Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “wave data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31
All sourcesNASA NTRSDOE OSTI
NASA NTRS2010

High-Efficiency K-Band Space Traveling-Wave Tube Amplifier for Near-Earth High Data Rate Communications

The RF performance of a new K-Band helix conduction cooled traveling-wave tube amplifier (TWTA), is presented in this paper. A total of three such units were manufactured, tested and delivered. The first unit is currently flying onboard NASA's Lunar Reconnaissance Orbiter (LRO) spacecraft and has flawlessly completed over 2000 orbits around the Moon. The second unit is a proto-flight model. The third unit will fly onboard NASA's International Space Station (ISS) as a very compact and lightweight transmitter package for the Communications, Navigation and Networking Reconfigurable Testbed (CoNNeCT), which is scheduled for launch in 2011. These TWTAs were characterized over the frequencies 25.5 to 25.8 GHz. The saturated RF output power is greater than 40 W and the saturated RF gain is greater than 46 dB. The saturated AM-to-PM conversion is 3.5 /dB and the small signal gain ripple is 0.46 dB peak-to-peak. The overall efficiency of the TWTA, including that of the electronic power conditioner (EPC) is as high as 45%.

Simons, Rainee N.↗
NASA NTRS1990

Flow separation in oblique shock wave turbulent boundary layer interactions

Available experimental data on flow separation in shock wave turbulent boundary layer interactions are reviewed at hypersonic and supersonic speeds in two dimensional and axisymmetric interactions. The conditions leading to flow separation and the subsequent changes in the flow are discussed. The effects of the Mach number, Reynolds number, surface cooling and the methods of detecting separation are discussed. Pertinent experimental data for the separated flow characteristics in turbulent boundary layer oblique shock wave interactions are also presented and discussed. Empirical correlations for separated flows are also reviewed.

Hamed, A.↗
NASA NTRS1994

Equatorial Kelvin waves: A UARS MLS view

Data from the Microwave Limb Sounder (MLS) instrument on the Upper Atmosphere Research Satellite (UARS) are used to compare two periods of Kelvin wave activity during different stages of the equatorial quasi-biennial oscillation. The analysis is carried out using an asynoptic mapping technique. A wide bandpass filter is used to isolate the frequency bands where Kelvin waves have been identified in previous studies. Time-height and time-latitude plots of the bandpassed data are used to identify Kelvin wave activity in the temperature and ozone fields. Frequency spectra of temperature and ozone amplitudes are constructed to further analyze the latitudinal and meridional distribution of Kelvin wave activity in zonal wavenumbers 1 and 2. The characteristics identified in these plots agree well with theoretical predictions and previous observations of middle atmosphere Kelvin waves. The time-height and time-latitude plots support the existence of Kelvin waves in discrete frequency bands; the slow, fast, and ultrafast Kelvin modes are all identified in the data. The characteristics of these modes do not vary much despite different mean flow conditions in the two periods examined. For the Kelvin wave-induced perturbations in ozone, the change from a transport-dominated regime below 10 hPa to a photochemically controlled regime above 10 hPa is clearly apparent in the height dependence of the phase difference between temperature and ozone. The ratios of the ozone perturbation amplitude to the temperature perturbation amplitude for the various observed Kelvin wave modes are in agreement with model estimates and LIMS (Limb Infrared Monitor of the Stratosphere) observations in the lower half of the region sampled but appear to be too large in the upper stratosphere and lower mesosphere.

Canziani, Pablo O.↗
DOE OSTI2020

A global ensemble of ocean wave climate projections from CMIP5-driven models

This dataset, produced through the Coordinated Ocean Wave Climate Project (COWCLIP) phase 2, represents the first coordinated multivariate ensemble of 21st Century global wind-wave climate projections available (henceforth COWCLIP2.0). COWCLIP2.0 comprises general and extreme statistics of significant wave height (H S ), mean wave period (T m ), and mean wave direction (θ m ) computed over time-slices 1979–2004 and 2081–2100, at different frequency resolutions (monthly, seasonally and annually). The full ensemble comprising 155 global wave climate simulations is obtained from ten CMIP5-based state-of-the-art wave climate studies and provides data derived from alternative wind-wave downscaling methods, and different climate-model forcing and future emissions scenarios. The data has been produced, and processed, under a specific framework for consistency and quality, and follows CMIP5 Data Reference Syntax, Directory structures, and Metadata requirements. Technical comparison of model skill against 26 years of global satellite measurements of significant wave height has been undertaken at global and regional scales. This new dataset provides support for future broad scale coastal hazard and vulnerability assessments and climate adaptation studies in many offshore and coastal engineering applications.

Science & Technology - Other Topics↗
NASA NTRS1971

Theoretical calculation of plane wave speeds for alkali metals under pressure.

Theoretical calculations of the variation with pressure of small amplitude plane wave speeds are performed for sodium and potassium at zero temperature. The results obtained for wave speeds associated with volume dependent second-order elastic coefficients show better agreement with experimental data than for wave speeds associated with shear dependent coefficients. This result is believed to be due to omission of the band structure correction to the strain energy density.

Eftis, J.↗
DOE OSTI2022

Nondestructive Evaluation of Stress Corrosion Cracking in a Welded Steel Plate Using Guided Ultrasonic Waves

Stress corrosion cracking (SCC) had occurred in early-generation high-level nuclear waste tanks constructed by welding carbon steel. This paper describes an ultrasonic inspection system and its fundamental ability to detect and quantify the length of SCC on thick welded steel plates. The finite element method (FEM) was applied to simulate the welding process to estimate the welding residual stress field. Growth of stress corrosion cracks is driven by crack stress intensities exceeding the subcritical cracking threshold intensity. The subject plate was experimentally inspected with ultrasonic nondestructive evaluation (NDE) techniques to characterize the extent of SCC. The NDE system uses a piezoelectric transducer to generate guided waves in the thick steel plate, and a scanning laser Doppler vibrometer (SLDV) to measure multidimensional time–space wavefield data over a user-defined scanning area in the plate surface. The measured wavefield data can show wave interactions in a localized area in the plate due to the presence of the discontinuities of the SCC. To generate an inspection image that can precisely show the crack’s location and/or the dimension, the wavefield data are further processed to generate inspection image that maps the entire sample plate so the crack can be clearly identified in the plate while its length can be readily estimated. In conclusion, the ultrasonic test results for crack length agree well with the visually estimated length and are close to that predicted by the FEM for cracks in the weld residual stress field.

36 MATERIALS SCIENCE↗
NASA NTRS1974

Flight test measurements and analysis of sonic boom phenomena near the shock wave extremity

A NASA flight test program conducted during the summer and fall of 1970 was devoted to investigating sonic boom phenomena near caustics formed by steady flight near the threshold Mach number, during accelerations, and at the lateral extremes of the ground carpet. The vertical extent of the shock waves attached to near-sonic airplanes was also studied. The flights were conducted over the 1500 ft instrumented BREN tower so that vertical surveys through the shock waves were measured. These data on caustic phenomena near the shock wave extremity were analyzed in detail and compared with theoretical results. Amplifications of shock wave strength varied from 2 to 5 during longitudinal accelerations, from 1 to 1.8 during steady threshold Mach number flight, and up to 3 for small inadvertent accelerations during flight near the threshold Mach number.

Haglund, G. T.↗
NASA NTRS1986

Effects of anisotropy on the frequency spectrum of gravity waves observed by MST radar

In the investigation of gravity waves using mesosphere-stratosphere-troposphere radar data, model gravity-wave spectra have been used. In these model spectra, one usually assumes azimuthal symmetry. The effect of spectral anisotropy on the observed spectrum is studied here. It is shown that for a general Garrett-Munk-type spectrum, the anisotropy does not affect the frequency spectrum observed by the vertically beamed radar. For the oblique beam, however, the observed frequency spectrum is changed. A general gravity wave spectrum including azimuthal anisotropy is considered.

Liu, C. H.↗
NASA NTRS2007

A Fast Method of Deriving the Kirchhoff Formula for Moving Surfaces

The Kirchhoff formula for a moving surface is very useful in many wave propagation problems, particularly in the prediction of noise from rotating machinery. Several publications in the last two decades have presented derivations of the Kirchhoff formula for moving surfaces in both time and frequency domains. Here we present a method originally developed by Farassat and Myers in time domain that is both simple and direct. It is based on generalized function theory and the useful concept of imbedding the problem in the unbounded three-dimensional space. We derive an inhomogeneous wave equation with the source terms that involve Dirac delta functions with their supports on the moving data surface. This wave equation is then solved using the simple free space Green's function of the wave equation resulting in the Kirchhoff formula. The algebraic manipulations are minimal and simple. We do not need the Green's theorem in four dimensions and there is no ambiguity in the interpretation of any terms in the final formulas. Furthermore, this method also gives the simplest derivation of the classical Kirchhoff formula which has a fairly lengthy derivation in physics and applied mathematics books. The Farassat-Myers method can be used easily in frequency domain.

Farassat, F.↗
DOE OSTI2021

Wave Measurements Using Multi-Frame Processing of Marine Radar Data

Marine radars have proven to be useful for measuring ocean waves, but the accuracy of the measurements is limited by several factors including the look-angle dependence of the radar signals as well as noise in the radar data. The look-angle dependence introduces a systematic error or bias in the measurements, and noise causes a random error. This paper describes a method of combining data from multiple radar frames that is optimal in the sense of minimizing the error for a set of biased measurements with random additive noise. The results are shown experimentally to increase the correlation of the radar estimates with buoy measurements.

47 OTHER INSTRUMENTATION↗
NASA NTRS1981

Plasma waves associated with energetic particles streaming into the solar wind from the earth's bow shock

Plasma wave and plasma data from ISEE 1 and 2 are examined. In the upstream solar wind, three dominant types of plasma waves are observed which are associated with energetic particle streams coming from the bow shock: ion acoustic waves, electron plasma oscillations, and whistler mode waves. The ion acoustic waves occur simultaneously with either ion beams or a dispersed ion population in the energy range from 0.5 to greater than 45 keV. The electron plasma oscillations are long-wavelength, nearly monochromatic electrostatic waves which are closely correlated with the flux of low-energy electrons, especially in the 0.2-1.5 keV range. Electromagnetic waves with frequencies below 200 Hz are observed when either ion beams or dispersed ion distributions are present; for these waves the refractive index determined from the wave B to E ratio is consistent with whistler mode radiation.

Anderson, R. R.↗
NASA NTRS1996

Evidence of Boundary Reflection of Kelvin and First-Mode Rossby Waves

TOPEX/POSEIDON sea level data leads to new opportunities to investigate some theoretical mechanisms suggested to be involved in the El Nino/Southern Oscillation phenomenon in the tropical Pacific ocean. In particular, we are interested in studying the western boundary reflection, a process crucial for the delayed action oscillator theory, by using the TOPEX/POSEIDON data from November 1992 to May 1995.

boundary reflection TOPEX/POSEIDON↗
NASA NTRS1980

Results of an ISEE-1 experiment to study the interactions between energetic particles and discrete VLF waves in the magnetosphere

Despite the malfunctioning of the digital portion of the experiment which is encoding the absolute amplitude of the wave spectrum with a fixed bias of approximately 20 dB, the analog portion of the instrument is acquiring excellent data concerning the wave function and relative amplitude. Results obtained over a 2-year period which have important implications for magnetospheric wave-particle interactions are examined in the areas of emission generation by nonconducted coherent waves, and cold plasma distribution in the inner magnetosphere.

Source record↗
NASA NTRS1987

Archival of Seasat-A satellite scatterometer data merged with in situ data at selected, illuminated sites over the ocean

A large data base of Seasat-A Satellite Scatterometer (SASS) measurements merged with high-quality surface-truth wind, wave, and temperature data has been documented. The data base was developed for all times when selected in situ measurement sites were within the SASS footprint. Data were obtained from 42 sites located in the coastal waters of North America, Australia, Western Europe, and Japan and were assembled by correlating the SASS and surface-truth measurements in both time and distance. These data have been archived on a set of nine-track 6250 bpi ASCII coded magnetic tapes, which are available from the National Technical Information Service.

Schroeder, Lyle C.↗
NASA NTRS2002

Nonlinear Internal Waves in the South China Sea During ASIAEX

Internal wave distribution maps have been compiled from more than one hundred ERS-1/2, RADARSAT and Space Shuttle SAR images in the South China Sea (SCS) from 1993 to 2000. Based on these distribution maps, most of internal waves in the northeast part of SCS were propagating westward. The wave crest can be as long as 200 km with amplitude of 100 m, due to strong current from the Kuroshio branching out into the SCS. In recent Asian Seas International Acoustics Experiment (ASIAEX), moorings have been deployed in April 2000 and May 2001. Simultaneous RADARSAT ScanSAR images have been collected during the field test to integrate with the model and the in-situ measurements in the SCS. During ASIAEX in May 2001, many large internal waves were observed at the test area and were the major features for acoustic volume interaction. The environmental parameters have been calculated based on extensive CTD castings and mooring data. Nonlinear internal wave models have been applied to simulate the wave evolution on the continental shelf and the results compare reasonably with mooring measurements. The evolution and dissipation of huge internal waves on the shelf break, mode-two waves, elevation waves, and wave-wave interaction are very important issues for acoustic propagation. The implication of internal wave effects on acoustic propagation will also be discussed.

ACOUSTIC PROPAGATION↗
NASA NTRS2006

Status of MTP Data Analysis for TCSP

Topics covered include: a) MTP temperature calibration and data analysis; b) Background for interpreting MTP data; c) Large amplitude temperature structure; d) Gravity waves (GWs) in MTP data; and e) Subsidence over hurricanes.

hurricanes↗