SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Empirical correlation of high energy electrons into materials allows predictions of practical ranges (measure of electron penetration) for different elements and alloys.
Balloon observations of proton and helium spectra in 1970, 1971 and 1972, reveal a factor of approximately 1.85 deviation from a single valued regression at low rigidities. This deviation decreases with increasing rigidity for both species. The period 1969-1970 is unique because time variations at low and high energies were anti-correlated. When satellite observations are used to extend the balloon observations to energies below 100 MeV/Nucleon, the proton spectrum showed a steeper slope in 1970 and 1972 than the characteristic J = AT spectrum observed during 1965-1969. The slope of the helium spectrum became continuously flatter during the same period (1970-1972). Computer generated spectra based on simple two parameter modulation models describe the basic features of the observations if one of the variable parameters is used to characterize the rigidity dependence of the diffusion coefficient. Models which do not allow such a variation are not consistent with the observations.
Cyclic debonding rates were measured during constant-amplitude loading of specimens made of graphite/epoxy bonded to aluminum and S-glass/epoxy bonded to aluminum. Both room-temperature and elevated-temperature curing adhesives were used. Debonding was monitored with a photoelastic coating technique. The debonding rates were compared with three expressions for strain-energy release rate calculated in terms of the maximum stress, stress range, or a combination of the two. The debonding rates were influenced by both adherent thickness and the cyclic stress ratio. For a given value of maximum stress, lower stress ratios and thicker specimens produced faster debonding. Microscopic examination of the debonded surfaces showed different failure mechanisms both for identical adherends bonded with different adhesive and, indeed, even for different adherends bonded with identical adhesives. The expressions for strain-energy release rate correlated the data for different specimen thicknesses and stress ratios quite well for each material system, but the form of the best correlating expression varied among material systems. Empirical correlating expressions applicable to one material system may not be appropriate for another system.
The current status of the analysis of Cen X-3 data from Uhuru concerning pulsations, orbital period and eccentricity, and extended lows, are reviewed. The pulse period decreases irregularly. The pulsed fraction (2-7 keV) is 70%-90% for single pulses but significantly less for superpositions of pulses, due to variability in shape. The pulses are narrower at higher energies with a correlated increase in fraction pulsed. The orbital period is found to both decrease and increase with p/p on the order of a few times 0.00001/year. A three sigma upper limit on the eccentricity of 0.003 is obtained; if no significant periastron motion is allowed over two years, the upper limit becomes 0.0016. The orbital period is found to be detectable during some extended lows but with a significantly decreased ratio of eclipsed to non-eclipsed intensity. Two transitions between normal high states and extended lows are studied, and a consistent model is obtained in which extended lows are caused by both burying the source in an increased stellar wind from the companion, and starving the source by decreasing the stellar wind. Changes in fraction pulsed during transitions and systematic differences in the harmonic content of the pulses are also found.
The population densities of both the ground and the 2D(5/2) metastable states of copper atoms in a double-pulsed copper-chloride laser are correlated with laser energy as a function of time after the dissociation current pulse. Time-resolved density variations of the ground and excited copper atoms were derived from measurements of optical absorption at 324.7 and 510.6 nm, respectively, over a wide range of operating conditions in laser tubes with diameters of 4 to 40 mm. The minimum delay between the two current pulses at which lasing was observed is shown to be a function of the initial density and subsequent decay of the metastable state. Similarly, the maximum delay is shown to be a function of the initial density and decay of the ground state.
In a computer simulation study of earthquakes a seismically active strike slip fault is represented by coupled mechanical blocks which are driven by a moving plate and which slide on a friction surface. Elastic forces and time independent friction are used to generate main shock events, while viscoelastic forces and time dependent friction add aftershock features. The study reveals that the size, length, and time and place of event occurrence are strongly influenced by the magnitude and degree of homogeneity in the elastic, viscous, and friction parameters of the fault region. For example, periodically reoccurring similar events are observed in simulations with near-homogeneous parameters along the fault, whereas seismic gaps are a common feature of simulations employing large variations in the fault parameters. The study also reveals correlations between strain energy release and fault length and average displacement and between main shock and aftershock displacements.
Systematic improvements in fabrication yield were obtained by appropriate control of the liquid phase epitaxial growth process, contact fabrication and surface preparation. To improve radiation hardness, the junction depth was decreased while overcoming the penalty in decreased solar cell efficiency which tends to go hand-in-hand with the reduction of junction depth in (AlGa) As-GaAs solar cells. Cells were made with an AMO efficiency of 18% and a junction depth of 0.5 micrometers, as compared to junction depths on the order of 1.0 micrometers. With respect to the damage caused by proton irradiation, the nature of the observed damage was correlated to the energy and penetration depth of the damaging protons.
The partitioning of trace elements between ionic crystals and the melt has been correlated with lattice energy of the host. The solid-liquid partition coefficient has been expressed in terms of the difference in relative ionic radius of the trace element and the homogeneous and heterogeneous strain of the host lattice. Predictions based on this model appear to be in general agreement with data for alkali nitrates and for rare-earth elements in natural garnet phenocrysts.
Fluctuations of low-energy electron fluxes during an inverted V event on Nov. 5, 1975 were detected by fixed-energy electrostatic analyzers used in the LEE (low-energy electron) experiment onboard the AE-D satellite. The flux fluctuations were observed at energies of 0.78, 1.38, and 2.62 keV, when these energies were below that of the monoenergetic beam. This suggests that the fluctuations might occur over a wide range of energies. The fluctuations were confined within a pitch angle of 15 degrees, the amplitude increasing with decreasing pitch angle. The oscillation frequencies centered around 1.75 Hz. Fluctuations at two energies were generally correlated. The heating of secondary electrons, deduced from an analysis of the distribution function, is attributed to anomalous heating by electron plasma wave turbulence, whose intensity was modulated by a low-frequency wave. The results are consistent with a model, according to which auroral precipitating electron beams enhance the anomalous resistivity at the topside ionosphere through parametric instabilities.
Magnetic helicity (Hm) is the mean value of the correlation between a turbulent magnetic field and the magnetic vector potential. A technique is described for determining Hm and its 'reduced' spectrum from the two point magnetic correlation matrix. The application of the derived formalism to solar wind magnetic fluctuations is discussed, taking into account cases for which only single point measurements are available. The application procedure employs the usual 'frozen in approximation' approach. The considered method is applied to an analysis of several periods of Voyager 2 interplanetary magnetometer data near 2.8 AU. During these periods the correlation length, or energy containing length, was found to be approximately 3 x 10 to the 11th cm
Dynamic mechanical analysis instrumentation was used for the development of specific test methodology in the determination of engineering parameters of selected materials, esp. plastics and elastomers, over a broad range of temperature with selected environment. The methodology for routine procedures was established with specific attention given to sample geometry, sample size, and mounting techniques. The basic software of the duPont 1090 thermal analyzer was used for data reduction which simplify the theoretical interpretation. Clamps were developed which allowed 'relative' damping during the cure cycle to be measured for the fiber-glass supported resin. The correlation of fracture energy 'toughness' (or impact strength) with the low temperature (glassy) relaxation responses for a 'rubber-modified' epoxy system was negative in result because the low-temperature dispersion mode (-80 C) of the modifier coincided with that of the epoxy matrix, making quantitative comparison unrealistic.
Cyclotron emission in the inner regions of an accretion disk around a matter accreting black hole can be appreciable. In the case of the X-ray source Cyg X-1, cyclotron emission may provide the soft photons needed for 'Comptonization' to produce high energy X-rays. The inverse correlation between the fluxes of high energy and low energy X-rays during the 'high' and 'low' states of Cyg X-1, may be understood as a result of the variation of the rate of accretion and the Compton scattering of the cyclotron photons. In the case of the X-ray source GX 339-4, the observed optical flux during the high states does not seem to be due to cyclotron emission, but probably due to reprocessing of high energy X-rays by the outer regions of the disk.
There are about 100 bright X-ray sources in the Galaxy that are accretion-driven systems composed of a neutron star and a low mass companion that fills its critical Roche lobe. Many of these systems generate recurring X-ray bursts that are the result of thermonuclear flashes in the neutron star's surface layers, and are accompanied by a somewhat delayed optical burst due to X-ray heating of accretion disk. The Rapid Burster discovered in 1976 exhibits an interval between bursts that is strongly correlated with the energy in the preceding burst. There is no optical identification for this object.
Radio, plasma, and magnetic field data obtained by Voyager 1 and Voyager 2 were used to examine the manner in which the Jovian hectometric radio emission (HOM) is controlled by the solar wind. Using the method of superposed epochs, it was found that the higher energy HOM is correlated with the IMF as well as with the solar wind density and pressure. However, unlike the Io-independent decametric radio emission (Non-Io DAM), the HOM displayed no correlation with the solar wind velocity, although this radio component appear to be also influenced by the IMF. The results suggest separate HOM amd Non-Io DAM sources.
Flow field measurements are presented of 3 subsonic rectangular cold air jets. The 3 cases presented had aspect ratios of 1 x 2, 1 x 4 at a Mach number of 0.09 and an aspect ratio of 1 x 2 at a Mach number of 0.9. All measurements were made using a 3-D laser Doppler anemoneter system. The presented data includes the mean velocity vector, all Reynolds stress tensor components, turbulent kinetic energy and velocity correlation coefficients. The data is presented in tabular and graphical form. No analysis of the measured data or comparison to other published data is made. All tabular data are available in ASCII format on MS-DOS compatible disks.
A series of copper-nickel alloys were fabricated, notched tensile specimens machined for each alloy, and the specimens tested in 34.5 MPa hydrogen and in air. A notched tensile ratio was determined for each alloy and the hydrogen environment embrittlement (HEE) determined for the alloys of 47.7 weight percent nickel to 73.5 weight percent nickel. Stacking fault probability and stacking fault energies were determined for each alloy using the x ray diffraction line shift and line profiles technique. Hydrogen environment embrittlement was determined to be influenced by stacking fault energies; however, the correlation is believed to be indirect and only partially responsible for the HEE behavior of these alloys.
Flow field measurements of three subsonic rectangular cold air jets are presented. The three cases had aspect ratios of 1x2, 1x4 at a Mach number of 0.09 and an aspect ratio of 1x2 at a Mach number of 0.9. All measurements were made using a 3-D laser Doppler anemometer system. The data includes the mean velocity vector, all Reynolds stress tensor components, turbulent kinetic energy and velocity correlation coefficients. The data are presented in tabular and graphical form. No analysis of the measured data or comparison to other published data is made.
The bonding of Nb(2+) with CH2, C2H2, and C2H4 is studied by using electronic structure calculations that include high levels of electron correlation. The binding energy for NbCH2(2+) is in good agreement with the lower bound determined from the reaction with CH4 but is significantly smaller than the value determined from the binding energy and ionization potential of NbCH2(+). The calculations and a new interpretation of the experiment indicate that the larger value is in error primarily because the ionization potential of NbCH2(+) determined from bracketing charge-exchange reactions is too small. The computed binding energy of NbC2H2(2+) is in good agreement with experiment. The calculations show that the bonding is predominantly covalent in character for both NbCH2(2+) and NbC2H2(2+), whereas for NbC2H4(2+) the electronic states that are predominantly ionic and covalent are nearly degenerate. The trend in binding energies, CH2 greater than C2H2 greater than C2H4, is consistent with the energy required to prepare the ligands for bonding.