Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TIME SIGNAL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30

Reconstruction of Time-Resolved Neutron Energy Spectra in Z-Pinch Experiments Using Time-of-flight Method

We present the reconstruction of neutron energy spectra from time-of-flight signals. This technique is useful in experiments with the time of neutron production in the range of about tens or hundreds of nanoseconds. The neutron signals were obtained by a common hard X-ray and neutron fast plastic scintillation detectors. The reconstruction is based on the Monte Carlo method which has been improved by simultaneous usage of neutron detectors placed on two opposite sides from the neutron source. Although the reconstruction from detectors placed on two opposite sides is more difficult and a little bit inaccurate (it followed from several presumptions during the inclusion of both sides of detection), there are some advantages. The most important advantage is smaller influence of scattered neutrons on the reconstruction. Finally, we describe the estimation of the error of this reconstruction.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Full-Circle Resolver-to-Linear-Analog Converter

A circuit generates sinusoidal excitation signals for a shaft-angle resolver and, like the arctangent circuit described in the preceding article, generates an analog voltage proportional to the shaft angle. The disadvantages of the circuit described in the preceding article arise from the fact that it must be made from precise analog subcircuits, including a functional block capable of implementing some trigonometric identities; this circuitry tends to be expensive, sensitive to noise, and susceptible to errors caused by temperature-induced drifts and imprecise matching of gains and phases. These disadvantages are overcome by the design of the present circuit. The present circuit (see figure) includes an excitation circuit, which generates signals Ksin(Omega(t)) and Kcos(Omega(t)) [where K is an amplitude, Omega denotes 2(pi)x a carrier frequency (the design value of which is 10 kHz), and t denotes time]. These signals are applied to the excitation terminals of a shaft-angle resolver, causing the resolver to put out signals C sin(Omega(t)-Theta) and C cos(Omega(t)-Theta). The cosine excitation signal and the cosine resolver output signal are processed through inverting comparator circuits, which are configured to function as inverting squarers, to obtain logic-level or square-wave signals .-LL[cos(Omega(t)] and -LL[cos(Omega(t)-Theta)], respectively. These signals are fed as inputs to a block containing digital logic circuits that effectively measure the phase difference (which equals Theta between the two logic-level signals). The output of this block is a pulse-width-modulated signal, PWM(Theta), the time-averaged value of which ranges from 0 to 5 VDC as Theta ranges from .180 to +180deg. PWM(Theta) is fed to a block of amplifying and level-shifting circuitry, which converts the input PWM waveform to an output waveform that switches between precise reference voltage levels of +10 and -10 V. This waveform is processed by a two-pole, low-pass filter, which removes the carrier-frequency component. The final output signal is a DC potential, proportional to Theta that ranges continuously from -10 V at Theta = -180deg to +10 V at Theta = +180deg..

Alhorn, Dean C.↗

Electronic clinical predictive thermometer using logarithm for temperature prediction

A thermometer that rapidly predicts body temperature based on the temperature signals received from a temperature sensing probe when it comes into contact with the body. The logarithms of the differences between the temperature signals in a selected time frame are determined. A line is fit through the logarithms and the slope of the line is used as a system time constant in predicting the final temperature of the body. The time constant in conjunction with predetermined additional constants are used to compute the predicted temperature. Data quality in the time frame is monitored and if unacceptable, a different time frame of temperature signals is selected for use in prediction. The processor switches to a monitor mode if data quality over a limited number of time frames is unacceptable. Determining the start time on which the measurement time frame for prediction is based is performed by summing the second derivatives of temperature signals over time frames. When the sum of second derivatives in a particular time frame exceeds a threshold, the start time is established.

Cambridge, Vivien J.↗

Stochastic Resonance and First Arrival Time for Excitable Systems

We study the noise induced thermally activated barrier crossing of Brownian particles that hop in a piecewise linear potential. Using the exact analytic solutions and via numerical simulations not only we explore the dependence for the first passage time of a single particle but also we calculate the first arrival time for one particle out of N particles. The first arrival time decreases as the number of particles increases as expected. We then explore the thermally activated barrier crossing rate of the system in the presence of time varying signal. The dependence of signal to noise ratio SNR as well as the power amplification (η) on model parameters is explored. η and SNR depict a pronounced peak at particular noise strength. In the presence of N particles, η is considerably amplified as N steps up showing the weak periodic signal plays a vital role in controlling the noise induced dynamics of the system. Moreover, for the sake of generality, the viscous friction γ is considered to decrease exponentially when the temperature T of the medium increases (γ=Be{sup −AT}) as proposed originally by Reynolds (Philos Trans R Soc Lond 177:157, 1886).

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Optical Detection of Tunneling Ionization

We have experimentally detected optical harmonics that are generated due to a tunneling-ionization-induced modulation of the electron density. The optical signature of electron tunneling can be isolated from concomitant optical responses by using a noncollinear pump-probe setup. Whereas previously demonstrated tools for attosecond metrology of gases, plasmas, and surfaces rely on direct detection of charged particles, detection of the background-free time-resolved optical signal, which uniquely originates from electron tunneling, offers an interesting alternative that is especially suited for systems in which free electrons cannot be directly measured.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Discovery of an unconventional quantum echo by interference of Higgs coherence

Detecting photon echoes from superconducting Higgs modes is challenging due to the necessity of preserving and retrieving phase coherence encoded in multiple Higgs and quasiparticle (QP) excitations. Here, we demonstrate the emergence of a Higgs echo in niobium superconductors. This approach disentangles unique quantum pathways involving the Higgs mode and QP excitations. Using Higgs echo spectroscopy, we also uncover unconventional echo formation caused by inhomogeneous broadening and “soft” QP bands, which dynamically evolve under terahertz (THz) driving. Specifically, THz pulse pairs modulate the superconducting gap, imprinting coherence and forming a temporal “Higgs grating.” This grating produces echoes with distinctive characteristics: (i) echo rephasing spectral peaks at superconducting gap frequencies, (ii) asymmetric echo formation delays unlike those observed in atoms or semiconductors, and (iii) negative-time echo signals stemming from Higgs-QP anharmonic interactions. Combined with advanced time-frequency analysis, these findings distinguish Higgs from QP responses and clarify their intricate interactions in THz-driven superconductivity.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Specific features of use of wide-gap semi-insulating materials for recording of nuclear radiation

Operation of detectors in strong radiation fields or an imperfect fabrication technology gives rise to a considerable amount of structural defects in materials. Using a p{sup +}-v-n{sup +} detector structure in the unconventional forward-bias mode has been considered as a way to minimize the space-charge accumulation caused by long-term capture of carriers to deep levels. The efficiency of carrier transport and the signal amplitude spectrum were studied as functions of the applied voltage and time of signal shaping by the electronic circuit for the example of a CVD-grown 4H-SiC film containing up to 2.5 x 10{sup 17} cm{sup -3} of primary knocked-out atoms. The detector was tested with 5.4 MeV {alpha} particles in the temperature range 20-140{sup o}C. It was demonstrated that, despite the transport of only one-fourth of the whole amount of charge, the main line of the spectrum has a high energy resolution (7%) for the given conditions.

36 MATERIALS SCIENCE↗

Exponential Decay in the Sensitivity Analysis of Nonlinear Dynamic Programming

In this report, we study the sensitivity of discrete-time dynamic programs with nonlinear dynamics and objective to perturbations in the initial conditions and reference parameters. Under uniform controllability and boundedness assumptions for the problem data, we prove that the directional derivative of the optimal state and control at time $k$, $x^*_k$, and $u^*_k$, with respect to the reference signal at time $i$, $d_i$, will have exponential decay in terms of $|k-i|$ with a decay rate $\rho$ independent of the temporal horizon length. The key technical step is to prove that a version of the convexification approach proposed by Verschueren et al. can be applied to the KKT conditions and results in a convex quadratic program with uniformly bounded data. In turn, Riccati techniques can be further employed to obtain the sensitivity result, borne from the observation that the directional derivatives are solutions of quadratic programs with structure similar to the KKT conditions themselves. We validate our findings with numerical experiments on a small nonlinear, nonconvex, dynamic program.

97 MATHEMATICS AND COMPUTING↗

PySolate : A Python‐Based Thresholding Tool to Denoise or Designal Seismic Waveforms Based on the Continuous Wavelet Transform

PySolate is a Python‐based toolset that implements the continuous wavelet transform and nonlinear thresholding operations to denoise or designal seismic data, following Langston and Mousavi (2019). This filtering approach can remove microseismic noise to isolate intermediate‐period seismic signals that are key to enabling full‐waveform modeling and analysis of smaller‐magnitude regional events. This approach is best for the application to signals with frequency or time separation of signal and noise, in contrast to Fourier analysis, which is effective when signal and noise are separated in frequency. We demonstrate the Python toolset using the six announced Democratic People’s Republic of Korea declared nuclear tests, showing the effectiveness of isolating the seismic signal compared to standard bandpass filtering. In conclusion, we also demonstrate the ease of using the toolset with any Python processing tools.

Asia↗

Equivalence of time-multiplexed and frequency-multiplexed signals in digital communications.

In comparing different techniques for multiplexing N binary data signals into a single channel, time-division multiplexing (TDM) is known to have a theoretic efficiency of 100 percent (neglecting sync power) and thus seems to outperform frequency-division multiplexing systems (FDM). By considering more general FDM systems, we will show that both TDM and FDM are equivalent and have an efficiency of 100 percent. The difference between the systems is in the multiplexing and demultiplexing subsystems, but not in the performance or in the generated waveforms.

Timor, U.↗

Fast signal averager

Electron beam of cathode ray tube with fast phosphor is intensity-modulated by input signal to produce repetitive horizontal trace of luminous intensity proportional to time-varying signal strength. Horizontal trace of cathode ray tube occurs so repetitive portion of signal of interest is encompassed within its length.

Cornsweet, T. N.↗

A1 moonquakes - Source distribution and mechanism

Two novel analysis techniques have been used to study focal mechanisms of A1 moonquakes, which occur at the most active of the 80 deep-moonquake source regions identified to date. The first is the cross-spectral analysis of matching signal waveforms. Cross phase spectra clearly show relative polarity of signals and give precise time relationships between signals, thus enabling accurate detemination of relative source locations within the source region. The second is the analysis of amplitude ratios, which reveal the patterns of P- and S-wave radiations around the source region. A1 moonquake foci are found to be concentrated in a nearly horizontal planar region less than 1 km in diameter. Their focal mechanism may be described by slippages along a horizontal plane with the slip direction rotating with and predominantly controlled by the shifting tidal stress field. Thus, A1 moonquakes represent a process of simple storage and release of tidal energy with no evidence for a release of accumulated tectonic stress.

Nakamura, Y.↗

Current Mode Logic Fan Out

Current mode logic is used in high speed timing systems for particle accelerators due to the fast rise time of the electrical signal. This software provides the necessary documentation to produce multiple copies of a single input for distribution to multiple devices. This software supports the DOE mission by providing a method for producing high speed signals in accelerator timing systems.

Long, Joseph De↗

Integrating vehicle trajectory planning and arterial traffic management to facilitate eco-approach and departure deployment

Eco-approach and departure (EAD) enable continuous vehicle motion in urban signalized corridors. Since such a motion can extend to the EAD vehicles’ followers, it makes EAD a promising technology to benefit the traffic flow where automated vehicles and conventional vehicles coexist. Most existing EAD studies envision an ideal setting that neglects real-world operational conditions such as lane changes, multi-movement intersection configuration, partially automated fleet, and/or limited traffic state awareness. This study aims to fill the gap by designing an EAD algorithm considering real-world traffic operation constraints. The proposed algorithm uses a model predictive controller to minimize vehicle speed reduction and variation based on the real-time traffic signal control plan and measured queues at the intersection. The required inputs are readily available at many modern intersections. We observed that the proposed controller’s performance might degrade because of lane-changing maneuvers and lead-left turn traffic signals. These observations motivated our development of a lane change management strategy and a signal control implementation strategy to facilitate the EAD implementation. The lane change management strategies separate the EAD operations and lane-changing maneuvers in time and space. The signal control implementation strategy applies lag-left turn signals to enable EAD operation for both the through and left-turn vehicles. Compared to the non-EAD case, our EAD approach produces 2.5% to 7.8% energy savings while keeping similar intersection mobility. Notably, this approach brings about 2.5% to 3.6% energy savings in a 2% CAV case. This result demonstrates the feasibility of deploying EAD at low connected automated vehicle penetration rates.

Arterial corridor management↗

High-resolution frequency determination of discrete signal components

An important problem in many applications involves the determination of the frequency of a limited set of sinusoidal components in a time domain signal. The Fourier transform is used as the fundamental tool for conversion to the frequency domain. In the present investigation, an analysis is conducted of the errors inherent in the use of the Fourier transform without time domain windowing, and an algorithm is developed which makes it possible to obtain the frequency of the component signals with high accuracy. This algorithm combines the advantages of the Gaussian window with the computational efficiency of the Fast Fourier Transform (FFT).

Walton, E. K.↗

RECOVERING A SHORT TIMESCALE SIGNAL FROM A PAIR OF LONG-DELAY VISARS

We introduce the benefits of analyzing VISAR data in the Fourier domain, particularly for recovering the short time scale signal component. In particular, by combining data from two VISARS having different long delays, we effectively reproduce the short time resolution ability of a short delay while retaining the superior sensitivity to absolute velocity of a long delay. Two different delays are generally desired, not only to untangle integer fringe skips, but to circumvent the fact that a single VISAR cannot record signal components of frequencies periodic with its reciprocal delay. Combining two different delays solves this. We treat the VISARs as linear filters and process and combine the signals in the Fourier domain with a direct equation, without any iteration of time-retarded equations. The technique is demonstrated with a numerical simulation.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗