Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “WIND PRESSURE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

Simultaneous Global Pressure and Temperature Measurement Technique for Hypersonic Wind Tunnels

High-temperature luminescent coatings are being developed and applied for simultaneous pressure and temperature mapping in conventional-type hypersonic wind tunnels, providing global pressure as well as Global aeroheating measurements. Together, with advanced model fabrication and analysis methods, these techniques will provide a more rapid and complete experimental aerodynamic and aerothermodynamic database for future aerospace vehicles. The current status in development of simultaneous pressure- and temperature-sensitive coatings and measurement techniques for hypersonic wind tunnels at Langley Research Center is described. and initial results from a feasibility study in the Langley 31-Inch Mach 10 Tunnel are presented.

Buck, Gregory M.↗
NASA NTRS2013

Strong Temporal Variation Over One Saturnian Year: From Voyager to Cassini

Here we report the combined spacecraft observations of Saturn acquired over one Saturnian year (approximately 29.5 Earth years), from the Voyager encounters (1980-81) to the new Cassini reconnaissance (2009-10). The combined observations reveal a strong temporal increase of tropic temperature (approximately 10 Kelvins) around the tropopause of Saturn (i.e., 50 mbar), which is stronger than the seasonal variability (approximately a few Kelvins). We also provide the first estimate of the zonal winds at 750 mbar, which is close to the zonal winds at 2000 mbar. The quasi-consistency of zonal winds between these two levels provides observational support to a numerical suggestion inferring that the zonal winds at pressures greater than 500 mbar do not vary significantly with depth. Furthermore, the temporal variation of zonal winds decreases its magnitude with depth, implying that the relatively deep zonal winds are stable with time.

Cassini↗
DOE OSTI2021

Tower Water-Vapor Mixing Ratio Value-Added Product Report

The purpose of the Tower Water-Vapor Mixing Ratio (TWRMR) value-added product (VAP) is to calculate water-vapor mixing ratios at the 25-meter and 60-meter levels of the meteorological tower and also report best-estimate temperature, relative humidity, and pressure measurements at the 2-meter, 25-meter, and 60-meter levels at the Atmospheric Radiation Measurement (ARM) user facility Southern Great Plains (SGP) Central Facility. Because there are no barometric pressure sensors at the 25-meter and 60-meter levels on the tower, the hypsometric equation is used along with surface pressure values from the surface meteorological instrumentation (MET), the surface meteorological observation system (SMOS), or the temperature, humidity, wind, and pressure system (THWAPS) to derive barometric pressures at those altitudes (Ritsche 2008, 2011a, 2011b). After this is done, water-vapor mixing ratio can be calculated directly.

54 ENVIRONMENTAL SCIENCES↗
NASA NTRS1979

Inhibition of solar wind impingement on Mercury by planetary induction currents

Analytic methods are developed for taking into account finite planetary conductivity in modeling departures from equilibrium of a magnetospheric boundary caused by solar wind stagnation pressure variations. Using the lowest suggested value of the planetary dipole moment (2.4 x 10 to the 22nd G cu cm), it is estimated that a minimum pressure of about 38 P sub 0 (where P sub 0 is the external stagnation pressure in the steady state) is required to force the standoff distance down to the subsolar surface of Mercury if the pressure change persists for at least 1 day. This value is 4.3 times that which would be predicted if Mercury had no core, and it is larger than the maximum pressure predicted at Mercury's orbit (about 25 P sub 0) on the basis of hourly averaged solar wind statistics at 1 AU.

Hood, L. L.↗
NASA NTRS1983

Cape Canaveral, Florida range reference atmosphere 0-70 km altitude

The RRA contains tabulations for monthly and annual means, standard deviations, skewness coefficients for wind speed, pressure temperature, density, water vapor pressure, virtual temperature, dew-point temperature, and the means and standard deviations for the zonal and meridional wind components and the linear (product moment) correlation coefficient between the wind components. These statistical parameters are tabulated at the station elevation and at 1 km intervals from sea level to 30 km and at 2 km intervals from 30 to 90 km altitude. The wind statistics are given at approximately 10 m above the station elevations and at altitudes with respect to mean sea level thereafter. For those range sites without rocketsonde measurements, the RRAs terminate at 30 km altitude or they are extended, if required, when rocketsonde data from a nearby launch site are available. There are four sets of tables for each of the 12 monthly reference periods and the annual reference period.

Tingle, A.↗
NASA NTRS1995

Plasmas in the outer heliosphere

We review the observed properties of the solar wind in the outer heliosphere, including observations from Voyager and the Pioneers, as well as from inner heliospheric probes as appropriate. These observations are crucial to modeling of the heliosphere and its interactions with the interstellar medium, since the wind ram pressure and its temporal variations are important in understanding the distance to the termination shock and heliopause and how those boundaries might vary in time. We focus on results since Solar Wind 7. Among the issues we will discuss are: (1) the time scales for and statistical properties of variations in the ram pressure in the outer heliosphere, and how those variations might affect the morphology of the heliospheric/interstellar medium interface; (2) the question of possible solar wind slowing in the outer heliosphere due to the pick-up of interstellar ions; (3) the issue of whether there is bulk heating of the solar wind associated either with interstellar ion pick-up or with continued heating due to stream-stream interactions; (4) evidence for latitudinal variations in solar wind properties; and (5) the 1.3 year periodicities apparent in the outer heliosphere, and the close correspondence with similar variations seen with inner heliospheric probes.

Belcher, J. W.↗
DOE OSTI2012

STELLAR WIND INFLUENCE ON PLANETARY DYNAMOS

We examine the possible influence of early stellar wind conditions on the evolution of planetary dynamo action. In our model, the dynamo operates within a significant ambient magnetospheric magnetic field generated by the interaction between the stellar wind and the planetary magnetic field. This provides a negative feedback mechanism which quenches the dynamo growth. The external magnetic field magnitude which the dynamo experiences, and thus the strength of the quenching, depends on the stellar wind dynamic pressure. As this pressure significantly changes during stellar evolution, we argue that under early stellar system conditions the coupling between the stellar wind and the interior dynamics of a planet is much more important than has been thought up to now. We demonstrate the effects of the feedback coupling in the course of stellar evolution with a planet at a similar distance to the central star as Mercury is to the Sun.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1986

Liquid crystals for high-altitude in-flight boundary layer flow visualization

A novel method for visualization of laminar to turbulent boundary layer transition in flight is presented, in which liquid crystal coatings are used to indicate the transition by a change of color (in response to the changes in the wall shear and the temperature). The liquid crystals applied to the wing surfaces were either cholesteric crystals formulated to be active between temperatures of 30 and 100 F or a sample of chiral nematic liquid crystals formulated to be active between -18 and -22 F. Liquid crystal coatings were shown to provide visualization data at flight altitudes and temperatures at which data could not be obtained previously. Flight evaluations were successfully conducted on a T-34C and a Learjet research aircraft at Mach numbers of up to 0.8 and altitudes of up to 50,000 ft. The time response during oscillating sideslip tests was very rapid. In wind tunnel tests, a hysteresislike behavior was observed in the liquid crystal coatings, possibly because of the lower dynamic pressures in wind tunnels as compared to flight.

Gall, P. D.↗
NASA NTRS1990

Simulation of pressure and temperature responses for the 20 Inch Supersonic Wind Tunnel

A simulation of the pressure and temperature responses of the 20 inch Supersonic Wind Tunnel (SWT) is developed. The simulation models the tunnel system as a set of lumped parameter volumes connected by flow regulating elements such as valves and nozzles. Simulated transient responses of temperature and pressure for the five boundary points of the 20 inch SWT operating map are produced from their respective initial conditions, tunnel operating conditions, heater input power, and valve positions. Upon reaching steady state, a linearized model for each operating point is determined. Both simulated and actual tunnel responses are presented for comparison.

Motter, Mark A.↗
DOE OSTI2017

Location of intense electromagnetic ion cyclotron (EMIC) wave events relative to the plasmapause: Van Allen Probes observations

In this paper, we have studied the spatial location relative to the plasmapause (PP) of the most intense electromagnetic ion cyclotron (EMIC) waves observed on Van Allen Probes A and B during their first full precession in local time. Most of these waves occurred over an L range of from -1 to +2 R E relative to the PP. Very few events occurred only within 0.1 R E of the PP, and events with a width in L of < 0.2 R E occurred both inside and outside the PP. Wave occurrence was always associated with high densities of ring current ions; plasma density gradients or enhancements were associated with some events but were not dominant factors in determining the sites of wave generation. Storm main and recovery phase events in the dusk sector were often inside the PP, and dayside events during quiet times and compressions of the magnetosphere were more evenly distributed both inside and outside the PP. Superposed epoch analyses of the dependence of wave onset on solar wind dynamic pressure (Psw), the SME (SuperMAG auroral electrojet) index, and the SYM-H index showed that substorm injections and solar wind compressions were temporally closely associated with EMIC wave onset but to an extent that varied with frequency band, magnetic local time, and storm phase, and location relative to the PP. Finally, the fact that increases in SME and Psw were less strongly correlated with events at the PP than with other events might suggest that the occurrence of those events was affected by the density gradient.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1987

Solar cycle changes in the ionization sources of the nightside Venus ionosphere

Using new and previous experimental evidence, it is argued that the height-integrated flux of O(+) ions transported from the dayside Venus ionosphere into the nightside ionosphere is strongly reduced (shut off) at solar cycle minimum (SCmin) and that the electron impact source becomes the predominant nightside ionization source during this phase of the solar cycle. The height-integrated transterminator O(+) flux, which is probably the dominant nightside ionization source at solar cycle maximum (SCmax), is shut off at SCmin by compression of the dayside ionopause to low altitude. It is suggested that the ionopause is depressed because the dayside ionospheric kinetic pressure field is reduced by a factor of approximately 3 from its SCmas value and that the typical SCmin solar wind dynamic pressure, which is not less than the typical SCmax value, cannot be balanced by the ionospheric pressure field at altitudes above approximately 250 km.

Knudsen, William C.↗
NASA NTRS2004

Clouds Aerosols Internal Affaires: Increasing Cloud Fraction and Enhancing the Convection

Clouds developing in a polluted environment have more numerous, smaller cloud droplets that can increase the cloud lifetime and liquid water content. Such changes in the cloud droplet properties may suppress low precipitation allowing development of a stronger convection and higher freezing level. Delaying the washout of the cloud water (and aerosol), and the stronger convection will result in higher clouds with longer life time and larger anvils. We show these effects by using large statistics of the new, 1km resolution data from MODIS on the Terra satellite. We isolate the aerosol effects from meteorology by regression and showing that aerosol microphysical effects increases cloud fraction by average of 30 presents for all cloud types and increases convective cloud top pressure by average of 35mb. We analyze the aerosol cloud interaction separately for high pressure trade wind cloud systems and separately for deep convective cloud systems. The resultant aerosol radiative effect on climate for the high pressure cloud system is: -10 to -13 W/sq m at the top of the atmosphere (TOA) and -11 to -14 W/sq m at the surface. For deeper convective clouds the forcing is: -4 to -5 W/sq m at the TOA and -6 to -7 W/sq m at the surface.

Koren, Ilan↗
NASA NTRS1976

Early meteorological results from the Viking 2 lander

Early results from the meteorological instruments on the Viking 2 lander are presented. As on lander 1, the daily patterns of temperature, wind, and pressure have been highly repetitive during the early summer period. The average daily maximum temperature was 241 K and the diurnal minimum was 191 K. The wind has a vector mean of 0.7 meter per second from the southeast with a diurnal amplitude of 3 meters per second. Pressure exhibits both diurnal and semidiurnal oscillations, although of substantially smaller amplitude than those of lander 1. Departures from the repetitive diurnal patterns begin to appear on sol 37.

Hess, S. L.↗
NASA NTRS1975

Integration time required to extract accurate static and dynamic data from transonic wind-tunnel tests

Because the forces and pressures on wind-tunnel models tested at transonic speeds are not steady, even for 'static' aerodynamic tests, integration time is required to obtain data of acceptable accuracy. The integration time required for both static and dynamic tests is evaluated analytically and confirmed by experimental measurements. It is shown that, for static and dynamic tests, the accuracy obtained is a function of integration time, frequency content of the signal, and the ratio of the dynamic amplitude to the full signal of interest. In addition, for the dynamic case, the frequency band width used in analysis is important. Results of this study indicate that, for typical data accuracy desired from models in a large transonic wind tunnel (11- by 11-ft), up to the following integration times are required: static force and moment tests, 0.5 sec; static pressure tests, 0.1 sec; flutter tests, 30 to 60 sec; and random-dynamic tests, 10 sec.

Muhlstein, L., Jr.↗
NASA NTRS1979

Integration Time Required to Extract Accurate Data from Transonic Wind-Tunnel Tests

Because the forces and pressures on wind-tunnel models tested at transonic speeds are not steady, even for static aerodynamic tests, integration time is required to obtain data of acceptable accuracy. The integration time required for both static and dynamic tests is evaluated analytically and confirmed by experimental measurements. It is shown that, for static and dynamic tests, the accuracy obtained is a function of integration time, frequency of the signal, and the ratio of the dynamic amplitude to the full signal of interest. In addition, for the dynamic case, the frequency bandwidth used in analysis is important. Results of this study indicate that, for typical data accuracy desired from models in a large transonic wind tunnel (11- by 11-ft), up to the following integration times are required: static force and moment tests, 0.5 s; static pressure tests, 1 s; flutter tests, 30 to 60 s; and random-dynamic tests, 10 s.

Muhlstein, Lado, Jr.↗