SEARCH · Engineering Papers

Results for “conduction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 577 records · Page 32

All sources NASA NTRS DOE OSTI

NASA NTRS1978

Velocity, temperature, and electrical conductivity profiles in hydrogen-oxygen MHD duct flows

Two-dimensional duct flow computations for radial distributions of velocity, temperature, and electrical conductivity are reported. Calculations were carried out for the flow conditions representative of a hydrogen-oxygen combustion driven MHD duct. Results are presented for: profiles of developing flow in a smooth duct, and for profiles of fully developed pipe flow with a specified streamwise shear stress distribution. The predicted temperature and electrical conductivity profiles for the developing flows compare well with available experimental data.

Greywall, M. S.↗

NASA NTRS1978

The importance of electron heat conduction in the energy balance of the F-region

Taking into account heat conduction in the analysis of electron temperature data acquired by the AE-C satellite during the daytime at middle latitudes is shown to bring theoretical electron temperature profiles in good agreement with experimental ones. Middle latitude passes were chosen because in this region the horizontal electron temperature gradient is negligible and the height variation can be approximated by the satellite data. Inclusion of heat conduction is shown to have little effect on low-latitude data.

Hoegy, W. R.↗

NASA NTRS1978

Backscattering from a Gaussian-distributed perfectly conducting rough surface

The original intent of the reported investigation was to find a solution to the composite surface scattering problem which provided for a continuous transition between the near-specular physical optics and wide-angle tilted plane Bragg solutions. The employed approach is based on analytical techniques rather than physical considerations. The analysis employs a perturbation technique developed by Burrows (1967, 1968, 1973), which because of its simplicity, is the key to the entire solution. The analysis is restricted to the case of backscattering from a perfectly conducting surface. General expressions are presented for the scattering from a Gaussian perfectly conducting surface characterized by an anisotropic spectrum and possessing many scales of roughness. The accuracy of the result is dependent upon the large-scale structure having large height excursions and small curvature.

Brown, G. S.↗

NASA NTRS1978

Direct measurements of the atmospheric conduction current

A method of measuring the atmospheric conduction current above the ground has been employed to obtain data for 12 weeks during the first half of 1974. The instrument consists of a split aluminum sphere suspended by insulated wires to a wooden frame. The measuring electronics and the transmitter are enclosed within the spherical structure. The interaction of the instrument with its atmospheric electrical environment is analyzed, and it is shown that in steady state conditions, predictable differences in the instrumentally measured currents and the atmospheric conduction current will be less than 5% and in the nonsteady state situations the difference is less than 20%. Diurnal variations, a probable winter-summer variation, sunrise, and fog effects were observed for the data obtained during fair-weather conditions. Disturbed weather data are interpreted for the effects of low clouds on the atmospheric current. The charge concentrations within overcast clouds sufficient to produce the observed reversed atmospheric currents are estimated to be small in relation to values in thunderclouds.

Burke, H. K.↗

NASA NTRS1978

Continuous-flow electrophoresis: Membrane-associated deviations of buffer pH and conductivity

The deviations in buffer pH and conductivity which occur near the electrode membranes in continuous-flow electrophoresis were studied in the Beckman charged particle electrophoresis system and the Hanning FF-5 preparative electrophoresis instrument. The nature of the membranes separating the electrode compartments from the electrophoresis chamber, the electric field strength, and the flow rate of electrophoresis buffer were all found to influence the formation of the pH and conductivity gradients. Variations in electrode buffer flow rate and the time of electrophoresis were less important. The results obtained supported the hypothesis that a combination of Donnan membrane effects and the differing ionic mobilities in the electrophoresis buffer was responsible for the formation of the gradients. The significance of the results for the design and stable operation of continuous-flow electrophoresis apparatus was discussed.

Smolka, A. J. K.↗

NASA NTRS1977

A general unified approach to modelling switching dc-to-dc converters in discontinuous conduction mode

A method for modelling switching converters in the discontinuous conduction mode is developed, whose starting point is the unified state-space representation, and whose end result is a complete linear circuit model which correctly represents all essential features, namely, the input, output, and transfer properties (static dc as well as dynamic ac small signal). While the method is generally applicable to any switching converter operating in the discontinuous conduction mode, it is extensively illustrated for the three common power stages (buck, boost, and buck-boost). The results for these converters are then easily tabulated owing to the fixed equivalent circuit topology of their canonical circuit model.

Cuk, S.↗

NASA NTRS1978

Velocity, temperature, and electrical conductivity profiles in hydrogen-oxygen MHD duct flows

This paper presents results of two-dimensional duct flow computations for radial distributions of velocity, temperature, and electrical conductivity. Calculations were carried out for the flow conditions representative of NASA Lewis hydrogen-oxygen combustion driven MHD duct. Results are presented for two sets of computations: (1) profiles of developing flow in a smooth duct, and (2) profiles of fully developed pipe flow with a specified streamwise shear stress distribution. The predicted temperature and electrical conductivity profiles for the developing flows compared well with available experimental data.

Greywall, M. S.↗

NASA NTRS1979

The effects of magnetic structure on the conduction cooling of flare loops

A model of the sheared magnetic field in a coronal loop is used to evaluate the average cross-field suppression of axial thermal conduction. If the energy source is uniform in radius, this can lead to heat-flux reduction by a factor greater than three. When the source is annular, in a region of radius where the current density and shear are peaked, the effect can be significantly larger. In one extreme case, however, in which magnetic tearing provides the heating in a very narrow layer, the spatial resonance of the source excitation in a long loop leads to approximately axial conduction.

Van Hoven, G.↗

NASA NTRS1976

Effects of friction and heat conduction on sound propagation in ducts

The theory of sound propagation is examined in a viscous, heat-conducting fluid, initially at rest and in a uniform state, and contained in a rigid, impermeable duct with isothermal walls. Topics covered include: (1) theoretical formulation of the small amplitude fluctuating motions of a viscous, heat-conducting and compressible fluid; (2) sound propagation in a two dimensional duct; and (3) perturbation study of the inplane modes.

Huerre, P.↗

NASA NTRS1978

An assessment of LACIE and related methodologies for conducting crop inventories

The Large Area Crop Inventory Experiment (LACIE) is a joint undertaking of the U.S. Department of Agriculture, the National Oceanic and Atmospheric Administration of the U.S. Department of Commerce, and the National Aeronautics and Space Administration. It is designed to verify an economically important application of remote sensing from earth orbital satellites. The first two phases of the experiment have been completed. A description of the experiment and a short discussion on the results and conclusions of the first two phases are presented. The LACIE design is compared with other designs for conducting crop inventories. An integrated design methodology (based upon accumulated LACIE experience) is discussed for conducting crop acreage surveys in developing countries.

Tokerud, R. E.↗

NASA NTRS1979

Near-surface daytime thermal conductivity in the lunar regolith

If mass and heat transport properties in the top few cm of the lunar surface correspond, estimates of the daytime thermal conductivity based on the diffusivity calculated from in situ concentration gradients of low temperature volatile elements should be possible. Concentration gradients of Hg and Br in response to the diurnal heat pulse have been measured in samples from cores. The conductivity estimated is either approximately 10 to the -3rd or approximately 2 x 10 to the -4th W/cm-degrees K depending on the assumptions made. The latter value is in agreement with near-surface daytime thermal properties calculated by Keihm et al. (1973) to explain the mean surface temperature. An activation energy for diffusion of Hg in the top few cm of the lunar surface is estimated to be approximately 8 kcal/mole and suggests either vapor or surface migration. Fixation of the concentration gradient after the cores were extracted may be due to lack of a temperature gradient to act as a driving force or to disruption of grain contacts or their corrosion on exposure to air.

Reed, G. W., Jr.↗

NASA NTRS1980

The potential for damage from the accidental release of conductive carbon fibers from aircraft composites

The paper considers the potential for damage from the accidental release of conductive carbon fibers from aircraft composites. The electrical conductivity of carbon and graphite fibers has led to electrical equipment damage from the inadvertent release of virgin fibers into the atmosphere; an accidental release of carbon fibers from filamentary composites from the burning of crashed commercial airliners could damage electrical and electronic equipment. The experimental and analytical results by NASA of the methods of assessing the extent of potential damage in terms of costs is presented; the NASA materials research program to provide alternate or modified composites to overcome electrical hazards of carbon composites in aircraft structures is described.

Bell, V. L.↗

NASA NTRS1980

Application of finite-element-techniques to the interaction of conduction and radiation in an absorbing, scattering and emitting medium

In this paper, the authors demonstrate that a Galerkin finite element method of analysis, utilizing isoparametric elements, offers a viable means of solving continuum thermal radiation problems with conduction in a participating medium. The participating medium was considered to be a gray radiation medium exhibiting isotropic absorption, emission, and scattering characteristics and optical properties that are independent of temperature. The medium was considered to be bounded by infinite parallel opaque, gray surfaces with diffuse emission and reflection characteristics. In solving this problem, a finite element formulation was developed to describe a system in radiative equilibrium. Then the results of this first analysis were linked with a second finite element model which incorporated conduction into the analysis. The results of this study were found to be in good agreement with existing published data. The model offers the following advantageous features: geometric generality, a computational algorithm which is 'convenient' and 'computable', and a functional basis for extension of the radiation model to higher order approximation.

Wu, S. T.↗

NASA NTRS1981

Radiated and conducted EMI from a 30-cm ion thruster

In order to properly assess the interaction of a spacecraft with the EMI environment produced by an ion thruster, the EMI environment was characterized. Therefore, radiated and conducted emissions were measured from a 30-cm mercury ion thruster. The ion thruster beam current varied from zero to 2.0 amperes and the emissions were measured from 5 KHz to 200 MHz. Several different types of antennas were used to obtain the measurements. The various measurements that were made included: magnetic field due to neutralizer/beam current loop; radiated electric fields of thruster and plume; and conducted emissions on arc discharge, neutralizer keeper and magnetic baffle lines.

Whittlesey, A. C.↗

NASA NTRS1981

Capabilities offered by the Space Transportation System for the conduct of scientific experiments

The capabilities of the Space Transportation System (STS) to support the conduct of scientific investigations in space are reviewed for two modes of operation - dedicated Spacelab missions and mixed cargo missions. Along with these capabilities exist certain limitations. Their significance and NASA's approach for dealing with them are described. Examples of the unique aspects of the STS's capabilities are demonstrated by citing some of the investigations under development for early STS missions and others planned for future development. In addition, augmentation packages to increase STS capabilities are reviewed, and their impact on the conduct of future scientific investigations is projected.

Bensimon, M.↗

NASA NTRS1980

Nordheim-Gorter like behavior and one carrier conduction in a quasi-one-dimensional system

A linear correlation has been observed between the thermopower and the conductivity in the high-temperature state (T greater than 220 K) of the TTF halide and pseudohalide salts. It is suggested that this correlation indicates conduction by a single type of carrier under two types of scattering and represents the first reported extension of the Nordheim-Gorter behavior to any quasi-one-dimensional conductor.

Datta, T.↗

NASA NTRS1981

Effect of thermal conduction and radiation on the dynamics of a flaring coronal loop

A systematic study of the effects of thermal conduction and radiation (Cox-Tucker type) on the dynamic response of a coronal loop is presented. The study is based on a one-fluid hydrodynamic description of a magnetic flux loop subject to a sudden localized heating, simulating the flare energy release. Numerical results are obtained for the heating of a full loop at one end and symmetrical heating at both ends. The results show that: (1) the basic response is the propagation of a hydrodynamic shock; (2) thermal conduction (Coulomb type) has significant effects; and radiation has only minor influence unless the density exceeds 10 to the 11th per cu cm. It is noted that the uniform flaring of a loop is associated with heating of long duration. Short pulse-like heating results in the nonuniform brightening and propagation of luminous fronts similar to that sometimes observed in flare loops.

Wu, S. T.↗

NASA NTRS1981

Numerical stability of an explicit finite difference scheme for the solution of transient conduction in composite media

A theoretical evaluation of the stability of an explicit finite difference solution of the transient temperature field in a composite medium is presented. The grid points of the field are assumed uniformly spaced, and media interfaces are either vertical or horizontal and pass through grid points. In addition, perfect contact between different media (infinite interfacial conductance) is assumed. A finite difference form of the conduction equation is not valid at media interfaces; therefore, heat balance forms are derived. These equations were subjected to stability analysis, and a computer graphics code was developed that permitted determination of a maximum time step for a given grid spacing.

Campbell, W.↗