Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “hypersonic flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31
All sourcesNASA NTRSDOE OSTI
NASA NTRS1962

A Preliminary Theoretical Study of the Expansion Tube, a New Device for Producing High-Enthalpy Short-Duration Hypersonic Gas Flows

A preliminary theoretical study was conducted of a new technique for producing high-enthalpy gas flows. The device considered utilizes an unsteady expansion process for the purpose of total-enthalpy multiplication. Analyses were conducted for both perfect and real air in equilibrium, assuming idealized diaphragm bursts, centered expansion waves, and continuum flow. Results of the study showed the expansion tube capable of outperforming the conventional shock tunnel by a factor of approximately 2 in velocity for the same test-section ambient density and pressure. The degree of dissociation is low at all phases of the thermodynamic cycle in the expansion tube; thus the test-section air has a good possibility of being in equilibrium. Maximum pressures involved in the cycle for duplicating a typical reentry from, a lunar mission are low enough for existing pressure-vessel techniques. Both the known and anticipated advantages and disadvantages of this new concept are also discussed.

TUBING↗
NASA NTRS1972

Hypersonic rarefied flow over sharp slender cones

Drag, heat transfer, and number flux were measured on sharp cones in the near free, molecule flow regime, and the results were compared with available Monte Carlo calculations. In general, the calculations predicted the magnitude of the data; however, the heat transfer and drag increased with increasing Knudsen number at a faster rate than predicted. Also the drag coefficients measured for the slender cones at high Knudsen number were higher than predicted for free molecule flow. These disagreements between theory and experiment could possibly be attributed to the simplicity of the surface interaction laws assumed in the theory. Reynolds analogy factors obtained from the experimental measurements agreed with free-molecule values and also with that obtained by the Monte Carlo technique.

Kussoy, M. I.↗
NASA NTRS1973

Computer programs for predicting supersonic and hypersonic interference flow fields and heating

This report describes computer codes which calculate two-dimensional shock interference patterns. These codes compute the six types of interference flows as defined by Edney (Aeronaut. Res. Inst. of Sweden FAA Rep. 115). Results include properties of the inviscid flow field and the inviscid-viscous interaction at the surface along with peak pressure and peak heating at the impingement point.

Morris, D. J.↗
NASA NTRS1974

Hypersonic nonequilibrium flow past a sphere at low Reynolds numbers

Detailed flow field properties are computed in the nose region of a sphere from the Navier-Stokes equations for a range of Reynolds numbers. Comparisons are made of theoretical flow fields with those obtained in experiments and also with other analyses. In particular, the effects of various approximations on the flow field are investigated. It is shown that the Navier-Stokes model consistently predicts a smaller region of disturbance upstream of a sphere than that in experiments.

Li, C. P.↗
NASA NTRS1974

Raman scattering applied to hypersonic air flow

The Raman scattering technique was applied to measure the local static temperature and gas number density over a sharp-edge flat-plate model in a Mach 5 nozzle of the Langley nozzle test chamber with air as the test gas. The angle of attack varied from -5 to 15 deg, and the stagnation temperature varied from 317 to 442 K, with stagnation pressures ranging from 170 kN to 2.8 MN/sq m. The measured values of static temperature and density ranged from 60 to 100 K and from 0.03 to 0.8 kg/cu m, respectively. A comparison with calculated values based on static pressure measurements along the model shows that the Raman scattering technique is a viable measurement method in applications to high-speed three-dimensional flows.

Hillard, M. E., Jr.↗
NASA NTRS1975

Correlation of boundary layer quantities for hypersonic laminar flows with zero pressure gradient for several gases

The laminar boundary layer has been theoretically studied for six gases for flows over cold walls with zero pressure gradient at Mach numbers between 5.5 and 12.5 to correlate boundary layer quantities for the various gases. The flow conditions considered correspond to those that can be generated in test facilities such as the shock tunnel and the expansion tube. Computed results obtained using real gas properties indicate that the Eckert number based on edge conditions serves to correlate the results in terms of the wall shear stress and enthalpy gradient, the Stanton number, and the momentum thickness for the various gases within plus or minus 10 per cent for Te = Tw and Te approximately 3Tw. Computed Reynolds analogy factors exhibit very good agreement with those predicted by the Colburn analogy. Velocity and displacement thicknesses correlate well with Eckert number for Te = Tw, but fail to correlate for Te approximately 3Tw. Differences in results are traced to property variations. Results show that the Eckert number is a significant correlating variable for the flows considered.

Cook, W. J.↗
NASA NTRS1977

Downstream influence of swept slot injection in hypersonic turbulent flow

Results of an experimental and numerical investigation of tangential swept slot injection into a thick turbulent boundary layer at Mach 6 are presented. Film cooling effectiveness, skin friction, and flow structure downstream of the swept slot injection were investigated. The data were compared with that for unswept slots, and it was found that cooling effectiveness and skin friction reductions are not significantly affected by sweeping the slot.

Hefner, J. N.↗
NASA NTRS1981

A numerical simulation of hypersonic viscous flow over arbitrary geometries at angle of attack

An implicit conservative, noniterative, finite-difference algorithm that predicts the supersonic, laminar or turbulent viscous flow about arbitrary geometries at large angles of attack is presented. The three-dimensional parabolized form of the thin-layer Navier-Stokes equations are written in generalized coordinates. These equations are solved using the delta form of the Beam-Warming implicit algorithm. Flow field simulations have been obtained for a blunt biconic with windward and leeward cuts and an X-24C lifting body for both laminar and turbulent flow at various Mach numbers and angles of attack. When compared with experiment or with previous theories, these computational predictions show good agreement.

Chaussee, D. S.↗
NASA NTRS1981

Computation of hypersonic viscous flow around three-dimensional bodies at high angles of attack

A parabolized Navier-Stokes code capable of predicting steady viscous supersonic flows with cross-flow separation is applied to three-dimensional arbitrary geometries at high angles of attack. The numerical procedure, which is implicit, noniterative, and of second-order accuracy in the marching direction, has been used to compute complicated flow fields containing a relatively thick sonic layer and regions of strong viscous-inviscid interaction. A consistent and accurate procedure has also been developed to provide the necessary starting data through timewise integration of the equations of motion near the nose-tip region of the body. Numerical results obtained from the present method compare well with experiment for both the surface pressures and heat transfer.

Rizk, Y. M.↗
NASA NTRS1986

Study of hypersonic inlet flow fields with a three-dimensional Navier-Stokes code

A three-dimensional Navier-Stokes code is used to study the flow through an inlet with a rectangular capture area, but with circular or essentially circular internal cross-sections. The inlet may have a center body extending partially or fully over the length of the inlet. Calculations are made under a variety of geometrical constraints imposed on the inlet cross-sections to study the flow quality in the inlet. It is observed that for this class of inlets, the boundary layer has a tendency to thicken and separate readily due to the adverse pressure gradient caused by the continuous compression in the inlet. Since no experimental results are yet available, this paper has presented only the numerical results from the present analysis.

Kumar, A.↗
NASA NTRS1986

Direct simulation of hypersonic transitional flow

A review of recent calculations obtained with Bird's direct simulation Monte Carlo (DSMC) method are presented for the transitional flowfield encountered at reentry conditions. Consequently, the emphasis is to simulate the real-gas effects resulting from a highly energetic nonequilibrium flow. The DSMC calculations for both wide-angle and slender bodies are compared with experimental and continuum calculations. The wide angle body calculations simulate the windward nose of the Shuttle Orbiter and projected aeroassisted orbital transfer vehicles. For the slender, blunted configurations, both two-dimensional and axisymmetric results are presented. Comparisons between the DSMC and continuum calculations show the altitude range where differences in flowfield structure and surface quantities become significant.

Moss, J. N.↗