Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Specific impulse”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 613 records · Page 34
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Solar rocket system concept analysis

The use of solar energy to heat propellant for application to Earth orbital/planetary propulsion systems is of interest because of its performance capabilities. The achievable specific impulse values are approximately double those delivered by a chemical rocket system, and the thrust is at least an order of magnitude greater than that produced by a mercury bombardment ion propulsion thruster. The primary advantage the solar heater thruster has over a mercury ion bombardment system is that its significantly higher thrust permits a marked reduction in mission trip time. The development of the space transportation system, offers the opportunity to utilize the full performance potential of the solar rocket. The requirements for transfer from low Earth orbit (LEO) to geosynchronous equatorial orbit (GEO) was examined as the return trip, GEO to LEO, both with and without payload. Payload weights considered ranged from 2000 to 100,000 pounds. The performance of the solar rocket was compared with that provided by LO2-LH2, N2O4-MMH, and mercury ion bombardment systems.

Boddy, J. A.↗
NASA NTRS1980

Advanced concepts

The relative strengths of those interactions which enable propulsive forces are listed as well as the specific impulse of various propellants. Graphics show the linear synchronous motor of the mass driver, the principle of the direct current electromagnetic launcher, and the characteristics of the rail gun.

Banks, B. A.↗
NASA NTRS1980

A preliminary assessment of the impact of 2-D exhaust-nozzle geometry on the cruise range of a hypersonic aircraft with top-mounted ramjet propulsion

A theoretical study of full length and shortened, two dimensional, isentropic, exhaust nozzles integrated with top mounted ramjet propulsion nacelles were conducted. Both symmetric and asymmetric contoured nozzles with a range of angular orientations were considered. Performance comparisons to determine optimum installations for a representative hypersonic vehicle at Mach 5 cruise conditions are presented on the basis of cruise range, propulsive specific impulse, inlet area requirements, and overall lift drag ratio. The effect of approximating the nozzle internal contours with planar surfaces and the determination of viscous and frozen flow effects are also presented.

Vahl, W. A.↗
NASA NTRS1979

Characteristics of primary electric propulsion systems

The use of advanced electric propulsion systems will provide cost and performance benefits for future energetic space missions. A methodology to predict the characteristics of advanced electric propulsion systems was developed and programmed for computer calculations to allow evaluation of a broad set of technology and mission assumptions. The impact on overall thrust system characteristics was assessed for variations of propellant type, total accelerating voltage, thruster area, specific impulse, and power system approach. The data may be used both to provide direction to technology emphasis and allow for preliminary estimates of electric propulsion system properties for a wide variety of application.

Byers, D. C.↗
NASA NTRS1979

The MPD thruster development program

Recent research results have inferred that the self-field magnetoplasmadynamic (MPD) thruster can attain efficiency and specific impulse levels which are competitive with ion thrusters. Based on these results, a program was initiated at JPL to develop this thruster for application on future spacecraft. Preliminary mission analyses have shown that the high thrust density MPD arcjet is advantageous for high power missions, such as a short trip time earth orbit transfer vehicle or a nuclear powered outer planet explorer. Direct thrust stand verification of the inferred performance levels used in these analyses is planned for a facility being assembled at Princeton University. A parallel effort at JPL is considering various thruster system configurations, energy storage concepts and propellant control techniques. In addition, a one pulse per second thruster test facility is planned at JPL to be used for thruster optimization studies including erosion and lifetime measurements.

Rudolph, L. K.↗
NASA NTRS1980

Technology status of a liquid fluorine-hydrazine rocket engine for a planetary spacecraft propulsion system

This paper discusses the current status of a fluorine-hydrazine rocket engine development program. Incorporation of a thin rhenium inner liner successfully eliminated corrosion of the carbon/carbon composite thrust chamber wall experienced during a previous test program. The results of hot-fire tests utilizing reworked and new injectors which provide increased fuel film cooling showed that thrust chamber head-end temperatures could be maintained at an acceptable level. As expected, the accompanying specific impulse performance loss requires optimizing the amount of film cooling to minimize the loss. The efforts to refine the rhenium liner vapor deposition process culminated in a carbon/carbon composite thrust chamber total test duration of 1008 seconds. Tasks presently in process include: (1) fabrication of two carbon/carbon composite thrust chambers incorporating 60:1 expansion ratio nozzles; (2) injector tests to optimize performance and cooling; (3) additional refinements to the rhenium lining process; and (4) fabrication and test of a freestanding rhenium thrust chamber.

Appel, M. A.↗
NASA NTRS1980

Applications of an MPD propulsion system

Recent studies of the self-field magnetoplasmadynamic (MPD) thruster indicate that the attainable value of thrust efficiency can be over 50% with argon propellant at 5000 sec. Projections for hydrogen propellant show that the specific impulse may exceed 10,000 sec. Improving performance projections such as these create a need for systems and applications studies to be updated. This paper reviews the configurations for an MPD propulsion system and those missions on which such a system might find application. An MPD propulsion system could be used for: (1) attitude control and stationkeeping of large space structures, (2) interorbit transportation, and (3) interplanetary propulsion. A trajectory analysis of a Saturn Orbiter using a nuclear power supply and an MPD propulsion system is presented. A LEO to GEO MPD-OTV concept is presented that uses a remote source transmitting power to the OTV in the form of microwaves. Trajectory analysis of this latter concept indicates that a payload of 20,000 kg can be delivered to GEO in about 20 days if the MPD propulsion system receives 20 MW of input power.

Jones, R. M.↗
NASA NTRS1981

Electromagnetic interference assessment of an ion drive electric propulsion system

An electric propulsion thrust system has the capability of providing a high specific impulse for long duration scientific missions in space. The EMI from the elements of an ion engine was characterized. The compatibility of ion drive electric propulsion systems with typical interplanetary spacecraft engineering was predicted.

Whittlesey, A. C.↗
NASA NTRS1981

Performance capabilities of the 8-cm mercury ion thruster

A preliminary characterization of the performance capabilities of the 8-cm thruster in order to initiate an evaluation of its application to LSS propulsion requirements is presented. With minor thruster modifications, the thrust was increased by about a factor of four while the discharge voltage was reduced from 39 to 22 volts. The thruster was operated over a range of specific impulse of 1950 to 3040 seconds and a maximum total efficiency of about 54 percent was attained. Preliminary analysis of component lifetimes, as determined by temperature and spectroscopic line intensity measurements, indicated acceptable thruster lifetimes are anticipated at the high power level operation.

Mantenieks, M. A.↗
NASA NTRS1981

Extended operating range of the 30-cm ion thruster with simplified power processor requirements

A two grid 30 cm diameter mercury ion thruster was operated with only six power supplies over the baseline J series thruster power throttle range with negligible impact on thruster performance. An analysis of the functional model power processor showed that the component mass and parts count could be reduced considerably and the electrical efficiency increased slightly by only replacing power supplies with relays. The input power, output thrust, and specific impulse of the thruster were then extended, still using six supplies, from 2660 watts, 0.13 newtons, and 2980 seconds to 9130 watts, 0.37 newtons, and 3820 seconds, respectively. Increases in thrust and power density enable reductions in the number of thrusters and power processors required for most missions. Preliminary assessments of the impact of thruster operation at increased thrust and power density on the discharge characteristics, performance, and lifetime of the thruster were also made.

Rawlin, V. K.↗
NASA NTRS1981

Performance of large inert-gas thrusters

The performance of large inert-gas thrusters is predicted based on present knowledge of ion optics performance and discharge chamber operation. Calculated performance data are given for argon and xenon propellants. The effect of varying propellant utilization and thruster diameter is discussed and the optimum choice of beam diameter for very large systems is indicated for low, intermediate, and high specific impulses. Optimum discharge chamber depths are also specified. Although detailed design considerations may modify the predictions, the general trends indicated should still be useful for directing future technology efforts and evaluating mission studies involving large thrusters.

Kaufman, H. R.↗
NASA NTRS1981

Performance capabilities of the 8-cm Mercury ion thruster

The paper presents an initial characterization of the performance capabilities and constraints of the 8-cm Hg ion thruster system with a view to evaluating its application to large space system propulsion requirements. With minor thruster modifications, the thrust was increased by about a factor of four, while the discharge voltage was reduced from 39 to 22 volts. The thruster was operated over a range of specific impulse of 1950 to 3040 seconds, and a maximum total efficiency of about 54% was attained at a discharge voltage of 24 volts and thruster input power of 0.49 kW.

Mantenieks, M. A.↗
NASA NTRS1981

An evaluation of nuclear electric propulsion for planetary exploration missions

A set of nuclear electric propulsion (NEP) system parameters for planetary exploration missions is described. Orbiter missions to the planets Saturn, Uranus and Neptune were selected for assessment, and five delivery modes were evaluated. The NEP system envisioned for this application consisted of a nuclear fission reactor with a thermoelectric conversion system and a thrust subsystem comprised of power processors coupled with mercury ion-bombardment thrusters. The results indicate that an NEP system sized at 90-160 kW electrical power rating and operating within a specific impulse range of 4500-5500 sec provides adequate performance for outer planet exploration.

Nagorski, R. P.↗
NASA NTRS1981

Spacecraft mission and shielding thermal study for a space-storable fluorine-hydrazine propulsion system

The thermal management and shielding problems related to a space-storable fluorine-hydrazine propulsion system are investigated. The general configuration of a space storable propulsion spacecraft and three types of shield configurations are described in detail. An advanced MLI shielding design is proposed showing good agreement with test data. All examined shield configurations were found to be acceptable for inner as well as outer planetary missions. However, for the latter small local heaters may be required to maintain the fluorine above a minimum required temperature of approximately -350 F. The fluorine/hydrazine system with a 25 percent higher specific impulse than the conventionally used propulsion systems, was suggested for interplanetary missions that require substantial velocity changes.

Jones, J. A.↗
NASA NTRS1981

Space Shuttle SRM performance improvement

A number of options for Solid Rocket Motor (SRM) performance improvement were studied and evaluated by NASA with respect to payload improvement potential, technical risk, schedule, cost, and impact on Shuttle system performance. It was found that the SRM delivered specific impulse could be improved by increasing the nozzle expansion ratio from 7.16 to 7.72. This was achieved by decreasing the throat diameter of the nozzle exit cone, while staying within tooling, facility, and ICD limitations. A simple modification of the grain inhibiting pattern was made to reshape the thrust-time history and thereby obtain more delivered impulse during the early portion of motor operation. These performance options, initiated in October 1980, provide a 3,000 lb payload increase. Longer range options are the use of a filament wound composite case, a HTPB propellant, and further increases in the nozzle expansion ratio. These improvements have a potential of 10,000 to 11,000 lb payload increase.

Speak, C. A.↗
NASA NTRS1981

Space Shuttle main engine progress through the first flight

A system overview is presented for the Space Shuttle Main Engine (SSME), and extensive performance comparisons are made with the Saturn V booster powerplant showing (1) staged-combustion turbopump pressures of 7,500 vs 1,100 psi for the Saturn V first stage; (2) a specific impulse of 455 vs 300; (3) power density of 100 vs 20 hp/lb; and (4) chamber pressures of 3200 vs 1000 psia. An account is then given of the SSME testing program, engine certification process and flight aboard the Space Shuttle Columbia, with attention to anomalies detected during flight in turbopump operation and mixture ratio sensor function.

Johnson, J. R.↗