SEARCH · Engineering Papers

Results for “turbulence methods”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30

All sources NASA NTRS DOE OSTI

NASA NTRS1974

A method for the measurement and the statistical analysis of atmospheric turbulence

The instantaneous values of output voltages representing the wind velocity vector and the temperature at different elevations of the 250-foot meteorological tower located at NASA Wallops Flight Center are provided with the three dimensional split-film TSI Model 1080 anemometer system. The output voltages are sampled at a rate of one every 5 milliseconds, digitized and stored on digital magnetic tapes for a time period of approximately 40 minutes, with the use of a specially designed data acqusition system. A new calibration procedure permits the conversion of the digital voltages to the respective values of the temperature and the velocity components in a Cartesian coordinate system connected with the TSI probe with considerable accuracy. Power, cross, coincidence and quadrature spectra of the wind components and the temperature are obtained with the use of the fast Fourier transform. The cosine taper data window and ensemble and frequency smoothing techniques are used to provide smooth estimates of the spectral functions.

Tieleman, H. W.↗

NASA NTRS1976

Performance and boundary-layer evaluation of a sonic inlet

Tests were conducted to determine the boundary layer characteristics and aerodynamic performance of a radial vane sonic inlet with a length/diameter ratio of 1 for several vane configurations. The sonic inlet was designed with a slight wavy wall type of diffuser geometry, which permits operation at high inlet Mach numbers (sufficiently high for good noise suppression) without boundary layer flow separation and with good total pressure recovery. A new method for evaluating the turbulent boundary layer was developed to separate the boundary layer from the inviscid core flow, which is characterized by a total pressure variation from hub to tip, and to determine the experimental boundary layer parameters.

Schmidt, J. F.↗

NASA NTRS1977

Summary of calculation procedures for nonsimilar two- and three-dimensional compressible turbulent boundary layers (finite difference, finite element and weighted residual methods), appendix

This numerical prediction summary indicates the wide variety of such procedures which are available. Most procedures have detailed user manuals, and in many cases the codes are available. Many of the special effects treated by various methods (such as nonequilibrium or equilibrium chemistry, transition, roughness etc.) are indicated.

Source record↗

NASA NTRS1979

Inverse boundary-layer technique for airfoil design

A description is presented of a technique for the optimization of airfoil pressure distributions using an interactive inverse boundary-layer program. This program allows the user to determine quickly a near-optimum subsonic pressure distribution which meets his requirements for lift, drag, and pitching moment at the desired flow conditions. The method employs an inverse turbulent boundary-layer scheme for definition of the turbulent recovery portion of the pressure distribution. Two levels of pressure-distribution architecture are used - a simple roof top for preliminary studies and a more complex four-region architecture for a more refined design. A technique is employed to avoid the specification of pressure distributions which result in unrealistic airfoils, that is, those with negative thickness. The program allows rapid evaluation of a designed pressure distribution off-design in Reynolds number, transition location, and angle of attack, and will compute an airfoil contour for the designed pressure distribution using linear theory.

Henderson, M. L.↗

NASA NTRS1982

An experimental documentation of a separated trailing-edge flow at a transonic Mach number

A detailed experiment on the separated flow field at a sharp trailing edge is described and documented. The separated flow is a result of sustained adverse pressure gradients. The experiment was conducted using an elongated airfoil-like model at a transonic Mach number and at a high Reynolds number of practical interest. Measurements made include surface pressures and detailed mean and turbulence flow quantities in the region just upstream of separation to downstream into the near-wake, following wake closure. The data obtained are presented mostly in tabular form. These data are of sufficient quality and detail to be useful as a test case for evaluating turbulence models and calculation methods.

Viswanath, P. R.↗

NASA NTRS1983

An experimental documentation of trailing-edge flows at high Reynolds number

Experiments documenting attached trailing-edge and near-wake flows at high Reynolds numbers are described. A long, airfoil-like model was tested at subsonic and low transonic Mach numbers, and both symmetrical and asymmetrical flows with pressure gradients upstream of the trailing edge were investigated. Model surface pressures and detailed mean and turbulence flow qualities were measured in the vicinity of the trailing edge and in the near-wake. The data obtained are of sufficient quality and detail to be useful as test cases in assessing turbulence models and calculation methods.

Viswanath, P. R.↗

NASA NTRS1984

Optical measurements of fluctuating temperatures in a supersonic turbulent flow using one- and two-photon, laser-induced fluorescence

A laser-induced fluorescence technique was developed that provides a practical means of nonintrusively measuring the instantaneous temperatures in low-temperature turbulent flows. The capabilities of the method are reviewed, and its application to a simple, two-dimensional, turbulent boundary-layer flow at Mach 2 is reported. Measurements of the average temperature distribution through the boundary layer and the magnitudes of temperature fluctuations about their average values are presented.

Gross, K. P.↗

NASA NTRS1984

Calculation of boundary layers of oscillating airfoils

A two-point finite difference unsteady laminar and turbulent boundary layer computational method was used to investigate the properties of the flow around an airfoil (NACA 0012) oscillating through angles of attack up to 18 degrees, for reduced frequencies of 0.01 and 0.20. The unsteady potential flow was determined using the unsteady potential flow method of Geissler. The influence of transition location on stal behavior was investigated, using both experimentally determined transition information, and transition located at the pressure peak; the results show the need for viscous-inviscid interaction in future computation of such flows.

Cebeci, T.↗

NASA NTRS1984

Near-field turbulence properties of single- and two-stream plane mixing layers

Detailed mean-flow and turbulence measurements have been made in the near-field of two plane mixing layers in air with a maximum velocity of 21 m/s. The experimental rig enabled mixing layers of velocity ratios 0 and 0.46 to be generated simultaneously. Cases with both tripped and untripped initial boundary layers were studied. In all cases, it was found that the two-stream layer developed to the self-preserving state in a distance much shorter than the single-stream layer which followed accepted criteria for the development distance. The asymptotic levels of the turbulence quantities in the two-stream layer, and the development of the single-stream layer showed agreement with existing data. The results suggest that the two-stream mixing layer should provide a better test case for the development of turbulence models and calculation methods than the single-stream mixing layer.

Mehta, R. D.↗

NASA NTRS1984

Optical measurements of fluctuating temperatures in a supersonic turbulent flow using one- and two-photon, laser-induced fluorescence

A laser-induced fluorescence technique has been developed that provides a practical means of nonintrusively measuring the instantaneous temperatures in low-temperature turbulent flows. The capabilities of the method are reviewed, and its application to a simple, two-dimensional, turbulent boundary-layer flow at Mach 2 is reported. Measurements of the average temperature distribution through the boundary layer and the magnitudes of temperature fluctuations about their average values are presented.

Gross, K. P.↗

NASA NTRS1985

An experimental study of plane mixing layer development

Mean flow and turbulence was measured in the near field of two plane mixing layers in air with a maximum velocity of 21 m/sec. The experimental rig enabled mixing layers of velocity ratios 0 and 0.46 to be generated simultaneously. Gases with both tripped and untripped initial boundary layers were studied. It was found that the two stream layer developed to the self preserving state in a distance much shorter than did the single stream layer which followed accepted criteria for the development distance. The asymptotic levels of the turbulence quantities in the two stream layer and the development of the single stream layer showed agreement with existing data. It is suggested that the two stream mixing layer should provide a better test case for the development of turbulence models and calculation methods than the single stream mixing layer.

Mehta, R. D.↗

NASA NTRS1984

Airfoil trailing edge flow measurements and comparison with theory, incorporating open wind tunnel corrections

Trailing edge data for boundary layer-near wake thickness parameters are given for airfoils and flat plates. Reynolds number effects are examined as a function of model size, velocity and boundary layer tripping. These data expand that presented previously by the authors particularly for airfoil non-zero angles of attack. Comparisons are made here with boundary layer calculations using potential flow modeling and a well documented two-dimensional finite-difference method for laminar and turbulent boundary layers. Open wind tunnel corrections to angle of attack and camber are developed and are incorporated in the potential flow modeling to assure correct comparisons for non-zero angles of attack. It was found that although the open tunnel flow turbulence affected boundary layer transition for the higher velocities the theory successfully 'brackets' the data. Comparisons demonstrate the degree of accuracy one might expect for the prediction of boundary layer thickness parameters when given only geometry and nominal flow conditions as input to boundary layer codes.

Brooks, T. F.↗

NASA NTRS1987

Supercomputing of supersonic flows using upwind relaxation and MacCormack schemes

The performance of two numerical solution schemes, (1) an implicit upwind relaxation with a finite-volume discretization (Thomas and Walters, 1985) and (2) an explicit-implicit MacCormack (1981) scheme with a finite-difference discretization, is compared in two-dimensional simulations of supersonic flow past a flat plate with leading edge, a rearward-facing step, a 10-deg compression corner, a NACA 0012 airfoil at high angle of attack, and a cavity. The algebraic turbulence model, the solution methods, and the boundary conditions and SIMD coding are explained, and the results are presented in tables and graphs and characterized with reference to published experimental data. Scheme (1) is found to converge more rapidly and to give more accurate results than (2) in a wide range of problem types.

Baysal, O.↗

NASA NTRS1988

A transonic interactive boundary-layer theory for laminar and turbulent flow over swept wings

A 3-D laminar and turbulent boundary-layer method is developed for compressible flow over swept wings. The governing equations and curvature terms are derived in detail for a nonorthogonal, curvilinear coordinate system. Reynolds shear-stress terms are modeled by the Cebeci-Smith eddy-viscosity formulation. The governing equations are descretized using the second-order accurate, predictor-corrector finite-difference technique of Matsuno, which has the advantage that the crossflow difference formulas are formed independent of the sign of the crossflow velocity component. The method is coupled with a full potential wing/body inviscid code (FLO-30) and the inviscid-viscous interaction is performed by updating the original wing surface with the viscous displacement surface calculated by the boundary-layer code. The number of these global iterations ranged from five to twelve depending on Mach number, sweep angle, and angle of attack. Several test cases are computed by this method and the results are compared with another inviscid-viscous interaction method (TAWFIVE) and with experimental data.

Woodson, Shawn H.↗

NASA NTRS1990

Some observations on the Houbolt-Rainey and peak-hold methods of flutter onset prediction

A subcritical response method for flutter onset prediction developed by Houbolt and Rainey in 1958 is compared with the Peak-Hold Method which was apparently first applied to flutter onset prediction by Sandford, Abel, and Gray in the early 1970's. The rational argument presented shows that the two methods are not different, but are actually the same. So, because there is an analytical foundation for the Houbolt-Rainey Method, then there is the same analytical foundation for the Peak-Hold Method. Further, it is suggested that, in applying Peak-Hold Method in cases where turbulence is used as the excitation force, the variation of the reciprocal of the response amplitude with the reciprocal of the dynamic pressure to be used to extrapolate to flutter onset rather than the variation with dynamic pressure which is the current practice because the linear trend which is predicted to occur for the former is easier to extrapolate to the flutter condition than the nonlinear trend predicted to occur for the latter.

Doggett, Robert V., Jr.↗

NASA NTRS1990

Time-dependent jet flow and noise computations

Methods for computing jet turbulence noise based on the time-dependent solution of Lighthill's (1952) differential equation are demonstrated. A key element in this approach is a flow code for solving the time-dependent Navier-Stokes equations at relatively high Reynolds numbers. Jet flow results at Re = 10,000 are presented here. This code combines a computationally efficient spectral element technique and a new self-consistent turbulence subgrid model to supply values for Lighthill's turbulence noise source tensor.

Berman, C. H.↗

NASA NTRS1991

Analytical methods for the development of Reynolds-stress closures in turbulence

The derivation of Reynolds-stress models for viscous incompressible turbulent flow on the basis of the Navier-Stokes and continuity equations is explored in an analytical review. The formulation of the basic equations is outlined, and particular attention is given to zero-equation and one-equation models based on eddy viscosity, two-equation (k-l, k-epsilon, and k-omega) models, and second-order closure models. The superior performance of the second-order models is demonstrated by numerical results for (1) the return to isotropy from anisotropic homogeneous turbulence, (2) homogeneous turbulent shear flow in a rotating frame, (3) and fully developed inhomogeneous turbulent channel flow in a rotating frame. The inherent limitations of the Reynolds-stress approach and areas for further improvement are discussed.

Speziale, Charles G.↗

NASA NTRS1987

Needs and status of CFD code validation

The two types of Computational Fluid Dynamics code validations, solution-to-solution comparison and solution-to-experiment comparison, are discussed. It is suggested that to develop more detailed experiments the following things are necessary: (1) further development of turbulence models; (2) better methods for numerical validation of CFD codes; (3) evaluation of disagreements; and (4) continued determination of experimental scatter. All data and results are presented in viewgraph form.

Holst, Terry L.↗