Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “feasibility”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 613 records · Page 34
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Solar-assisted gas-energy water-heating feasibility for apartments

Studies of residential energy use, solar-energy technology for buildings, and the requirements for implementing technology in the housing industry led to a project to develop a solar water heater for apartments. A design study for a specific apartment was used to establish a solar water-heater cost model which is based on plumbing contractor bids and manufacturer estimates. The cost model was used to size the system to minimize the annualized cost of hot water. The annualized cost of solar-assisted gas-energy water heating is found to be less expensive than electric water heating but more expensive than gas water heating. The feasibility of a natural gas utility supplying the auxiliary fuel is evaluated. It is estimated that gas-utilizing companies will find it profitable to offer solar water heating as part of a total energy service option or on a lease basis when the price of new base-load supplies of natural gas reaches $2.50-$3.00 per million Btu.

Davis, E. S.↗
NASA NTRS1975

Availability of a communications satellite - Requirement and feasibility

An estimated 45 communications satellites will be in geostationary orbit in the 1980s. Based on past history, half of the subsystem failures will be due to design failures. Methods now used to achieve present availabilities are summarized in this paper. To increase the availability of a single satellite to 99.99%, new techniques are needed; several possibilities are suggested herein. New developments, including nickel-hydrogen batteries, magnetic bearings, and solid-state amplifiers, are possible solutions to long standing problem areas in communications satellites. Launching a satellite two or three years before the system is needed is one way to reduce design failures in subsequent satellites. Diversity of manufacture can be used to obtain the maximum advantage from redundant elements. Finally, unmanned module exchange at geostationary orbit has been shown to be technically feasible.

Gordon, G. D.↗
NASA NTRS1976

Feasibility demonstration of a variable frequency driver-microwave transient regression rate measurement system

The feasibility of a system capable of rapidly and directly measuring the low-frequency (motor characteristics length bulk mode) combustion response characteristics of solid propellants has been investigated. The system consists of a variable frequency oscillatory driver device coupled with an improved version of the JPL microwave propellant regression rate measurement system. The ratio of the normalized regression rate and pressure amplitudes and their relative phase are measured as a function of varying pressure level and frequency. Test results with a well-characterized PBAN-AP propellant formulation were found to compare favorably with the results of more conventional stability measurement techniques.

Strand, L. D.↗
NASA NTRS1976

Feasibility of Coherent and Incoherent Backscatter Experiments from the AMPS Laboratory. Technical Section

A computer program simulated the spectrum which resulted when a radar signal was transmitted into the ionosphere for a finite time and received for an equal finite interval. The spectrum derived from this signal is statistical in nature because the signal is scattered from the ionosphere, which is statistical in nature. Many estimates of any property of the ionosphere can be made. Their average value will approach the average property of the ionosphere which is being measured. Due to the statistical nature of the spectrum itself, the estimators will vary about this average. The square root of the variance about this average is called the standard deviation, an estimate of the error which exists in any particular radar measurement. In order to determine the feasibility of the space shuttle radar, the magnitude of these errors for measurements of physical interest must be understood.

Mozer, F. S.↗
NASA NTRS1976

Fiscal year 1976 progress report on a feasibility study evaluating the use of surface penetrators for planetary exploration

The feasibility of employing penetrators for exploring Mars was examined. Eight areas of interest for key scientific experiments were identified. These include: seismic activity, imaging, geochemistry, water measurement, heatflow, meteorology, magnetometry, and biochemistry. In seven of the eight potential experiment categories this year's progress included: conceptual design, instrument fabrication, instrument performance evaluation, and shock loading of important components. Most of the components survived deceleration testing with negligible performance changes. Components intended to be placed inside the penetrator forebody were tested up to 3,500 g and components intended to be placed on the afterbody were tested up to 21,000 g. A field test program was conducted using tentative Mars penetrator mission constraints. Drop tests were performed at two selected terrestrial analog sites to determine the range of penetration depths for anticipated common Martian materials. Minimum penetration occurred in basalt at Amboy, California. Three full-scale penetrators penetrated 0.4 to 0.9 m into the basalt after passing through 0.3 to 0.5 m of alluvial overburden. Maximum penetration occurred in unconsolidated sediments at McCook, Nebraska. Two full-scale penetrators penetrated 2.5 to 8.5 m of sediment. Impact occurred in two kinds of sediment: loess and layered clay. Deceleration g loads of nominally 2,000 for the forebody and 20,000 for the afterbody did not present serious design problems for potential experiments. Penetrators have successfully impacted into terrestrial analogs of the probable extremes of potential Martian sites.

Blanchard, M. B.↗
NASA NTRS1977

Feasibility study of automatic control of crew comfort in the shuttle Extravehicular Mobility Unit

Computer simulation is used to demonstrate that crewman comfort can be assured by using automatic control of the inlet temperature of the coolant into the liquid cooled garment when input to the controller consists of measurements of the garment inlet temperature and the garment outlet temperature difference. Subsequent tests using a facsimile of the control logic developed in the computer program confirmed the feasibility of such a design scheme.

Cook, D. W.↗
NASA NTRS1976

Feasibility study of modern airships, phase 2. Volume 2: Airport feeder vehicle

The Airport Feeder vehicle is a VTOL, semi-buoyant ellipsoidal airship capable of transporting passengers or cargo to major CTOL hub terminals from suburban and downtown depots. Six tasks were reviewed: (1) vehicle design definition, (2) operational procedures analysis, (3) cost analysis, (4) comparison with alternate transportation modes, (5) mission/vehicle feasibility assessment, and (6) technology assessment.

Source record↗
NASA NTRS1976

Scintillating plastic fibers as light pipes for a cosmic ray hodoscope: Feasibility calculations and measured attenuation characteristics

A candidate hodoscope uses arrays of scintillator fibers, followed by an image intensifier and imaging system such as that proposed for the X-ray shadowgraph. A literature search was performed to ascertain the experience of other workers with hodoscopes using this or similar principles. Calculations were performed to determine the feasibility of candidate systems and some laboratory experiments were performed to attempt to check these numbers.

Source record↗
NASA NTRS1975

F-8 oblique wing structural feasibility study

The feasibility of fitting a rotating oblique wing on an F-8 aircraft to produce a full scale manned prototype capable of operating in the transonic and supersonic speed range was investigated. The strength, aeroelasticity, and fatigue life of such a prototype are analyzed. Concepts are developed for a new wing, a pivot, a skewing mechanism, control systems that operate through the pivot, and a wing support assembly that attaches in the F-8 wing cavity. The modification of the two-place NTF-8A aircraft to the oblique wing configuration is discussed.

Koltko, E.↗
NASA NTRS1977

Feasibility analysis of gravitational experiments in space

Experiments on gravitation and general relativity suggested by different workers in the past ten or more years are reviewed, their feasibility examined, and the advantages of performing them in space were studied. The experiments include: (1) the gyro relativity experiment; (2) experiments to test the equivalence of gravitational and inertial mass; (3) an experiment to look for nongeodesic motion of spinning bodies in orbit around the earth; (4) experiments to look for changes of the gravitational constant G with time; (5) a variety of suggestions; laboratory tests of experimental gravity; and (6) gravitational wave experiments.

Everitt, C. W. F.↗
NASA NTRS1977

Feasibility study of microprocessor systems suitable for use in developing a real-time for the 4.75 GHz scatterometer

A class of signal processors suitable for the reduction of radar scatterometer data in real time was developed. The systems were applied to the reduction of single polarized 13.3 GHz scatterometer data and provided a real time output of radar scattering coefficient as a function of incident angle. It was proposed that a system for processing of C band radar data be constructed to support scatterometer system currently under development. The establishment of a feasible design approach to the development of this processor system utilizing microprocessor technology was emphasized.

Source record↗
NASA NTRS1971

The 2-8 GHz solar dynamic spectra and polarization measurement feasibility study

The preliminary system design of a Solar Microwave Spectrograph (SMS) is presented. This design resulted from a study to determine the feasibility of measuring solar polarization and dynamic spectra over the range of two to eight GHz, using broadband radio frequency instrumentation and rapid recording equipment in conjunction with radio telescopes. The scientific value of the proposed SMS instrument is discussed, with remarks concerning data reduction and analysis and a presentation of the engineering plan to implement the SMS system.

Haddock, F. T.↗
NASA NTRS1976

A preliminary assessment of the feasibility of deriving liquid and gaseous fuels from grown and waste organics

An estimate is obtained of the yearly supply of organic material for conversion to fuels, the energy potential is evaluated, and the fermentation and pyrolysis conversion processes are discussed. An investigation is conducted of the estimated cost of fuel from organics and the conclusions of an overall evaluation are presented. It is found that climate, land availability and economics of agricultural production and marketing, food demand, fertilizer shortage, and water availability combine to cast doubts on the feasibility of producing grown organic matter for fuel, in competition with food, feed, or fiber. Less controversial is the utilization of agricultural, industrial, and domestic waste as a conversion feedstock. The evaluation of a demonstration size system is recommended.

Graham, R. W.↗
NASA NTRS1976

Feasibility of a second-order gravitational red-shift experiment

The number of gravitation experiments undertaken since the advent of Einstein's theory of gravitation is quite small, with, so far, only the famous perihelion-advance experiment and a recent lunar-laser-ranging experiment being capable of measuring a nonlinear, second-order effect. It now appears that another distinct test of the second-order term may be feasible through the use of very stable atomic clocks. This experiment, which would measure the second-order gravitational red-shift, is a bona fide test of the field equations of gravity, not just a test of the underlying principle of equivalence. The nature of such an experiment, the basic equations, model-orbit calculations, and some tracking-accuracy requirements are presented. It is concluded that current space-probe tracking capabilities cannot determine all the necessary orbital parameters with sufficient accuracy for this experiment at the present time.

Jaffe, J.↗
NASA NTRS1977

Feasibility study of modern airships. Phase 2: Executive summary

A feasibility study of modern airships has been completed. Three promising modern airship systems' concepts and their associated missions were studied; (1) a heavy-lift airship, employing a non-rigid hull and a significant amount of rotor lift, used for short-range transport and positioning of heavy military and civil payloads, (2) a VTOL (vertical take-off and landing), metalclad, partially buoyant airship used as a short-haul commercial transport; and (3) a class of fully-buoyant airships used for long-endurance Navy missions. The heavy-lift airship concept offers a substantial increase in vertical lift capability over existing systems and is projected to have lower total operating costs per ton-mile. The VTOL airship transport concept appears to be economically competitive with other VTOL aircraft concepts but can attain significantly lower noise levels. The fully-buoyant airship concept can provide an airborne platform with long endurance that satisfies many Navy mission requirements.

Source record↗
NASA NTRS1973

Feasibility study of an Integrated Program for Aerospace vehicle Design (IPAD). Volume 1A: Summary

IPAD was defined as a total system oriented to the product design process. This total system was designed to recognize the product design process, individuals and their design process tasks, and the computer-based IPAD System to aid product design. Principal elements of the IPAD System include the host computer and its interactive system software, new executive and data management software, and an open-ended IPAD library of technical programs to match the intended product design process. The basic goal of the IPAD total system is to increase the productivity of the product design organization. Increases in individual productivity were feasible through automation and computer support of routine information handling. Such proven automation can directly decrease cost and flowtime in the product design process.

Miller, R. E., Jr.↗