Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “hypersonic flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 613 records · Page 34
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Computer programs for predicting supersonic and hypersonic interference flow fields and heating

This report describes computer codes which calculate two-dimensional shock interference patterns. These codes compute the six types of interference flows as defined by Edney (Aeronaut. Res. Inst. of Sweden FAA Rep. 115). Results include properties of the inviscid flow field and the inviscid-viscous interaction at the surface along with peak pressure and peak heating at the impingement point.

Morris, D. J.↗
NASA NTRS1974

Hypersonic nonequilibrium flow past a sphere at low Reynolds numbers

Detailed flow field properties are computed in the nose region of a sphere from the Navier-Stokes equations for a range of Reynolds numbers. Comparisons are made of theoretical flow fields with those obtained in experiments and also with other analyses. In particular, the effects of various approximations on the flow field are investigated. It is shown that the Navier-Stokes model consistently predicts a smaller region of disturbance upstream of a sphere than that in experiments.

Li, C. P.↗
NASA NTRS1974

Raman scattering applied to hypersonic air flow

The Raman scattering technique was applied to measure the local static temperature and gas number density over a sharp-edge flat-plate model in a Mach 5 nozzle of the Langley nozzle test chamber with air as the test gas. The angle of attack varied from -5 to 15 deg, and the stagnation temperature varied from 317 to 442 K, with stagnation pressures ranging from 170 kN to 2.8 MN/sq m. The measured values of static temperature and density ranged from 60 to 100 K and from 0.03 to 0.8 kg/cu m, respectively. A comparison with calculated values based on static pressure measurements along the model shows that the Raman scattering technique is a viable measurement method in applications to high-speed three-dimensional flows.

Hillard, M. E., Jr.↗
NASA NTRS1975

Correlation of boundary layer quantities for hypersonic laminar flows with zero pressure gradient for several gases

The laminar boundary layer has been theoretically studied for six gases for flows over cold walls with zero pressure gradient at Mach numbers between 5.5 and 12.5 to correlate boundary layer quantities for the various gases. The flow conditions considered correspond to those that can be generated in test facilities such as the shock tunnel and the expansion tube. Computed results obtained using real gas properties indicate that the Eckert number based on edge conditions serves to correlate the results in terms of the wall shear stress and enthalpy gradient, the Stanton number, and the momentum thickness for the various gases within plus or minus 10 per cent for Te = Tw and Te approximately 3Tw. Computed Reynolds analogy factors exhibit very good agreement with those predicted by the Colburn analogy. Velocity and displacement thicknesses correlate well with Eckert number for Te = Tw, but fail to correlate for Te approximately 3Tw. Differences in results are traced to property variations. Results show that the Eckert number is a significant correlating variable for the flows considered.

Cook, W. J.↗
NASA NTRS1977

Downstream influence of swept slot injection in hypersonic turbulent flow

Results of an experimental and numerical investigation of tangential swept slot injection into a thick turbulent boundary layer at Mach 6 are presented. Film cooling effectiveness, skin friction, and flow structure downstream of the swept slot injection were investigated. The data were compared with that for unswept slots, and it was found that cooling effectiveness and skin friction reductions are not significantly affected by sweeping the slot.

Hefner, J. N.↗
NASA NTRS1981

A numerical simulation of hypersonic viscous flow over arbitrary geometries at angle of attack

An implicit conservative, noniterative, finite-difference algorithm that predicts the supersonic, laminar or turbulent viscous flow about arbitrary geometries at large angles of attack is presented. The three-dimensional parabolized form of the thin-layer Navier-Stokes equations are written in generalized coordinates. These equations are solved using the delta form of the Beam-Warming implicit algorithm. Flow field simulations have been obtained for a blunt biconic with windward and leeward cuts and an X-24C lifting body for both laminar and turbulent flow at various Mach numbers and angles of attack. When compared with experiment or with previous theories, these computational predictions show good agreement.

Chaussee, D. S.↗
NASA NTRS1981

Computation of hypersonic viscous flow around three-dimensional bodies at high angles of attack

A parabolized Navier-Stokes code capable of predicting steady viscous supersonic flows with cross-flow separation is applied to three-dimensional arbitrary geometries at high angles of attack. The numerical procedure, which is implicit, noniterative, and of second-order accuracy in the marching direction, has been used to compute complicated flow fields containing a relatively thick sonic layer and regions of strong viscous-inviscid interaction. A consistent and accurate procedure has also been developed to provide the necessary starting data through timewise integration of the equations of motion near the nose-tip region of the body. Numerical results obtained from the present method compare well with experiment for both the surface pressures and heat transfer.

Rizk, Y. M.↗
NASA NTRS1986

Study of hypersonic inlet flow fields with a three-dimensional Navier-Stokes code

A three-dimensional Navier-Stokes code is used to study the flow through an inlet with a rectangular capture area, but with circular or essentially circular internal cross-sections. The inlet may have a center body extending partially or fully over the length of the inlet. Calculations are made under a variety of geometrical constraints imposed on the inlet cross-sections to study the flow quality in the inlet. It is observed that for this class of inlets, the boundary layer has a tendency to thicken and separate readily due to the adverse pressure gradient caused by the continuous compression in the inlet. Since no experimental results are yet available, this paper has presented only the numerical results from the present analysis.

Kumar, A.↗
NASA NTRS1986

Direct simulation of hypersonic transitional flow

A review of recent calculations obtained with Bird's direct simulation Monte Carlo (DSMC) method are presented for the transitional flowfield encountered at reentry conditions. Consequently, the emphasis is to simulate the real-gas effects resulting from a highly energetic nonequilibrium flow. The DSMC calculations for both wide-angle and slender bodies are compared with experimental and continuum calculations. The wide angle body calculations simulate the windward nose of the Shuttle Orbiter and projected aeroassisted orbital transfer vehicles. For the slender, blunted configurations, both two-dimensional and axisymmetric results are presented. Comparisons between the DSMC and continuum calculations show the altitude range where differences in flowfield structure and surface quantities become significant.

Moss, J. N.↗
NASA NTRS1987

Driving mechanism of unsteady separation shock motion in hypersonic interactive flow

Wall pressure fluctuations were measured under the steady separation shock waves in Mach 5 turbulent interactions induced by unswept circular cylinders on a flat plate. The wall temperature was adiabatic. A conditional sampling algorithm was developed to examine the statistics of the shock wave motion. The same algorithm was used to examine data taken in earlier studies in the Princeton University Mach 3 blowdown tunnel. In these earlier studies, hemicylindrically blunted fins of different leading-edge diameters were tested in boundary layers which developed on the tunnel floor and on a flat plate. A description of the algorithm, the reasons why it was developed and the sensitivity of the results to the threshold settings, are discussed. The results from the algorithm, together with cross correlations and power spectral density estimates suggests that the shock motion is driven by the low-frequency unsteadiness of the downstream separated, vortical flow.

Dolling, D. S.↗
NASA NTRS1986

Direct simulation of hypersonic transitional flow

A review of recent calculations obtained with Bird's direct simulation Monte Carlo (DSMC) method are presented for the transitional flowfield encountered at reentry conditions. Consequently, the emphasis is to simulate the real-gas effects resulting from a highly energetic nonequilibrium flow. The DSMC calculations for both wide-angle and slender bodies are compared with experimental and continuum calculations. The wide angle body calculations simulate the widward nose of the Shuttle Orbiter and projected aeroassisted orbital transfer vehicles. For the slender, blunted configurations, both two-dimensional and axisymmetric results are presented. Comparisons between the DSMC and continuum calculations show the altitude range where differences in flowfield structure and surface quantities become significant.

Moss, J. N.↗
NASA NTRS1989

Three dimensional PNS solutions of hypersonic internal flows with equilibrium chemistry

An implicit procedure for solving parabolized Navier-Stokes equations under the assumption of a general equation of state for a gas in chemical equilibrium is given. A general and consistent approach for the evaluation of Jacobian matrices in the implicit operator avoids the use of unnecessary auxiliary quantities and approximations, and leads to a simple expression. Applications to two- and three-dimensional flow problems show efficiency in computer time and economy in storage.

Liou, May-Fun↗
NASA NTRS1989

Hypersonic rarefied flow about plates at incidence

The direct-simulation Monte Carlo method has been used in a numerical study of the transitional flow about two plate configurations at incidence; one of the two plates, both of which are 12 m long, has zero thickness, while the other has a thickness of 0.5 m and a node radius of 0.5 m. The flow conditions simulated are those of the Space Shuttle Orbiter during 7.5 km/hr reentry, in the 200-100 km altitude range encompassing most of the transitional flow for this vehicle. The results obtained clearly demonstrate that transitional effects are significant even at those altitudes where the flow about a typical space vehicle has been considered free-molecular.

Dogra, Virendra K.↗