Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Finite-differences”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 613 records · Page 34
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Interface procedures for overlapping grids

The solution of partial differential equations by means of either implicit or conservative explicit finite-difference methods, on the one hand, or multicomponent overlapping grid schemes on the other, is presently subjected to interpolation at grid boundaries in an attempt to eliminate the time lag. The accuracy of the transient solution of a hyperbolic or parabolic partial differential equation is dependent on the procedures used to transfer information between grids in a composite grid system. The present techniques reduce numerical solution errors.

Mastin, C. Wayne↗
NASA NTRS1986

A computational/experimental study of the flow around a body of revolution at angle of attack

The incompressible Navier-Stokes equations are numerically solved for steady flow around an ogive-cylinder (fineness ration 4.5) at angle of attack. The three-dimensional vortical flow is investigated with emphasis on the tip and the near wake region. The implicit, finite-difference computation is performed on the CRAY X-MP computer using the method of pseudo-compressibility. Comparisons of computational results with results of a companion towing tank experiment are presented for two symmetric leeside flow cases of moderate angles of attack. The topology of the flow is discussed and conclusions are drawn concerning the growth and stability of the primary vortices.

Zilliac, Gregory G.↗
NASA NTRS1947

Determination of elastic stresses in gas-turbine disks

A method is presented for the calculation of elastic stresses in symmetrical disks typical of those of a high-temperature gas turbine. The method is essentially a finite-difference solution of the equilibrium and compatibility equations for elastic stresses in a symmetrical disk. Account can be taken of point-to-point variations in disk thickness, in temperature, in elastic modulus, in coefficient of thermal expansion, in material density, and in Poisson's ratio. No numerical integration or trial-and-error procedures are involved and the computations can be performed in rapid and routine fashion by nontechnical computers with little engineering supervision. Checks on problems for which exact mathematical solutions are known indicate that the method yields results of high accuracy. Illustrative examples are presented to show the manner of treating solid disks, disks with central holes, and disks constructed either of a single material or two or more welded materials. The effect of shrink fitting is taken into account by a very simple device.

Manson, S S↗
NASA NTRS1950

Direct method of design and stress analysis of rotating disks with temperature gradient

A method is presented for the determination of the contour of disks, typified by those of aircraft gas turbines, to incorporate arbitrary elastic-stress distributions resulting from either centrifugal or combined centrifugal and thermal effects. The specified stress may be radial, tangential, or any combination of the two. Use is made of the finite-difference approach in solving the stress equations, the amount of computation necessary in the evolution of a design being greatly reduced by the judicious selection of point stations by the aid of a design chart. Use of the charts and of a preselected schedule of point stations is also applied to the direct problem of finding the elastic and plastic stress distribution in disks of a given design, thereby effecting a great reduction in the amount of calculation. Illustrative examples are presented to show computational procedures in the determination of a new design and in analyzing an existing design for elastic stress and for stresses resulting from plastic flow.

Manson, S S↗
NASA NTRS1985

An Algorithm for Efficient Maximum Likelihood Estimation and Confidence Interval Determination in Nonlinear Estimation Problems

An algorithm for maximum likelihood (ML) estimation is developed with an efficient method for approximating the sensitivities. The algorithm was developed for airplane parameter estimation problems but is well suited for most nonlinear, multivariable, dynamic systems. The ML algorithm relies on a new optimization method referred to as a modified Newton-Raphson with estimated sensitivities (MNRES). MNRES determines sensitivities by using slope information from local surface approximations of each output variable in parameter space. The fitted surface allows sensitivity information to be updated at each iteration with a significant reduction in computational effort. MNRES determines the sensitivities with less computational effort than using either a finite-difference method or integrating the analytically determined sensitivity equations. MNRES eliminates the need to derive sensitivity equations for each new model, thus eliminating algorithm reformulation with each new model and providing flexibility to use model equations in any format that is convenient. A random search technique for determining the confidence limits of ML parameter estimates is applied to nonlinear estimation problems for airplanes. The confidence intervals obtained by the search are compared with Cramer-Rao (CR) bounds at the same confidence level. It is observed that the degree of nonlinearity in the estimation problem is an important factor in the relationship between CR bounds and the error bounds determined by the search technique. The CR bounds were found to be close to the bounds determined by the search when the degree of nonlinearity was small. Beale's measure of nonlinearity is developed in this study for airplane identification problems; it is used to empirically correct confidence levels for the parameter confidence limits. The primary utility of the measure, however, was found to be in predicting the degree of agreement between Cramer-Rao bounds and search estimates.

Murphy, Patrick Charles↗
NASA NTRS1980

Fast, Conservative Algorithm for Solving the Transonic Full-Potential Equation

A fast, fully implicit approximate factorization algorithm designed to solve the conservative, transonic, full-potential equation in either two or three dimensions is described. The algorithm uses an upwind bias of the density coefficient for stability in supersonic regions. This provides an effective upwind difference of the streamwise terms for any orientation of the velocity vector (i.e., rotated differencing), thereby greatly enhancing the reliability of the present algorithm. A numerical transformation is used to establish an arbitrary body-fitted, finite-difference mesh. Computed results for both airfoils and simplified wings demonstrate substantial improvement in convergence speed for the new algorithm relative to standard successive-line over-relaxation algorithms.

Holst, Terry L.↗
NASA NTRS1981

Two-Dimensional Inlet Simulation Using a Diagonal Implicit Algorithm

A modification of an implicit approximate-factorization finite-difference algorithm applied to the two-dimensional Euler and Navier-Stokes equations in general curvilinear coordinates is presented for supersonic freestream flow about and through inlets. The modification transforms the coupled system of equations Into an uncoupled diagonal form which requires less computation work. For steady-state applications the resulting diagonal algorithm retains the stability and accuracy characteristics of the original algorithm. Solutions are given for inviscid and laminar flow about a two-dimensional wedge inlet configuration. Comparisons are made between computed results and exact theory.

Chaussee, D.S.↗
NASA NTRS1961

Cross-Sectional Deformations of Monocoque Beams and Their Effects on the Natural Vibration Frequencies

The variational principle, differential equations, and boundary conditions governing the cross-sectional distortions due to inertia loading of a two-dimensional model of a thin monocoque wing are shown. A theoretical analysis of this simplified model is made in order to determine the nature of the coupling between the cross-sectional modes and the spanwise deformation modes. General solutions are obtained in finite-difference form for arbitrary cross sections and an exact solution is presented for a parabolic-arc cross section of constant cover thickness. The application of these results in evaluating the coupled frequencies of the actual structure is discussed. Frequencies evaluated for a parabolic-arc monocoque beam show good agreement with experimental values.

Thomson, Robert G.↗
NASA NTRS1981

Calculation of Unsteady Transonic Flow over an Airfoil

An implicit finite-difference solver for either the Euler equations or the "thin-layer" Navier-Stokes equations was used to calculate a transonic flow over the NACA 64A010 airfoil pitching about its one-quarter chord. An unsteady automatic grid-generation procedure that will improve significantly the computational efficiency of various unsteady flow problems is described. The calculated results for both inviscid and viscous flows at Much number 0.8 over the airfoil oscillating with reduced frequency referenced to one-half chord, 0.2, are compared with experimental data measured in the Ames 11 x 11-ft Transonic Wind Tunnel. Nonlinear, unsteady effects of the flow on the surface pressure variations, shock-wave excursions, and overall airloads are examined. Good agreements between the results of computations and experiments were obtained. In the shock-wave region, however, the results of the viscous-flow computations showed closer agreement with the experimental data.

Chyu, W. J.↗
NASA NTRS1981

Calculation of Unsteady Transonic Flow Over an Airfoil

An implicit finite-difference solver for either the Euler equations or the "thin-layer" Navier-Stokes equations was used to calculate a transonic flow over the NACA 64A010 airfoil pitching about its one-quarter chord. An unsteady automatic grid-generation procedure that will improve significantly the computational efficiency of various unsteady flow problems is described. The calculated results for both inviscid and viscous flows at Mach number 0.8 over the airfoil oscillating with reduced frequency referenced to one-half chord, 0.2, are compared with experimental data measured in the Ames 11 x 11 ft Transonic Wind Tunnel. Nonlinear, unsteady effects of the flow on the surface pressure variations, shock-wave excursions, and overall airloads are examined. Good agreements between the results of computations and experiments were obtained. In the shock-wave region, however, the results of the viscous-flow computations showed closer agreement with the experimental data.

Chyu, W. J.↗
NASA NTRS1981

Nonreflecting Far-Field Boundary Conditions for Unsteady Transonic Flow Computation

The approximate nonreflecting far-field boundary condition, as proposed by Engquisi and Majda, is implemented In the computer code LTRAN2. This code solves the Implicit finite-difference representation of the small-disturbance equations for unsteady transonic flows about airfoils. The nonreflecting boundary condition and the description of the algorithm for Implementing these conditions In LTRAN2 tire discussed. Various cases re computed and compared with results from the older, more conventional procedures. One concludes that the nonreflecting far-field boundary approximation allows the far-field boundary to be located closer to the airfoil; this permits a decrease in the computer lime required to obtain the solution through the use of fewer mesh points.

Kwak, D.↗
NASA NTRS1986

The Critical Role of Computational Fluid Dynamics in Rotary-Wing Aerodynamics

Helicopter rotor aerodynamics is basically the study of unsteady aerodynamic flows in a rotating and translating coordinate system. Current trends in this field are briefly reviewed by examining recent advances in lifting-surface theory, wake modeling, panel methods, and finite-difference models' Examples are used to illustrate selected current methods and some indications of promising future directions are highlighted.

Davis, Sanford S.↗
NASA NTRS1986

A Conservation Treatment of Zonal Boundaries for Euler Equation Calculations

Finite-difference calculations require the generation of a grid for the region of interest. A zonal approach, wherein the given region is subdivided into zones and the grid for each zone is generated independently, makes the grid-generation process for complicated topologies and for regions requiring selective grid refinement a fairly simple task. This approach results in new boundaries within the given region, that is, zonal boundaries at the interfaces of the various zones. The zonal-boundary scheme (the integration scheme used to update the points on the zonal boundary) for the Euler equations must be conservative, accurate, stable, and applicable to general curvilinear coordinate systems. A zonal-boundary scheme with these desirable properties is developed in this study. The scheme is designed for explicit, first-order-accurate integration schemes but can be modified to accommodate second-order-accurate explicit and implicit integration schemes. Results for inviscid flow, including supersonic flow over a cylinder, blast-wave diffraction by a ramp, and one-dimensional shock-tube flow are obtained on zonal grids. The conservative nature of the zonal-boundary scheme permits the smooth transition of the discontinuities associated with these flows from one zone to another. The calculations also demonstrate the continuity of contour lines across zonal boundaries that can be achieved with the present zonal scheme.

Rai, Man Mohan↗
NASA NTRS1984

The Prediction of Transonic Flows on an Advancing Rotor

The object of this investigation was to find and demonstrate a means of performing efficient finite-difference computations of rotor loading for a trimmed rotor in high-speed, forward flight. The essence of the scheme that was developed is a loose-coupled iteration procedure between a finite difference and a comprehensive integral rotor code. The coupling involves a transfer of appropriate load and inflow data on the advancing side between the two codes such that consistency maintained. Sample computations, including a limited comparison with model rotor data, are presented. The scheme converges rapidly. However, even one iteration with this scheme can provide sufficient accuracy for many purposes.

Tung, Chee↗
NASA NTRS1975

Advances in Application of Fast Semidirect Computational Methods in Transonic Flow

This paper is intended as a review and summary of the advances made in a recently developed approach for rapid numerical solution of the equations of inviscid transonic aerodynamics. The investigation has been limited to two-dimensional, steady, inviscid flow over airfoils in a subsonic free stream, with emphasis on development of a rapid computational technique, rather than on generality of application. The approach uses finite-difference algorithms called "fast direct elliptic solvers" within an iteration scheme. "Direct" means that the entire computation field is solved at once, rather than in successive traverses over the field as in a point- or line-relaxation method. Such an iterative method is referred to as "semidirect." The iterative convergence can be faster than in other relaxation methods because changes are felt simultaneously at all points in each succeeding iteration. Direct elliptic solvers and semidirect methods have restrictions, but these are gradually being removed. Direct solvers were first developed for solving Poisson's equation on a rectangle without interior boundaries. A method to treat first-order systems, a direct Cauchy-Riemann solver has also been developed. Numerical treatment of part of a system of nonlinear equations by a Poisson solver has been reported. Also Poisson solvers in semidirect methods were used for nonseparable elliptic equations. The semidirect method was extended to the solution of a problem of mixed type, where the improved Murman-Cole transonic small-disturbance difference equations were solved. A slightly supercritical flow over a biconvex airfoil was treated successfully, but the iterations did not converge for more strongly supercritical conditions In another work the addition of terms ot both sides of the difference equations stabilized the iteration for supercritical conditions with large supersonic zones. For this, the Cauchy-Riemann solver was revised to incl,ude the needed terms. Most recently, the evaluation of parameters for rapid convergence and comparisons, with Murman's line-relaxation method was described. The method was extended to full second order accuracy in a fully conservative formulation in another work.

Martin, E. Dale↗
NASA NTRS1986

Applications of a Conservative Zonal Scheme to Transient and Geometrically Complex Problems

A conservative zoning technique, wherein the flow field for a finite-difference calculation is divided into several regions to simplify grid generation, is discussed and is applied in the solution of a two-dimensional problem of complex topology. Calculations are performed on two zonal, or patched, grid systems for the supersonic flow over a double-airfoil configuration. The solution is smooth and continuous across the zonal interfaces, and shock waves pass through the boundaries without distortion. In addition, the time accuracy of the zonal boundary method is verified by a two-zone cylinder calculation with a stationary inner and a rotating outer mesh. The feasibility of the zonal approach for use in the solution of geometrically complex and unsteady problems is thus demonstrated.

Hessenius, Kristin A.↗