Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “approximate computing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

The Effect of Cumulus Cloud Field Anisotropy on Domain-Averaged Solar Fluxes and Atmospheric Heating Rates

Cumulus clouds can become tilted or elongated in the presence of wind shear. Nevertheless, most studies of the interaction of cumulus clouds and radiation have assumed these clouds to be isotropic. This paper describes an investigation of the effect of fair-weather cumulus cloud field anisotropy on domain-averaged solar fluxes and atmospheric heating rate profiles. A stochastic field generation algorithm was used to produce twenty three-dimensional liquid water content fields based on the statistical properties of cloud scenes from a large eddy simulation. Progressively greater degrees of x-z plane tilting and horizontal stretching were imposed on each of these scenes, so that an ensemble of scenes was produced for each level of distortion. The resulting scenes were used as input to a three-dimensional Monte Carlo radiative transfer model. Domain-average transmission, reflection, and absorption of broadband solar radiation were computed for each scene along with the average heating rate profile. Both tilt and horizontal stretching were found to significantly affect calculated fluxes, with the amount and sign of flux differences depending strongly on sun position relative to cloud distortion geometry. The mechanisms by which anisotropy interacts with solar fluxes were investigated by comparisons to independent pixel approximation and tilted independent pixel approximation computations for the same scenes. Cumulus anisotropy was found to most strongly impact solar radiative transfer by changing the effective cloud fraction, i.e., the cloud fraction when the field is projected on a surface perpendicular to the direction of the incident solar beam.

Hinkelman, Laura M.↗

An approximation formula for a class of fault-tolerant computers

An approximation formula is derived for the probability of failure for fault-tolerant process-control computers. These computers use redundancy and reconfiguration to achieve high reliability. Finite-state Markov models capture the dynamic behavior of component failure and system recovery, and the approximation formula permits an estimation of system reliability by an easy examination of the model.

White, A. L.↗

Calculation of laminar heating rates on three-dimensional configurations using the axisymmetric analogue

A theoretical method was developed for computing approximate laminar heating rates on three dimensional configurations at angle of attack. The method is based on the axisymmetric analogue which is used to reduce the three dimensional boundary layer equations along surface streamlines to an equivalent axisymmetric form by using the metric coefficient which describes streamline divergence (or convergence). The method was coupled with a three dimensional inviscid flow field program for computing surface streamline paths, metric coefficients, and boundary layer edge conditions.

Hamilton, H. H., II↗

A block iterative finite element algorithm for numerical solution of the steady-state, compressible Navier-Stokes equations

An iterative method for numerically solving the time independent Navier-Stokes equations for viscous compressible flows is presented. The method is based upon partial application of the Gauss-Seidel principle in block form to the systems of nonlinear algebraic equations which arise in construction of finite element (Galerkin) models approximating solutions of fluid dynamic problems. The C deg-cubic element on triangles is employed for function approximation. Computational results for a free shear flow at Re = 1,000 indicate significant achievement of economy in iterative convergence rate over finite element and finite difference models which employ the customary time dependent equations and asymptotic time marching procedure to steady solution. Numerical results are in excellent agreement with those obtained for the same test problem employing time marching finite element and finite difference solution techniques.

Cooke, C. H.↗

A block iterative finite element algorithm for numerical solution of the steady-state, compressible Navier-Stokes equations

An iterative method for numerically solving the time independent Navier-Stokes equations for viscous compressible flows is presented. The method is based upon partial application of the Gauss-Seidel principle in block form to the systems of the nonlinear algebraic equations which arise in construction of finite element (Galerkin) models approximating solutions of fluid dynamic problems. The continuous cubic element on triangles is employed for function approximation. Computational results for a free shear flow at Re = 1000 indicate significant achievement of economy in iterative convergence rate over finite element and finite difference models which employ the customary time dependent equations and symptotic time marching procedure to steady solution. Numerical results are in excellent agreement with those obtained for the same test problem employing time marching finite element and finite difference solution techniques.

Cooke, C. H.↗

An alternative approach to the numerical simulation of steady inviscid flow

A numerical procedure for the efficient simulation of steady inviscid flow is described and its utility demonstrated. Application of the surrogate equation technique allows the formulation of stable, fully conservative, type dependent finite difference equations for use in obtaining numerical solutions to systems of first order partial differential equations, such as the steady state Euler equations or their various approximations. Computational results are presented for the full Euler equations and for the transonic disturbance equations. For the latter case, a computational efficiency greater than that obtained by means of the standard perturbation potential approach is indicated.

Johnson, G. M.↗

Accuracies of three computationally efficient algorithms for computing atmospheric transmittances

Three algorithms for calculating polychromatic atmospheric transmittance functions have been tested using a set of eleven distinct temperature profiles in order to compare transmittance accuracies achievable by the three methods. The comparison of rms errors demonstrates that the iterative method of McMillin and Fleming (1976) is the most accurate of the efficient algorithms currently available for gases with constant mixing ratios; its accuracy approaches that of the spectroscopic parameters and the computational approximations used in the ground-truth line-by-line calculations. The method of Arking et al. (1974), while less accurate, has the advantage of being perfectly general and easily adapted to cases where spectral bandwidths are varied

Mcmillin, L. M.↗

An alternative approach to the numerical simulation of steady inviscid flow

A numerical procedure for the efficient simulation of steady inviscid flow is described and its utility is demonstrated. The method is uniformly valid for application in the subsonic, transonic and supersonic flow regimes. It does not rely on the introduction of additional assumptions beyond those necessary to obtain the Euler equations from the Navier-Stokes equations, nor does it make use of a time-asymptotic solution of the unsteady equations of motion. Application of the herein-defined surrogate equation technique allows the formulation of stable, fully-conservative, type-dependent finite difference equations for use in obtaining numerical solutions to systems of first-order partial differential equations, such as the steady-state Euler equations or their various approximations. Computational results are presented for the full Euler equations used to simulate rotational subsonic flow and for the transonic small disturbance equations. For the latter case, a computational efficiency greater than that obtained by means of the standard perturbation potential approach is indicated.

Johnson, G. M.↗

Spatial variation of cosmic rays near the heliospheric current sheet

A quantitative comparison between theoretical predictions and observations of the intensity of galactic cosmic rays near the interplanetary current sheet is reported. Comparison of model calculations is made with a statistical analysis of observations of galactic cosmic rays at Earth and the simultaneous position of the current sheet. An ensemble of different current sheet inclinations is used, in order to make the analysis of the computations approximate the method used to analyses the data.

Jokipii, J. R.↗

Cosmic rays near the heliospheric current sheet. II - An ensemble approach to comparing theory and observation

A quantitative comparison is carried out between theoretical predictions and observations of the intensity of galactic cosmic rays near the interplanetary current sheet. Model calculations are compared with a statistical analysis of observations of galactic cosmic rays at the earth and the simultaneous position of the current sheet. Since the observations were made over a period of several years, the inclination of the current sheet varied considerably, and comparison with any one model calculation referring to a given inclination would not be appropriate. An ensemble of different current sheet inclinations are used to generate expected values with the model in order to make the analysis of the computations approximate the method used to analyze the data. Agreement is found between theory and observation at energies of the order of a few GeV.

Jokipii, J. R.↗

On computing eigensolution sensitivity data using free vibration solutions

A simplified method of computing eigensolution sensitivity derivatives in structural dynamics is developed. It is shown that if the elements of stiffness and mass matrices associated with a design variable are homogeneous functions of that design variable, then eigenvalue derivatives can be computed from element strain and kinetic energies. Furthermore, if cross-mode energies are known, eigensolution derivatives of modified systems can be computed approximately using assume mode reanalysis formulation. A ten bar truss example is used to illustrate the present formulations.

Wang, B. P.↗

Proceedings of the Second Joint Technology Workshop on Neural Networks and Fuzzy Logic, volume 2

Documented here are papers presented at the Neural Networks and Fuzzy Logic Workshop sponsored by NASA and the University of Texas, Houston. Topics addressed included adaptive systems, learning algorithms, network architectures, vision, robotics, neurobiological connections, speech recognition and synthesis, fuzzy set theory and application, control and dynamics processing, space applications, fuzzy logic and neural network computers, approximate reasoning, and multiobject decision making.

Lea, Robert N.↗

Numerical solutions of 2-D multi-stage rotor/stator unsteady flow interactions

The Rai method of single-stage rotor/stator flow interaction is extended to handle multistage configurations. In this study, a two-dimensional Navier-Stokes multi-zone approach was used to investigate unsteady flow interactions within two multistage axial turbines. The governing equations are solved by an iterative, factored, implicit finite-difference, upwind algorithm. Numerical accuracy is checked by investigating the effect of time step size, the effect of subiteration in the Newton-Raphson technique, and the effect of full viscous versus thin-layer approximation. Computer results compared well with experimental data. Unsteady flow interactions, wake cutting, and the associated evolution of vortical entities are discussed.

Yang, R.-J.↗

Proceedings of the Second Joint Technology Workshop on Neural Networks and Fuzzy Logic, volume 1

Documented here are papers presented at the Neural Networks and Fuzzy Logic Workshop sponsored by NASA and the University of Houston, Clear Lake. The workshop was held April 11 to 13 at the Johnson Space Flight Center. Technical topics addressed included adaptive systems, learning algorithms, network architectures, vision, robotics, neurobiological connections, speech recognition and synthesis, fuzzy set theory and application, control and dynamics processing, space applications, fuzzy logic and neural network computers, approximate reasoning, and multiobject decision making.

Lea, Robert N.↗

Simplified Digital Spectrum Analyzer

Spectrum analyzer computes approximate cross-correlations between noisy input signal and reference signal of known frequency, yielding measure of amplitude of sinusoidal component of input. Complexity and power consumed less than other digital spectrum analyzers. Performs no multiplications, and because processes data on each frequency independently, focuses on narrow spectral range without processing data on rest of spectrum.

Cole, Steven W.↗