SEARCH · Engineering Papers

Results for “SIGNALS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31

All sources NASA NTRS DOE OSTI

NASA NTRS1989

Microwave oscillator with reduced phase noise by negative feedback incorporating microwave signals with suppressed carrier

Oscillator configurations which reduce the effect of 1/f noise sources for both direct feedback and stabilized local oscillator (STALO) circuits are developed and analyzed. By appropriate use of carrier suppression, a small signal is generated which suffers no loss of loop phase information or signal-to-noise ratio. This small signal can be amplified without degradation by multiplicative amplifier noise, and can be detected without saturation of the detector. Together with recent advances in microwave resonator Qs, these circuit improvements will make possible lower phase noise than can be presently achieved without the use of cryogenic devices.

Dick, G. J.↗

NASA NTRS1989

Application of adaptive least-squares algorithm to multi-element array signal reconstruction

Results are presented in terms of the performance improvement of a multi-feed array configuration over the usual single feed system when an adaptive least-squares algorithm is applied for the signal reconstruction. Two versions of the least-squares algorithm are presented, one of which is based on the maximization of the signal-to-noise ratio while the other is based on the deconvolution of received signal field. These algorithms were developed for the purpose of minimizing degradations arising from various sources, which can severely limit the performance (gain) of a single-feed system.

Kumar, R.↗

NASA NTRS1990

A real-time signal combining system for Ka-band feed arrays using maximum-likelihood weight estimates

A real-time digital signal combining system for use with Ka-band feed arrays is proposed. The combining system attempts to compensate for signal-to-noise ratio (SNR) loss resulting from antenna deformations induced by gravitational and atmospheric effects. The combining weights are obtained directly from the observed samples by using a sliding-window implementation of a vector maximum-likelihood parameter estimator. It is shown that with averaging times of about 0.1 second, combining loss for a seven-element array can be limited to about 0.1 dB in a realistic operational environment. This result suggests that the real-time combining system proposed here is capable of recovering virtually all of the signal power captured by the feed array, even in the presence of severe wind gusts and similar disturbances.

Vilnrotter, V. A.↗

NASA NTRS1990

Multistage estimation of received carrier signal parameters under very high dynamic conditions of the receiver

A multistage estimator is provided for the parameters of a received carrier signal possibly phase-modulated by unknown data and experiencing very high Doppler, Doppler rate, etc., as may arise, for example, in the case of Global Positioning Systems (GPS) where the signal parameters are directly related to the position, velocity and jerk of the GPS ground-based receiver. In a two-stage embodiment of the more general multistage scheme, the first stage, selected to be a modified least squares algorithm referred to as differential least squares (DLS), operates as a coarse estimator resulting in higher rms estimation errors but with a relatively small probability of the frequency estimation error exceeding one-half of the sampling frequency, provides relatively coarse estimates of the frequency and its derivatives. The second stage of the estimator, an extended Kalman filter (EKF), operates on the error signal available from the first stage refining the overall estimates of the phase along with a more refined estimate of frequency as well and in the process also reduces the number of cycle slips.

Kumar, Rajendra↗

NASA NTRS1989

Estimation of signal-to-noise - A new procedure applied to AVIRIS data

To make the best use of narrowband airborne visible/infrared imaging spectrometer (AVIRIS) data, an investigator needs to know the ratio of signal to random variability or noise (signal-to-noise ratio or SNR). The signal is land cover dependent and varies with both wavelength and atmospheric absorption; random noise comprises sensor noise and intrapixel variability (i.e., variability within a pixel). The three existing methods for estimating the SNR are inadequate, since typical laboratory methods inflate while dark current and image methods deflate the SNR. A new procedure is proposed called the geostatistical method. It is based on the removal of periodic noise by notch filtering in the frequency domain and the isolation of sensor noise and intrapixel variability using the semi-variogram. This procedure was applied easily and successfully to five sets of AVIRIS data from the 1987 flying season and could be applied to remotely sensed data from broadband sensors.

Curran, Paul J.↗

NASA NTRS1990

Impulsive signals in the night ionosphere of Venus - Comparison of results obtained below the local electron gyro frequency with those above

Impulsive VLF signals at low altitudes in the night ionosphere of Venus occur both above and below the electron gyro frequency. The strength of the magnetic field has a very strong influence on the occurrence rates of these impulsive emissions at all frequencies. Above about one-quarter of the local electron gyro frequency the waves occur most frequently for strong magnetic fields and much less frequently for weak fields. However, below about one-quarter of the electron gyro frequency, the occurrence rate is much less sensitive to field strength. At all frequencies the occurrence rate depends little on the direction of the magnetic field. The occurrence rate is strongly dependent on local time especially above the electron gyro frequency. Here, the occurrence rate peaks sharply at 2100 LT. Below the local electron gyro frequency the occurrence rate also shows a maximum near 2100 LT but decreases much more slowly with increasing local time. The rate of occurrence of low frequency signals varies little with altitude but the occurrence of the higher frequency signals decreases rapidly. These properties are consistent with a broadband source of VLF waves in the Venus atmosphere such as would be provided by intracloud lightning.

Russell, C. T.↗

NASA NTRS1990

Fourier analysis and signal processing by use of the Moebius inversion formula

A novel Fourier technique for digital signal processing is developed. This approach to Fourier analysis is based on the number-theoretic method of the Moebius inversion of series. The Fourier transform method developed is shown also to yield the convolution of two signals. A computer simulation shows that this method for finding Fourier coefficients is quite suitable for digital signal processing. It competes with the classical FFT (fast Fourier transform) approach in terms of accuracy, complexity, and speed.

Reed, Irving S.↗

NASA NTRS1990

A novel multistage estimation of signal parameters

A multistage estimation scheme is presented for estimating the parameters of a received carrier signal possibly phase-modulated by unknown data and experiencing very high Doppler, Doppler rate, etc. Such a situation arises, for example, in the case of the Global Positioning Systems (GPS). In the proposed scheme, the first-stage estimator operates as a coarse estimator of the frequency and its derivatives, resulting in higher rms estimation errors but with a relatively small probability of the frequency estimation error exceeding one-half of the sampling frequency (an event termed cycle slip). The second stage of the estimator operates on the error signal available from the first stage, refining the overall estimates, and in the process also reduces the number of cycle slips. The first-stage algorithm is a modified least-squares algorithm operating on the differential signal model and referred to as differential least squares (DLS). The second-stage algorithm is an extended Kalman filter, which yields the estimate of the phase as well as refining the frequency estimate. A major advantage of the is a reduction in the threshold for the received carrier power-to-noise power spectral density ratio (CNR) as compared with the threshold achievable by either of the algorithms alone.

Kumar, Rajendra↗

NASA NTRS1990

The modulation of a radar signal from the ocean surface due to slope and hydrodynamic effects

The modulation of the signal level of a tower-based radar scatterometer illuminating a small area of the ocean surface is predicted from direct measurements of the hydrodynamic conditions of the ocean surface and compared with X band radar measurements taken simultaneously. The radar backscatter is assumed to be due to Bragg resonance between the signal and the ripple waves. The effects of the slope of the ocean surface due to passing long waves are modeled by converting a measured wave height series into a slope time series. Laser-slope-gauge measurements of the spectrum of the ripple waves that ride upon the long ocean waves are used to predict the hydrodynamic effects. Comparisons with the measured radar signal show that the slope modulation alone gives a poor prediction of the modulation. Inclusion of the hydrodynamic effects in the simulation appears more promising, although it also is not entirely successful with this data set.

West, James C.↗

NASA NTRS1991

Algorithm Reveals Sinusoidal Component Of Noisy Signal

Algorithm performs simple statistical analysis of noisy signal to yield preliminary indication of whether or not signal contains sinusoidal component. Suitable for preprocessing or preliminary analysis of vibrations, fluctuations in pressure, and other signals that include large random components. Implemented on personal computer by easy-to-use program.

Kwok, Lloyd C.↗

NASA NTRS1991

Control circuitry using electronic emulation of a synchro signal for accurate control of position and rate of rotation for shafts

The invention disclosed is a digital circuit which emulates a synchro signal in a synchro-resolver follower system for precise control of shaft position and rotation at very low rotational rates. The invention replaces the synchro and drive motor in a synchro-resolver follower system with a digital and analog synchro emulation circuit for generating the resolver control signal. The synchro emulation circuit includes amplitude modulation means to provide relatively high frequency resolver excitation signals for accurate resolver response even with very low shaft rotation rates.

Howard, David E.↗

NASA NTRS1991

Comment on 'A re-examination of impulsive VLF signals in the night ionosphere of Venus'

Taylor and Cloutier (TC, 1988) previously argued that Singh and Russell (SR, 1986) wrongly identified telemetry interference as VLF broadband signals originating in Venus 'lightning events'. A response was made by Russell and Singh (RS, 1989). This comment criticizes RS, arguing that the SR did not distinguish between signal and noise and that RS makes false claims about the SR analysis. In a reply to TC, Russell argues that the SR paper, while flawed, was not intended to be quantitative and succeeds in bringing attention to the morphology of the signals seen in the upper three channels of the Pioneer Venus electric field detector.

Taylor, H. A., Jr.↗

NASA NTRS1992

Microcontrollers Generate Timing Signals For CCD Arrays

Microcontrollers generate timing signals for charge-coupled-device array detectors in electronic system developed to test such detectors. With microcontroller, one changes timing signals via software, without changes in wiring. Approach more flexible, timing signals changed easier and quicker.

Hostetter, Marilyn K.↗

NASA NTRS1992

Open-Loop Acquisition Of Suppressed Carrier Signals

Three digital techniques for open-loop acquisition of suppressed carrier signals in presence of binary-phase-shift-keyed (BPSK) modulation representing non-return-to-zero (NRZ) data symbols. Based on assumption that offset, tau, between timing of symbols and clock in receiver unknown, but fixed fraction of symbol period, T. In all three, fast Fourier transforms (FFT's) performed on outputs of integrate-and-dump filters that are parts of Costas-type loops used to demodulate BPSK signals. Timing of integrate-and-dump filters constant. Outputs mixed to obtain an error signal.

Shah, Biren N.↗

NASA NTRS1992

Asymmetry In Biphase Data Signals

Report presents analysis of some effects of asymmetry in Manchester (biphase) binary data signal transmitted by phase modulation of sinusoidal carrier signal. Report extends analysis described in article, "Effects of Asymmetry of NRZ Data Signals on Performance" (NPO-18261), to include case where data biphase-modulated directly on residual carrier.

Nguyen, Tien M.↗

NASA NTRS1991

Jitter model and signal processing techniques for pulse width modulation optical recording

A jitter model and signal processing techniques are discussed for data recovery in Pulse Width Modulation (PWM) optical recording. In PWM, information is stored through modulating sizes of sequential marks alternating in magnetic polarization or in material structure. Jitter, defined as the deviation from the original mark size in the time domain, will result in error detection if it is excessively large. A new approach is taken in data recovery by first using a high speed counter clock to convert time marks to amplitude marks, and signal processing techniques are used to minimize jitter according to the jitter model. The signal processing techniques include motor speed and intersymbol interference equalization, differential and additive detection, and differential and additive modulation.

Liu, Max M.-K.↗

NASA NTRS1991

SEDS1 mission software verification using a signal simulator

The first flight of the Small Expendable Deployer System (SEDS1) is scheduled as the secondary payload of a Delta II in late 1992. The objective of the SEDS1 mission is to collect data to validate the concept of tethered satellite systems and to verify computer simulations used to predict their behavior. A series of tests will be performed to exercise the software modules which make up the Mission Software of the SEDS Data System. These tests will be performed by using a SEDS Signal Simulator to generate signals which will simulate the inputs normally produced by sensors and circuits in the SEDS system. The SEDS Signal Simulator will be used in the debugging and in the formal verification of the SEDS1 Mission Software. The Simulator will not only emulate normal flight conditions but also exercise all modules written to handle anticipated anomalous flight conditions, conditions that would be difficult to reproduce and control with actual SEDS hardware. The simulator will help to expedite software development and to increase the confidence of the users of the Mission Software. With little modification, the Simulator should be useful in the software development of future SEDS flights.

Pierson, William E.↗

NASA NTRS1990

A method for modelling peak signal statistics on a mobile satellite transponder

A simulation method is proposed. The simulation was developed to model the peak duration and energy content of signal peaks in a mobile communication satellite operating in a Frequency Division Multiple Access (FDMA) mode and presents an estimate of those power peaks for a system where the channels are modeled as band limited Gaussian noise, which is taken as a reasonable representation for Amplitude Commanded Single Sideband (ACSSB), Minimum Shift Keying (MSK), or Phase Shift Keying (PSK) modulated signals. The simulation results show that, under this hypothesis, the level of the signal power peaks for 10 percent, 1 percent, and 0.1 percent of the time are well described by a Rayleigh law and that their duration is extremely short and inversely proportional to the total FDM system bandwidth.

Bilodeau, Andre↗