Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “analytical methods”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29
All sourcesNASA NTRSDOE OSTI
NASA NTRS1971

Analytical prediction of the heat transfer from a blood vessel near the skin surface when cooled by a symmetrical cooling strip

An analytical method was developed to estimate the amount of heat extracted from an artery running close to the skin surface which is cooled in a symmetrical fashion by a cooling strip. The results indicate that the optimum width of a cooling strip is approximately three times the depth to the centerline of the artery. The heat extracted from an artery with such a strip is about 0.9 w/m-C which is too small to affect significantly the temperature of the blood flow through a main blood vessel, such as the carotid artery. The method is applicable to veins as well.

Chato, J. C.↗
NASA NTRS1972

Coolant pressure and airflow distribution in a strut-supported transpiration-cooled vane for a gas turbine engine

An analysis to predict pressure and flow distribution in a strut-supported wire-cloth vane was developed. Results were compared with experimental data obtained from room-temperature airflow tests conducted over a range of vane inlet airflow rates from 10.7 to 40.4 g/sec (0.0235 to 0.0890 lb/sec). The analytical method yielded reasonably accurate predictions of vane coolant flow rate and pressure distribution.

Kaufman, A.↗
NASA NTRS1972

Analytical and experimental investigation of circulation control by means of a turbulent Coanda jet

An analytical and experimental investigation of circulation control on a circular cylinder by means of tangential blowing (Coanda effect) is presented. The analytical method developed has also been used to estimate the blowing coefficients required for achieving potential flow on airfoils with flaps. The analysis is presented for conditions for which the flow in the boundary layer ahead of the jet exit is turbulent. The turbulent boundary layer and the jet layer on the upper surface, and the turbulent boundary layer on the lower surface are computed by a multi-strip integral method. The region of integration is between the correponding transition and separation points on each surface. Longitudinal curvature effects, which give rise to a radial pressure gradient across the jet layer and to an additional adverse tangential pressure gradient just upstream of the separation point, are included in the jet layer analysis in an approximate manner. The longitudinal curvature effect is found to have a pronounced influence on the separation of the jet layer.

Levinsky, E. S.↗
NASA NTRS1972

The application of elastohydrodynamic lubrication in gear tooth contacts

An analytical method is presented for determining elastohydrodynamic film thickness in gears from theory and how the film affects gear failure and life. The practical aspects of gear lubrication are presented, including mechanical and service variables which must be considered to obtain optimum gear performance under severe operating conditions.

Townsend, D. P.↗
NASA NTRS1971

Theory of spiral structure.

The question whether the galactic spiral arms are material objects or wave patterns is discussed. A semiempirical approach is adopted in presenting the concept of density waves. The theory of density waves is considered, giving attention to a survey of theoretical developments by analytical methods, the implication of a spiral pattern of density waves, spirals with moderately small pitch angle, and the origin and permanence of galactic spirals. The theoretical aspects discussed are tested against more detailed observations in the Milky Way system. It is pointed out that the density wave concept introduced by Lindblad, including the material concentration of both gas and stars, is the essential basis for the spiral structure of disk-shaped galaxies.

Lin, C. C.↗
NASA NTRS1972

Thermal/structural optimization of cryogenic storage systems.

An analytical method has been developed to optimize a cryogenic storage system designed for long term storage of cryogenic propellants. The type of propellant, mission duration, thermal environment, insulation thermal properties, insulation vent time, and the storage system weight penalty imposed by the design pressure were considered as the dependent parameters. The optimum system insulation thickness and vent pressure were then calculated in terms of these parameters. The method was applied to the design of the Space Shuttle Orbiter oxygen and hydrogen tanks to obtain an optimum design. It was determined that for the mission examined, the hydrogen tank optimum design was close to the initial pressure. A continuously vented hydrogen tank, therefore, was close to the optimum design. Also, it was determined that for this particular mission the oxygen tank should not be vented.

Navickas, J.↗
NASA NTRS1972

Calculation of aerodynamic characteristics of STOL aircraft with externally-blown jet-augmented flaps.

Analytical methods to predict the interference between lifting surfaces and high-bypass-ratio turbofan engines are described. A three-dimensional nonplanar vortex-lattice lifting surface method is used to predict the characteristics of a wing with leading-edge slat and multiple slotted trailing-edge flaps including effects of externally induced velocity fields. A flow model of the wake of a high-bypass-ratio turbofan is described which is capable of predicting the induced velocity field both inside and outside the jet wake. These methods are combined to predict the longitudinal characteristics of several STOL transport models utilizing externally-blown flaps and comparisons with data are shown. The results indicate good agreement between experiment and theory for various configurations under a wide range of power conditions.

Mendenhall, M. R.↗
NASA NTRS1972

Hailstone impact simulator.

The hailstone impact simulator was constructed to provide experimental data in support of a program to develop the analytical methods for predicting hail damage to aircraft structures. This paper describes the simulator, its operation, the type of data obtained, and the resulting damage by individual hailstones to metallic flat sheets and spherical caps. Simulated hailstones of 1.3, 2.5, 3.8, and 5.1 cm in diameter were used at impact velocities of 60 to 600 m/s.

Alfaro-Bou, E.↗
NASA NTRS1972

Performance estimates for a supersonic axisymmetric inlet system.

Results of recent tests of a large-scale axisymmetric mixed-compression inlet system designed for Mach number 2.65 indicate that the performance of the supersonic diffuser and required boundary-layer bleed system can be accurately estimated with relatively new analytic methods. Thus, many wind tunnel testing hours can be saved by avoiding much of the usual ?cut and try' wind tunnel development.

Sorensen, N. E.↗
NASA NTRS1972

Effects of interplanetary magnetic field on the propagation of flare-generated interplanetary shock waves.

The effects of an interplanetary magnetic field on the propagation of flare-generated interplanetary shock waves are investigated with an approximate analytical method. It is found that the interplanetary magnetic field is relatively unimportant for strong shocks as far as the shock speed and transit time are concerned. It has more significant effects for weak shocks. However, in all the situations examined, the error committed if the magnetic field is neglected is no more than 10%. It is suggested that a model without a magnetic field gives sufficiently accurate numerical results for the propagation of flare-generated shocks.

Tam, C. K. W.↗
NASA NTRS1972

Quantifying parameters influencing the spacing of geostationary satellites.

Parameters affecting satellite spacing must be investigated to fully exploit the limited capacity of the geostationary orbit. The usefulness of laboratory experiments, analytic methods, and space environment experiments in quantifying these factors is discussed. It is concluded that space environment experiments are required to evaluate the effects of operationally related parameters including antenna gain patterns, polarization, and antenna instabilities. A unique method of measuring the time-variant effects of the earth station antenna characteristics on satellite spacing is described as a possible space environment experiment. The proposed experiment uses a single satellite to obtain the required data.

Henry, V. F.↗
NASA NTRS1972

Analytic prediction of dynamic stall characteristics.

A new approach is presented for solving the problem of predicting dynamic stall characteristics. In this approach, the unsteady aerodynamic characteristics are related theoretically to static aerodynamic characteristics which are readily available for a great number of airfoil shapes. Using these static experimental data as an input, the developed analytical method predicts dynamic stall characteristics that are in good agreement with available experimental data. The analysis is also extended to include frequency and amplitude modulation effects.

Ericsson, L. E.↗
NASA NTRS1971

Study of a remote probing technique for inhomogeneous media.

Study of remote probing of inhomogeneous media making use of the known reflection coefficient of the medium as a function of the varied incident angle of the probing plane wave. An analytical method is developed for processing these reflection coefficient data. A critical evaluation of the numerical aspects of the method is presented.

Mittra, R.↗
NASA NTRS1962

Comparison of the Effectiveness of Flares With That of Fins for Stabilizing Low Fineness Ratio Bodies at Mach Numbers From 0.6 to 5.8

An experimental and analytical investigation has been made of the effectiveness of flares and of fins for providing aerodynamic stability of low-fineness-ratio bodies near zero angle of attack. Wind-tunnel tests were performed at Mach numbers from 0.6 to 3.8 to measure the normal force, center of pressure, and drag of bodies consisting of conical noses in combination with cylindrical midsections and finned or flared aftersections. This study included an investigation of the effects of nose bluntness, midbody length, flare angle (from 0° to 20°), and fin leading-edge bluntness. The results showed that for the same plan-form area, flares were more effective than fins, but for the same drag, fins were more effective than flares. Flow separation, which occurred ahead of a flare at certain Mach numbers, resulted in an increase in the stabilizing effectiveness of the flare and a decrease in the drag. However, flow separation led to large undesirable shifts in the center of pressure. Blunt fins were found to be more effective than sharp fins, with the vertical as well as the horizontal fins contributing to the effectiveness. Comparisons of the analytical with the experimental results indicated that the analytical method employed gave good estimates of the stabilizing effectiveness of both fins and flares throughout the supersonic Mach number range.

Leland H Jorgensen↗
NASA NTRS1972

Analytical study of striated nozzle flow with small radius of curvature ratio throats

An analytical method was developed which is capable of estimating the chamber and throat conditions in a nozzle with a low radius of curvature throat. The method was programmed using standard FORTRAN 4 language and includes chemical equilibrium calculation subprograms (modified NASA Lewis program CEC71) as an integral part. The method determines detailed and gross rocket characteristics in the presence of striated flows and gives detailed results for the motor chamber and throat plane with as many as 20 discrete zones. The method employs a simultaneous solution of the mass, momentum, and energy equations and allows propellant types, 0/F ratios, propellant distribution, nozzle geometry, and injection schemes to be varied so to predict spatial velocity, density, pressure, and other thermodynamic variable distributions in the chamber as well as the throat. Results for small radius of curvature have shown good comparison to experimental results. Both gaseous and liquid injection may be considered with frozen or equilibrium flow calculations.

Norton, D. J.↗
NASA NTRS1972

Analytical and experimental study of axisymmetric truncated plug nozzle flow fields

Experimental and analytical investigation of the flow field and base pressure of internal-external-expansion truncated plug nozzles are discussed. Experimental results for two axisymmetric, conical plug-cylindrical shroud, truncated plug nozzles are presented for both open and closed wake operations. These results include extensive optical and pressure data covering nozzle flow field and base pressure characteristics, diffuser effects, lip shock strength, Mach disc behaviour, and the recompression and reverse flow regions. Transonic experiments for a special planar transonic section are presented. An extension of the analytical method of Hall and Mueller to include the internal shock wave from the shroud exit is presented for closed wake operation. Results of this analysis include effects on the flow field and base pressure of ambient pressure ratio, nozzle geometry, and the ratio of specific heats. Static thrust is presented as a function of ambient pressure ratio and nozzle geometry. A new transonic solution method is also presented.

Muller, T. J.↗
NASA NTRS1972

Development report, mass flow controller PN 5716068

The design, development, and manufacture of an all mechanical mass flow controller are discussed. A test program was conducted using inert gas as the test medium. The unit controlled the pressure within plus of minus one percent. An analytical method is presented for relating the control pressure error with error in mass flow.

Taylor, W.↗