The land leading edges showed irregular wear and the beginning of a convergent groove that exhibited sharp, detailed wear at the land trailing edges. Surface grooving, burnishing, 'whipping', and hot spots and streaks were found. With a smooth-plug rotor, post-test leakage increased 30 percent over pretest leakage.
SN1987A hard x ray continuum spectra obtained on 29 Oct. 1987, 9-10 Apr. 1988, and 11 Nov. 1988, from balloon flight measurements are presented. The spectra, spanning the energy range from 25 keV to 300 keV, were analyzed using a detector response matrix inversion technique that converts the spectra from counts/sec-sq cm-kev to photons/sec-sq cm-kev allowing direct comparison with theoretical models. The results indicate that the bulk of the Co-56 is mixed moderately through the inner regions of the SN envelope but they do not preclude the mixing of a small amount of the Co-56 further out into the envelope necessary to account for the observed Co-56 line fluxes. The effect of the ratio of Co-57 to Co-56 on the 11 Nov. 1988, continuum spectrum is discussed.
The binary X-ray pulsar SMC X- 1 has been observed at hard X-rays with the High Energy X-Ray Experiment (HEXE) on nine occasions between Nov. 1987 and March 1989. A thin thermal bremsstrahlung fit to the phase averaged spectrum yields a plasma temperature (14.4 +/- 1.3) keV and a luminosity above (1.1 +/- 0.1) x 10 exp 38 erg/s in the 20-80 keV band. Pulse period values have been established for three observations, confirming the remarkably stable spin-up trend of SMC X-1. In one of the three observations the pulse profile was seen to deviate from a dominant double pulsation, while at the same time the pulsed fraction was unusually large. For one observation we determined for the first time the pulsed fraction in narrow energy bands. It increases with photon energy from about 20 percent up to over 60 percent in the energy range from 20 to 80 keV.
The ability to guarantee the deadlines of synchronous messages while maintaining a good aggregate throughput is an important consideration in the design of distributed real-time systems. In this paper, we study two token ring protocols, the priority driven protocol and the timed token protocol, for their suitability for hard real-time systems. Both these protocols use a token to control access to the transmission medium. In a priority driven protocol, messages are assigned priorities and the protocol ensures that messages are transmitted in the order of their priorities. Timed token protocols do not provide for priority arbitration but ensure that the maximum access delay for a station is bounded. For both protocols, we first derive the schedulability conditions under which the transmission deadlines of a given set of synchronous messages can be guaranteed. Subsequently, we use these schedulability conditions to quantitatively compare the average case behavior of the protocols. This comparison demonstrates that each of the protocols has its domain of superior performance and neither dominates the other for the entire range of operating conditions.
Our objective is to perform on homogeneous, fully equilibrated dispersions the full set of experiments characterizing the transition from fluid to solid and the properties of the crystalline and glassy solid. These include measurements quantifying the nucleation and growth of crystallites, the structure of the initial fluid and the fully crystalline solid, and Brownian motion of particles within the crystal, and the elasticity of the crystal and the glass. Experiments are being built and tested for ideal microgravity environment. Here we describe the ground based effort, which exploits a fluidized bed to create a homogeneous, steady dispersion for the studies. The differences between the microgravity environment and the fluidized bed is gauged by the Peclet number Pe, which measures the rate of convection/sedimentation relative to Brownian motion. We have designed our experiment to accomplish three types of measurements on hard sphere suspensions in a fluidized bed: the static scattering intensity as a function of angle to determine the structure factor, the temporal autocorrelation function at all scattering angles to probe the dynamics, and the amplitude of the response to an oscillatory forcing to deduce the low frequency viscoelasticity. Thus the scattering instrument and the colloidal dispersion were chosen such as that the important features of each physical property lie within the detectable range for each measurement.
In recently years, Ga(0.5)In((0.5)P/GaAs cells have drawn increased attention both because of their high efficiencies and because they are well suited for space applications. They can be grown and processed as two-junction devices with roughly twice the voltage and half the current of GaAs cells. They have low temperature coefficients, and have good potential for radiation hardness. We have previously reported the effects of electron irradiation on test cells which were not optimally designed for space. From those results we estimated that an optimally designed cell could achieve 20 percent after irradiation with 10(exp 15) cm(exp -2) 1 MeV electrons. Modeling studies predicted that slightly higher efficiencies may be achievable. Record efficiencies for EOL performance of other types of cells are significantly lower. Even the best Si and InP cells have BOL efficiencies lower than the EOL efficiency we report here. Good GaAs cells have an EOL efficiency of 16 percent. The InP/Ga(0.5)In(0.5)As two-junction, two-terminal device has a BOL efficiency as high as 22.2 percent, but radiation results for these cells were limited. In this study we use the previous modeling and irradiation results to design a set of Ga(0.5)In(0.5)P/GaAs cells that will demonstrate the importance of the design parameters and result in high-efficiency devices. We report record AMO efficiencies: a BOL efficiency of 25.7 percent for a device optimized for BOL performance and two of different designs with EOL efficiencies of 19.6 percent (at 10(exp 15) cm(exp -2) 1MeV electrons). We vary the bottom-cell base doping and the top-cell thickness to show the effects of these two important design parameters. We get an unexpected result indicating that the dopant added to the bottom-cell base also increases the degradation of the top cell.
Molecular dynamics simulation is used to study the piston driven shock wave at Mach 1.5, 3, and 10. A shock tube, whose shape is a circular cylinder, is filled with hard sphere molecules having a Maxwellian thermal velocity distribution and zero mean velocity. The piston moves and a shock wave is generated. All collisions are specular, including those between the molecules and the computational boundaries, so that the shock development is entirely causal, with no imposed statistics. The structure of the generated shock is examined in detail, and the wave speed; profiles of density, velocity, and temperature; and shock thickness are determined. The results are compared with published results of other methods, especially the direct simulation Monte-Carlo method. Property profiles are similar to those generated by direct simulation Monte-Carlo method. The shock wave thicknesses are smaller than the direct simulation Monte-Carlo results, but larger than those of the other methods. Simulation of a shock wave, which is one-dimensional, is a severe test of the molecular dynamics method, which is always three-dimensional. A major challenge of the thesis is to examine the capability of the molecular dynamics methods by choosing a difficult task.
In a sample of impulsive bursts with rise times less than 30 s, a correlation between burst rise times and the frequency of maximum microwave emission has been found. The immplications for source structure and dynamics are discussed. Previously evidence was found that such bursts are caused by some propagating disturbance such as a shock wave or thermal conduction front. Combining that evidence with the microwave and hard X-ray spectral information suggests that the most rapid bursts are emitted from the most compact and intensely magnetized sources. The most rapid bursts also exhibited the hardest X-ray spectra, as published previously. These facts are important clues to understanding the physical process responsible for impulsive bursts. A model for the bursts is suggested, based on the observations and inferences described.
In this study we perform a statistical study on, 8319 X-Ray solar flares observed with the Hard X-Ray Spectrometer (HXRBS) on the Solar Maximum Mission satellite (SMM). The events are examined in terms of the durations, maximum intensities, and intensity profiles. It is concluded that there is no evidence for a correlation between flare intensity, flare duration, and flare asymmetry. However, we do find evidence for a rapid fall-of in the number of short-duration events.
The delayed hard (up to 25 GeV) photons observed more than an hour following a gamma-ray burst on 1994 February 17 may result from the collisions of relativistic nucleons with a dense cloud, producing pi(0). The required cloud density is approx. 2 x 10(exp 11)/cu cm. This cloud may be the remains of the disrupted envelope of a neutron star, and may survive as an excretion disk of approx. 10(exp 14) - 10 (exp 15) cm radius around the coalescing binary.
SN 1987A hard X-ray continuum spectra obtained on 1987 October 29, 1988 April 9-10, and 1988 November 11 from balloon-flight measurments are presented. The spectra, spanning the energy range from 25 keV to 300 keV, have been analyzed using a detector response matrix inversion technique that converts the spectra form counts/s/sq cm keV to photons/s/sq cm keV allowing direct comparison with theoretical models. The results indicate that the bulk of the (56)Co is mixed moderately through the inner regions of the supernova envelope but they do not preclude the mixing of a small amount of the (56)Co farther out into the envelope necessary to account for the observed (56)Co line fluxes. The effect of the ratio (57)Co to (56)Co on the 1988 November 11 continuum spectrum is discussed.
A hybrid detector is under development for use as a balloon-borne instrument in hard x-ray astronomy. The detector provides broad band coverage by coupling an optical avalanche chamber to a phoswich. The optical avalanche chamber yields superior instrument response at low energies while the scintillator takes over at the higher energies where the gas becomes transparent: at 25 keV, the addition of the gas chamber improves the energy resolution by a factor of 2.5 and the spatial resolution by a factor of 10 as compared to the stand-alone response of the phoswich. A half-scale prototype instrument is being constructed for test purposes and to help resolve a number of design questions involving the coupling of the two components.
We present first results from a comprehensive investigation into the distribution of luminosity within the 50 brightest cosmic gamma-ray bursts detected by the Burst and Transient Source Experiment (BATSE). The internal luminosity function psi(L) is defined such that the quantity psi(L)dL represents the fraction of total emission time during which the burst possesses a luminosity between L and L + dL. For these brightest bursts, the psi(L) functions are quasi-power-law-like and decrease in amplitude with increasing luminosity. Through investigation of both individual psi(L) distributions and data from the ensemble of bursts, we demonstrate a high probability for correlation between the shape of the internal luminosity function as measured by the average logarithmic slope and the burst duration as measured by the T(sub 90) parameter and, with lower significance, between the shape of psi(L) and the burst photon-fluence spectral index. We furthermore demonstrate a correlation between burst hardness ratio and duration in these brightest bursts which is opposite to that of the entire gamma-ray burst ensemble.
In a two-day balloon flight during October 1995, the Caltech coded aperture gamma ray imaging payload (GRIP-2) imaged various fields in the Galactic plane and center in the 25 to 600 keV energy band. The large phoswich detector, the 15 deg field of view, the 30 arcmin angular resolution and 6 arcmin point source localization capability of GRIP-2 provides the possibility of surveying the accreting binary population of the Galaxy at high energy. The instrument is described and preliminary imaging results are reported on. The capabilities of this instrument for hard X-ray/gamma ray imaging are demonstrated.
The original program for evaluating the tribological properties several different hard coatings for liquid film bearing applications was curtailed when the time for the program was reduced from 3 years to 1. Of the several different coatings originally planned for evaluation, we decided to concentrate on one coating, carbon nitride. At BIRL, we have been instrumental in the development of reactively sputtered carbon nitride coatings, and we have found that it is a very interesting new material with very good tribological properties. In this program, we found that the reactively sputtered carbon nitride does not bond well directly to hardened 440C stainless steel; but if an interlayer of titanium nitride is added between the carbon nitride and the 440C, the adhesion of the dual coating combination is very good. Statistically designed experiments were run with the dual layer combination, and 3 variables were chosen for the Box-Benken design, which were the titanium nitride interlayer thickness, the nitrogen partial pressure during the reactive sputtering of the carbon nitride, and the carbon nitride substrate bias voltage. Two responses were studied from these three variables; the adhesion of the dual coating combination to the 440C substrate and the friction coefficient of the carbon nitride in dry sliding contact with 52100 steel in air. The best adhesion came with the thickness interlayer thickness studied, which was 4 micrometers, and the lowest coefficient of friction was 0.1, which was achieved when the bias voltage was in the range of -80 to - 120 V and the nitrogen partial pressure was 3 mTorr.
The objective of this project is to determine the characteristics of flare energy transport processes through the study of soft X-rays, hard X-rays, and their interrelationships through analysis of Yohkoh SXT, HXT, and BCS data, and comparison with theoretical models. The personnel involved in the research include SSL Assistant Research Physicists Dr. Peng Li and Dr. James McTiernan.
This investigation has involved the correlation of BATSE-observed solar hard X-ray emission with the characteristics of soft X-ray emitting plasma observed by the Yohkoh Bragg Crystal Spectrometers. The goal was to test the hypothesis that localized electron beam heating is the dominant energy transport mechanism in impulsive flares, as formulated in the thick-target electron-heated model of Brown.