Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Balloons”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 523 records · Page 29

Model reference adaptive control for the azimuth-pointing system of a balloon-borne stabilized platform

A balloon-born stabilized platform has been developed for the remotely operated altitude-azimuth pointing of a millimeter wave telescope system. This paper presents a development and implementation of model reference adaptive control (MRAC) for the azimuth-pointing system of the stabilized platform. The primary goal of the controller is to achieve pointing rms better than 0.1 deg. Simulation results indicate that MRAC can achieve pointing rms better than 0.1 deg. Ground test results show pointing rms better than 0.03 deg. Data from the first flight at the National Scientific Balloon Facility (NSBF) Palestine, Texas show pointing rms better than 0.02 deg.

Lubin, Philip M.↗

Balloon-Borne System Would Aim Instrument Toward Sun

Proposed system including digital control computer, control sensors, and control actuators aims telescope or other balloon-borne instrument toward Sun. Pointing system and instrument flown on gondola, suspended from balloon. System includes reaction wheel, which applies azimuthal control torques to gondola, and torque motor to apply low-frequency azimuthal torques between gondola and cable. Three single-axis rate gyroscopes measure yaw, pitch, and roll. Inclinometer measures roll angle. Two-axis Sun sensor measures deviation, in yaw and pitch, of attitude of instrument from line to apparent center of Sun. System provides initial coarse pointing, then maintains fine pointing.

Polites, M. E.↗

Stratospheric constituent distributions from balloon-based limb thermal emission measurements

This research task deals with an analysis of infrared thermal emission observations of the Earth's atmosphere for determination of trace constituent distributions. Infrared limb thermal emission spectra in the 700-2000 cm(exp -1) region were obtained with a liquid nitrogen cooled Michelson interferometer-spectrometer (SIRIS) on a balloon flight launched from Palestine, Texas, at nighttime on September 15-16, 1986. An important objective of this work is to obtain simultaneously measured vertical mixing ratio profiles of O3, H2O, N2O, NO2, N2O5, HNO3 and ClONO2 and compare with measurements made with a variety of techniques by other groups as well as with photochemical model calculations. A portion of the observed spectra obtained by SIRIS from the balloon flight on September 15-16, 1986, has been analyzed with a focus on calculation of the total nighttime odd nitrogen budget from the simultaneously measured profiles of important members of the NO(sub x) family. The measurements permit first direct determination of the nighttime total odd nitrogen concentrations NO(sub y) and the partitioning of the important elements of the NO(sub x) family.

Abbas, Mian M.↗

Piloted simulation study of a balloon-assisted deployment of an aircraft at high altitude

A piloted simulation was used to study the feasibility of a balloon assisted deployment of a research aircraft at high altitude. In the simulation study, an unmanned, modified sailplane was carried to 110,000 ft with a high altitude balloon and released in a nose down attitude. A remote pilot controlled the aircraft through a pullout and then executed a zoom climb to a trimmed, 1 g flight condition. A small parachute was used to limit the Mach number during the pullout to avoid adverse transonic effects. The use of small rocket motor was studied for increasing the maximum attainable altitude. Aerodynamic modifications to the basic sailplane included applying supercritical airfoil gloves over the existing wing and tail surfaces. The aerodynamic model of the simulated aircraft was based on low Reynolds number wind tunnel tests and computational techniques, and included large Mach number and Reynolds number effects at high altitude. Parametric variations were performed to study the effects of launch altitude, gross weight, Mach number limit, and parachute size on the maximum attainable stabilized altitude. A test altitude of approx. 95,000 ft was attained, and altitudes in excess of 100,000 ft was attained.

Murray, James↗

Determination of balloon drag

The evolution of an empirical drag relationship that has stimulated rethinking regarding the physics of balloon drag phenomena is discussed. Combined parasitic drag from all sources in the balloon system are estimated to constitute less than 10 percent of the total system drag. It is shown that the difference between flight-determined drag coefficients and those based on the spherical assumption should be related to the square of the Froude number.

Conrad, George R.↗

Structural behavior of scientific balloons - Finite element simulation and verification

An off-the-shelf nonlinear finite element code was used to analyze fully inflated scientific balloons. The thin balloon film was modeled by shell bending elements. Numerical difficulties caused by insignificant bending stiffness terms were overcome by introducing some artificial bending stiffness. This approximation is justified by the fact that in thin shells with nonzero Gaussian curvature the membrane solution component is essentially independent of the bending solution component. Perturbation of the coveraged solution by increasing the bending stiffness by a full decade verified this assertion. This analytical approach was experimentally verified. As a result of this verification process it was discovered that the generally accepted linearly visco-elastic model for polyethylene film is inappropriate for a significant planar (as opposed to uniaxial) stress state. A linear elastic model presents a good approximation for planar stress states.

Schur, Willi W.↗

Long-duration ballooning at mid-latitudes and in Antarctica

Since the latter 1980s, there have been only two NASA balloon program failures out of over 100 flights involving astrophysical, space physics and upper atmosphere research activities. Since the successful flight of the Gamma Ray Advanced Detector, numerous requests have been received for flights in the Antarctic region. Such long-duration flights would employ the standard zero-pressure balloon of 28 MCF two-cap type, which carries a 3000-lb nominal suspended weight to 130,000 ft. For Antarctica, the nominal science weight would be from 1500 lbs to as much as 1900 lbs, with some sacrifice in altitude.

Jones, W. V.↗

Determination of balloon gas mass and revised estimates of drag and virtual mass coefficients

In support of the NASA Balloon Program, small-scale balloons were flown with varying lifting gas and total system mass. Instrument packages were developed to measure and record acceleration and temperature data during these tests. Top fitting and instrument payload accelerations were measured from launch to steady state ascent and through ballast drop transients. The development of the small lightweight self-powered Stowaway Special instrument packages is discussed along with mathematical models developed to determine gas mass, drag and virtual mass coefficients.

Robbins, E.↗

Balloons on planet Venus - Final results

On June 11 and 15, 1985 two packages with balloons have been inserted in the atmosphere of Venus from the Soviet VEGA landing modules. This paper summarizes the pressure, temperature, wind illumination and backscattering data from the balloons.

Blamont, J.↗

Scientific ballooning payload termination loads

NASA's high altitude balloon borne scientific payloads are typically suspended from a deployed flat circular parachute. At flight termination, the recovery train is pyrotechnically separated at the parachute apex and balloon nadir interface. The release of elastic energy stored in the parachute at zero initial vertical velocity in the rarefied atmosphere produces high canopy opening forces that subject the gondola to potentially damaging shock loads. Data from terminations occurring at altitudes to 40 km with payloads up to 2500 kg on parachutes up to 40 m in diameter are presented. Measured loads are markedly larger than encountered via packed parachute deployment for similar canopy loadings. Canopy inflation is significantly suppressed in the early stages and then accelerated during final blossoming. Data interpretation and behavioral phenomena are discussed along with proposed shock attenuation techniques.

Robbins, E.↗

Balloon observations of interstellar CII (158 microns) and OI (63 microns) forbidden lines

Interstellar CII and OI forbidden lines were observed by the Balloon-Borne Infrared Telescope (BIRT) with a Fabry-Perot spectrometer. Two balloon flights were successfully made. With a method of 'frequency switching', diffuse CII forbidden-line emission was efficiently detected and mapped in extended regions around HII/molecular cloud complexes and in a wide area of the Galactic plane. It has been shown that the CII forbidden-line emission is very strong and ubiquitously distributed in interstellar space in the Galaxy.

Shibai, H.↗

Analysis of atmospheric trace constituents from high resolution infrared balloon-borne and ground-based solar absorption spectra

Results of ongoing studies of high-resolution solar absorption spectra aimed at the identification and quantification of trace constituents of importance in the chemistry of the stratosphere and upper troposphere are presented. An analysis of balloon-borne and ground-based spectra obtained at 0.0025/cm covering the 700-2200/cm interval is presented. The 0.0025/cm spectra, along with corresponding laboratory spectra, improves the spectral line parameters, and thus the accuracy of quantifying trace constituents. Results for COF2, F22, SF6, and other species are presented. The retrieval methods used for total column density and altitude distribution for both ground-based and balloon-borne spectra are also discussed.

Goldman, A.↗

Balloon-borne submillimeterwave stratospheric measurements

A new remote sensing instrument, the Submillimeterwave Limb Sounder, has been developed to simultaneously measure ClO, HCl, O3 and HO2 from high altitude balloon and aircraft platforms. The instrument is a double sideband heterodyne radiometer measuring atmospheric thermal emission spectra near 640 GHz from the Earth's limb. The instrument was flown in April and October, 1991 and in February, 1992 on high altitude balloon platforms over the southwestern United States.

Stachnik, R. A.↗

Testing balloon gas

In the generation, storage, and use of hydrogen for balloon purposes it is necessary to be able to determine, first, its lifting power, and, secondly, its purity. The lifting power may be determined directly from the specific gravity. Contamination by other gases may be determined by analysis for oxygen, carbon dioxide, etc., by the usual methods of gas analysis. The determination of oxygen is important, since the presence of oxygen in amounts beyond certain limits will make the compressing, handling, and use of the gas hazardous. If the specific gravity of the gas is known, however, it may not be necessary to analyze the gas for oxygen and other gases, because the specific gravity in itself is a delicate criterion of the purity of hydrogen. Report describes a simple, portable apparatus for testing hydrogen, with special reference to its use in balloons.

Edwards, Junius David↗

Electrodynamics of the Middle Atmosphere: Superpressure Balloon Program

This project called Electrodynamics of the Middle Atmosphere (EMA): Superpressure Balloon Program was begun by the PI at the Aerospace Corporation in Los Angeles under joint NSF and NASA funding originally combined in one grant ATM80-17071 and has continued at the University of Washington under grants ATM8212283, ATM84-11326 and ATM86-15628 and NASA grants NAGW-724 and NAGS-635. In the EMA experiment a comprehensive set of electrical parameters was measured during eight long-duration balloon flights in the Southern Hemisphere stratosphere. These flights resulted in the largest vector electric field data set ever collected from the stratosphere which has been a treasure-trove of new phenomena. Since the stratosphere has never been electrodynamically sampled in this systematic manner before, it is perhaps not surprising that several new discoveries have been made and reported. Another way to measure the success of this first EMA project is to note that all together the total data rate was about 1 bit/sec/payload amounting to 12 MBytes (1/3 of 1 standard 1600 BPI magnetic tape) which nevertheless has resulted in 14 papers and 2 masters theses (so far! . Ten of these papers and one masters thesis specifically acknowledge the support by NASA grant NAGS-635 are discussed herein.

Holzworth, Robert H.↗

Scientific Balloons

This video discusses how NASA uses large helium-filled balloons to take payloads up 25 miles to the edge of space to gather data. Balloons provide a cost effective approach to reach these heights.

Source record↗

Observation of ozone and aerosols in the Antarctic ozone hole of 1991 under the Polar Patrol Balloon (PPB) Project. Preliminary result

We present preliminary results for the PPB (Polar Patrol Balloon) experiment. The balloon was launched at 07:55 UT on 23 September and dropped at 21 UT on 28 September 1991. During the period, ozone and aerosol concentrations were measured correspondingly along the track. During the Lagrangian type observation, drastic change of ozone concentration in 'same air mass' and positive correlation between ozone concentration and sulfate aerosol amount were obtained at the level within 80-78 hPa. During the descent motion at 80 deg S active PSC's (type-1 and -2) were observed from 200 hPa to 80 hPa.

Hayashi, Masahiko↗