Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Bounds”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30

Muon capture rates on O-16 leading to bound states of N-16.

A low-energy spectrum of gamma-rays following muon capture in O-16 was obtained with a high-resolution 1 cu cm Ge(Li) detector. The graph of the spectrum shows the separation of contaminant peaks from the 120 keV N-16 line. It is pointed out that there is a large discrepancy between the capture rate obtained in the investigation and results reported by Deutsch et al. (1969).

Kane, F. R.↗

Analysis and design of advanced composite bounded joints

Advances in the analysis of adhesive-bonded joints are presented with particular emphasis on advanced composite structures. The joints analyzed are of double-lap, single-lap, scarf, stepped-lap and tapered-lap configurations. Tensile, compressive, and in-plane shear loads are covered. In addition to the usual geometric variables, the theory accounts for the strength increases attributable to adhesive plasticity (in terms of the elastic-plastic adhesive model) and the joint strength reductions imposed by imbalances between the adherends. The solutions are largely closed-form analytical results, employing iterative solutions on a digital computer for the more complicated joint configurations. In assessing the joint efficiency, three potential failure modes are considered. These are adherend failure outside the joint, adhesive failure in shear, and adherend interlaminar tension failure (or adhesive failure in peel). Each mode is governed by a distinct mathematical analysis and each prevails throughout different ranges of geometric sizes and proportions.

Hart-Smith, L. J.↗

An implicit sampling theorem for bounded bandlimited functions

A rigorous proof of the 'strong bias tone' scheme is embodied in the implicit sampling theorem. The representation of signals that are sample functions of possible nonstationary random processes being of principal interest, the proof could not directly invoke results from classical analysis, which depend on the existence of the Fourier transform of the function under consideration; rather, it is based on Zakai's (1965) theorem on the series expansion of functions, band-limited under a suitably extended definition. A practical circuit that restores an approximate version of the signal from its sine-wave-crossings is presented and possible improvements to it are discussed.

Bar-David, I.↗

Stabilizing feedback control for dynamical systems with bounded uncertainty

The theories of differential games and generalized dynamic systems are used to deduce stabilizing controllers for quasi-linear systems. Attention is given to a class of dynamic systems subject to parameter and input uncertainty whose values range in a given compact set. Using a worst case design philosophy, a feedback control is derived that assures uniform asymptotic (Liapunov) stability of the origin under all admissible uncertainties.

Gutman, S.↗

Bounds on thickness and loading noise of rotating blades and the favorable effect of blade sweep on noise reduction

The maxima of amplitudes of thickness and loading noise harmonics are established when the radial distribution of blade chord, thickness ratio, and lift coefficient is specified. It is first shown that only airfoils with thickness distribution and chordwise loading distributions which are symmetric with respect to midchord need be considered for finding the absolute maxima of thickness and loading noise. The resulting chordwise thickness and load distributions for these maximum noise conditions require infinite slope at some points along the chord but otherwise are uniform. It is shown that sweeping the blades reduces the thickness and loading noise, but there is no optimum sweep which generates the lowest noise.

Farassat, F.↗

High-flying Mini-Sniffer RPV - Mars bound

The Mini-Sniffer is a small unmanned survey aircraft developed by NASA to conduct turbulence and atmospheric pollution measurements from ground level to an altitude of 90,000 ft. Carrying a 25-lb air sampling apparatus, the Mini-Sniffer typically cruises for one hour at 70,000 ft before being remotely piloted back to earth. A hydrazine monopropellant engine powers the craft, while a PCM telemetering system and a radar transponder provide control functions. Development of a high-performance low-Reynolds-number airfoil could make the research craft suitable for a low-altitude terrain-following mission on Mars.

Reed, R. D.↗

Upper bound and probable value of the rate constant of the reaction OH + HO2 yields H2O + O2

Discharge-flow experiments at 295 K of the OH + HO2 reaction are described in which excess O3 is added to OH through a movable injector; OH concentration is measured downstream by resonance fluorescence with and without addition of excess NO just upstream of the detector so that both OH concentration and OH concentration + HO2 concentration are determined independently. The data are compared with a computer model involving 12 reaction steps. A simple sensitivity analysis is carried out to establish how errors in the other 'known' rate constants affect the data fit. Best agreement is obtained between computer calculations and experiments when k1 for the OH + HO2 reaction is in the range 2-3 x 10 to the -11th cu cm/s. Values above about 5 x 10 to the -11th are very unlikely whereas those below about 1 x 10 to the -11th are less strongly excluded.

Chang, J. S.↗

Regressions by leaps and bounds and biased estimation techniques in yield modeling

The author has identified the following significant results. It was observed that OLS was not adequate as an estimation procedure when the independent or regressor variables were involved in multicollinearities. This was shown to cause the presence of small eigenvalues of the extended correlation matrix A'A. It was demonstrated that the biased estimation techniques and the all-possible subset regression could help in finding a suitable model for predicting yield. Latent root regression was an excellent tool that found how many predictive and nonpredictive multicollinearities there were.

Marquina, N. E.↗

Diffuse X-ray emission from Abell clusters 401 and 399 - A gravitationally bound system

The X-ray emission from the Abell 401-399 region has been studied using data obtained by the A-1 proportional counter aboard HEAO 1 in two different ways. The first involved routine scanning of the region during the all-sky survey, and the second was an observation in which the instrument was pointed at A401 during a lunar occultation. The emission is shown to be unusually extended and to be centered on a point lying between A401 and A399. The best fit of a uniform disk model to the data yielded a radius of 25.5 + or -4.4 arcmin for the lunar occultation and 42 + or - 17 arcmin for the scans. A possible explanation of the results is that A401 and A399 are both diffuse cluster X-ray sources. Alternatively, the emission may come from a large gas cloud of at least 10 to the 15th solar masses enveloping both clusters.

Ulmer, M. P.↗

Phase change in liquid face seals. II - Isothermal and adiabatic bounds with real fluids

Analytical studies of phase change effects in parallel and tapered liquid face seals are presented. An isothermal and adiabatic model of low Reynolds number flow are considered by numerical integration of the descriptive equations for a real fluid, and its thermodynamic properties are calculated for each step, using a computer program for the steam tables or fluid thermodynamic properties. It was shown that for low leakage rate the isothermal model is more accurate and for high leakage rates the adiabatic model is more accurate; that both models yield the same conclusions regarding stability; and that the transient of collapse is described by the adiabatic model which predicts a catastrophic collapse and then either failure or explosive return to a larger film thickness value. Finally, it is shown that converging seals may become unstable and the mass leakage rate is reduced significantly below the all liquid value when boiling occurs.

Hughes, W. F.↗

Transmitted sound field due to an impulsive line acoustic source bounded by a plate followed by a vortex sheet

The propagation of sound due to a line acoustic source in the moving stream across a semiinfinite vortex sheet which trails from a rigid plate is examined in a linear theory for the subsonic case. A solution for the transmitted sound field is obtained with the aid of multiple integral transforms and the Wiener-Hopf technique for both the steady state (time harmonic) and initial value (impulsive source) situations. The contour of inverse transform and hence the decomposition of the functions are determined through causality and radiation conditions. The solution obtained satisfies causality and the full Kutta conditions. The transmitted sound field is composed of two waves in both the stady state and initial value problems. One is the wave scattered from the edge of the plate which is associated with the bow wave and the instability wave. These waves exist in the downstream sectors. The other is the wave transmitted through the vortex sheet which is also associated with the instability wave. Regional divisions of the transmitted sound field are identified.

Miura, T.↗