Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Damping”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 505 records · Page 28
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Stiffness and damping characteristics of aluminum in creep

Tensile creep tests conducted at 200 C were performed on annealed commercially pure aluminum specimens in order to measure the dominant elevated temperature dislocation processes. Testing consisted of applying small lateral loads to measure flexural stiffness, and vibrating the specimens laterally in order to measure dynamic modulus and internal damping. It was concluded that (1) the strain hardening increased static stiffness and decreased internal damping during early creep, and (2) the dynamic modulus remained essentially constant at the elastic value during creep. These results imply that primary creep may constitute a mechanism of recovery of dislocatory disorder induced by yielding the material during loading, and that the inelastic modulus utilized as a mathematical concept in several creep buckling theories is not a directly measurable material property.

Berkovits, A.↗
NASA NTRS1977

Influence of oil-squeeze-film damping on steady-state response of flexible rotor operating to supercritical speeds

Experimental data were obtained for the unbalance response of a flexible rotor to speeds above the third lateral bending critical. Squeeze-film damping coefficients calculated from measured data showed good agreement with short-journal-bearing approximations over a frequency range from 5000 to 31,000 cmp. Response of a rotor to varying amounts of unbalance was investigated. A very lightly damped rotor was compared with one where oil-squeeze dampers were applied.

Cunningham, R. E.↗
NASA NTRS1977

Development of procedures for calculating stiffness and damping properties of elastomers in engineering applications. Part 4: Testing of elastomers under a rotating load

A test rig designed to measure stiffness and damping of elastomer cartridges under a rotating load excitation is described. The test rig employs rotating unbalance in a rotor which runs to 60,000 RPM as the excitation mechanism. A variable resonant mass is supported on elastomer elements and the dynamic characteristics are determined from measurements of input and output acceleration. Five different cartridges are considered: three of these are buttons cartridges having buttons located in pairs, with 120 between each pair. Two of the cartridges consist of 360 elastomer rings with rectangular cross-sections. Dynamic stiffness and damping are measured for each cartridge and compared with predictions at different frequencies and different strains.

Darlow, M. S.↗
NASA NTRS1978

Nonlinear Landau damping in the ionosphere

A model is presented to explain the non-resonant waves which give rise to the diffuse resonance observed near 3/2 f sub H by the Alouette and ISIS topside sounders, where f sub H is the ambient electron cyclotron frequency. In a strictly linear analysis, these instability driven waves will decay due to Landau damping on a time scale much shorter than the observed time duration of the diffuse resonance. Calculations of the nonlinear wave particle coupling coefficients, however, indicate that the diffuse resonance wave can be maintained by the nonlinear Landau damping of the sounder stimulated 2f sub H wave. The time duration of the diffuse resonance is determined by the transit time of the instability generated and nonlinearly maintained diffuse resonance wave from the remote short lived hot region back to the antenna. The model is consistent with the Alouette/ISIS observations, and clearly demonstrates the existence of nonlinear wave-particle interactions in the ionosphere.

Kiwamoto, Y.↗
NASA NTRS1977

Landau damping and steepening of interplanetary nonlinear hydromagnetic waves

According to collisionless shock theories, the thickness of a shock front should be of the order of the characteristic lengths of the plasmas (the Debye length, the proton and Larmor radii, etc.). Chao and Lepping (1974), found, however, that 30% of the observed interplanetary shocks at 1 AU have thicknesses much larger than these characteristic lengths. It is the objective of the present paper to investigate whether the competition between nonlinear steepening and Landau damping can result in a wave of finite width that does not steepen into a shock. A heuristic model of such a wave is developed and tested by the examples of two structures that are qualitatively shocklike, but thicker than expected from theory. It is found that both events are in the process of steepening and their limiting thicknesses due to Landau damping are greater than the corresponding proton Larmor radius for both structures as observed at Mariner 5 (nearer the sun than 1 AU) but are comparable to the proton Larmor radius for Explorer (near 1 AU) observations.

Barnes, A.↗
NASA NTRS1977

Numerical analysis of free vibrations of damped rotating structures

This paper is concerned with the efficient numerical solution of damped and undamped free vibration problems of rotating structures. While structural discretization is achieved by the finite element method, the associated eigenproblem solution is effected by a combined Sturm sequence and inverse iteration technique that enables the computation of a few required roots only without having to compute any other. For structures of complex configurations, a modal synthesis technique is also presented, which is based on appropriate combinations of eigenproblem solution of various structural components. Such numerical procedures are general in nature, which fully exploit matrix sparsity inherent in finite element discretizations, and prove to be most efficient for the vibration analysis of any damped rotating structure, such as rotating machineries, helicopter and turbine blades, spinning space stations, among others.

Gupta, K. K.↗
NASA NTRS1978

Transfer of training on manual control systems differing in short period frequency and damping characteristics

Each of four groups of 16 subjects was trained on one of four compensatory tracking tasks that differed with regard to short period natural frequency and damping characteristics. After completion of the training sessions, the members of each group either transferred to a task on which they had not been trained or continued with their original task. Analysis of the training data indicated that relative task difficulty was largely determined by system damping which, however, had little effect on the amount of transfer during the transfer trials. The effect of system frequency was essentially reversed, and a marked interaction between training and transfer frequencies was observed in the transfer data. Similar results were obtained both with relative error scores and transinformation scores. Positive transfer was exhibited by most of the groups when they transferred to tasks on which they had not been trained.

Lincoln, R. S.↗
NASA NTRS1978

On sound transmission into a heavily-damped cylinder

A mathematical model for the transmission of sound into a thin monocoque cylindrical shell is discussed. The model is used to evaluate an oblique plane wave incident upon a flexible thin cylindrical shell. The solution is applicable to the transmission of sound under actual flight conditions. The model is then used to determine curves of cylinder-transmission loss for heavily damped cylinders. Numerical results are found for several plane-wave incidence angles for a narrow-bodied jet fuselage made of aluminum. It is noted that damping (i.e., the loss factor) increases, dips because of reduced cylinder resonances, and eventually disappears when the loss factor of the shell is large enough.

Koval, L. R.↗
NASA NTRS1979

Determination of subcritical frequency and damping from B-1 flight flutter test data

The application of the time-lag products correlation/frequency analysis procedure to determine subcritical frequency and damping from structural response measurements made during flight flutter test of the B-1 prototype airplane is described. The analysis procedure, the test airplane, and flight test procedures are discussed. Summary frequency and damping results are presented for six transonic flight conditions. Illustrative results obtained by applying various options and variations of the analysis method are included for one flight condition.

Dobbs, S. K.↗
NASA NTRS1978

The stability of an asymmetric rotor in damped supports

A general-purpose method of evaluating the stability of an asymmetric flexible rotor, mounted in symmetric damped bearings, is defined. This method evaluates the complex eigenvalues of the rotor system by solving the equations of motion in a rotating coordinate frame. The application of this method to a rotor mounted in tilting-pad bearings is demonstrated. The observed behavior of a number of different rotor configurations is compared with corresponding predictions of stability. For the configurations predicted to be unstable, a distinct and unnegotiable threshold of instability is encountered. The sharpness of this threshold is emphasized by careful balancing at speeds fractionally below the threshold. In a final configuration predicted to be marginally stable, lightly damped resonant behavior, negotiable by balancing, is encountered in the region of the first critical speed.

Smalley, A. J.↗
NASA NTRS1979

Particle acceleration in solar flares by cyclotron damping of cascading turbulence

It is pointed out that cyclotron damping of cascading turbulence can be a very efficient acceleration process because the turbulence is generally damped by the suprathermal tail of the particle distribution. Using a simplified approach to the transfer of wave energy down the spectrum, analytic time-dependent solutions are derived which describe the growth of the tail and its effect back on the turbulence. They suggest that with this mechanism, a sizable fraction of all the available energy ends up in a very small minority of the particles at the flare site, in accord with observations. Preferential acceleration of heavy elements is generally expected. The enhancement mechanism is very sensitive; and if He-3 is preaccelerated by even a modest amount, it could be enhanced by many orders of magnitude, as observed in some flares.

Eichler, D.↗
NASA NTRS1982

Damping Vibration at an Impeller

Vibration of pump shaft is damped at impeller--where vibration-induced deflections are greatest--by shroud and seal. Damping reduces vibrational motion of shaft at bearings and load shaft places on them. Flow through clearance channel absorbs vibration energy.

Hager, J. A.↗
NASA NTRS1979

The damping of seismic waves and its determination from reflection seismograms

The damping in theoretical waveforms is described phenomenologically and a classification is proposed. A method for studying the Earth's crust was developed which includes this damping as derived from reflection seismograms. Seismic wave propagation by absorption, attenuation of seismic waves by scattering, and dispersion relations are considered. Absorption of seismic waves within the Earth as well as reflection and transmission of elastic waves seen through boundary layer absorption are also discussed.

Engelhard, L.↗
NASA NTRS1981

Apparatus for damping operator induced oscillations of a controlled system

Flight control-related apparatus for damping operator induced oscillations of a controlled system responding to an operator controlled signal is described. The device utilizes a lag-lead filter for frequency and amplitude estimation of the control input, and a rectification and smoothing filter for producing a signal proportional to the absolute value of the frequency and amplitude estimate for use in suppression of the control system output signal. In one embodiment, this is accomplished by computing a correction signal in a correction generating section. In a second embodiment, a second rectification and smoothing filter produces a signal proportional to the absolute value of the controlled input signal. A ratio of the outputs of the first and second rectification and smoothing filters is then used in a generator to generate a gain factor k sub q for the control system to reduce the gain of the output signal of the control system, thereby to provide a damped control output signal without rate limiting the controlled element.

Edwards, J. W.↗
NASA NTRS1982

Controllability of inherently damped large flexible space structures

Graph theoretic techniques are used to study controllability of linear systems which represent large flexible orbiting space systems with inherent damping. The controllability of the pair of matrices representing the system state and control influence matrices is assured when all states in the model are reachable in a digraph sense from at least one input and also when the term rank of a Boolean matrix whose non trivial components are based on the state and control influence matrices has a term rank of the order of the state vector. The damping matrix does not influence the required number of actuators but gives flexibility to the possibility locations of the actuators for which the system is controllable.

Reddy, A. S. S. R.↗
NASA NTRS1982

A computer package for the design and eigenproblem solution of damped linear multidegree of freedom systems

Systems described by the matrix differental equation are considered. An interactive design routine is presented for positive definite mass, damping, and stiffness matrices. Designing is accomplished by adjusting the mass, damping, and stiffness matrices to obtain a desired oscillation behavior. The algorithm also features interactively modifying the physical structure of the system, obtaining the matrix structure and a number of other system properties. In case of a general system, where the M, C, and K matrices lack any special properties, a routine for the eigenproblem solution of the system is developed. The latent roots are obtained by computing the characteristic polynomial of the system and solving for its roots. The above routines are prepared in FORTRAN IV and prove to be usable for the machines with low core memory.

Ahmadian, M.↗
NASA NTRS1980

Damping enhancement and attitude control of large space structures

Enhancement of modal damping in large space structures (LSS) is highly desirable and sometimes essential for the stability of the primary attitude control system. This paper considers the use of a number of Annular Momentum Control Devices (AMCD's) for damping enhancement in LSS. It is proved that the closed-loop system is stable in the sense of Lyapunov. Sufficient conditions for asymptotic stability are also obtained.

Joshi, S. M.↗
NASA NTRS1982

On passive damping mechanisms in large space structures

The significance is explained of even tiny amounts of passive energy dissipation to ensure successful stabilization of large, flexible space structures. Study of scale effects on various mechanisms indicates that modal damping ratios are likely to decrease as size increases in a family of similar structures. Paper focuses on thermal dissipation induced by strain gradients during vibration of monolithic configurations. Past work and the expected magnitudes of this damping are reviewed, along with reasons why it is, to some degree, under the designer's control. In the search for the highest practical values, unidirectional metallic composites and other arrangements are examined

Ashley, H.↗