Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “W”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30
All sourcesNASA NTRSDOE OSTI
NASA NTRS2017

NOx Emissions Characteristics and Correlation Equations of Two P and W's Axially Staged Sector Combustors Developed Under NASA Environmentally Responsible Aviation (ERA) Project

Two P&W (Pratt & Whitney)'s axially staged sector combustors have been developed under NASA's Environmentally Responsible Aviation (ERA) project. One combustor was developed under ERA Phase I, and the other was developed under ERA Phase II. Nitrogen oxides (NOx) emissions characteristics and correlation equations for these two sector combustors are reported in this article. The Phase I design was to optimize the NOx emissions reduction potential, while the Phase II design was more practical and robust. Multiple injection points and fuel staging strategies are used in the combustor design. Pilot-stage injectors are located on the front dome plate of the combustor, and main-stage injectors are positioned on the top and bottom (Phase I) or on the top only (Phase II) of the combustor liners downstream. Low power configuration uses only pilot-stage injectors. Main-stage injectors are added to high power configuration to help distribute fuel more evenly and achieve lean burn throughout the combustor yielding very low NOx emissions. The ICAO (International Civil Aviation Organization) landing-takeoff NOx emissions are verified to be 88 percent (Phase I) and 76 percent (Phase II) under the ICAO CAEP/6 (Committee on Aviation Environmental Protection 6th Meeting) standard, exceeding the ERA project goal of 75 percent reduction, and the combustors proved to have stable combustion with room to maneuver on fuel flow splits for operability.

sector combustor test↗
NASA NTRS2018

W-8 Inlet In-Duct Array Evaluation

An overview is provided of an evaluation of the data quality for inlet in-duct array measurements in the W-8 Single Stage Axial Compressor Facility with measurements of a rotor alone configuration.

aeroacoustic↗
NASA NTRS2018

High Power W-Band/F-Band Schottky Diode Based Frequency Multipliers

A solid state device chip including diodes (generating a higher frequency output through frequency multiplication of the input frequency) and a novel on-chip power combining design. Together with the on-chip power combining, the chip has increased efficiency because the diodes' anodes, being micro-fabricated simultaneously on the same patch of a GaAs wafer under identical conditions, are very well balanced. The diodes' GaAs heterostructure and the overall chip geometry are designed to be optimized for high power operation. As a result of all these features, the device can generate record-setting power having a signal frequency in the F-band and W-band (30% conversion efficiency).

Siles Perez, Jose Vicente↗
NASA NTRS2020

Analysis of a 100-W Regenerative Fuel Cell Demonstration

A 100-W regenerative fuel cell (RFC) demonstration was successfully completed at the NASA Glenn Research Center on December 11, 2014. This effort was funded by Advanced Space Power Systems milestone and represented the first demonstration of passive laboratory-scale stacks arranged as an RFC, consisting of a non-flow-through fuel cell and a static-feed electrolyzer. Once developed, these stacks present the potential to minimize system mass, volume, and parasitic power in comparison to existing terrestrial electrochemical systems and nonnuclear power generation options. Testing involved the fuel cell powering a simulated load then recycling fuel cell product water by subsequently electrolyzing it to regenerate hydrogen and oxygen gases for fuel cell operations. A total of five cycles were completed over a 2-week period, yielding cell voltage data for stack performance and quality measures for regenerated reactants. Overall, round-trip efficiency was calculated to be 47.4 percent. Gas crossover was observed in electrolyzer gas products, as residual gas analysis showed 1.1 percent hydrogen in oxygen and 0.4 percent oxygen in hydrogen. Fuel cell product water was determined to be more acidic and conductive and have a higher fluoride content when compared to deionized water.

fuel cell↗
NASA NTRS2018

A W-Band Spatial Power-Combining Amplifier using GaN MMICs

In this paper, we describe a miniature powercombiner for monolithic millimetre-wave integrated circuit (MMIC) chips using spatial power-combining with cavity modes. We have designed GaN MMIC power amplifier chips for 94 GHz, and illustrate the concept of the W-Band Spatial Power Combining Amplifier (WSPCA). Using 1 Watt, 94 GHz MMIC chips in a two-way cavity mode combiner, we were able to achieve 2 Watts of output power with 9 dB gain and 15 % PAE. This technique could be extended to high power MMICs and larger numbers of chips to achieve higher output power in a compact size. The applications include earth science radar, but may be extended to other applications requiring wider bandwidth.

Gawande, Rohit↗
NASA NTRSDate not supplied

Hot Hydrogen Testing of W-coated dUN Kernels for Nuclear Thermal Propulsion

Tungsten-coated kernels of uranium nitride (UN) are a possible reactor fuel component for nuclear thermal propulsion. Hot hydrogen testing of such kernels (approx. 250μm diameter, coating thickness 5μm) has been performed at temperatures from 1800°C to 2300°C for 30min each, using depleted uranium nitride (dUN). In addition to direct observations and mass loss measurements, the samples were analyzed by XRD and SEM/EDS after each run. Decomposition of dUN and the formation of molten uranium happened at all temperatures tested with reaction rates increasing with temperature, despite the tungsten coating. At 2300°C, the kernels disintegrated and molten uranium seeped through the wall and bottom of the tungsten crucible employed. These hot hydrogen tests allowed to test the integrity of the tungsten coating and addressed the operating limits of the loose tungsten-coated dUN kernels. Improved results are expected upon consolidation of the tungsten-coated dUN kernels in a Mo-W alloy matrix.

nuclear fuels↗
DOE OSTI2023

Recent measurements of W and Z (+jets) at ATLAS and CMS

Vector boson measurements at the LHC are an ideal laboratory to study detailed properties of the QCD and electroweak sectors of the Standard Model. These proceedings review several recent measurements of W and Z bosons by the ATLAS and CMS collaborations.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗
DOE OSTI2024

Cold Climate Degradation: An Analysis of Double-Axis Tracked, E-W Vertical, and Fixed-Tilt Photovoltaic Deployments in Alaska

As countries around the world transition towards renewable energy, there is increasing interest in using photovoltaic (PV) technologies to help decarbonize remote northern communities due to their scalability and affordability. However, a major barrier towards large-scale adoption of PV in cold climates is performance uncertainty under extreme environmental conditions including snowfall, freeze-thaw cycles, and high wind loads. Existing literature on PV degradation rates in the North is relatively limited, with published degradation rates varying between -0.2%/year (Sweden) to -1.3%/year (Scotland). At this workshop, we will present preliminary results on the long-term performance of two diverse photovoltaic sites located in Fairbanks, Alaska at 64.8 degrees N: a monofacial Al-BSF double-axis tracking site maintained by the Cold Climate Housing Research Center (CCHRC), and a bifacial PERC/SHJ E-W vertical and south-facing fixed-tilt site maintained by the Alaska Center Energy and Power (ACEP). CCHRC data has been collected over a period of 15 years, while ACEP site data has been collected over 4 years. Using the degradation analysis tool, RdTools, we will present annual system degradation rates, seasonal performance ratio, and identify potential cold climate failure mechanisms for commercially available PV technologies. This analysis will add to existing literature by directly comparing the performance of multiple PV configurations in Alaska.

bifacial↗
DOE OSTI2026

Developing the hybrid scenario in DIII-D and KSTAR for W-compatible long-pulse operation

Long-pulse, high-performance operation with tungsten plasma-facing components is a crucial challenge for achieving steady-state (SS) goals in ITER and future fusion devices. This paper presents a joint international effort between the DIII-D and KSTAR tokamaks aimed at demonstrating the compatibility of the high q 95 ~ 6 hybrid scenario with a tungsten divertor and superconducting coils. A DIII-D hybrid scenario recipe is successfully tailored to KSTAR’s operational constraints, which facilitates cross-device studies. The results show successful 30 s long-pulse operation in KSTAR at a normalized beta (β N = 2.4) with a benign m/n = 4/3 mode and effective mitigation of tungsten accumulation. Despite this success, the KSTAR scenario exhibits a greater than 25% reduction in thermal confinement compared to the DIII-D reference. To investigate this discrepancy, we performed a predictive TGYRO validation study, which suggests that the difference is likely caused by a weaker temperature pedestal in the KSTAR discharge due to a higher and narrower density pedestal. In addition, such lower thermal confinement leads to higher impurity accumulation, possibly due to a change in neoclassical transport with increased inward pinch, which further degrades global confinement. We also report that stationary, long-pulse operation with sustained thermal confinement requires consistent fueling and wall conditioning. These findings highlight the importance of optimized fueling and real-time wall conditioning in achieving a high temperature pedestal and strong global confinement during stable long-pulse operation. We propose potential approaches toward fully SS, long-pulse operation, including real-time wall conditioning using an impurity dropper in KSTAR and future tokamaks.

DIII-D↗
DOE OSTI2024

Measurement of single top-quark production in association with a W boson in pp collisions at $\sqrt{s}$ =13 TeV with the ATLAS detector

The inclusive cross section for the production of a single top quark in association with a Formula Presented boson is measured using Formula Presented of proton-proton collision data collected with the ATLAS detector at $\sqrt{s}$ =13 TeV. Events containing two charged leptons and at least one jet identified as originating from a b-quark are selected. A multivariate discriminant is constructed to separate the tW signal from the $t\bar{t}$ background. The cross section is extracted using a profile likelihood fit to the signal and control regions and it is measured to be σ tW = 75$^{+15}_{–14}$, in good agreement with the Standard Model prediction. The measured cross section is used to extract a value for the left-handed form factor at the Wtb vertex times the Cabibbo-Kobayashi-Maskawa matrix element |$f$ LV $V$ tb | of 0.97±0.10.

Cabibbo–Kobayashi–Maskawa matrix↗
DOE OSTI2025

Characterization of W production during ICRF operations: experiments and modeling

For successfully heating plasma with waves in the ion cyclotron range of frequencies (ICRFs), mitigating impurity production is just as crucial as maximizing power coupling, especially in high-Z environments. ICRF can effectively deposit energy on ions, modify turbulence-driven transport, and enhance fusion reaction efficiency, but only when its power coupling has minimal impact on impurity production. To do so, one must rely on a toroidal array of at least three active elements excited with appropriate phasing and power ratio to reduce the currents induced on the antenna frame below levels critical for physical sputtering. In contrast to classic two-strap antennas, which are optimized for dipole phasing with equal power on both straps, three-strap antennas in ASDEX Upgrade (AUG)—but also four-strap antennas in JET, Alcator C-Mod, SPARC and ITER—offer the possibility to act also on the power ratio between the central and outer straps. With optimal settings, impurity production can be reduced substantially, making the ICRF compatible with the high-Z wall. This paper explores the characteristics of the AUG three-strap antennas in terms of impurity production, as well as the key role of plasma composition in this process. Numerical simulations were performed using SSWICH and Petra-M (finite element codes) to quantify impurity production and compare with experimental results. Energies of ions falling on antenna limiters (measured with probes) are well predicted by both codes. These tools are then used to further describe the source of the impurity, namely the gross erosion of tungsten from an ICRF antenna, for different plasma mixtures. Results are also compared to spectroscopy data. Ultimately, we show that deleterious effects of the ICRF on plasma surface interactions will be weaker in plasmas containing larger fractions of highly ionized heavier low-Z impurity, which is typically relevant for experiments relying on impurity seeding.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2020

Materials Data on W(S4Cl3)2 by Materials Project

WCl6(S)8 is Magnesium tetraboride-like structured and crystallizes in the triclinic P-1 space group. The structure is zero-dimensional and consists of two octasulfur molecules and two tungsten(vi) chloride molecules.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Materials Data on W(NCl3)2 by Materials Project

WCl6N2 is Fluorite structured and crystallizes in the cubic Fm-3m space group. The structure is zero-dimensional and consists of eight ammonia molecules and four tungsten(vi) chloride molecules.

36 MATERIALS SCIENCE↗