Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “data conditioning”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Noise and static performance characteristics of a STOL aircraft jet flap

Static noise and performance tests were conducted on a 1/4-scale jet flap model with a multilobe nozzle of array area ratio of 2.7. The model nozzle and flap tested were a two-dimensional section of a distributed blowing system similar to previously investigated augmentor wing systems without the upper shroud and intake door. Noise data were measured with the nozzle alone and also during attached flow conditions with the flap at two turning angles representing takeoff and approach conditions. The noise data are scaled to a 200,000-lb TOGW four-engine airplane and are presented in terms of perceived noise level and one-third octave band sound pressure level. Comparisons are made with the noise levels produced by an augmentor wing airplane fitted with a three-element acoustically lined augmentor flap. The static performance is presented in terms of thrust recovery and effective turning angle.

Harkonen, D. L.↗
NASA NTRS1982

A comparative study of the thematic mapper and Landsat spectral bands from field measurement data

Principal component and factor analysis techniques were applied to the spectral data collected over 27 field plots of various crops under varying agronomic conditions. The spectral data was integrated over the proposed thematic mapper bands and Landsat MSS spectral bands. The results were examined to compare the discrimination power of the thematic mapper. Previously announced in STAR as N81-33549

Badhwar, G. D.↗
NASA NTRS1982

Communication satellite ground station receiver performance at low data rates

Performance of satellite ground station receivers at low data rates is analyzed for power-limited satellites, when various amounts of frequency dynamics are present. Specifically, the lowest data rates for which the receiver can successfully demodulate suppressed-carrier BPSK data under a wide variety of conditions are determined. Minimum data rates on the order of 100 to 1400 bits per second are achievable with a bit error probability less than 0.00001 and with a mean time to cycle slip on the order of 1/2 hour or more, when Costas loops are employed for carrier extraction.

Riddle, L. P.↗
NASA NTRS1991

Program Analyzes Errors In STAGS

EAC computer program designed for analysis of errors in results of STAGS computer program (COSMIC Program HQN-10967). Requires input data for geometry of plate, properties of material, and set of boundary conditions. These input data come from STAGS code. (The specific link between input and output data from STAGS and input data for EAC is POSTP, postprocessor program in STAGS processors.) EAC computes continuous solution from discrete results of STAGS in order to estimate error of results of STAGS. Written in FORTRAN 77.

Thurston, Gaylen A.↗
NASA NTRS2008

Lithium-Ion Battery Demonstrated for NASA Desert Research and Technology Studies

Lithium-ion batteries have attractive performance characteristics that are well suited to a number of NASA applications. These rechargeable batteries produce compact, lightweight energy-storage systems with excellent cycle life, high charge/discharge efficiency, and low self-discharge rate. NASA Glenn Research Center's Electrochemistry Branch designed and produced five lithium-ion battery packs configured to power the liquid-air backpack (LAB) on spacesuit simulators. The demonstration batteries incorporated advanced, NASA-developed electrolytes with enhanced low-temperature performance characteristics. The objectives of this effort were to (1) demonstrate practical battery performance under field-test conditions and (2) supply laboratory performance data under controlled laboratory conditions. Advanced electrolyte development is being conducted under the Exploration Technology Development Program by the NASA Jet Propulsion Laboratory. Three field trials were successfully completed at Cinder Lake from September 10 to 12, 2007. Extravehicular activities of up to 1 hr and 50 min were supported, with residual battery capacity sufficient for 30 min of additional run time. Additional laboratory testing of batteries and cells is underway at Glenn s Electrochemical Branch.

Bennett, William R.↗
NASA NTRS2018

The Land Surface Data Toolkit (LDT v7.2) - A Data Fusion Environment for Land Data Assimilation Systems

The effective applications of land surface models (LSMs) and hydrologic models pose a varied set of data input and processing needs, ranging from ensuring consistency checks to more derived data processing and analytics. This article describes the development of the Land surface Data Toolkit (LDT), which is an integrated framework designed specifically for processing input data to execute LSMs and hydrological models. LDT not only serves as a preprocessor to the NASA Land Information System (LIS), which is an integrated framework designed for multi-model LSM simulations and data assimilation (DA) integrations, but also as a land-surface-based observation and DA input processor. It offers a variety of user options and inputs to processing datasets for use within LIS and stand-alone models. The LDT design facilitates the use of common data formats and conventions. LDT is also capable of processing LSM initial conditions and meteorological boundary conditions and ensuring data quality for inputs to LSMs and DA routines. The machine learning layer in LDT facilitates the use of modern data science algorithms for developing data-driven predictive models. Through the use of an object-oriented framework design, LDT provides extensible features for the continued development of support for different types of observational datasets and data analytics algorithms to aid land surface modeling and data assimilation.

droughts and floods↗
NASA NTRS2019

Noise Abatement Flight Test Data Report

An acoustic flight test of six helicopters conducted by NASA, FAA, and the US Army is described. Microphone arrays were used to collect acoustic data for source noise characterization, to investigate the acoustic impacts of maneuvering flight, and to develop and evaluate noise abatement operations for helicopters on approach. Atmospheric data and vehicle state data were also collected. Noise metrics are calculated and plotted for all conditions tested. All data described are publicly available upon request.

Rotorcraft↗
NASA NTRS2006

DSMC Simulations of Apollo Capsule Aerodynamics for Hypersonic Rarefied Conditions

Direct simulation Monte Carlo DSMC simulations are performed for the Apollo capsule in the hypersonic low density transitional flow regime. The focus is on ow conditions similar to that experienced by the Apollo Command Module during the high altitude portion of its reentry Results for aerodynamic forces and moments are presented that demonstrate their sensitivity to rarefaction that is for free molecular to continuum conditions. Also aerodynamic data are presented that shows their sensitivity to a range of reentry velocity encompasing conditions that include reentry from low Earth orbit lunar return and Mars return velocities to km/s. The rarefied results are anchored in the continuum regime with data from Navier Stokes simulations

Moss, James N.↗
NASA NTRS1996

Use of CCSDS and OSI Protocols on the Advanced Communications Technology Satellite

Although ACTS (Advanced Communications Technology Satellite) provides an almost error-free channel during much of the day and under most conditions, there are times when it is not suitable for reliably error-free data communications when operating in the uncoded mode. Because coded operation is not always available to every earth station, measures must be taken in the end system to maintain adequate throughput when transferring data under adverse conditions. The most effective approach that we tested to improve performance was the addition of an 'outer' Reed-Solomon code through use of CCSDS (Consultative Committee for Space Data Systems) GOS 2 (a forward error correcting code). This addition can benefit all users of an ACTS channel including those applications that do not require totally reliable transport, but it is somewhat expensive because additional hardware is needed. Although we could not characterize the link noise statistically (it appeared to resemble uncorrelated white noise, the type that block codes are least effective in correcting), we did find that CCSDS GOS 2 gave an essentially error-free link at BER's (bit error rate) as high as 6x10(exp -4). For users that demand reliable transport, an ARQ (Automatic Repeat Queuing) protocol such as TCP (Transmission Control Protocol) or TP4 (Transport Protocol, Class 4) will probably be used. In this category, it comes as no surprise that the best choice of the protocol suites tested over ACTS was TP4 using CCSDS GOS 2. TP4 behaves very well over an error-free link which GOS 2 provides up to a point. Without forward error correction, however, TP4 service begins to degrade in the 10(exp -7)-10(exp -6) range and by 4x10(exp -6), it barely gives any throughput at all. If Congestion Avoidance is used in TP4, the degradation is even more pronounced. Fortunately, as demonstrated here, this effect can be more than compensated for by choosing the Selective Acknowledgment option. In fact, this option can enable TP4 to deliver some throughput at error rates as high as 10(exp -5).

Chirieleison, Don↗
NASA NTRS1978

Comparison of several NASTRAN analytical techniques for large structures

In order to plan for the finite element structural analysis of future aircraft, five static analysis techniques using the MacNeal-Schwendler Corporation version of NASTRAN were evaluated. The structure was analyzed as: (1) a single model with a symmetric loading condition; (2) a single model with symmetric/nonsymmetric loading conditions; (3) three substructures in three phases using tape storage with a symmetric loading condition; (4) three superelements using data base storage with a symmetric loading condition; and (5) three superelements using data base storage with cyclic symmetry for symmetric/nonsymmetric loading conditions. The superelement techniques proved superior to the single model approaches by reducing computer time for redesign work by as much as 70 percent.

Zemer, D. T.↗
NASA NTRSDate not supplied

Artificial Intelligence (AI) Methods for Automating the Impact Tool Evidence Library

INTRODUCTION: The development of the Evidence Library for use with the IMPACT (Informing Mission Planning via Analysis of Complex Tradespaces) probability risk assessment tool involved a multilayered, time intensive process of data collection and analysis by subject matter experts from the Exploration Medical Capability (ExMC) Element Clinical and Science Team to produce clinical findings forms (CliFFs) for 120 medical conditions. Artificial Intelligence Large Language Models (LLMs) can be leveraged to facilitate this process, thus reducing labor and time. TOPIC: CliFFs contain information about medical conditions as they pertain to spaceflight. This includes condition definitions, incidence data, crew task impairment estimates caused by conditions, treatment protocols and references to literature used for gathering condition evidence. Guided by the Evidence Library Methods document and the CliFF development instructions, a team has leveraged Microsoft Azure AI services and open-source documentation to construct an AI-assisted automated pipeline for CliFF development. This process is designed to search, retrieve, and evaluate the applicable data, and ultimately generate a completed CliFF. The LLM evaluates the relevance of each of the source materials to spaceflight, either as direct evidence or as an analog. The model extracts keywords and generates brief summaries to enhance search and retrieval in later stages of CliFF development. For instance, it can calculate epidemiological statistical data, such as incidence rates and the likelihood of best or worst-case scenarios. APPLICATION: Large Language Models (LLMs) can efficiently summarize large amounts of text. Leveraging this technology will automate data retrieval and evidence gathering for medical databases, like the IMPACT tool, by aiding in the labor-intensive process of analyzing large bodies of literature and organizing it into a formatted document like a CliFF. This added efficiency will enable expeditious expansion of the Evidence Library with additional medical conditions and update previous CLiFFs as new technology becomes available.

Ali Al↗
NASA NTRS2012

Acoustic Investigation of Jet Mixing Noise in Dual Stream Nozzles

In an earlier study, a prediction model for jet noise in dual stream jets was proposed that is founded on velocity scaling laws in single stream jets and similarity features of the mean velocity and turbulent kinetic energy in dual stream flows. The model forms a composite spectrum from four component single-stream jets each believed to represent noise-generation from a distinct region in the actual flow. While the methodology worked effectively at conditions considered earlier, recent examination of acoustic data at some unconventional conditions indicate that further improvements are necessary in order to expand the range of applicability of the model. The present work demonstrates how these predictions compare with experimental data gathered by NASA and industry for the purpose of examining the aerodynamic and acoustic performance of such nozzles for a wide range of core and fan stream conditions. Of particular interest are jets with inverted velocity and temperature profiles and the appearance of a second spectral peak at small aft angles to the jet under such conditions. It is shown that a four-component spectrum succeeds in modeling the second peak when the aft angle refraction effects are properly incorporated into the model. A tradeoff of noise emission takes place between two turbulent regions identified as transition and fully mixed regions as the fan stream velocity exceeds that of the core stream. The effect of nozzle discharge coefficients will also be discussed.

Khavaran, Abbas↗
NASA NTRS1975

A search for sulfide-bearing areas using LANDSAT-1 data and digital image-processing techniques

Two experiments were conducted using LANDSAT-1 multispectral scanner data to identify ground features that are indicators of sulfide-bearing rock. A nearby known sulfide deposit was used as a control. In the first experiment, false-color composites were examined visually to locate possible favorable areas; in the second, favorable areas were classified by digital-computer processing. The results of the experiment show that outcrops of hydrothermally altered and mineralized rock can be identified from LANDSAT-1 data under favorable conditions. The empirical method of digital-computer classification of the multispectral scanner data was relatively unrefined and rapid. The five mineralized prospecting sites identified are in locations that the geologist would not have selected as favorable on the basis of geologic knowledge or photogeologic interpretation at the time of the investigation.

Schmidt, R. G.↗