Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “point spread functions”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 613 records · Page 34

Surface photometry of comet P/Encke

A scheme to clean cometary digital images from offending background-star trails, and this technique has been applied to a pair of deep Kitt Peak 4-m plates of comet P/Encke, taken in October 1980. Simultaneous and subsequent digital spectra have been obtained at Lick Observatory. The non-polluted coma images show a strong asymmetric sunward-oriented fan/jet, and an extended and rounder (mostly gaseous) main coma, out to approximately 100,000 km radius. The stellar-trail point-spread function has a narrow width (sigma approximately 0.6 arcsec), so that spatial resolution better than approximately 300 km is achieved at the comet. The photometric gradient near the nucleus is very steep, strongly suggesting an icy-grain component which evaporates quickly (at radii equal to or less than 500 km) in the sunlight. Further from the nucleus, the profile becomes shallower, bluer, and more gas dominated. The effect of solar radiation pressure on C2, CN, and other molecules is probably responsible for the rounding of the outer, fainter isophotes. The source of the molecules is likely to be larger than the nucleus itself, and a substantial fraction may originate in the jet. The technique described here may also be applicable in surface photometry of galaxies, in cases where the heavy image pollution by foreground stars is present.

Djorgovski, S.↗

Comments on the intercalibration of multisensor, multitemporal, multichannel digital radiance data

When comparing the recorded radiance data obtained on a given date by means of different sensors or on different dates using the same sensor, the values in question must be referred to some common datum. It is presently noted that more data are required for remote sensing instruments, and that these should consist of gain, offset, spectral response and point spread function for each bandpass. Such information will be the bases for studies of sensor intercalibration procedure.

Duggin, M. J.↗

Theoretical analysis of Wolter/LSM X-ray telescope systems

A ray tracing analysis has been performed for the spectral slicing zoom X-ray telescope for configurations in which a convex layered synthetic microstructure (LSM) optic is placed in front of the prime focus or a concave LSM optic is placed behind the prime focus. The analysis has considered the geometrical shape of the LSM optic to be either a hyperboloid, sphere, ellipsoid or constant optical path aspheric element for two configurations of the glancing incidence X-ray telescope: the ATM Experimental S-056 Wolter I system and the Stanford/MSFC Wolter-Schwarzchild nested system. For the different systems the RMS blur circle radii, the point spread function (PSF), the full width half maximum (FWHM) of the PSF have been evaluated as a function of field angle and magnification of the secondary to determine resolution of the system. The effects of decentration and tilt of the selected LSM element on the performance of the system have been studied to determine mounting and alignment tolerances.

Shealy, D. L.↗

Simulation of LANDSAT multispectral scanner spatial resolution with airborne scanner data

A technique for simulation of low spatial resolution satellite imagery by using high resolution scanner data is described. The scanner data is convolved with the approximate point spread function of the low resolution data and then resampled to emulate low resolution imagery. The technique was successfully applied to Daedalus airborne scanner data to simulate a portion of a LANDSAT multispectra scanner scene.

Hlavka, C. A.↗

Photometry of resolved galaxies. V - NGC 6822

Three-color CCD frames of the local group irregular galaxy NGC 6822 have been reduced to GRI photometry for 3475 stars using RICHFLD point-spread function fitting techniques. The data are compared with earlier work on this galaxy, particularly with Kayser (1966) on a star-by-star basis. Color-magnitude diagrams are constructed from the data and compared with both theoretical stellar model tracks and the expected foreground star contamination. A luminosity function for the blue stars is derived; comparison of this luminosity function with those of 10 other irregular galaxies indicates that NGC 6822 has a typical young star population. The stellar birthrate and initial mass function are estimated for this galaxy. The slope at the bright end of the mass function looks similar to recent results for the Galaxy, the Magellanic Clouds, and the irregular galaxy Sextans A. NGC 6822 appears to be presently forming stars at a slower rate for its mass than Sextans A or the Magellanic Clouds.

Hoessel, J. G.↗

Theoretical analysis of segmented Wolter/LSM X-ray telescope systems

The Segmented Wolter I/LSM X-ray Telescope, which consists of a Wolter I Telescope with a tilted, off-axis convex spherical Layered Synthetic Microstructure (LSM) optics placed near the primary focus to accommodate multiple off-axis detectors, has been analyzed. The Skylab ATM Experiment S056 Wolter I telescope and the Stanford/MSFC nested Wolter-Schwarzschild x-ray telescope have been considered as the primary optics. A ray trace analysis has been performed to calculate the RMS blur circle radius, point spread function (PSF), the meridional and sagittal line functions (LST), and the full width half maximum (PWHM) of the PSF to study the spatial resolution of the system. The effects on resolution of defocussing the image plane, tilting and decentrating of the multilayer (LSM) optics have also been investigated to give the mounting and alignment tolerances of the LSM optic. Comparison has been made between the performance of the segmented Wolter/LSM optical system and that of the Spectral Slicing X-ray Telescope (SSXRT) systems.

Shealy, D. L.↗

Astronomical imaging by filtered weighted-shift-and-add technique

The weighted-shift-and-add speckle imaging technique is analyzed using simple assumptions. The end product is shown to be a convolution of the object with a typical point-spread function (psf) that is similar in shape to the telescope psf and depends marginally on the speckle psf. A filter can be applied to each data frame before locating the maxima, either to identify the speckle locations (matched filter) or to estimate the instantaneous atmospheric psf (Wiener filter). Preliminary results show the power of the technique when applied to photon-limited data and to extended objects.

Ribak, Erez↗

A parametric study of various synthetic aperture telescope configurations for coherent imaging applications

The comparative advantages of synthetic aperture telescopes (SATs) of segmented primary mirror and common secondary mirror type, on the one hand, and on the other those employing an array of independent telescopes, are discussed. The diffraction-limited optical performance of both redundant and nonredundant subaperture configurations are compared in terms of point spread function characteristics and encircled energy plots. Coherent imaging with afocal telescope SATs involves a pupil-mapping operation followed by a Fourier transform one. A quantitative analysis of the off-axis optical performance degradation due to pupil-mapping errors is presented, together with the field-dependent effects of residual design aberrations of independent telescopes.

Harvey, James E.↗

X-ray optics - A technique for high resolution imaging

Both scattering and figure errors in grazing incidence optics are larger in the plane of incidence than out-of-plane by a factor equal to 1/sin theta, where theta is the graze angle. When the full annular aperture of a grazing incidence telescope is stopped down, the point spread function becomes highly elliptical with a width as much as sin theta times narrower than the full image. In practice, this means that improvements in resolution of up to 100 times can be achieved, and effective resolution can approach the diffraction limit. Laboratory data demonstrating the effect are presented.

Cash, Webster↗

Simulation Of Satellite Imagery From Aerial Imagery

High-resolution-image data convolved with point-spread function. Report describes use of higher-resolution-image data from aerial photographs or electronic scans of ground to simulate lower resolution images obtained if same area of ground viewed from imaging system in orbit. Simulation technique helpful in analysis of data received from operating satellites and in design of future satellite-borne imaging systems.

Hlavka, Christine A.↗

Wavefront error sensing

A two-step approach to wavefront sensing for the Large Deployable Reflector (LDR) was examined as part of an effort to define wavefront-sensing requirements and to determine particular areas for more detailed study. A Hartmann test for coarse alignment, particularly segment tilt, seems feasible if LDR can operate at 5 microns or less. The direct measurement of the point spread function in the diffraction limited region may be a way to determine piston error, but this can only be answered by a detailed software model of the optical system. The question of suitable astronomical sources for either test must also be addressed.

Tubbs, Eldred F.↗

A component decomposition model for evaluating atmospheric effects in remote sensing

A radiance value of a target pixel recorded by a remote sensor can be decomposed into three components: (1) attenuated target signature, (2) pure atmospheric radiation, and (3) the contribution made by the ground through the atmospheric scattering process. Given the meteorological and optical parameters of a layer-structured atmosphere, its transmittance and radiance distribution can be accurately calculated with a plane-parallel radiative transfer model. For a uniform surface, the ground contribution can be obtained by comparing radiances for an atmosphere over a black but nonemitting surface and the same atmosphere with an underlying ground of given albedo or temperature. For an inhomogeneous surface, the first two components remain the same as long as the surface is a plane. The third may be estimated using the locally averaged top-of-atmosphere radiance. An atmospheric point spread function is calculated by a Monte Carlo approach and is used for retrieving the ground signature through a deconvolution procedure.

Li, S.↗

Resonance scattering by sodium in Mercury's atmosphere. I - The effect of phase and atmospheric smearing

The dependence of the intensity in the sodium D1 and D2 lines on the planetary phase and position of the disk is presented. Theoretical intensities are convolved with an atmospheric point spread function with FWHM of 0.5 and 2.0 arcsec for planetary phases 60 and 90 deg. It is shown that although the absolute intensities are extremely dependent on seeing, the I(D2)/I(D1) ratio remains a reliable indicator of column abundance regardless of the seeing function. For a uniform distribution of sodium, limb brightening will be apparent for a seeing disk with FWHM of 0.5 arcsec but will not be apparent for a FWHM of 2.0 arcsec.

Killen, R. M.↗

Measurement of micro-roughness and effects of detector bandwidth and finite width

Surface micro-roughness of grazing incidence optics has long been recognized as a critical parameter in the control of the scattered X-ray intensity and its effects on the point spread function half-energy width. Accurate knowledge of the amplitude of surface micro-roughness is vital to assess optic predicted performance during the final stages of fabrication. This requires not only a knowledge of the spatial bandwidth over which surface features must be measured, but also knowledge of the bandwidth of the measurement instrument. We show that the standard assumption that instruments respond up to their Nyquist limit is an oversimplification which neglects the finite detector size and its bandwidth limiting effects when sampling a real (i.e., two-dimensional) surface.

Reid, P. B.↗

High spatial resolution 10 micron imaging of IRC + 10216

Precise high-resolution 10-micron images of the carbon star IRC + 10216 have been obtained with a scanned linear array. The low noise and high dynamic range of these images permit deconvolution of the telescope point-spread function, revealing the radial brightness distribution of the circumstellar dust shell: approximate reflection symmetry is found in west-east scans, with a distinct division into two components of diameter about 0.40 and 2.2 arcsec. It is shown that this morphology is consistent with published interferometric data that had cast doubt upon an earlier, idealized two-component model. The observed brightness distribution implies that the circumstellar dust density may deviate substantially from the 1/r squared radial dependence expected for spherically symmetric outflow with constant velocity and constant rate of mass loss.

Bloemhof, E. E.↗

Encircled energy correction method for raytrace programs

Program adjustments to increase the accuracy of the diffraction-based encircled energy analysis algorithms of the optical design computer programs ACCOS-V and SYNOPSYS are proposed. It is noted that the erroneous algorithms are based on the incorrect assumption that all the energy in a diffraction point spread function is contained within a circle of finite radius. Using these adjustments, more accurate encircled energy results are obtained for circles of radii less than or equal to the 100 percent boundary.

Dantzler, Andrew A.↗

Maximum entropy deconvolution of the optical jet of 3C 273

The technique of maximum entropy image restoration is applied to the problem of deconvolving the point spread function from a deep, high-quality V band image of the optical jet of 3C 273. The resulting maximum entropy image has an approximate spatial resolution of 0.6 arcsec and has been used to study the morphology of the optical jet. Four regularly-spaced optical knots are clearly evident in the data, together with an optical 'extension' at each end of the optical jet. The jet oscillates around its center of gravity, and the spatial scale of the oscillations is very similar to the spacing between the optical knots. The jet is marginally resolved in the transverse direction and has an asymmetric profile perpendicular to the jet axis. The distribution of V band flux along the length of the jet, and accurate astrometry of the optical knot positions are presented.

Evans, I. N.↗