Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “VTOL AIRCRAFT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Display/control requirements for automated VTOL aircraft

A systematic design methodology for pilot displays in advanced commercial VTOL aircraft was developed and refined. The analyst is provided with a step-by-step procedure for conducting conceptual display/control configurations evaluations for simultaneous monitoring and control pilot tasks. The approach consists of three phases: formulation of information requirements, configuration evaluation, and system selection. Both the monitoring and control performance models are based upon the optimal control model of the human operator. Extensions to the conventional optimal control model required in the display design methodology include explicit optimization of control/monitoring attention; simultaneous monitoring and control performance predictions; and indifference threshold effects. The methodology was applied to NASA's experimental CH-47 helicopter in support of the VALT program. The CH-47 application examined the system performance of six flight conditions. Four candidate configurations are suggested for evaluation in pilot-in-the-loop simulations and eventual flight tests.

Hoffman, W. C.↗
NASA NTRS1988

Unsteady features of jets in lift and cruise modes for VTOL aircraft

Experiments were performed to simulate jet plume effects associated with VTOL aircraft in takeoff and cruise modes. A water facility was used to investigate the influence of inclination angle and separation distance on the three-dimensional fountain flowfield generated by two impinging jets operating at a jet Reynolds number of 250,000. Substantial differences in the flow features were observed for different spacings between the jets. Plume effects in cruise mode were simulated by a supersonic unheated jet parallel to a wall. Variation of the distance between the wall and the edge of the plume is shown to have a major controlling effect on the supersonic screech instability.

Kibens, V.↗
NASA NTRS1981

Influence of friction forces on the motion of VTOL aircraft during landing operations on ships at sea

Equations describing the friction forces generated during landing operations on ships at sea were formulated. These forces depend on the platform reaction and the coefficient of friction. The platform reaction depends on the relative sink rate and the shock absorbing capability of the landing gear. The friction coefficient varies with the surface condition of the landing platform and the angle of yaw of the aircraft relative to the landing platform. Landings by VTOL aircraft, equipped with conventional oleopneumatic landing gears are discussed. Simplifications are introduced to reduce the complexity of the mathematical description of the tire and shock strut characteristics. Approximating the actual complicated force deflection characteristic of the tire by linear relationship is adequate. The internal friction forces in the shock strut are included in the landing gear model. A set of relatively simple equations was obtained by including only those tire and shock strut characteristics that contribute significantly to the generation of landing gear forces.

Howard, J. C.↗
NASA NTRS1976

The design of digital-adaptive controllers for VTOL aircraft

Design procedures for VTOL automatic control systems have been developed and are presented. Using linear-optimal estimation and control techniques as a starting point, digital-adaptive control laws have been designed for the VALT Research Aircraft, a tandem-rotor helicopter which is equipped for fully automatic flight in terminal area operations. These control laws are designed to interface with velocity-command and attitude-command guidance logic, which could be used in short-haul VTOL operations. Developments reported here include new algorithms for designing non-zero-set-point digital regulators, design procedures for rate-limited systems, and algorithms for dynamic control trim setting.

Stengel, R. F.↗
NASA NTRS1980

An investigation of automatic guidance concepts to steer a VTOL aircraft to a small aviation facility ship

A detailed system model of a VTOL aircraft approaching a small aviation facility ship was developed and used to investigate several approach guidance concepts. A preliminary anaysis of the aircraft-vessel landing guidance requirements was conducted. The various subelements and constraints of the flight system are described including the landing scenario, lift fan aircraft, state rate feedback flight control, MLS-based navigation, sea state induced ship motion, and wake turbulence due to wind-over-deck effects. These elements are integrated into a systems model with various guidance concepts. Guidance is described in terms of lateral, vertical, and longitudinal axes steering modes and approach and landing phases divided by a nominal hover (or stationkeeping) point defined with respect to the landing pad. The approach guidance methods are evaluated, and the two better steering concepts are studied by both single pass and Monte Carlo statistical simulation runs. Four different guidance concepts are defined for further analysis for the landing phase of flight.

Sorensen, J. A.↗
NASA NTRS1965

Operational Experiences with the X-14A Deflected-Jet VTOL Aircraft

During 5 1/2 years of flight research with a deflected-jet VTOL aircraft a 2 number of operational problems were experienced and investigated. These experiences can be grouped into two general categories: (1) the effects of the jet engine and its operation and (2) the restrictions imposed upon the pilot's operation due to reduced visual reference. This report is an examination of these problems and., in some cases, presents possible solutions to these problems.

Rolls, L. Stewart↗
NASA NTRS1962

Experimental Research on 4-Duct Tandem VTOL Aircraft Configurations

This paper presents a brief summary of several wind-tunnel investigations conducted at the Langley Research Center of the NASA to study the aerodynamic and stability and control characteristics of several VTOL aircraft configurations powered by four tilting ducted propellers arranged in tandem pairs. Specifically the two rear ducts could be mounted close alongside the upper rear portion of the fuselage with small wing panels attached to the outboard side of the ducts or could be mounted outboard on the tips of a small wing located high on the rear portion of the fuselage. The two front ducts were always mounted close inboard on the forward part of the fuselage and could be mounted either in a high or low position on the fuselage. The results of the investigation indicated that aircraft of this type could have acceptable aerodynamic and static longitudinal and lateral stability and control characteristics in both transition and normal cruise flight except for the possible qualification that the lateral force due to sideslip is abnormally high and might cause the aircraft to be too sensitive to side gusts.

VTOL AIRCRAFT↗
NASA NTRS1972

Simulation study of the lift roll coupling problem for hovering VTOL aircraft

The effects of lift-roll coupling on the handling qualities of hovering VTOL aircraft using differential thrust for roll control were assessed in a piloted simulation study in the Ames six-degrees-of-freedom motion simulator. The configuration tested has three vertical thrust sources, one on the roll axis and two laterally displaced from the roll axis, with a thrust distribution of 25%/50%/25%. The outboard thrust sources were modulated to provide roll control whereas all three provided height control. Maximum thrust-to-weight ratio was varied together with a coupling parameter that combined roll-inertia, weight, and engine location. Results showed that handling qualities are affected not only by the occurrence of lift-roll coupling (dependent on both variables) but also by the severity of the coupling (dependent on the coupling parameter alone). However, the advantages of differential thrust for control can be retained with careful design.

Jacobsen, R. A.↗
NASA NTRS1975

Benefits of VTOL aircraft in offshore petroleum logistics support

The mission suitability and potential economic benefits of advanced VTOL aircraft were investigated for logistics support of petroleum operations in the North Sea and the Gulf of Mexico. Concepts such as the tilt rotor and lift/cruise fan are promising for future operations beyond 150 miles offshore, where their high cruise efficiency provides savings in trip time, fuel consumption, and capital investment. Depending upon mission requirements, the aircraft operating costs are reduced by as much as 20 percent to 50 percent from those of current helicopters.

Wilcox, D. E.↗
NASA NTRS1976

A velocity-command controller for a VTOL aircraft

A technique is presented for calculating feedback and feedforward gain matrices that enable a VTOL aircraft to track input commands of forward and vertical velocity while maintaining acceptable responses to pilot inputs. Leverrier's algorithm is used for determining a set of state-variable, feedback gains that force the closed-loop poles and zeros of one pilot-input transfer function to pre-selected positions in the s-plane. This set of feedback gains is then used to calculate the feedback and feedforward gains for the velocity-command controller. The method is computationally attractive since the gains are determined by solving systems of linear, simultaneous equations. The method is used in a digital simulation of the CH-47 helicopter to control longitudinal dynamics.

Reid, G. F.↗
NASA NTRS1976

A velocity-command controller for a VTOL aircraft

A technique is presented for calculating feedback and feedforward gain matrices that enable a VTOL aircraft to track input commands of forward and vertical velocity while maintaining acceptable responses to pilot inputs. Leverrier's algorithm is used for determining a set of state-variable, feedback gains that force the closed-loop poles and zeros of one pilot-input transfer function to pre-selected positions in the s-plane. This set of feedback gains is then used to calculate the feedback and feedforward gains for the velocity-command controller. The method is computationally attractive since the gains are determined by solving systems of linear, simultaneous equations. The method has been used in a digital simulation of the CH-47 helicopter to control longitudinal dynamics.

Reid, G. F.↗