Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “control stability”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 595 records · Page 33
All sourcesNASA NTRSDOE OSTI
NASA NTRS1946

Flight Measurements of the Directional Stability and Control of a P-51D Airplane with a Horn-Balanced Rudder as Compared with Previously Tested Vertical-Tail Configurations

At the request of the Air Materiel Command, Army Air Forces, flight tests were conducted on a P-5lD-20-NA (AAF No. 44-63826) airplane equipped with a horn-balanced rudder. This rudder was fitted with an unbalancing tab as was the original product fan rudder. Tests were made both with the unbalancing tab in operation and with the unbalancing tab locked. The modification to the original vertical tail consisted of removing the cap from the top of the fin and adding 1.91 square feet of area to the rudder as the horn balance and 0.82 square foot of area to the top of the rudder aft of the hinge line. A comparison of the directional stability and control characteristics of the P-51D airplane with three different vertical-tail configurations - the horn balance, original production, and extended tail (with unbalancing tab locked) configurations are presented herein. The tests of the horn-balanced rudder were conducted at the Langley Laboratory in 1945. The tests of the original-tail configuration were previously conducted at the Ames Aeronautical Laboratory. Tests of the extended-tail configuration were conducted at the Langley Laboratory and are reported.

Mungall, Robert G.↗
NASA NTRS1978

Orbiting Astronomical Observatory (OAO-A2) stabilization and control subsystem

The OAO was successfully operating for approximately 11 months and has made over 2500 stellar observations. The OAO control system was a complex system which takes the 4500-lb vehicle through initial stabilization to star tracker control where a pointing accuracy of less than 1 arc minute was achieved. To obtain this pointing accuracy, the system used six orthogonally mounted gimbaled star trackers. The trackers were two gimbaled devices, having a 1-deg field of view with a + or - 43 deg gimbal excursion. The tracker could recognize and track 2.0 magnitude stars or brighter. The flight results indicated spacecraft pointing accuracies of less than 1 arc minute after tracker calibration with spacecraft jitter less than 3 arc seconds.

Huber, T. E.↗
NASA NTRS1974

Pressure activated stability-bypass-control valves to increase the stable airflow range of a Mach 2.5 inlet with 40 percent internal contraction

The throat of a Mach 2.5 inlet with a coldpipe termination was fitted with a stability-bypass system. The inlet stable airflow range provided by various stability-bypass entrance configurations in alternate combination with several stability-bypass exit controls was determined for both steady-state conditions and internal transient pulses. Transient results were also obtained for the inlet with a choke point at the diffuser exit. Instart angles of attack were determined for the various stability-bypass entrance configurations. The response of the inlet-coldpipe system to internal and external oscillating disturbances was determined. Poppet valves at the stability-bypass exit provided an inlet stable airflow range of 28 percent or greater at all static and transient conditions.

Mitchell, G. A.↗
NASA NTRS1976

Theoretical Stability and Control Characteristics of Wings With Various Amounts of Taper and Twist

Stability derivatives have been computed for twisted wings of different planforms that include variations in both the wing taper and the aspect ratio. Taper ratios of 1.0, 0.50, and 0.25 are considered for each of three aspect ratios: 6, 10, and 16. The specific derivatives for which results are given are the rolling moment and the yawing moment derivatives with respect to rolling velocity, yawing velocity, and angle of sideslip. In addition to the stability derivatives, results are included for determining the theoretical rolling moment due to aileron deflection and a series of influence lines is given by which the loading across the span may be determined for any angle-of-attack distribution that may occur on the wing planforms considered.

Henry A Pearson↗
NASA NTRS1938

Theoretical stability and control characteristics of wings with various amounts of taper and twist

Stability derivatives have been computed for twisted wings of different plan forms that include variations in both the wing taper and the aspect ratio. Taper ratios of 1.0, 0,50, and 0.25 are considered for each of three aspect ratios: 6, 10, and 16. The specific derivatives for which results are given are the rolling-moment and the yawing-moment derivatives with respect to (a) rolling velocity, (b) yawing velocity, and (c) angle of sideslip. These results are given in such a form that the effect of any initial symmetrical wing twist (such as may be produced by flaps) on the derivatives may easily be taken into account. In addition to the stability derivatives, results are included for determining the theoretical rolling moment due to aileron deflection and a series of influence lines is given by which the loading across the span may be determined for any angle-of-attack distribution that may occur on the wing plan forms considered. The report also includes incidental references to the application of the results.

Pearson, Henry A↗
NASA NTRS1992

Control and stabilization of nonholonomic dynamic systems

The paper establishes a theoretical framework for the control of nonholonomic dynamic systems, i.e., dynamic systems with nonintegrable constraints, with emphasis on control properties for nonholonomic systems that have no counterpart in holonomic systems. A model for nonholonomic dynamic systems is presented in terms of differential-algebraic equations defined on a phase space. A reduction procedure is carried out to obtain reduced-order state equations. Conditions for smooth asymptotic stabilization to an m-dimensional equilibrium manifold are presented. It is also demonstrated that a single equilibrium solution cannot be asymptotically stabilized using continuous state feedback. An approach using geometric phases is developed as a basis for the control of Caplygin systems.

Bloch, Anthony M.↗
NASA NTRS1946

High-Speed Longitudinal-Stability and Control Characteristics of the Consolidated Vultee Lark Missile as Predicted from Wind-Tunnel Tests (TED No. NACA 2391)

A high-speed wind-tunnel investigation of the aerodynamic characteristics of a full-scale model of the Consolidated Vultee Lark indicates that the missile possesses satisfactory longitudinal-stability and-control characteristics throughout the Mach number range from 0.2 to 0.85, but that the maximum lift coefficients developed are not high enough to insure interception of the target at high altitudes. A reduction in wing loading appears advisable. Although the static longitudinal stability at zero angle of attack changes with Mach number and with lift coefficient, satisfactory control should be possible at all times as the tails retain their relatively large effectiveness throughout the range of Mach numbers and lift coefficients tested. Minimum stability and maximum maneuverability occur around 0.80 Mach number and 0.2 lift coefficient, which corresponds to level flight conditions of the missile. The optimum ratio of tail-to-wing deflection is 0.4.

Axelson, John A.↗
NASA NTRS1976

Aeroelastic stability and control of an oblique wing

Dynamic model tests were staged to compare the aeroelastic stability of a free-flying oblique-winged aircraft and the known divergent instability characterizing swept-forward wing configurations, to test the effect of wing elasticity on aileron control and trim. The aircraft fuselage was clamped in some tests and left free to roll in others. Two rigid wing panels were hinged near the wing center with elastic restraining springs. It is found that the aeroelastic divergence affecting swept-forward wings does not occur with an oblique wing, whose aeroelastic instability sets in at a dynamic pressure exceeding that for static divergence of swept-forward wings, and appears in the form of undamped oscillations. Oblique wing stability is sensitive to the moment of inertia of the fuselage in roll. Roll control and lateral trim are attainable with conventional ailerons, even at speeds at which divergence of a clamped forward wing shows up.

Jones, R. T.↗
NASA NTRS1980

Longitudinal stability and control in wind shear with energy height rate feedback

The longitudinal linearized equations of motion in wind shear were derived for the NASA Terminal Configured Vehicle, a modified Boeing 737 airplane. In addition to the apparent acceleration terms resulting from wind shear, the equations included altitude dependent stability derivatives. A linear analysis of these equations indicates a first order divergence type of instability due to wind shear in which head wind decreased with altitude. Furthermore, this instability cannot be stabilized by attitude control alone. However, attitude control used in combination with an addition feedback loop which consisted of the energy height rate feedback to the throttle proved to be effective in suppressing instability due to wind shear. A brief piloted, real time, nonlinear simulation indicated the desirability of using a display based on the rate of change of energy height rate and of commanded thrust.

Gera, J.↗
NASA NTRS1995

Advanced controls for stability assessment of solar dynamics space power generation

In support of the power requirements for the Space Station Alpha (SSA), a joint program by the U.S. and Russia for a permanently manned space station to be launched into orbit by 1998, a robust control scheme is needed to assure the stability of the rotating machines that will be integrated into the power subsystem. A framework design and systems studies for modeling and analysis is presented. It employs classical d-q axes machine model with voltage/frequency dependent loads. To guarantee that design requirements and necessary trade studies are done, a functional analysis tool CORE is used for the study. This provides us with different control options for stability assessment. Initial studies and recommendations using advanced simulation tools are also presented. The benefits of the stability/control scheme for evaluating future designs and power management are discussed.

Momoh, James A.↗
NASA NTRS1995

Implementation of a Single-Stage-To-Orbit (SSTO) model for stability and control analysis

Three NASA centers: Marshall Space Flight Center (MSFC), Langley Research Center (LaRC), and Johnson Space Center (JSC) are currently involved in studying a family of single-stage- and two-stage-to-orbit (SSTO/TSTO) vehicles to serve as the next generation space transportation system (STS). A rocketed winged-body is the current focus. The configuration (WB001) is a vertically-launched, horizontally-landing system with circular cross-section. Preliminary aerodynamic data was generated by LaRC and is a combination of wind-tunnel data, empirical methods, and Aerodynamic Preliminary Analysis System-(APAS) generated values. JSC's efforts involve descent trajectory design, stability analysis, and flight control system synthesis. Analysis of WB001's static stability indicates instability in 'tuck' (C(sub mu) less than 0: Mach = 0.30, alpha greater than 3.25 deg; Mach = 0.60, alpha greater than 8.04), an unstable dihedral effects (C(sub l(beta)) greater than 0: Mach = 30,alpha less than 12 deg.; Mach = 0.60, alpha less than 10.00 deg.), and, most significantly, an unstable weathercock stability derivative, C(sub n(beta)), at all angles of attack and subsonic Mach numbers. Longitudinal trim solutions for Mach = 0.30 and 0.60 indicate flight path angle possibilities ranging from around 12 (M = 0.30) to slightly over 20 degrees at Mach = 0.60. Trim angles of attack increase from 6.24 at Mach 0.60 and 10,000 feet to 17.7 deg. at Mach 0.30, sea-level. Lateral trim was attempted for a design cross-wind of 25.0 knots. The current vehicle aerodynamic and geometric characteristics will only yield a lateral trim solution at impractical tip-fin deflections (approximately equal to 43 deg.) and bank angles (21 deg.). A study of the lateral control surfaces, tip-fin controllers for WB001, indicate increased surface area would help address these instabilities, particularly the deficiency in C(sub n(beta)), but obviously at the expense of increased vehicle weight. Growth factors of approximately 7 were determined using a design C(sub n(beta)) of 0.100/radian (approximate subsonic values for the orbiter).

Ingalls, Stephen A.↗
DOE OSTI2023

Energy Transitions Initiative Partnership Project: City and Borough of Sitka, Alaska - Modeling and Controls Assistance and Renewable Energy Resource Assessment [Slides]

This presentation provides a summary of the ETIPP project objectives and findings for Sitka, Alaska, including sizing of wind penetration, dynamic models, and analysis of efficiency of load control, stability and grid control impacts of wind capacity expansions and locations, and wind-hydro control coordination.

17 WIND ENERGY↗
NASA NTRS1945

Determination of the Stability and Control Characteristics of a Tailless All-Wing Airplane Model with Sweepback in the Langley Free-Flight Tunnel

Force and flight tests were performance on an all-wing model with windmilling propellers. Tests were conducted with deflected and retracted flaps, with and without auxiliary vertical tail surfaces, and with different centers of gravity and trim coefficients. Results indicate serious reduction of stick-fixed longitudinal stability because of wing-tip stalling at high lift coefficient. Directional stability without vertical tail is undesirably low. Low effective dihedral should be maintained. Elevator and rudder control system is satisfactory.

WING FLAPS - DEFLECTION↗
NASA NTRS1982

Feedback stabilization and control of linear neutral systems

The first problem treated here is the realization and stabilization of linear neutral systems with discrete delays. It is shown that any autonomous linear neutral system with discrete delays is zero-state equivalent to an abstract linear system over a local ring of operators. Using the abstract model, the basic existence question for neutral realization is then settled. For general infinite dimensional linear systems, there is no precise analog of the finite dimensional state space isomorphism theorem. Because of this, the notion of spectral minimality must be introduced. For the case of single input-single output systems, realizations are obtained that are both minimal and spectrally minimal. Using the Cruz-Hale theory of stable D-operators, conditions are given that ensure that any poles introduced into the realization are strictly contained in the left half plane and indeed are characterized as characteristic values of the D-operator. The problem of the feedback stabilization of neutral systems is then considered using the abstract model. It is shown that, for neutral systems with commensurable delays and a stable D-operator in the sense of Cruz and Hale, Morses theorem (1976) on pole assignment over a PID implies stabilizability in the reachable case.

Tarn, T. J.↗