Results for “GAS MIXTURE” — Page 30

NASA NTRS1986

A two-dimensional numerical study of the flow inside the combustion chambers of a motored rotary engine

A numerical study was performed to investigate the unsteady, multidimensional flow inside the combustion chambers of an idealized, two-dimensional, rotary engine under motored conditions. The numerical study was based on the time-dependent, two-dimensional, density-weighted, ensemble-averaged conservation equations of mass, species, momentum, and total energy valid for two-component ideal gas mixtures. The ensemble-averaged conservation equations were closed by a K-epsilon model of turbulence. This K-epsilon model of turbulence was modified to account for some of the effects of compressibility, streamline curvature, low-Reynolds number, and preferential stress dissipation. Numerical solutions to the conservation equations were obtained by the highly efficient implicit-factored method of Beam and Warming. The grid system needed to obtain solutions were generated by an algebraic grid generation technique based on transfinite interpolation. Results of the numerical study are presented in graphical form illustrating the flow patterns during intake, compression, gaseous fuel injection, expansion, and exhaust.

Shih, T. I. P.↗

NASA NTRS1986

Fatigue of 1018 steel in hydrogen

Tests are performed at different hydrogen pressures and mechanical load parameter values (applied load, stress concentration factor, applied load frequency) to study enhanced fatigue crack growth in SAE 1018 steel. Oxygen was introduced as a hydrogen-oxygen gas mixture environment in order to compare the role of oxygen in crack inhibition with that previously reported for both static and cyclic loading of higher strength steels. In a number of experiments, a thin film of palladium was applied to the specimen surface to facilitate the study of steel-hydrogen interaction in the absence of any surface impedance to hydrogen entry. The kinetics of the diffusing atoms are found to be influenced by the stress field around the notch tip and the applied frequency. An increment in environmental effect occurred when applied load or stress concentration factor was increased.

Lo, S. H.↗

NASA NTRS1985

Photochemical reactions in interstellar grains photolysis of CO, NH3, and H2O

The interstellar grains are currently considered to be the basic building blocks of comets and, possibly, meteorites. To test this theory, a simulation of the organic layer accreted onto interstellar dust particles was prepared by slow deposition of a CO:NH3:H2O gas mixture on an Al block at 10 K, with concomitant irradiation with vacuum UV. The results of the HPLC and IR analyses of the nonvolatile residue formed by photolysis at 10 K are compared with those observed at 77 K and 298 K. Some of the compounds that may be present on the surfaces of interstellar dust particles have been identified, and some specific predictions concerning the types of molecular species present in comets could be drawn. The results also suggest that photochemical reactions may have been important for the formation of meteorite components. The implication of the findings to the questions of the source of organic matter on earth and the origin of life are discussed.

Agarwal, V. K.↗

NASA NTRS1987

Studies of CO oxidation on Pt/SnO2 catalyst in a surrogate CO2 laser facility

Samples of 1% Pt/SnO2 catalyst were exposed to a stoichiometric gas mixture of 1% CO and 1.2% O2 in helium over a range of flowrates from 5 to 15 sccm and temperatures from 338 to 394 Kelvin. Reaction rate constants for the catalytic oxidation of carbon monoxide and their temperature dependence were determined and compared with previous literature values.

Batten, Carmen E.↗

NASA NTRS1987

Low power arcjet thruster pulse ignition

An investigation of the pulse ignition characteristics of a 1 kW class arcjet using an inductive energy storage pulse generator with a pulse width modulated power converter identified several thruster and pulse generator parameters that influence breakdown voltage including pulse generator rate of voltage rise. This work was conducted with an arcjet tested on hydrogen-nitrogen gas mixtures to simulate fully decomposed hydrazine. Over all ranges of thruster and pulser parameters investigated, the mean breakdown voltages varied from 1.4 to 2.7 kV. Ignition tests at elevated thruster temperatures under certain conditions revealed occasional breakdowns to thruster voltages higher than the power converter output voltage. These post breakdown discharges sometimes failed to transition to the lower voltage arc discharge mode and the thruster would not ignite. Under the same conditions, a transition to the arc mode would occur for a subsequent pulse and the thruster would ignite. An automated 11 600 cycle starting and transition to steady state test demonstrated ignition on the first pulse and required application of a second pulse only two times to initiate breakdown.

Sarmiento, Charles J.↗

NASA NTRS1986

Life problems of dc and RF-excited low-power CW CO2 waveguide lasers

A number of different, RF-excited 3-W CW CO2 waveguide lasers have been built. Four of these lasers, after continuously working for 15,000-30,000 h, still yield about 70 percent of their original power output. The design variations cover N2and CO-bearing gas mixtures, as well as internal- and external-capacitively coupled excitation electrodes. A similar laser survived 50,000 5-min-ON/5-min-OFF cycles without significant mirror damage. It was not possible to find suitable cold cathodes that allow the building of longitudinally dc-excited CW CO2 waveguide lasers that work for such extended periods of time.

Hochuli, U. E.↗

NASA NTRS1986

High-temperature oxidation of a rapidly solidified amorphous Ta-Ir alloy

The oxidation products formed at 500 and 700 C on an amorphous Ta-44.5 at. pct Ir alloy in an Ar-0.1 percent O2 gas mixture were characterized using SEM, XRD, EPMA, TEM, STEM, AES, and XPS. Initially, a thin (3-4 nm) layer of Ta2O5 formed at the surface of the alloy. Continued growth of the Ta2O5, which occurred very rapidly, involved diffusion of oxygen anions from the Ta2O5/gas interface to the alloy/Ta2O5 interface, where tantalum was selectively oxidized. Because the oxide grew more quickly than iridium could diffuse back into the alloy, the iridium coalesced into platelets of crystalline iridium-rich alloy that were oriented approximately parallel to the oxide/alloy interface, and which became embedded in a matrix of Ta2O5. The unoxidized core remained in the glassy state. The oxidation process and/or the dissolution of oxygen into the unoxidized alloy caused the alloy to become embrittled.

Cotell, Catherine M.↗

NASA NTRS1986

A two-dimensional numerical study of the flow inside the combustion chamber of a motored rotary engine

A numerical study was performed to investigate the unsteady, multidimensional flow inside the combustion chambers of an idealized, two-dimensional, rotary engine under motored conditions. The numerical study was based on the time-dependent, two-dimensional, density-weighted, ensemble-averaged conservation equations of mass, species, momentum, and total energy valid for two-component ideal gas mixtures. The ensemble-averaged conservation equations were closed by a K-epsilon model of turbulence. This K-epsilon model of turbulence was modified to account for some of the effects of compressibility, streamline curvature, low-Reynolds number, and preferential stress dissipation. Numerical solutions to the conservation equations were obtained by the highly efficient implicit-factored method of Beam and Warming. The grid system needed to obtain solutions were generated by an algebraic grid generation technique based on transfinite interpolation. Results of the numerical study are presented in graphical form illustrating the flow patterns during intake, compression, gaseous fuel injection, expansion, and exhaust.

Shih, T. I-P.↗

NASA NTRS1987

The performance of a multistep proportional counter for use in X-ray astronomy

The addition of a parallel field preamplification region has been shown to dramatically improve the performance of a standard multiwire proportional counter, permitting high overall gas gains to be achieved, a prerequisite for good spatial resolution, without in any way compromising energy resolution. The resulting device, known as a multistep detector, has been tested over a wide range of operating conditions and fill gas mixtures. Results are presented here detailing the performance available with argon and xenon as the principal gases, these being of particular relevance to X-ray astronomy.

Ramsey, B. D.↗

NASA NTRS1987

The calculation of high-temperature equilibrium and nonequilibrium specific heat data for N2, O2 and NO

Specific heat data for high-temperature air species are needed to compute the temperature and enthalpy of gas mixtures in aerothermodynamics flowfield calculations. Accurate data are known only for temperatures under 6000 K, but are required for temperatures exceeding 25,000 K. In the present study, CP data are computed for N2, O2 and NO. The calculations are based on summations over all the vibration-rotation energy levels for all known bound electronic states. Estimates are made for the error introduced by the neglect of possible additional high-lying electronic states. In addition, a scheme for the partitioning of the internal energy into vibrational, rotational and electronic contributions is presented which consistently accounts for the nonseparable nature of the various energy modes. The multitemperature specific heat data are recommended for use in nonequilibrium flowfield models.

Jaffe, Richard L.↗

NASA NTRS1987

Low power arcjet thruster pulse ignition

An investigation of the pulse ignition characteristics of a 1 kW class arcjet using an inductive energy storage pulse generator with a pulse width modulated power converter identified several thruster and pulse generator parameters that influence breakdown voltage including pulse generator rate of voltage rise. This work was conducted with an arcjet tested on hydrogen-nitrogen gas mixtures to simulate fully decomposed hydrazine. Over all ranges of thruster and pulser parameters investigated, the mean breakdown voltages varied from 1.4 to 2.7 kV. Ignition tests at elevated thruster temperatures under certain conditions revealed occasional breakdowns to thruster voltages higher than the power converter output voltage. These post breakdown discharges sometimes failed to transition to the lower voltage arc discharge mode and the thruster would not ignite. Under the same conditions, a transition to the arc mode would occur for a subsequent pulse and the thruster would ignite. An automated 11 600 cycle starting and transition to steady state test demonstrated ignition on the first pulse and required application of a second pulse only two times to initiate breakdown.

Sarmiento, Charles J.↗

NASA NTRS1988

Modulated-Voltage Metastable-Ionization Detector

New detector retains sensitivity of conventional ones but automatically reduces voltage to prevent current saturation at higher values, enabling quantitative determination of relative concentrations approaching 100 percent. Detector includes feedback circuitry to prevent current saturation. When detector current begins to exceed threshold, detector high voltage reduced to keep current from rising much more. Recorder output shows detector-current and voltage-reduction signals from gas mixture with constituents both above and below threshold concentration. Those above threshold cause both current and voltage-reduction peaks. Those below threshold give rise to current peaks only.

Carle, Glenn C.↗

NASA NTRS1988

Diamond film by hot filament CVD method

Diamond synthesis by the hot filament CVD method is discussed. A hot filament decomposes gas mixtures and oxygen containing organic compounds such as alcohols. which are carbon sources. The resulting thin films, growth mechanisms, and characteristics and problems associated with the hot filament CVD method are analyzed and evaluated.

Hirose, Y.↗

NASA NTRS1986

Catalytic recombination of dissociation products with Pt/SnO2 for rare and common isotope long-life, closed-cycle CO2 lasers

This paper reports results on recombination of pulsed CO2 laser dissociation products with Pt/SnO2 catalysts, and supporting studies in a surrogate laboratory catalyst reactor. The closed-cycle, pulsed CO2 laser has been continuously operated for one million pulses with an overall power degradation of less than 5 percent by flowing the laser gas mixture through a 2-percent Pt/SnO2 catalyst bed. In the surrogate laboratory reactor, experiments have been conducted to determine isotopic exchange with the catalyst when using rare-isotope gases. The effects of catalyst pretreatment, sample weight, composition, and temperature on catalyst efficiency have also been determined.

Brown, Kenneth G.↗

NASA NTRS1986

The diffusion of individual molecules within a gas

The Direct Simulation Monte Carlo method is used to study the positional history of the individual molecules in a gas that is homogeneous at the macroscopic level and is in Maxwellian equilibrium at the microscopic level. The behavior at small times is characterized by 'persistence of velocity' effects, and a 'random walk' type of dispersal occurs over a longer timescale. It is shown that the rate of dispersal can be directly related to the self-diffusion coefficient. In addition, the diffusion coefficients are obtained directly from one-dimensional calculations, and the local Knudsen number at which the Chapman-Enskog theory breaks down is determined. Results are presented for both simple gases and gas mixtures.

Bird, G. A.↗

NASA NTRS1987

Electric discharge synthesis of HCN in simulated Jovian atmospheres

Corona discharge is presently considered as a possible source of the HCN detected in the Jovian atmosphere at 2.2 x 10 to the -7th moles/sq cm column density, for the cases of gas mixtures containing H2, CH4, and NH3, with H2/CH4 ratios from 4.4 to 1585. A 3:1 ratio of corona discharge to lightning energy similar to that of the earth is applied to Jupiter. Depending on the lightning energy available on Jupiter and the eddy diffusion coefficients in the synthesis region, HCN column densities generated by corona discharge could account for about 10 percent of the HCN observed.

Stribling, Roscoe↗

NASA NTRS1987

Mass spectrometric studies of phosphine pyrolysis and OMVPE growth of InP

The mechanism of PH3 decomposition was studied by using D2 as a carrier gas and analyzing the reaction products with a mass spectrometer. The effects of InP and silica surfaces were investigated. The only gaseous product below 600 C is H2. Since any gas-phase H atoms would produce HD, the reaction occurs entirely on the surface. The slow step is the unimolecular removal of the first hydrogen atom, with an activation energy of 36.0 kcal/mole on InP surfaces. The reaction on InP is first-order for PH3 concentrations as high as 15 percent, so the surface is not saturated at those conditions. When trimethylindium (TMIn) is added to the gas mixture, the mechanism changes dramatically, probably proceeding via an unstable intermediate adduct of TMIn and PH3 which eliminates CH4 upon formation. This concerted reaction lowers the pyrolysis temperatures of both PH3 and TMIn.

Larsen, C. A.↗

NASA NTRS1988

The possible contamination of Jupiter

The Galileo probe, though at present its future is uncertain, would, if not sterilized, represent a good chance of contaminating Jupiter. Most scientists opposed to sterilizing the probe argue that to order the probe sterilized would be the death of the project, since sterilization would entail a reconstruction of the probe, and there are not enough funds to accomplish this. These scientists, however, are ignoring a relatively simple and inexpensive alternative to the traditional heat sterilization method. The main threat of contamination comes from Galileo's exterior surfaces: the shell of the probe and its parachute. The probe innermost components would not represent a threat since the probe is sealed. In light of the fact that only the exterior of Galileo would have to be sterilized, heat would not have to be used as a method of sterilization. Instead, various gas mixtures could be sprayed entirely over the probe and its parachute, gases which would kill any and all bacteria. This idea is more thoroughly examined.

Garcia, Joe↗