Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “oscillating flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Experimental measurements on an oscillating 70-degree delta wing in subsonic flow

A series of low-speed wind tunnel tests on a 70-degree sharp leading-edged delta wing at both static and dynamic conditions were performed to investigate the aerodynamic forces and moments. Forces and moments were obtained from a six component internal strain gauge balance. Static results compared well with the previous experimental findings. Large amplitude dynamic motion was produced by sinusoidally oscillating the model over a range of reduced frequencies. Substantial force and moment overshoots, a delay in dynamic stall, and hysteresis loops between the values of aerodynamnic loads in upstroke and downstroke motion were observed, all of which were strong functions of the reduced frequency. The aerodynamic forces and moments were influenced by the Reynolds number. Asymmetrical vortex bursting produced by nonzero sideslip angle created a complex rolling moment variations with angle of attack.

Soltani, M. R.↗
NASA NTRS1983

End wall flows in rotors and stators of a single stage compressor

A computer code for solving the parabolized Navier-Stokes equations for internal flows was developed. Oscillations that develop in the calculation procedure are discussed. The measurements made in the hub and annulus wall boundary layers are summarized. The flow in the hub wall boundary layer, starting ahead of the inlet guide vanes to the inlet of the rotor is traced.

Govindan, T. R.↗
NASA NTRS2021

Performance Assessment of Fluidic Oscillators Tested on the NASA Hump Model

Flow separation control over a wall-mounted hump model was studied experimentally to assess the performance of fluidic oscillators (sweeping jet actuators). An array of fluidic oscillators was used to control flow separation. The results showed that the fluidic oscillators were able to achieve substantial control over the separated flow by increasing the upstream suction pressure and downstream pressure recovery. Using the data available in the literature, the performance of the fluidic oscillators was compared to other active flow control (AFC) methods such as steady blowing, steady suction, and zero-net-mass-flux (ZNMF) actuators. Several integral parameters, such as the inviscid flow comparison coefficient, pressure drag coefficient, and modified normal force coefficient, were used as quality metrics in the performance comparison of the AFC methods. These quality metrics indicated the superiority of the steady suction method, especially at lower excitation amplitudes that is followed by the fluidic oscillators, steady blowing, and the ZNMF actuators, respectively. An aerodynamic figure of merit (AFM) was also constructed using the integral parameters and AFC power usage. The AFM results revealed that, for this study, steady suction was the most efficient AFC method at lower excitation amplitudes. The steady suction loses its efficiency as the excitation amplitude increases, and the fluidic oscillators become the most efficient AFC method. Both the steady suction and the fluidic oscillators have an AFM > 1 for the range tested in this study, indicating that they provide a net benefit when the AFC power consumption is also considered. On the other hand, both the steady blowing and ZNMF actuators were found to be inefficient AFC methods (AFM < 1) for the current configuration. Although they improved the flow field by controlling flow separation, the power requirement was more than their benefit.

Fluidic oscillators↗
NASA NTRS1998

Development of High Speed Interferometry Imaging and Analysis Techniques for Compressible Dynamic Stall

The development of a high-speed, phase-locked, realtime, point diffraction interferometry system for quantitative imaging unsteady separated flows is described. The system enables recording of up to 224 interferograms of the dynamic stall flow over an oscillating airfoil using a drum camera at rates of up to 40 KHz controlled by custom designed electronic interlocking circuitry. Several thousand interferograms of the flow have been obtained using this system. A comprehensive image analysis package has been developed for automatic processing of this large number of images. The software has been specifically tuned to address the special characteristics of airfoil flow interferograms. Examples of images obtained using the standard and the high-speed interferometry techniques are presented along with a demonstration of the image processing routine's ability to resolve the fine details present in these images.

Chandrasekhara, M. S.↗
NASA NTRS1992

Acoustic modes in fluid networks

Pressure and flow rate eigenvalue problems for one-dimensional flow of a fluid in a network of pipes are derived from the familiar transmission line equations. These equations are linearized by assuming small velocity and pressure oscillations about mean flow conditions. It is shown that the flow rate eigenvalues are the same as the pressure eigenvalues and the relationship between line pressure modes and flow rate modes is established. A volume at the end of each branch is employed which allows any combination of boundary conditions, from open to closed, to be used. The Jacobi iterative method is used to compute undamped natural frequencies and associated pressure/flow modes. Several numerical examples are presented which include acoustic modes for the Helium Supply System of the Space Shuttle Orbiter Main Propulsion System. It should be noted that the method presented herein can be applied to any one-dimensional acoustic system involving an arbitrary number of branches.

Michalopoulos, C. D.↗
NASA NTRS1973

Unsteady transonic flow analysis for low aspect ratio, pointed wings.

Oswatitsch and Keune's parabolic method for steady transonic flow is applied and extended to thin slender wings oscillating in the sonic flow field. The parabolic constant for the wing was determined from the equivalent body of revolution. Laplace transform methods were used to derive the asymptotic equations for pressure coefficient, and the Adams-Sears iterative procedure was employed to solve the equations. A computer program was developed to find the pressure distributions, generalized force coefficients, and stability derivatives for delta, convex, and concave wing planforms.

Kimble, K. R.↗
NASA NTRS1985

Symposium on Numerical and Physical Aspects of Aerodynamic Flows, 3rd, California State University, Long Beach, CA, January 21-24, 1985, Proceedings

Among the topics discussed are hydrodynamic stability and turbulent transition, separated flow simulations employing finite difference methods, a quasi-simultaneous finite difference approach for strongly interacting flow, the Newton solution of coupled Euler and boundary layer equations, multielement airfoil aerodynamics, vorticity dynamics, the significance of the thin layer Navier-Stokes approximation, a comparison of interactive and Navier-Stokes calculations of separating boundary layer flows, and a Navier-Stokes analysis for the mechanism of shock wave/boundary layer interactions. Also discussed are transonic interactions of unsteady vortical flows, boundary layers on oscillating airfoils, a laser-interferometer skin friction meter, flow over surface-mounted semibluff bodies, computations for spinning and spin-stabilized supersonic projectiles, transition calculations in three-dimensional flows, the effect of projectile boattailing in transonic flow, flow characteristics of a body of revolution at incidence, the influence of the boundary layer on the leading edge flow of a swept wing, and an interactive scheme for three-dimensional transonic flows.

Source record↗
NASA NTRS1992

Algorithm development with applications to aerodynamics and aeroelasticity

The development of a streamwise upwind algorithm is presented. Applications of this algorithm to steady flow over a delta wing and unsteady flow over an oscillating wing, respectively, are covered. An extension to higher order accuracy for upwind methods is discussed. This scheme will use the compatibility relations for the extension. The use of multiple zones in the calculation of unsteady flows is considered. Multiple zones are one way to treat complex configurations, such as complete aircraft. Aeroelastic calculations are discussed. A procedure for aeroelastic calculations is described that simultaneously solves the aerodynamic and structural equations of motion. Sample calculations are given to illustrate the above.

Goorjian, P. M.↗
NASA NTRS2004

Concentration Measurements in Self-Excited, Momentum-Dominated Helium Jets

Flow structure of momentum-dominated pure helium jets discharged vertically into ambient air was investigated using high-speed rainbow schlieren deflectometry (RSD) technique. Effects of the operating parameters, i.e., Reynolds number (Re) and Richardson number (Ri), on the oscillatory behavior of the flow were examined over a range of experimental conditions. To seek the individual effect of these parameters, one of them was fixed and the other was varied with certain constraints. Measurements revealed highly periodic oscillations in the laminar region as well as high regularity in transition and turbulent regions. Maximum spectral power profiles at different axial locations indicated the oscillation amplitude increasing until the breakdown of the jet in the turbulent regime. The transition from the laminar to turbulent flow was also investigated. Fast Fourier transform analysis performed in the transition regime showed that the flow oscillates at a unique frequency, which was the same in the upstream laminar flow region. Measured deflection angle data were used in Abel inversion algorithm to construct the helium concentration fields. Instantaneous helium concentration contours revealed changes in the flow structure and evolution of vortical structures during an oscillation cycle. Temporal evolution plots of helium concentration at different axial location showed repeatable oscillations at all axial and radial locations up to the turbulent regime. A cross-correlation technique, applied to find the spatial displacements of the vortical structures, provided correlation coefficient peaks between consecutive schlieren images. Results show that the vortical structure convected and accelerated only in the axial direction.

Yildirim, Bekir Sedat↗
NASA NTRS1975

Observations of an intense field-aligned thermal ion flow and associated intense narrow band electric field oscillations

An investigation is conducted concerning the conditions encountered during a Javelin sounding rocket experiment conducted on Apr. 3, 1970 at Fort Churchill, Canada. Evidence is presented that near the equatorward edge of the auroral arc an intense beam of cold plasma ions was flowing parallel to the earth's magnetic field. The beam was associated with intense narrow band electric field oscillations near the local ion gyrofrequency. The data support the hypothesis that intense electrostatic ion cyclotron waves were driven unstable by field-aligned currents.

Bering, E. A.↗
NASA NTRS1991

Unsteady supersonic flow around delta wings with symmetric and asymmetric flaps oscillation

A parametric study is presented to investigate the effect of reduced frequency of the leading-edge flaps on the locally-conical, unsteady, supersonic flow around a delta wing. This study covers symmetric and antisymmetric forced oscillation of the leading-edge flaps. The effects of the freestream Mach number and angle of attack are also presented. The problem is solved using time-accurate integration of the unsteady, compressible, thin-layer Navier-Stokes equations and the unsteady, linearized, Navier-displacement equations. The delta wing is of aspect ratio of 1.5 and its leading-edge flaps are hinged at 65 percent of the local-half span length. The reduced frequency is varied between 2 pi and pi/2. Two supersonic flow conditions have been investigated; the first is for a freestream Mach number of 2.4 and an angle of attack of 19 deg and the second is for a freestream Mach number of 1.5 and an angle attack of 15 deg.

Kandil, Osama A.↗
NASA NTRS2003

Resonance Effects in the NASA Transonic Flutter Cascade Facility

Investigations of unsteady pressure loadings on the blades of fans operating near the stall flutter boundary are carried out under simulated conditions in the NASA Transonic Flutter Cascade facility (TFC). It has been observed that for inlet Mach numbers of about 0.8, the cascade flowfield exhibits intense low-frequency pressure oscillations. The origins of these oscillations were not clear. It was speculated that this behavior was either caused by instabilities in the blade separated flow zone or that it was a tunnel resonance phenomenon. It has now been determined that the strong low-frequency oscillations, observed in the TFC facility, are not a cascade phenomenon contributing to blade flutter, but that they are solely caused by the tunnel resonance characteristics. Most likely, the self-induced oscillations originate in the system of exit duct resonators. For sure, the self-induced oscillations can be significantly suppressed for a narrow range of inlet Mach numbers by tuning one of the resonators. A considerable amount of flutter simulation data has been acquired in this facility to date, and therefore it is of interest to know how much this tunnel self-induced flow oscillation influences the experimental data at high subsonic Mach numbers since this facility is being used to simulate flutter in transonic fans. In short, can this body of experimental data still be used reliably to verify computer codes for blade flutter and blade life predictions? To answer this question a study on resonance effects in the NASA TFC facility was carried out. The results, based on spectral and ensemble averaging analysis of the cascade data, showed that the interaction between self-induced oscillations and forced blade motion oscillations is very weak and can generally be neglected. The forced motion data acquired with the mistuned tunnel, when strong self-induced oscillations were present, can be used as reliable forced pressure fluctuations provided that they are extracted from raw data sets by an ensemble averaging procedure.

Lepicovsky, J.↗
NASA NTRS1979

Experimental investigation of flow and heating in a resonance tube

Experiments have been performed to determine the basic mechanism of heating in resonance tubes of square section with constant area excited by underexpanded jet flows. The jet flow between the nozzle exit and the tube inlet plays a key role in the performance of a resonance tube. A detailed and systematic investigation of the unsteady complex shock structure in this part of the flow region has led to a better understanding of the fundamental mechanisms associated with the gas heating in such tubes. A study of the effects of tube location in relation to free-jet shock location (without the presence of the resonance tube) has shed further light on the underlying mechanism of sustained oscillations of the flow in a resonance tube.

Sarohia, V.↗
NASA NTRS1966

Nonlinear oscillations of a fluttering plate.

Two- and three-dimensional plates in high supersonic flow undergoing limit cycle oscillations analyzed, using aerodynamic theory and von Karman large deflection plate theory

PLATE THEORY↗
NASA NTRS1992

Navier-Stokes computations for oscillating control surfaces

Unsteady Navier-Stokes computations have been performed for simulating transonic flows over wings with oscillating control surfaces using a locally moving grid and a stationary-mismatched zoning scheme. An F-5 wing and a clipped delta wing are chosen for the present study. The computed unsteady pressures and the response characteristics to the control surface motions are compared with experimental data. The results successfully predict main features of the unsteady pressure profiles, such as the double peaks at the shock wave and at the hinge line.

Obayashi, Shigeru↗