Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “OMEGA”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 595 records · Page 33

Evaluation of the Tau-Omega Model Over Bare and Wheat-Covered Flat and Periodic Soil Surfaces at P- and L-band

It has been over ten years since the successful launch of the first-ever dedicated satellite for global soil moisture monitoring; Soil Moisture and Ocean Salinity (SMOS). Looking towards the future, P-band (0.3-1 GHz) is a promising technique to replace or enhance the L-band (1.4 GHz) SMOS and SMAP (Soil Moisture Active Passive) missions because of an expected reduction in roughness and vegetation impact, leading to an improved soil moisture accuracy over rougher soil surfaces and more densely vegetated areas. Accordingly, this investigation evaluated the tau-omega model at P-band (0.75 GHz) using a tower-based experiment in Victoria, Australia, where brightness temperature observations were collected concurrently at P- and L-band over bare and wheat-covered flat and periodic soil surfaces. The potential to retrieve soil moisture without discriminating periodic and flat surfaces was investigated by applying the roughness and vegetation parameters calibrated for flat soil to retrieve the moisture of periodic soil. Results showed that P-band had a comparable RMSE across different roughness configurations (variations less than 0.016 m3/m3) for both bare and wheat-covered soil, while the L-band RMSE was only comparable for wheat-covered soil, indicating that periodic surfaces did not need to be discriminated in such scenarios. Conversely, a difference of 0.022 m3/m3 was observed for L-band with bare soil. A reduced vegetation impact was also demonstrated at P-band, with an RMSE of 0.029 m3/m3 achieved when completely ignoring the wheat existence with under 4-kg/m2 vegetation water content, whereas at L-band the RMSE increased to 0.063 m3/m3. This study therefore paves the way for a successful P-band radiometer mission for obtaining more accurate global soil moisture information.

P-band↗

Evaluation of the Tau-Omega Model over a Dense Corn Canopy at P- and L-band

As an emerging technique, P-band (0.3-1GHz) may improve soil moisture remote sensing compared to L-band (1.4 GHz) SMOS (Soil Moisture and Ocean Salinity) and SMAP (Soil Moisture Active Passive) missions, because of its greater moisture retrieval depth resulting from its longer wavelength. Consequently, a number of tower-based experiments were undertaken in Victoria, Australia, to understand and quantify potential improvements. The study reported here has extended the evaluation of the tau-omega model to a scenario with a dense corn canopy whose vegetation water content reached ~20 kg/m 2 , and compared the soil moisture retrieval performance at P- and L-band. Based on the locally calibrated parameters, the results from both the SCA (Single Channel Algorithm) and DCA (Dual Channel Algorithm) approaches presented a clear reduction in vegetation impact at P-band compared to L-band. While the root-mean-square error (RMSE) for P-band did not achieve the 0.04-m 3 /m 3 target accuracy of SMOS and SMAP, i.e., 0.054 m 3 /m 3 for the SCA and 0.074 m 3 /m 3 for the DCA, this performance can be regarded as acceptable considering the extremely high vegetation water content. In comparison, the RMSEs at L-band were larger than 0.1 m 3 /m 3 for both the SCA and the DCA approaches. Additionally, DCA performed better in correlation coefficient and unbiased RMSE, while SCA performed better in RMSE at P-band due to the larger bias when using DCA. Moreover, the calibrated vegetation parameters at P-band were found to apply to broader conditions than those at L-band, likely due to the reduced vegetation impact.

P-band↗

Crossed-Beam Energy Transfer in Implosion Experiments on OMEGA

Radiative hydrodynamic simulations of implosion experiments on the OMEGA laser system [Boehly et al., Opt. Commun. 133, 495 (1997)] show that energy transfer between crossing laser beams can reduce laser absorption by 10%–20%. A new quantitative model for the crossed-beam energy transfer has been developed, allowing one to simulate the coupling of multiple beams in the expanding corona of implosion targets. Scattered-light and bang-time measurements show good agreement with predictions of this model when nonlocal heat transport is employed. The laser absorption can be increased by narrowing laser beams and/or employing two-color light, which both reduce the crossed-beam energy transfer.

Igumenshchev, I V↗

Nucleon, Delta and Omega excited state spectra at three pion mass values

The energies of the excited states of the Nucleon, Delta and Omega are computed in lattice QCD, using two light quarks and one strange quark on anisotropic lattices. The calculations are performed at three values of the pion mass: 392(4), 438(3) and 521(3) MeV. We employ the variational method with a basis of about ten interpolating operators enabling six energies to be distinguished clearly in each irreducible representation of the octahedral group. We compare our calculations of nucleon excited states with the low-lying experimental spectrum. There is reasonable agreement for the pattern of states.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Increasing plant growth by modulating omega-amidase expression in plants

The present disclosure relates to compositions and methods for increasing the leaf-to-root ratio of the signal metabolite 2-oxoglutaramate and related proline molecules in plants by modulating levels of .omega.-amidase to increase nitrogen use efficiency, resulting in enhanced growth, faster growth rates, greater seed and fruit/pod yields, earlier and more productive flowering, increased tolerance to high salt conditions, and increased biomass yields.

59 BASIC BIOLOGICAL SCIENCES↗

Study of laser-driven cone-in-shell implosion with picosecond monochromatic x-ray radiography on OMEGA

Fuel assembly of a laser-driven cone-in-shell target was studied using picosecond monochromatic x-ray radiography and two-dimensional radiation-hydrodynamics simulation for Fast Ignition (FI) laser fusion. A deuterated plastic shell with a re-entrant Au cone was used as a standard cone-in-shell target in fast ignition heating experiments on OMEGA [W. Theobald et al., Phys. Plasmas 18, 056305 (2011)].

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

OpenFAST Modeling of the T-Omega Wind Floating Offshore Wind Turbine System

To reduce the cost of offshore wind energy through a more efficient design of the floating support structure, T-Omega Wind developed a novel lightweight and shallow-draft platform concept that aims to achieve a wave-following behavior without resonance amplification. The rotor and generator are carried by four tower legs with each leg supported by a shallow-draft float at the base. In preparation for a more detailed analysis, a coupled aero-hydro-elastic model of the proposed concept is developed in OpenFAST. The detailed modeling approach is presented, including a novel application of the SubDyn substructure dynamics module of OpenFAST to approximate the loads on the axle tube at the tower top from the rotor hub bearings. Preliminary results obtained with the OpenFAST model by rigidifying the substructure and blades indicate that the original sizing of the design can lead to large hub acceleration in the axial/surge and pitch directions due to platform-pitch motion. The high axial acceleration also potentially leads to large bending moments in the four tower legs. To address these issues, an updated design is developed with, among other changes, increased float spacing at the tower base and improved shear-transmitting geometry of the tower legs. The new design suggests significantly reduced extreme hub accelerations under the same conditions even with structural flexibility and will be further analyzed in the future through full aero-hydro-servo-elastic simulations.

ENGINEERING,WIND ENERGY↗

OpenFAST Modeling of the T-Omega Wind Floating Offshore Wind Turbine System: Preprint

To reduce the cost of offshore wind energy through a more efficient design of the floating support structure, T-Omega Wind developed a novel lightweight and shallow-draft platform concept that aims to achieve a wave-following behavior without resonance amplification. The rotor and generator are carried by four tower legs with each leg supported by a shallow-draft float at the base. In preparation for a more detailed analysis, a coupled aero-hydro-elastic model of the proposed concept is developed in OpenFAST. The detailed modeling approach is presented, including a novel application of the SubDyn substructure dynamics module of OpenFAST to approximate the loads on the axle tube at the tower top from the rotor hub bearings. Preliminary results obtained with the OpenFAST model by rigidifying the substructure and blades indicate that the original sizing of the design can lead to large hub acceleration in the axial/surge direction and in the pitch direction due to platform-pitch motion. The high hub acceleration also potentially leads to large bending moments in the four tower legs. To address the issue identified, an updated design is developed with, among other changes, increased float spacing at the tower base and improved geometry of the tower legs. The new design suggests significantly reduced extreme platform pitch angles under the same conditions and will be further analyzed in the future through full aero-hydro-servo-elastic simulations.

FOWT↗

Scale Setting with the Omega Baryon

This work will discuss a recent calculation of the gradient flow scale $w_0$ in lattice QCD using the omega baryon mass.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

A pulsed-laser calibration system for the laser backscatter diagnostics at the Omega laser

A calibration system has been developed that allows a direct determination of the sensitivity of the laser backscatter diagnostics at the Omega laser. A motorized mirror at the target location redirects individual pulses of a mJ-class laser onto the diagnostic to allow the in-situ measurement of the local point response of the backscatter diagnostics. Featuring dual wavelength capability at the 2nd and 3rd harmonic of the Nd:YAG laser, both spectral channels of the backscatter diagnostics can be directly calibrated. In addition, channel cross-talk and polarization sensitivity can be determined. The calibration system has been employed repeatedly over the last two years and has enabled precise backscatter measurements of both stimulated Brillouin scattering and stimulated Raman scattering in gas-filled hohlraum targets that emulate conditions relevant to those in inertial confinement fusion targets.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Influence of molecular ordering on electrical and friction properties of omega-(trans-4-stilbene)alkylthiol self-assembled monolayers on Au (111)

The electrical and friction properties of omega-(trans-4-stilbene)alkylthiol self-assembled monolayers (SAMs) on Au(111) were investigated using atomic force microscopy (AFM) and near edge x-ray absorption fine structure spectroscopy (NEXAFS). The sample surface was uniformly covered with a molecular film consisting of very small grains. Well-ordered and flat monolayer islands were formed after the sample was heated in nitrogen at 120 oC for 1 h. While lattice resolved AFM images revealed a crystalline phase in the islands, the area between islands showed no order. The islands exhibit substantial reduction (50percent) in friction, supporting the existence of good ordering. NEXAFS measurements revealed an average upright molecular orientation in the film, both before and after heating, with a narrower tilt-angle distribution for the heated fim. Conductance-AFM measurements revealed a two orders of magnitude higher conductivity on the ordered islands than on the disordered phase. We propose that the conductance enhancement is a result of a better pi-pi stacking between the trans-stilbene molecular units as a result of improved ordering in islands.

36 MATERIALS SCIENCE↗

Annihilation of p-bar + p {yields} e{sup +} + e{sup -} + {pi}{sup 0} and p-bar + p {yields} {gamma} + {pi}{sup 0} through an {omega}-Meson intermediate state

The s-channel annihilation of a proton and an antiproton into a neutral pion and a real or virtual photon followed by lepton pair emission is studied. Such a mechanism is expected to play a role at moderate values of the total energy {radical}s, when the pion is emitted in the angular region around 90 Degree-Sign in the center-of-mass system. A fair comparison with the existing data is obtained taking scattering and annihilation channels into account. The cross section is calculated and numerical results are given in the kinematical range accessible in the PANDA experiment at FAIR.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Preshot Summary for Coax-14A OMEGA Experiments on January 28th, 2014

The goal of the Coax campaign is to implement an experiment with a highly anisotropic radiation source to benchmark the performance of CASSIO in a regime where radiation transport modeling requires an implicit Monte Carlo treatment instead of the standard diffusion treatment. The system is created by driving an Au halfhohlraum (halfraum) with a foam package mounted on the end opposite of the halfraum LEH. Different types of Ta apertures are inserted at the foam/halfraum interface to make the radiation drive incident on the foam anisotropic.

61 RADIATION PROTECTION AND DOSIMETRY↗

(abstract) OMEGA: A Gravitational Wave MIDEX Mission

Among the low frequency (LF) gravitational wave sources that are of astronomical interest are white dwarf binaries, neutron star binaries, massive black hole binaries, and compact stars spiralling into massive black holes. A mission to detect these sources has been proposed to NASA as a possible member of its low-cost, near-term MIDEX mission series. This mission utilizes six tiny miniprobes in high Earth orbit to produce a sensitive Michelson interferometer with million kilometer arms, yielding a strain sensitivity below 10^{-21} at periods longer than a hundred seconds. At this sensitivity, known binary stars will be seen and plausible unknown massive black hole events will be searched for.

gravitational waves binaries black holes neutron s↗

Algal Lipids and Omega-3 Production via Autotrophic and Heterotrophic Pathways at Cellana?s Kona Demonstration Facility, Hawaii

Cellana?s Kona Demonstration Facility (KDF) is a 2.5 hectare facility, with 17,000 sq. ft. under roof and 1 hectare of cultivation systems. KDF is designed to execute and support all stages of the production process at pilot scale, from cultivation through extraction. Since Feb. 2009, KDF has been producing up to 0.7MT dry weight of algal biomass per month, while at the same time optimizing processes of cultivation, harvesting, dewatering and extraction. The cultivation system at KDF uses ALDUO? technology, a hybrid system of photobioreactors (PBRs) and open ponds. All fluid transfers related to KDF cultivation and harvesting processes are operated and monitored by a remote Process-Control System. Fluid transfer data, together with biochemical data, enable the mass balance calculations necessary to measure productivity. This poster summarizes methods to improve both biomass and lipids yield by 1) alleviating light limitation in open ponds, 2) de-oxygenation and 3) heterotrophic lipid production for post-harvesting cultures.

09 BIOMASS FUELS↗