Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SHOCK LAYER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Aerothermodynamic environment for Jovian entry with silica heat shield

Solutions are presented for the stagnation-region shock-layer equations, including radiative transfer with spectral lines and silica ablation during Jovian entry. Results for variations of entry angle, sphere-cone configuration, and atmospheric model are given. The effect of silica ablation on the radiative and convective surface heating is correlated with the ratio of the wall to free-stream mass flux. Correlations are also given for spectral distributions. The effect of newly obtained SiO radiation properties on the surface heating is examined.

Green, M. J.↗
NASA NTRS1978

A new, compact far-infrared source in the W31 region

In a survey of the W31 region, a compact far-infrared source was detected at the position of the radio continuum source G 10.6-0.4. Associated with this infrared source and in close coincidence with its position is an H II region with a compact core and extended halo as well as OH and H2O masers. An extended molecular cloud, centered on these sources, has also been detected. The compact source and associated masers may be located at the H II region-molecular-cloud interface in a thin shocked layer of neutral gas driven into the molecular cloud by the expansion of the H II region. The compact H II region is depleted of dust and must be surrounded by a very dense shell of dust and gas (hydrogen number density in excess of 200,000 per cu cm). The source probably represents an early stage of stellar evolution.

Fazio, G. G.↗
NASA NTRS1979

Formulation of aerodynamic prediction techniques for hypersonic configuration design

An investigation of approximate theoretical techniques for predicting aerodynamic characteristics and surface pressures for relatively slender vehicles at moderate hypersonic speeds was performed. Emphasis was placed on approaches that would be responsive to preliminary configuration design level of effort. Supersonic second order potential theory was examined in detail to meet this objective. Shock layer integral techniques were considered as an alternative means of predicting gross aerodynamic characteristics. Several numerical pilot codes were developed for simple three dimensional geometries to evaluate the capability of the approximate equations of motion considered. Results from the second order computations indicated good agreement with higher order solutions and experimental results for a variety of wing like shapes and values of the hypersonic similarity parameter M delta approaching one.

Source record↗
NASA NTRS1979

Significance of shock and body slip conditions on Jovian entry heating

The influence of the body and shock slip conditions on the heating of a Jovian entry body is investigated. The flow in the shock layer is considered to be axisymmetric, steady, laminar, viscous, and in chemical equilibrium. Realistic thermophysical and step-function spectral models are employed and results are obtained by implicit finite-difference and iteractive procedures. The freestream conditions correspond to a typical Jovian entry trajectory point. The results indicate that the effect of the slip conditions is significant when the altitudes are higher than 225 km and that the contribution of a radiative heat-flux term in the energy equation should not be neglected at any altitude.

Tiwari, S. N.↗
NASA NTRS1979

A marching method for calculating line and continuum radiation in high energy flow fields

A method is presented for calculating nongrey radiative fluxes and intensities in a highly ionized, low temperature plasma with extreme line broadening. The method was developed to study radiative heating phenomena in the mass-injected hypersonic shock-layer environments characteristic of outer planet atmospheric entry, although it is not limited to such studies. The radiative properties model assumed local thermodynamic equilibrium and used standard continuum and molecular band models. The atomic line model, however, used a frequency-marching method for the frequency integration, which not only accounted completely for line overlapping (reabsorption) effects, but compared favorably in economy with the best equivalent-width methods. An assessment of hydrogen line-far-wing treatments, with recommendations for engineering models, is also presented.

Bolz, C. W., Jr.↗
NASA NTRS1980

Heating rate measurements over 30 deg and 40 deg (half angle) blunt cones in air and helium in the Langley expansion tube facility

Convective heat transfer measurements, made on the conical portion of spherically blunted cones (30 deg and 40 deg half angle) in an expansion tube are discussed. The test gases used were helium and air; flow velocities were about 6.8 km/sec for helium and about 5.1 km/sec for air. The measured heating rates are compared with calculated results using a viscous shock layer computer code. For air, various techniques to determine flow velocity yielded identical results, but for helium, the flow velocity varied by as much as eight percent depending on which technique was used. The measured heating rates are in satisfactory agreement with calculation for helium, assuming the lower flow velocity, the measurements are significantly greater than theory and the discrepancy increased with increasing distance along the cone.

Reddy, N. M.↗
NASA NTRS1980

Preliminary thermal analysis for Saturn entry

A preliminary thermal analysis based on recently defined Saturn entry conditions has been conducted. The study, using viscous-shock-layer and engineering codes employed for Project Galileo, investigated nonequilibrium chemistry effects on the Saturn thermal environment, defined the primary heat-transfer mode for heatshield design, delineated some problem areas for future thermal studies, and validated BIRCHES (Blunt Body Inviscid Radiative and Convective Heating Engineering Solutions) for parametric or design studies. The effect of nonequilibrium chemistry appears to significantly influence only the radiative fluxes with effects localized to the stagnation region. However, the heat-transfer mode pertinent to the overall heat-shield design is convection. The convective results of BIRCHES and a detailed code are in good agreement. The resulting mass-loss rates for the currently prescribed nominal Saturn entry conditions are small when compared with the values for nominal Jupiter entry conditions. With coupled carbon-phenolic ablation injection, the convective heating rates are reduced substantially while the radiative heating rates are increased when compared with the corresponding no-injection results.

Zoby, E. V.↗
NASA NTRS1980

Simulation of flat-plate turbulent boundary layers in cryogenic tunnels

The magnitudes of real-gas effects on flat-plate turbulent boundary layer simulations in a cryogenic nitrogen wind tunnel are investigated in order to determine the validity of the method used by Inger (1979) to estimate real-gas effects. Boundary layer solutions for real gases, ideal gases with a specific heat ratio of 1.6 and ideal diatomic gases (specific heat ratio 1.4) were obtained for the worst case conditions of maximum stagnation pressure (9 atm), minimum stagnation temperature (120 K) and Mach number of 1.2. Calculated boundary layer parameters such as friction coefficient and displacement thickness are shown to agree closely for the real gas and the ideal diatomic gas (specific heat ratio 1.4), while the ideal gas solution used by Inger is shown to differ from the real-gas values considerably. Results indicate that real-gas effects on a flat-plate turbulent boundary layer simulation in a cryogenic nitrogen tunnel are insignificant, and suggest the unlikelihood of the large real-gas effects reported by Inger for turbulent boundary layer shock interactions.

Adcock, J.↗
NASA NTRS1980

Techniques for aerodynamic and turbulence measurements in turbomachinery rotors

Nonoptical techniques currently used to measure flows in turbomachine rotors are reviewed, with particular reference to the measurement of the three-dimensional mean velocity, turbulence intensity, Reynolds stresses, static and stagnation pressures, and blade surface measurements. The high level of sophistication of rotor flow measurement techniques is demonstrated. Rotating probe measurements are well suited for low- and moderate-speed turbomachinery, while stationary quick-response probes (hot-wire and pressure probes) are applicable both in low- and high-speed turbomachines. Hot-wire probes, blade pressure transducers, and telemetry systems will provide the urgently needed basic information on steady and unsteady flow through a blade passage, including blade boundary layer, shock configuration, leakage and secondary flows.

Lakshminarayana, B.↗
NASA NTRS1980

Equivalent-cone calculation of nitric oxide production rate during Space Shuttle re-entry

The amount of nitric oxide likely to be produced in the shock layer around a Space Shuttle orbiter vehicle during its reentry is calculated at one point on the trajectory. An equivalent-cone is defined as one that produces the same amount of nitric oxide as the orbiter. The amounts of nitric oxide produced by the cone are calculated at points along the trajectory to determine their total and altitudinal distribution. The results show that about 14 tonne nitric oxide is produced at each entry, the peak occurring at 68 km altitude.

Park, C.↗
NASA NTRS1981

Effect of a finite ionization rate on the radiative heating of outer planet atmospheric entry probes

The influence of finite rate ionization in the inviscid gas just behind the stagnation shock wave on the radiation heating of probes entering the hydrogen helium atmospere of the major planets was investigated. At the present time, there is disagreement as to whether the radiative flux increases or decreases relative to its equilibrium value when finite rate ionization is considered. Leibowitz and Kuo content that the finite rate ionization in the hydrogen gas just behind the shock wave reduces the radiative flux to the probe, whereas Tiwari and Szema predict that it increases the radiative flux. The radiation modeling used in the calculations of both pairs of these investigators was reviewed. It is concluded that finite rate ionization in the inviscid region of the shock layer should reduce the cold wall radiative heating below the values predicted by equilibrium chemistry assumptions.

Nelson, H. F.↗
NASA NTRS1980

Interstellar shock waves

The structure of interstellar shocks driven by supernova remnants and by expanding H II regions around early-type stars is discussed. Jump conditions are examined, along with shock fronts, post-shock relaxation layers, collisional shocks, collisionless shocks, nonradiative shocks, radiative atomic shocks, and shock models of observed nebulae. Effects of shock waves on interstellar molecules are examined, with reference to the chemistry behind shock fronts, infrared and vibrational-rotational cooling by molecules, and observations of shocked molecules. Some current problems and applications of the study of interstellar shocks are summarized, including the initiation of star formation by radiative shock waves, interstellar masers, the stability of shocks, particle acceleration in shocks, and shocks in galactic nuclei.

Mckee, C. F.↗
NASA NTRS1981

Significance of turbulence and transition location on radiative heating with ablation injection

This paper presents forebody flowfield solutions for Jupiter entry conditions where the ablation injection rate is coupled with the surface heating rate. The calculations are made with a time-dependent viscous-shock-layer analysis where the flow is assumed to be in chemical equilibrium. Both laminar and turbulent solutions are presented to describe the impact of turbulence on surface mass loss rates for flow conditions where the heating is due primarily to radiation. Results are also presented where the transition location to turbulent flow is arbitrarily varied. Results show that the radiative heating rate values based on several downstream transition locations adjust quickly to the corresponding values based on transition near the stagnation point.

Moss, J. N.↗
NASA NTRS1981

Forebody and base region real gas flow in severe planetary entry by a factored implicit numerical method. II - Equilibrium reactive gas

The factored-implicit, gas-dynamic algorithm has been adapted to the numerical simulation of equilibrium reactive flows. Changes required in the perfect gas version of the algorithm are developed, and the method of coupling gas-dynamic and chemistry variables is discussed. A flow-field solution that approximates a Jovian entry case was obtained by this method and compared with the same solution obtained by HYVIS, a computer program much used for the study of planetary entry. Comparison of surface pressure distribution and stagnation line shock-layer profiles indicates that the two solutions agree well.

Davy, W. C.↗
NASA NTRS1981

An evaluation of computer codes for simulating the Galileo Probe aerothermal entry environment

The approaches of three computer flow field codes (HYVIS, COLTS, and RASLE), used to determine the Galileo Probe aerothermal environment and its effect on the design of the thermal protection system, are analyzed in order to resolve differences in their predicted results. All three codes account for the hypersonic, massively blown, radiation shock layers, characteristic of Jupiter entry. Significant differences, however, are evident in their solution procedures: the governing conservation equations, the numerical differencing methods, the governing physics (chemical, radiation, diffusion, and turbulence models), and the basic physical data (thermodynamic, transport, chemical, and spectral properties for atomic and molecular species). Solutions are compared for two near peak heating entry conditions for a Galileo Probe baseline configuration, having an initial mass of 242 kg and simulating entry into the Orton nominal atmosphere. The modern numerical methodology of COLTS and RASLE appear to provide an improved capability for coupled flow-field solutions.

Menees, G. P.↗
NASA NTRS1981

Galileo Probe forebody thermal protection

Material response solutions for the forebody heat shield on the candidate 310-kg Galileo Probe are presented. A charring material ablation analysis predicts thermochemical surface recession, insulation thickness, and total required heat shield mass. Benchmark shock layer solutions provide the imposed entry heating environments on the ablating surface. Heat shield sizing results are given for a nominal entry into modeled nominal and cool-heavy Jovian atmospheres, and for two heat-shield property models. The nominally designed heat shield requires a mass of at least 126 kg and would require an additional 13 kg to survive entry into the less probable cool-heavy atmosphere. The material-property model with a 30% surface reflectance reduces these mass requirements by as much as 16%.

Green, M. J.↗
NASA NTRS1982

Stereo electro-optical tracker study for the measurement of model deformations at the National Transonic Facility

The effects of model vibration, camera and window nonlinearities, and aerodynamic disturbances in the optical path on the measurement of target position is examined. Window distortion, temperature and pressure changes, laminar and turbulent boundary layers, shock waves, target intensity and, target vibration are also studied. A general computer program was developed to trace optical rays through these disturbances. The use of a charge injection device camera as an alternative to the image dissector camera was examined.

Hertel, R. J.↗
NASA NTRS1982

Effect of a finite ionization rate on the radiative heating of outer planet atmospheric entry probes

The influence of finite rate ionization in the inviscid gas just behind the stagnation shock wave on the radiative heating of probes entering the hydrogen-helium atmosphere of the major plants was investigated. Two opposing conclusions were reached as to how the ionization rate assumption affects the radiative transfer. Hydrogen-helium shock waves with a cold nonblowing wall boundary condition at the probe heat shield are emphasized. The study is limited to the stagnation shock layer.

Nelson, H. F.↗