Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Appendix G”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Technical summary of accomplishments made in preparation for the USSR barley exploratory experiment

The highlights of the work accomplished under each subcomponent of the U.S.S.R. Barley Pilot Experiment, which is scheduled for completion in 1984, are summarized. A significant amount of developmental system implementation activity was in the final stages of preparation prior to the rescoping of project tasks. Unpublished materials which are significant to this exploratory experiment are incorporated into the appendixes.

Chapman, G. M.↗
NASA NTRS1985

Finite difference operators on unstructured triangular meshes

A new form of the Laplace operator is derived which is shown to be second-order accurate when calculated at mesh triangle nodes if the cells corresponding to the nodes have a high degree of symmetry. It is demonstrated that the Laplace operator directly derived from Stokes' integral theorem is only zeroth-order accurate on these same cells. The construction of gradient and Laplace operators on unstructured triangular grids are discussed from the variational point of view. Two discrete representations of the Laplacian are compared to each other, and conclusions are drawn regarding their accuracy on a pointwise basis. Finally, geometric relations valid on arbitrary polygons are given for completeness in an appendix.

Erlebacher, G.↗
NASA NTRS1967

Standards of conduct for NASA special government employees

NASA regulations prescribing standards of conduct for all NASA employees, including special government employees, were approved by the Civil Service Commission on September 19, 1967, and by the Administrator on October 12, 1967, and were published in the Federal Register (32 F.R. 14648-14659) on October 21, 1967. The standards of conduct regulations are issued under Executive Order 11222 of May 11, 1965 (30 F.R. 6469, 3 C.F.R. 1965 Supp.; 5 C.F.R. 735.104), and Chapter 735 of the Federal Personnel Manual. For the convenience of special government employees, those portions of the NASA standards of conduct regulations which are applicable only to special government employees, Part F and Appendixes E, F, and G, are reissued in this handbook. Except for references to 'parts,' 'subparts,' 'sections,' etc., the text is identical to that published in the Federal Register.

Source record↗
NASA NTRS1971

Reconfigurable G and C computer study for space station use. Volume 7, appendix 5 - D-200 computer family. Appendix 6 - System error analysis. Appendix 7 - Reliability derivation for candidate computers. Appendix 8 - Power converter design data. Appendix 9 - Data transmission medium design Final report, 29 Dec. 1969 - 31 Jan. 1971

D-200 computer family, system error analysis, reliability derivation, and power converter design for reconfigurable guidance and control computer - Vol. 7

Source record↗
NASA NTRS1962

Interplanetary Trajectory Optimization with Powerlimited Propulsion Systems

A trajectory-optimization process is described in which the optimum­ thrust equations are derived using the calculus of variations. The mag­nitude of the thrust is constrained within an upper and a lower bound, but the thrust direction is arbitrary. This formulation allows both the constant-thrust program and the variable-thrust program to be con­sidered. For the constant-thrust program, certain propulsion-system parameters are optimized for maximum final vehicle mass. This theory has been used to study interplanetary missions to Venus and Mars using a power-limited propulsion system. Both one-way and round­ trip rendezvous trajectories are considered. The analysis employs a two-body inverse-square force-field model of three dimensions. An iterative routine used to solve the two-point boundary-value problem is described in the Appendix.

TRAJECTORY↗
NASA NTRS1985

Advanced EVA system design requirements study: EVAS/space station system interface requirements

The definition of the Extravehicular Activity (EVA) systems interface requirements and accomodations for effective integration of a production EVA capability into the space station are contained. A description of the EVA systems for which the space station must provide the various interfaces and accomodations are provided. The discussion and analyses of the various space station areas in which the EVA interfaces are required and/or from which implications for EVA system design requirements are derived, are included. The rationale is provided for all EVAS mechanical, fluid, electrical, communications, and data system interfaces as well as exterior and interior requirements necessary to facilitate EVA operations. Results of the studies supporting these discussions are presented in the appendix.

Woods, T. G.↗
NASA NTRS1996

Dynamic and Transient Performance of Turbofan/Turboshaft Convertible Engine With Variable Inlet Guide Vanes

A convertible engine called the CEST TF34, using the variable inlet guide vane method of power change, was tested on an outdoor stand at the NASA Lewis Research Center with a waterbrake dynamometer for the shaft load. A new digital electronic system, in conjunction with a modified standard TF34 hydromechanical fuel control, kept engine operation stable and safely within limits. All planned testing was completed successfully. Steady-state performance and acoustic characteristics were reported previously and are referenced. This report presents results of transient and dynamic tests. The transient tests measured engine response to several rapid changes in thrust and torque commands at constant fan (shaft) speed. Limited results from dynamic tests using the pseudorandom binary noise technique are also presented. Performance of the waterbrake dynamometer is discussed in an appendix.

McArdle, Jack G.↗
NASA NTRS1975

Shake test of rotor test apparatus with balance dampers in the 40 by 80 foot wind tunnel

A shake test was conducted to determine the dynamic characteristics of a rotor test apparatus on two strut systems with balance dampers in the Ames 40- by 80-ft wind tunnel. The rotor-off hub transfer function (acceleration per unit force as a function of frequency) was measured in the longitudinal and lateral directions, using a combination of broadband and discrete frequency excitation techniques. The dynamic data are summarized for the configurations tested, giving the following properties for each mode identified: the natural frequency, the hub response at resonance, the fixed system damping, the damping ratio, and the modal mass. The complete transfer functions are presented, and the detailed test results are included as an appendix.

Johnson, W.↗
NASA NTRS1979

Space vehicle meteoroid shielding design

Design principles of spaced, multiwall meteoroid protection are investigated in the light of experimental data generated during the Apollo Program. The outer wall or shield is shown to be the most important element in the meteoroid-spacecraft interaction. The condition of the debris is primarily a function of the shock pressure, the melting points of the meteoroid and the shield, and the length of the meteoroid and thickness of the shield. Spacing between the walls is effective up to approximately 100 times the length of the meteoroid. The required thickness of the second wall is shown to be proportional to the meteoroid mass, velocity, and density, and to the spacing between the walls, taken with exponents dependent upon the condition of the debris. The effects of placing additional elements (insulation or honeycomb cells) between the two walls are discussed, and the efficiency of various protective configurations is presented. An analysis of the meteoroid protection proposed for the Comet Halley probe is included as an appendix.

Cour-Palais, B. G.↗
NASA NTRS1984

GASP cloud- and particle-encounter statistics and their application to LFC aircraft studies. Volume 2: Appendixes

Summary studies are presented for the entire cloud observation archive from the NASA Global Atmospheric Sampling Program (GASP). Studies are also presented for GASP particle-concentration data gathered concurrently with the cloud observations. Cloud encounters are shown on about 15 percent of the data samples overall, but the probability of cloud encounter is shown to vary significantly with altitude, latitude, and distance from the tropopause. Several meteorological circulation features are apparent in the latitudinal distribution of cloud cover, and the cloud-encounter statistics are shown to be consistent with the classical mid-latitude cyclone model. Observations of clouds spaced more closely than 90 minutes are shown to be statistically dependent. The statistics for cloud and particle encounter are utilized to estimate the frequency of cloud encounter on long-range airline routes, and to assess the probability and extent of laminaar flow loss due to cloud or particle encounter by aircraft utilizing laminar flow control (LFC). It is shown that the probability of extended cloud encounter is too low, of itself, to make LFC impractical. This report is presented in two volumes. Volume I contains the narrative, analysis, and conclusions. Volume II contains five supporting appendixes.

Jasperson, W. H.↗
NASA NTRS1984

SAS 3 survey of the soft X-ray background

The results of a survey of the soft X-ray sky in the C band (0.10-0.28keV) are reported. The observations were carried out using two independent flow proportional counters on board the SAS 3 X-ray satellite which had a total angular resolution of 2.9 deg FWHM, and a total exposure of 2.2 x 10 to the 4th per sq cm s sr. It is found that C band counting rates were generally inversely correlated with the column density of the neutral hydrogen on all angular scales down to the lowest angular resolution of the detectors. In the region 90-180 deg l and 0-10 deg b, the relation between C-band rates and the column densities of neutral hydrogen was fitted with a residual rms deviation of less than 13 percent by a two-component numerical model of the X-ray background. For the apparent attenuation column density a value of 2.7 x 10 to the 20th per sq cm was obtained. On the basis of a computer simulation of the SAS 3 data, it is shown that the observed clumping of interstellar matter was consistent with the magnitude of spatial fluctuations in the C-band map. When the background rates were subtracted from the survey map, the subsequent map showed foreground emission and absorption features with improved sensitivity and clarity. A series of computer-generated maps incorporating the SAS 3 data is given in an appendix.

Marshall, F. J.↗
NASA NTRS1995

Replicator for characterization of cirrus and polar stratospheric cloud particles

A formvar replicator for installation in an aircraft pod has been designed, built, and flight tested on the NASA DC-8. The system incorporates a deicing capability (which can be pressure activated) to enable climb out through icing situations prior to deployment. The system can be operated at preselected speeds such that data can be recorded over a period of one to ten hours on 200 ft of 16mm film. A x2 speed control can be used during flight. Capability exists for detection of chemical constituents by appropriate doping of the formvar solution. An article entitled 'Measurements of ice particles in tropical cirrus anvils: importance in radiation balance' is attached as appendix A.

Hallett, John↗