Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “RADIATION MEASUREMENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

Flame Radiation Measurements

Spectral and total flame radiation measurements exhibited: (1) that radiant heat flux increases with vision combustor inlet air pressure; (2) the effect of fuel atomization characteristics on radiant heat flux; and (3) that a reduction in fuel hydrogen content produces a significant increase in radiant heat flux primarily at low combustor pressures.

Claus, R. W.↗

Radiation Measured with Different Dosimeters for ISS-Expedition 18-19/ULF2 on Board International Space Station during Solar Minimum

Radiation field of particles in low Earth orbit (LEO) is mainly composed of galactic cosmic rays (GCR), solar energetic particles and particles in SAA (South Atlantic Anomaly). GCR are modulated by solar activity, at the period of solar minimum activity, GCR intensity is at maximum and the main contributor for space radiation is GCR. At present for space radiation measurements conducted by JSC (Johnson Space Center) SRAG (Space Radiation Analysis Group), the preferred active dosimeter sensitive to all LET (Linear Energy Transfer) is the tissue equivalent proportional counter (TEPC); the preferred passive dosimeters are thermoluminescence dosimeters (TLDs) and optically stimulated luminescence dosimeters (OSLDs) sensitive to low LET as well as CR-39 plastic nuclear track detectors (PNTDs) sensitive to high LET. For the method using passive dosimeters, radiation quantities for all LET can be obtained by combining radiation results measured with TLDs/OSLDs and CR-39 PNTDs. TEPC, TLDs/OSLDs and CR-39 detectors were used to measure the radiation field for the ISS (International Space Station) - Expedition 18-19/ULF2 space mission which was conducted from 15 November 2008 to 31 July 2009 - near the period of the recent solar minimum activity. LET spectra (differential and integral fluence, absorbed dose and dose equivalent) and radiation quantities were measured for positions TEPC, TESS (Temporary Sleeping Station, inside the polyethylene lined sleep station), SM-P 327 and 442 (Service Module - Panel 327 and 442). This paper presents radiation LET spectra measured with TEPC and CR-39 PNTDs and radiation dose measured with TLDs/OSLDs as well as the radiation quantities combined from results measured with passive dosimeters.

Zhou, Dazhuang↗

An Automated Quality Assessment and Control Algorithm for Surface Radiation Measurements

We present an automated algorithm for testing surface broadband radiation measurements to detect erroneous data. The methodology has been developed using data from the US Department of Energy Atmospheric Radiation Measurement (ARM) Program. The testing includes physically possible limits as determined by the World Meteorological Organization (WMO) Baseline Surface Radiation Network, as well as user configurable limits based on climatological analysis of data collected at the measurement site. The algorithm can be run in near real time, or more typically on a daily basis. Additionally, longer monthly or yearly runs can be used to assess more subtle tendencies and problems in the data through evaluation of daily summaries of quality flagging.

54 ENVIRONMENTAL SCIENCES↗

2024 Atmospheric Radiation Measurement (ARM) Annual Report

This report provides an overview of the Atmospheric Radiation Measurement (ARM) user facility and a sample of achievements for fiscal year 2024 (FY2024). Strong collaborations between nine DOE national laboratories enable ARM to successfully operate in remote locations around the world. This unique partnership supports the DOE mission to provide for the energy security of the nation. Without the support of the following laboratories, ARM would not be the state-of-the-art facility that it is today. ARM is a multi-laboratory, U.S. Department of Energy (DOE) Office of Science user facility and a key contributor to national and international atmospheric and climate research efforts. ARM offers scientists cutting-edge, ground-based observatories, aerial observation capabilities, and high-performance computing. ARM’s capabilities have enabled more than 30 years of continuous measurements of cloud and aerosol properties and their effects on Earth’s energy balance.

54 ENVIRONMENTAL SCIENCES↗

Direct Measurement of Small Particle Growth and Aging at the Atmospheric Radiation Measurement Southern Great Plains Observatory Field Campaign Report

Two identical Captive Aerosol Growth and Evolution (CAGE) chambers were operated at the U.S. Department of Energy Atmospheric Radiation Measurement (ARM) user facility’s Southern Great Plains (SGP) observatory in the late summer and fall of 2021. The field study was scheduled to begin in spring, 2020, but was delayed because of the pandemic. CAGE chambers are designed to expose particles to an environment that mirrors that of the surroundings with or without a controlled perturbation designed to assess a sensitivity. The analysis here focuses on roughly the last two months of the overall study period during which measurements were almost continuous and when several perturbation experiments were conducted. Though the utility of a dual-chamber system is the ability to measure the influence of a single change on top of ambient conditions, both chambers were initially operated in the same way, with ambient air pulled through the gas exchange channel in both and ammonium sulfate particles injected into both. The similar time-dependent particle growth observed in the chambers for those periods provides confidence in differences observed during the subsequent perturbation experiments. The growth rate of particles in the reference chamber into which only ammonium sulfate particles were injected and for which only ambient air was pulled through were used to describe time-of-day averages. The average growth rate was highest in the evening and in the morning after sunrise and lowest in the late afternoon. The sensitivity of particle growth to secondary aerosol precursor gases was studied by adding them at a controlled rate to the ambient air flow pulled through one of the two chambers. Addition of 5 ppb of α-pinene resulted in an average particle growth rate of 4.4 nm hr -1 , compared with that of just 0.8 nm hr -1 in the reference chamber. The added α-pinene also triggered one new particle formation (NPF) event in the early evening just before sunset and another in the morning just after sunrise. Similarly, addition of 5 ppb of SO 2 to one chamber led to a pair of NPF events and to increased particle growth rate, though unlike the impact of added α-pinene, growth was enhanced only during the daytime when OH concentration is highest. The influence of aerosol liquid water on secondary aerosol formation and particle growth was investigated by injecting ammonium sulfate seed particles into one chamber and potassium sulfate particles into the other. Particles were injected into the two chambers four times over a 1.5-day period. The chamber relative humidity (RH) history during and following each injection was used to determine whether each particle type was crystalline or aqueous. For the case when both particle types remained crystalline throughout the period, they were tracked and for the case when they remained aqueous, the magnitude and time-dependence of the growth of both were almost exactly the same. For the other two cases the ammonium sulfate particles deliquesced upon injection and remained aqueous, while the potassium sulfate particles remained crystalline. For those two cases, the aqueous particles grew substantially faster than did the crystalline particles, providing evidence of the role of aerosol liquid water on secondary aerosol formation and particle growth.

54 ENVIRONMENTAL SCIENCES↗

Solar Radiation Measurements (CRADA Final Report)

Long-term solar radiation measurements are important for understanding solar resource availability and variability for systems design and deployment of cost-effective solar resource technologies. Additionally high-quality traceable solar measurements are required to validate satellite-based solar resource datasets that provide high-resolution long-term data covering the US. The purpose and intent of this agreement is to collect long-term solar radiation and meteorological measurements from the state-of-the-art facility at the University of Arizona to meet the above needs.

14 SOLAR ENERGY↗

Radiation measurements on the Mir Orbital Station

Radiation measurements made onboard the MIR Orbital Station have spanned nearly a decade and covered two solar cycles, including one of the largest solar particle events, one of the largest magnetic storms, and a mean solar radio flux level reaching 250 x 10(4) Jansky that has been observed in the last 40 years. The cosmonaut absorbed dose rates varied from about 450 microGy day-1 during solar minimum to approximately half this value during the last solar maximum. There is a factor of about two in dose rate within a given module, and a similar variation from module to module. The average radiation quality factor during solar minimum, using the ICRP-26 definition, was about 2.4. The drift of the South Atlantic Anomaly was measured to be 6.0 +/- 0.5 degrees W, and 1.6 +/- 0.5 degrees N. These measurements are of direct applicability to the International Space Station. This paper represents a comprehensive review of Mir Space Station radiation data available from a variety of sources. c2002 Elsevier Science Ltd. All rights reserved.

Mir Project↗

Evaluation of Arctic Broadband Surface Radiation Measurements

The Arctic is a challenging environment for making in-situ radiation measurements. A standard suite of radiation sensors is typically designed to measure the total, direct and diffuse components of incoming and outgoing broadband shortwave (SW) and broadband thermal infrared, or longwave (LW) radiation. Enhancements can include various sensors for measuring irradiance in various narrower bandwidths. Many solar radiation/thermal infrared flux sensors utilize protective glass domes and some are mounted on complex mechanical platforms (solar trackers) that rotate sensors and shading devices that track the sun. High quality measurements require striking a balance between locating sensors in a pristine undisturbed location free of artificial blockage (such as buildings and towers) and providing accessibility to allow operators to clean and maintain the instruments. Three significant sources of erroneous data include solar tracker malfunctions, rime/frost/snow deposition on the instruments and operational problems due to limited operator access in extreme weather conditions. In this study, a comparison is made between the global and component sum (direct [vertical component] + diffuse) shortwave measurements. The difference between these two quantities (that theoretically should be zero) is used to illustrate the magnitude and seasonality of radiation flux measurement problems. The problem of rime/frost/snow deposition is investigated in more detail for one case study utilizing both shortwave and longwave measurements. Solutions to these operational problems are proposed that utilize measurement redundancy, more sophisticated heating and ventilation strategies and a more systematic program of operational support and subsequent data quality protocols.

54 ENVIRONMENTAL SCIENCES↗

Regime dependence of cloud condensate variability observed at the Atmospheric Radiation Measurement Sites

Microphysical processes and cloud–radiation interaction occur on spatial scales of variability smaller than those represented explicitly in global weather forecasting and climate models. It is therefore necessary to parametrize the unresolved heterogeneity of humidity and cloud condensate in order to predict process rates accurately. Ground‐based observations from the Atmospheric Radiation Measurement sites located in various climatic regions of the world provide a source of high‐temporal‐resolution observations of cloud condensate. A number of different retrieval products for cloud condensate are assessed for the different geographical regions, years and seasons. The retrieval reliability varies with cloud type, but for cloud categories largely unaffected by precipitation a comparison across sites and longer time periods is possible. These observations confirm previously documented variability behaviour as a function of cloud fraction, but also reveal a systematic regime dependence that is not captured by existing parametrizations. Condensate variability measured as a fractional standard deviation (FSD) in warm boundary‐layer clouds is greater in the Tropics than in mid and high latitudes for scenes with comparable cloud type and fraction, with the observed FSD varying from 1.2 in the Tropics to 0.4 in the Arctic. A parametrization of the FSD of cloud liquid condensate based on the grid‐box mean total water amount and cloud fraction is formulated and shown to capture the observed range of FSD values better across different geographical sites and different seasons. The regime dependence of FSD for cirrus cloud is less pronounced than that for liquid clouds and is found largely to agree with FSD values previously derived from satellite observations.

Ahlgrimm, Maike↗

Pyroelectric detector development for the Radiation Measurement system

A new class of high detectivity pyroelectric detectors developed for optimization of the radiation measurement system within the framework of the Atmospheric Radiation Measurement program is described. These devices are intended to provide detectivities of up to about 10 exp 11 cm Hz exp 0.5/W with cooling to about 100 K required for the detector focal plane.

Hubbard, G. S.↗

Earth Radiation Measurement Science

This document is the final report for NASA Grant NAG1-1959, 'Earth Radiation Measurement Science'. The purpose of this grant was to perform research in this area for the needs of the Clouds and Earth Radiant Energy System (CERES) project and for the Earth Radiation Budget Experiment (ERBE), which are bing conducted by the Radiation and Aerosols Branch of the Atmospheric Sciences Division of Langley Research Center. Earth Radiation Measurement Science investigates the processes by which measurements are converted into data products. Under this grant, research was to be conducted for five tasks: (1) Point Response Function Measurements; (2) Temporal Sampling of Outgoing Longwave Radiation; (3) Spatial Averaging of Radiation Budget Data; (4) CERES Data Validation and Applications; and (5) ScaRaB Data Validation and Application.

Smith, G. Louis↗

The Atmospheric Radiation Measurement Program May 2003 Intensive Operations Period Examining Aerosol Properties and Radiative Influences: Preface to Special Section

Atmospheric aerosols influence climate by scattering and absorbing radiation in clear air (direct effects) and by serving as cloud condensation nuclei, modifying the microphysical properties of clouds, influencing radiation and precipitation development (indirect effects). Much of present uncertainty in forcing of climate change is due to uncertainty in the relations between aerosol microphysical and optical properties and their radiative influences (direct effects) and between microphysical properties and their ability to serve as cloud condensation nuclei at given supersaturations (indirect effects). This paper introduces a special section that reports on a field campaign conducted at the Department of Energy Atmospheric Radiation Measurement site in North Central Oklahoma in May, 2003, examining these relations using in situ airborne measurements and surface-, airborne-, and space-based remote sensing.

Ferrare, Richard↗

Optimization of Thermal Neutron Converter in SiC Sensors for Spectral Radiation Measurements

Optimization of the neutron converter in SiC sensors is presented. The sensors are used for spectral radiation measurements of thermal and fast neutrons and optionally gamma ray at elevated temperature in harsh radiation environment. The neutron converter, which is based on 10B, allows to detect thermal neutrons by means of neutron capture reaction. Two construction of the sensors were used to measure radiation in experiments. Sensor responses collected in experiments have been reproduced by the computer tool created by authors, it allows to validate the tool. The tool creates the response matrix function describing the characteristic of the sensors and it was used for detailed analyses of the sensor responses. Obtained results help to optimize the neutron converter in order to increase thermal neutron detection. Several enhanced construction of the sensors, which includes the neutron converter based on {sup 10}B or {sup 6}Li, were proposed. (authors)

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗