SEARCH · Engineering Papers

Results for “drops”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 577 records · Page 32

All sources NASA NTRS DOE OSTI

NASA NTRS1977

Effect of ice contamination of liquid-nitrogen drops in film boiling

Previously reported vaporization time data of liquid nitrogen drops in film boiling on a flat plate are about 30 percent shorter than predicted from standard laminar film boiling theory. This theory, however, had been found to successfully correlate the data for conventional fluids such as water, ethanol, benzene, or carbon tetrachloride. Experimental evidence that some of the discrepancy for cryogenic fluids results from ice contamination due to condensation is presented. The data indicate a fairly linear decrease in droplet evaporation time with the diameter of the ice crystal residue. After correcting the raw data for ice contamination along with convection, a comparison of theory with experiment shows good agreement.

Schoessow, G. J.↗

NASA NTRS1977

Effect of airstream velocity on mean drop diameters of water sprays produced by pressure and air atomizing nozzles

A scanning radiometer was used to determine the effect of airstream velocity on the mean drop diameter of water sprays produced by pressure atomizing and air atomizing fuel nozzles used in previous combustion studies. Increasing airstream velocity from 23 to 53.4 meters per second reduced the Sauter mean diameter by approximately 50 percent with both types of fuel nozzles. The use of a sonic cup attached to the tip of an air assist nozzle reduced the Sauter mean diameter by approximately 40 percent. Test conditions included airstream velocities of 23 to 53.4 meters per second at 293 K and atmospheric pressure.

Ingebo, R. D.↗

NASA NTRS1977

Effect of ice contamination on liquid-nitrogen drops in film boiling

Previously reported vaporization time data of liquid nitrogen drops in film boiling on a flat plate are about 30 percent shorter than predicted from standard laminar film boiling theory. This theory, however, had been found to successfully correlate the data for conventional fluids such as water, ethanol, benzene, or carbon tetrachloride. This paper presents experimental evidence that some of the discrepancy for cryogenic fluids results from ice contamination due to condensation. The data indicate a fairly linear decrease in droplet evaporation time with the diameter of the ice crystal residue. After correcting the raw data for ice contamination along with convection, a comparison of theory with experiment shows good agreement.

Schoessow, G. J.↗

NASA NTRS1977

Effect of airstream velocity on mean drop diameters of water sprays produced by pressure and air atomizing nozzles

Ingebo, R. D.↗

NASA NTRS1978

Potential drops above pulsar polar caps - Ultrarelativistic particle acceleration along the curved magnetic field

The paper calculates the acceleration of a nonneutral stream of charged particles from the surface of an isolated rotating magnetized neutron star in the case where the particle stream flows along the open field lines of a curved poloidal magnetic field. It is shown that very large electrostatic potential drops can occur in steady unidirectional space-charge-limited flow along the curved open field lines. The explicit incorporation of magnetic field line curvature is the essential element leading to this new result, assuming that all the charges are supplied by emission from the surface. It is emphasized that the current flow and charge density are unique if all of the assumptions are met, with the result that the accelerating electric field near the stellar surface is quite small compared to the vacuum field.

Scharlemann, E. T.↗

NASA NTRS1979

Preparatory studies of zero-g cloud drop coalescence experiment

Experiments to be performed in a weightless environment in order to study collision and coalescence processes of cloud droplets are described. Rain formation in warm clouds, formation of larger cloud drops, ice and water collision processes, and precipitation in supercooled clouds are among the topics covered.

Telford, J. W.↗

NASA NTRS1979

Mie disdrometer for in situ measurement of drop size distributions

Test results are shown for a disdrometer breadboard which uses Mie scattering and incoherent optical correlation for in situ measurement of drop size distribution in a cloud chamber.

Loos, H. G.↗

NASA NTRS1979

Some flow characteristics of conventional and tapered high pressure drop simulated seals

The leak rates through shaft seals with large pressure drops were simulated using gaseous hydrogen, or nitrogen flowing through an annulus with a nonrotating centerbody. The flows were choked. For concentric or eccentric position of the rotor and parallel or convergent tapered flow passages, data and analysis revealed that mass flux or leak rate can be determined from a relation whose normalizing parameters depend on the thermodynamic critical constants of the working fluid and an average flow area expressed in terms of the inlet and exit cross-sectional areas. Using these normalized relations, the flow data for parallel and three convergent tapered shaft seal configurations are in good agreement. Generalization to any simple gas or gas mixture is implied and demonstrated.

Hendricks, R. C.↗

NASA NTRS1979

The shape of a pendent liquid drop

Formal solutions of the static equilibrium equations for the form of the outer surface of a pendent liquid drop are studied. An approach is adopted in which only the one-parameter family determined by vertex height (u sub 0) need be described. Attention is restricted to rotationally symmetric configurations, and all symmetric solutions are characterized for the case where the Lagrange parameter lambda is equal to zero. It is shown that for any u sub 0 the function u(r; u sub 0) can be extended as a parametric solution of a system of equations for all arc lengths, yielding a curve without limit sets or double points, and that the resulting capillary rotation surface spreads out indefinitely away from the axis r = 0. The asymptotic form of the surface in the case of large absolute values of u sub 0 is characterized quantitatively, along with the global structure of all such surfaces.

Concus, P.↗

NASA NTRS1979

Some flow characteristics of conventional and tapered high-pressure-drop simulated seals

The leak rates through shaft seals with large pressure drops were simulated using gaseous hydrogen, or nitrogen flowing through an annulus with a nonrotating centerbody. The flows were choked. For concentric or eccentric position of the rotor and parallel or convergent tapered flow passages, data and analysis revealed that mass flux or leak rate can be determined from a relation whose normalizing parameters depend on the thermodynamic critical constants of the working fluid and an average flow area expressed in terms of the inlet and exit cross-sectional areas. Using these normalized relations, the flow data for parallel and three convergent, tapered, shaft-seal configurations are in good agreement. Generalization to any simple gas or gas mixtures is implied and demonstrated in part.

Hendricks, R. C.↗

NASA NTRS1981

Estimation of dynamic stability parameters from drop model flight tests

The overall remotely piloted drop model operation, descriptions, instrumentation, launch and recovery operations, piloting concept, and parameter identification methods are discussed. Static and dynamic stability derivatives were obtained for an angle attack range from -20 deg to 53 deg. It is indicated that the variations of the estimates with angle of attack are consistent for most of the static derivatives, and the effects of configuration modifications to the model were apparent in the static derivative estimates.

Chambers, J. R.↗

NASA NTRS1980

A numerical determination of the evolution of cloud drop spectra due to condensation on natural aerosol particles

The time variation in size of aerosol particles growing by condensation is studied numerically by means of an air parcel model which allows entrainment of air and aerosol particles. Particles of four types of aerosols typically occurring in atmospheric air masses were considered. The present model circumvents any assumption about the size distribution and chemical composition of the aerosol particles by basing the aerosol particle growth on actually observed size distributions and on observed amounts of water taken up under equilibrium by a deposit of the aerosol particles. Characteristic differences in the drop size distribution, liquid water content and supersaturation were found for the clouds which evolved from the four aerosol types considered.

Lee, I. Y.↗

NASA NTRS1982

Normal modes of a compound drop

The modes are characterized by their frequency, the attendant displacement of fluid boundaries, and the flow pressure fields within the fluids. The drops consist of three fluids; a core fluid, a fluid shell surrounding the core, and a host fluid surrounding the shell. These fluids are assumed to be inviscid and incompressible, and the core and the shell to be concentric. The theory is obtained by linearization of the equations of fluid motion to the lowest order of nonlinearity that yields the normal modes. Numerical values of mode frequencies and the associated relative displacements of the fluid boundaries are presented for several specific systems, and the results compared with observations.

Saffren, M.↗

NASA NTRS1982

A numerical study of drop-on-demand ink jets

Ongoing work related to development and utilization of a numerical model for treating the fluid dynamics of ink jets is discussed. The model embodies the complete nonlinear, time dependent, axi-symmetric equations in finite difference form. The jet nozzle geometry with no-slip boundary conditions and the existence of a contact circle are included. The contact circle is allowed some freedom of movement, but wetting of exterior surfaces is not addressed. The principal objective in current numerical experiments is to determine what pressure history, in conjunction with surface forces, will lead to clean drop formation.

Fromm, J.↗

NASA NTRS1982

Drop processes in natural clouds

A model of the diffusive mixing of dry and cloudy air, a process considered to be fundamental to the development of natural clouds, is presented. Water drops are formed at the cloud base by condensation upon nuclei and as they rise they grow by vapor diffusion in the slightly supersaturated environment of the clouds. Turbulent mixing between cloudy air and undersaturated air entrained from outside produces fluctuations in supersaturation, not linked to changes in vertical velocity, which cause broadening of the condensate spectrum and the rapid production of droplets large enough to engage in growth by coalescence. The probabilities of permanent union or the production of satellite droplets following the collision of a pair of raindrops is a sensitive function of several parameters. In some circumstances electrohydrodynamic bursting may influence the properties of clouds.

Latham, J.↗

NASA NTRS1982

Method of forming frozen spheres in a force-free drop tower

Hollow glass spheres are shaped by the effects of surface tension acting on bubbles of glass in its molten state. A downwardly flowing stream of air accelerated at a one-G rate of acceleration is established through a drop bubbles on molten glass are introduced into the stream of air and frozen and as they are accelerated at a one-G rate of acceleration.

Kendall, J. M., Jr.↗

NASA NTRS1982

Bubble migration inside a liquid drop in a space laboratory

The design of experiments in materials processing for trials on board the Shuttle are described. Thermocapillary flows will be examined as an aid to mixing in the formation of glasses. Acoustically levitated molten glass spheres will be spot heated to induce surface flow away from the hot spot to induce mixing. The surface flows are also expected to cause internal convective motion which will drive entrained gas bubbles toward the hot spot, a process also enhanced by the presence of thermal gradients. The method is called fining, and will be augmented by rotation of the sphere to cause bubble migration toward the axes of rotation to form one large bubble which is more easily removed. Centering techniques to fix the maximum centering accuracy will also be tried. Ground-based studies of bubble migration in a rotating liquid and in a temperature gradient in a liquid drop are reviewed.

Annamalai, P.↗

NASA NTRS1982

Large-amplitude free and driven drop-shape oscillations - Experimental observations

A quantitative study of some nonlinear aspects of drop-shape oscillations in a liquid-liquid system has been completed. The results suggest a soft nonlinearity in the fundamental resonant mode frequency as the oscillation amplitude is increased. Indications of an increase in the rate of decay have also been obtained. A study of the internal flow fields has revealed patterns of circulation not present at low amplitude.

Trinh, E.↗