Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “PASSENGER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Neutral buoyancy testing of a shuttle orbiter crew compartment

The architectural and man-machine aspects of a shuttle orbiter crew compartment were examined. All phases of the Orbiter's flight mode from launch through zero gravity, reentry, and ferry flight are considered. The data provides an initial design criteria that treats the crew compartment as a total system and provides data that has a direct contribution to the development of flight hardware. Primary interest was centered on the design of the galley, hygiene facility, passenger couches, airlock, work station, and flight deck access. The man-machine interface emphasis was placed on identifying and developing solutions for problems in mobility/restraint, ingress/egress, accessibility, and volume utilization.

Rosener, A. A.↗
NASA NTRS1973

STOL ride control feasibility study

The feasibility of developing a ride-smoothing control system for a 20-passenger turboprop STOL transport was assessed. Five different ride-control system configurations with varying degrees of complexity, performance, and cost were investigated. Results indicate that a satisfactory ride-control system can be practically implemented on the aircraft with minimum flight performance degradation.

Gordon, C. K.↗
NASA NTRS1972

Design integration and noise studies for jet STOL aircraft. Task 7A: Augmentor wing cruise blowing valveless system. Volume 2: Design exploration

A design integration study program was conducted to determine size and performance parameters of an augmentor wing cruise blowing (valveless) system in a 150-passenger STOL airplane for the purpose of defining size and configuration of static rig, flow duct, and wind tunnel test hardware. The studies encompassed blowing systems powered by low-pressure (single stage) and high-pressure (three and four stage) engine fans. A range of wing aspect ratios, wing thicknesses, and duct flow velocity effects were investigated to establish airplane characteristics which minimize takeoff gross weight while achieving sideline noise requirements for an advanced commercial STOL airplane.

Source record↗
NASA NTRS1973

The effect of noise constraints on engine cycle optimization for long-haul transports

Results are presented of NASA studies to determine optimum engine cycles for noise levels of 10, 15, and 20 EPNdb below current FAA regulations. The study aircraft were 200-passenger trijets flying over ranges of 5,556 and 10,200 km at cruise speeds of Mach 0.90 to 0.98. The economic impact of reducing noise, the identification of needed advanced technology and the effect of these advances are presented. The studies showed that the noise constraints imposed compromises on the optimum cycle with resulting economic penalties. The application of advanced engine technologies, however, could effectively offset these economic penalties.

Antl, R. J.↗
NASA NTRS1972

American Airlines Propeller STOL Transport Economic Risk Analysis

A Monte Carlo risk analysis on the economics of STOL transports in air passenger traffic established the probability of making the expected internal rate of financial return, or better, in a hypothetical regular Washington/New York intercity operation.

Ransone, B.↗
NASA NTRS1972

Air Cargo Marketing Development

The factors involved in developing a market for air cargo services are discussed. A comparison is made between the passenger traffic problems and those of cargo traffic. Emphasis is placed on distribution analyses which isolates total distribution cost, including logistical costs such as transportation, inventory, materials handling, packaging, and processing. Specific examples of methods for reducing air cargo costs are presented.

Kersey, J. W.↗
NASA NTRS1972

A Critique of Cab Regulatory Policy

The regulatory policies of the Civil Aviation Board are discussed. The objectives of the Civil Aviation Board are defined. Specific actions of the Civil Aviation Board with respect to passenger fares, rate levels, and load factors are presented. The decisions on successful and unsuccessful mergers of airlines during the 1938 to 1972 time period are analyzed. Tables of data are presented to show the economic aspects of airline operations during 1955, 1960, and 1970.

management methods↗
NASA NTRS1972

Economic and environmental aspects of STOL transportation

A system study to analyze the question of the impact of advanced STOL aircraft in meeting the needs of short-haul air transportation systems is discussed. The study is concerned with the following aspects: (1) service to the passenger, (2) economic viability, and (3) economic criteria to include community noise, ground and air decongestion, and air pollution. The STOL aircraft parameters are defined. Preliminary conclusions concerning the feasibility of short-haul air transportation are presented.

Stewart, E. C.↗
NASA NTRS1973

Research on future short-haul aircraft at the NASA Langley Research Center.

Some of the current research for improving our short-haul air-transportation system is reviewed. Promising aircraft range from helicopters, turbofan-powered STOL, through mechanical flap reduced take-off and landing (RTOL) concepts. Advanced rotorcraft technology can provide improved passenger, community, operational, and economic acceptability of civil transport helicopters. From wind-tunnel and design studies, techniques are available for achieving low-noise fixed-wing STOL and RTOL through proper engine and airframe design. Agreeable ride qualities, crosswind landing capability, and all-weather terminal operation are also goals of present effort.

Riebe, J. M.↗
NASA NTRS1973

Follow-on programs.

Discussion of space activities planned for the 1980's and resulting from the use of the Space Shuttle in providing easy access to orbits around the earth. Illustrations and brief explanatory notes describe the uses of the Space Shuttle in supporting space lab operations; retrieval and delivery of propulsion stages; placement, repair, and service of satellites; transportation of passengers and crews; execution of short-duration orbital missions; and rescue of endangered personnel.

Culbertson, P. E.↗
NASA NTRS1973

STOL ride control feasibility study.

A study to determine the feasibility of developing a ride smoothing control system for a passenger STOL aircraft has been performed for NASA. The de Havilland DHC-6 Twin Otter was selected for the feasibility study, since it is the only STOL aircraft presently certificated and in use by a number of United States air carriers. The study indicated that a ride control system that significantly reduces vertical and lateral accelerations can be practically implemented on the Twin Otter with minimum airplane performance degradation. The system uses symmetrical ailerons, elevator, rudder and spoiler control surfaces, with accelerometers and rate gyros as motion sensors.

Thompson, G. O.↗
NASA NTRS1973

The Influence of Wing Loading on Turbofan Powered STOL Transports with and Without Externally Blown Flaps

The effects of wing loading on the design of short takeoff and landing (STOL) transports using (1) mechanical flap systems, and (2) externally blown flap systems are determined. Aircraft incorporating each high-lift method are sized for field lengths of 2,000 feet, 2,500 feet, and 3,500 feet, and for payloads of 40, 150, and 300 passengers, for a total of 18 point-design aircraft. An assumed 1975 level of technology is applied to both concepts in terms of propulsion, weights, active controls, supercritical wing methodology, and acoustics. Low-wing-loading STOL configurations with mechanical flaps are found to be competitive with externally blown flap STOL configurations over wide ranges of payload and field length for the airworthiness rules and technology improvements assumed. Because the results of design studies like this one are sensitive to the ground rules assumed, careful attention is paid to describing the assumptions. These assumptions must be understood before the results are compared with other STOL airplane studies.

Morris, R. L.↗
NASA NTRS1974

Applicability of NASA (ARC) two-segment approach procedures to Boeing Aircraft

An engineering study to determine the feasibility of applying the NASA (ARC) two-segment approach procedures and avionics to the Boeing fleet of commercial jet transports is presented. This feasibility study is concerned with the speed/path control and systems compability aspects of the procedures. Path performance data are provided for representative Boeing 707/727/737/747 passenger models. Thrust margin requirements for speed/path control are analyzed for still air and shearing tailwind conditions. Certification of the two-segment equipment and possible effects on existing airplane certification are discussed. Operational restrictions on use of the procedures with current autothrottles and in icing or reported tailwind conditions are recommended. Using the NASA/UAL 727 procedures as a baseline, maximum upper glide slopes for representative 707/727/737/747 models are defined as a starting point for further study and/or flight evaluation programs.

Allison, R. L.↗
NASA NTRS1973

Design integration and noise studies for jet STOL aircraft. Task 7A: Augmentor wing cruise blowing valveless system. Volume 1: System design and test integration

Exploratory design studies conducted to establish the configuration of an augmentor wing vruise blowing (valveless) system in a 150-passenger STOL airplane were reported in NASA CR-114570. Those studies have been updated to incorporate the results of static rig, flow duct, and wind tunnel tests. Minor adjustments in duct flow velocity, flap length, and blowing nozzle geometry were incorporated to provide airplane characteristics that minimize takeoff gross weight and achieve sideline noise objectives for an advanced commercial STOL airplane.

Roepcke, F. A.↗
NASA NTRS1973

Design integration and noise studies for jet STOL aircraft. Task 7C: Augmentor wing cruise blowing valveless system. Volume 1: Static testing of augmentor noise and performance

Static performance and acoustic tests were conducted on a two-dimensional one-third-scale augmentor flap model that simulated a cruise blowing augmentor system designed for a scale augmentor flap model that simulated a cruise blowing augmentor, which offers a degree of 150-passenger STOL airplane. The cruise blowing augmentor, which offers a degree of simplicity by requiring no fan air diverter valves, was simulated by fitting existing lobe suppressor nozzles with new nozzle fairings. Flow turning performance of the cruise blowing augmentor was measured through a large range of flap deflection angles. The noise suppression characteristics of a multilayer acoustic lining installed in the augmentor were also measured.

Campbell, J. M.↗
NASA NTRS1974

Civil helicopter noise assessment study Boeing-Vertol model 347

A study was conducted to forecast the noise restrictions which may be imposed on civil transport helicopters in the 1975-1985 time period. Certification and community acceptance criteria were predicted. A 50 passenger tandem rotor helicopter based on the Boeing-Vertol Model 347 was studied to determine the noise reductions required, and the means of achieving them. Some of the important study recommendations are: (1) certification limits should be equivalent to 95 EPNdb at data points located at 500 feet to each side of the touchdown/takeoff point, and 1000 feet from this point directly under the approach and departure flight path. (2) community acceptance should be measured as Equivalent Noise Level (Leq), based on dBA, with separate limits for day and night operations, and (3) in order to comply with the above guidelines, the Model 347 helicopter will require studies and tests leading to several modifications.

Hinterkeuser, E. G.↗
NASA NTRS1974

Airline return-on-investment model for technology evaluation

This report presents the derivation, description, and operating instructions for a computer program (TEKVAL) which measures the economic value of advanced technology features applied to long range commercial passenger aircraft. The program consists of three modules; and airplane sizing routine, a direct operating cost routine, and an airline return-on-investment routine. These modules are linked such that they may be operated sequentially or individually, with one routine generating the input for the next or with the option of externally specifying the input for either of the economic routines. A very simple airplane sizing technique was previously developed, based on the Brequet range equation. For this program, that sizing technique has been greatly expanded and combined with the formerly separate DOC and ROI programs to produce TEKVAL.

Source record↗
NASA NTRS1973

Investigation of the reactions of skin panels in relation to duration of acoustical loading

Certain characteristics of the reactions of typical skin panels of a passenger aircraft to acoustical loading are being investigated, for development of an objective method of diagnostics for skin condition, under the operations and maintenance sections of civil aviation. There are a number of difficulties connected with the solution of this problem. The reactions of skin panels exposed to the noises of the exhaust jets are dependent on the aircraft operating conditions, the geometric parameters and limiting conditions of the panels.

Kvitka, V. Y.↗