SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Prototype gauge has been constructed of heavy clear plastic with engraved degree lines, numerals, and alignment lines. With suitable modification, gauge can be mass produced. It could be marketed directly to users or to manufacturers of circular multipin connectors.
Dichroic plate has orthogonally-disposed, loaded dipole apertures with their orientations arranged so as to cancel cross-coupling effects which would otherwise result in power loss to circularly polarized signal.
Acoustic radiation patterns are measured over a 320 deg arc for a point source in a finite length, hard walled, unflanged circular duct. The measured results are compared with computed results which are based on the Wiener-Hopf solution for radiation from a semi-infinite unflanged duct. Measurements and computations are presented for frequencies slightly below and slightly above each of the first four higher order radial mode cutoff frequencies. It is found that the computed and measured patterns show better agreement below the mode cut-off frequencies than above and that the agreement is better at lower frequencies that at higher frequencies. The computed radiation patterns do not show fine lobes which are caused by diffraction from the back end of the duct.
Drag measurements were obtained with circular cylinders attached to a flat-plate surface with their longitudinal axes perpendicular to the plate surface. When more than one cylinder was tested, they were alined in a spanwise row perpendicular to the free-stream velocity vector. The drag measurements were obtained through a range of Mach numbers from 2.3 to 4.6, cylinder heights ranging from approximately 0.4 to 3 times the undisturbed laminar boundary-layer thickness, and cylinder height-to-diameter ratios of 1.0 and approximately 2. Included in the paper is a complete presentation in figure form of the experimental results and a discussion of the more significant findings. An attempt is made to select the most appropriate parameters for correlating the experimental results and, where possible, these results are compared with theoretical calculations.
The theory, computer program, and numerical results of an investigation of an axial slot antenna on a circular cylinder are discussed. The cylinder is partially coated with a dielectric layer and the antenna radiates through a flush mounted window. The study was conducted to determine the effects of a high temperature dielectric layer on the performance of antennas mounted on a space shuttle. Mathematical models are developed to show the relationships of the parameters. Curves are developed to compare the theoretical and actual far field radiation patterns.
A circular-arc - conic boattail nozzle, typical of those used on a twin engine fighter, was tested on an underwing nacelle mounted on an F-106B aircraft. The boattail had a radius ratio r/r sub c of 0.41 and a terminal boattail angle of approximately 19 deg. The gas generator was a J85-GE-13 turbojet engine. The effects of Reynolds number and angle of attack on boattail pressure drag and boattail pressure profiles were investigated. Increasing Reynolds number resulted in reduced boattail drag at both Mach numbers of 0.6 and 0.9.
The stability of axially compressed cylinders with circular cutouts is analyzed numerically. An extension of the finite-difference method is used which removes the requirement that displacement components be defined in the directions of the grid lines. The results of this nonlinear analysis are found to be in good agreement with earlier experimental results.
Experimental data are analyzed to support theoretical predictions for discharge coefficients in circular-arc venturi flow meters operating in the critical sonic flow regime at throat Reynolds numbers above 150 thousand. The data tend to verify the predicted 0.25% decrease in the discharge coefficient during transition from a laminar to turbulent boundary layer. Four different test gases and three flow measurement facilities were used in the experiments with 17 venturis with throat sizes from 0.15 to 1.37 in. and Beta ratios ranging from 0.014 to 0.25. Recommendations are given as to how the effectiveness of future studies in the field could be improved.
Morse's equation for the radiation impedance of a vibrating rigid piston is extended to give the generalized radiation impedances of all modes in circular and annular ducts which have arbitrary wall admittance and which terminate in an infinite baffle. The extended equation is reduced to a single infinite integral which is a function of the mode radiation directivity factors. An infinite matrix equation is derived which relates the generalized mode reflection coefficients to the radiation impedances. Results are presented which show that the duct-wall admittance is a significant parameter in the effect of duct-determination reflections and that mode-coupling reflection effects may be more important than direct-mode reflection effects.
A search in many small regions of the Crab Nebula has resulted in the detection of a small component of circular polarization. The variation of the sign and magnitude with position in the Nebula indicates that the polarization is of interstellar origin. On the basis of the polarity, strength, and color dependence, it is concluded that the composition of the aligned grains causing this polarization is dielectric. Metallic particles are clearly ruled out.
Equations are presented for the calculation of the interelement mutual coupling in a finite-size planar array of waveguide-fed apertures in an infinite flat conductor. The general mutual admittance expression is evaluated for circular apertures, and the mutual coupling calculations are verified experimentally for two Te-(11) mode excited apertures. Qualitative agreement between calculations for a 183-element array and an infinite array establishes the validity of the finite-array theoretical model.
Equations are presented for the calculation of the interelement mutual coupling in a finite size planar array of wave-guide-fed apertures in an infinite flat conductor. The general mutual admittance expression is evaluated for circular apertures and the mutual coupling calculations are verified experimentally for two TE11 mode excited apertures. Qualitative agreement between calculations for a 183 element array and an infinite array establishes the validity of the finite array theoretical model.
An analysis is presented of the nonlinear effects of the gas motion as well as of the acoustic lining material on the transmission and attenuation of sound in a circular duct with a uniform cross-section and no mean flow. The acoustic material is characterized by an empirical, nonlinear impedance in which the instantaneous resistance is a nonlinear function of both the frequency and the acoustic velocity. The results show that there exist frequency bandwidths around the resonant frequencies in which the nonlinearity decreases the attenuation rate, and outside which the nonlinearity increases the attenuation rate, in qualitative agreement with experimental observations. Moreover, the effect of the gas nonlinearity increases with increasing sound frequency, whereas the effect of the material nonlinearity decreases with increasing sound frequency.
Log-helix conical antennas were examined as a way to satisfy the requirement for circular polarization of antennas for spacecraft use. It was concluded that a multiple-helix antenna which allows the helix lead angle to be changed can be used when the radiation and directivity in the direction of the reception point must be changed during flight.
Drag measurements were obtained for circular cylinders attached perpendicularly to a flat-plate surface. Measurements were obtained for a single cylinder and for rows of cylinders. The cylinders were alined at various sweep angles relative to the free-stream velocity vector and at spacings appropriate for roughness elements used as boundary layer trips. The drag measurements were obtained for Mach numbers of 3.95 and 4.60, ratios of cylinder height to an undisturbed laminar boundary layer displacement thickness of approximately 1.0 to 3.0, a cylinder height-to-diameter ratio of approximately 2, and sweep angles up to 60. A complete presentation of the experimental results is given. A discussion of the more significant findings, including the most appropriate parameters for correlating the experimental results, is presented.
The effect on stresses in a cylindrical shell with a circular penetration subject to internal pressure was investigated in thin, shallow linearly, elastic cylindrical shells. Results provide numerical predictions of peak stress concentration factors around nonreinforced and reinforced penetrations in pressurized cylindrical shells. Analytical results were correlated with published formulas, as well as theoretical and experimental results. An accuracy study was made of the finite element program for each of the configurations considered important in pressure vessel technology. A formula is developed to predict the peak stress concentration factor for analysis and/or design in conjunction with the ASME Boiler and Pressure Vessel Code.
A numerical method is developed to calculate the temperature distribution and radiation heat transfer for an annular fin and tube radiator, with fins having trapezoidal profiles. All surfaces are assumed gray and to emit and reflect diffusely. Radiative interactions between adjacent fins and between the fins and tube are included. The thermal conductivity of the fin material may vary linearly with temperature. Results of a parametric study of the special case of circular fins of triangular profile having constant thermal conductivity are presented and used to optimize a fin array with respect to minimum weight.
The two-dimensional steady flow of an incompressible viscous fluid past a circular cylinder, placed symmetrically in a simple shear field, has been studied for both the stationary and the freely rotating case by solving numerically the Navier-Stokes equations for values of the Reynolds number R in the range from 0.047 to 70. At R = 0.047, the results obtained are in substantial agreement with the analytic small-R perturbation solution given by Robertson and Acrivos (1970). Inertia effects were found, however, to play a significant role even at R = 1, and hence the calculated flow pattern for R greater than or equal to 1 differs significantly from that of the creeping-flow solution. Specifically, for the freely rotating case, the region of closed streamlines decreases rapidly in extent with increasing R, two symmetrically placed wakes are formed on either side of the cylinder, and the dimensionless rotational speed of the freely suspended cylinder decreases as the reciprocal of the square root of R.