SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A simple model of the lower corona which allows for a possible difference in the electron and proton temperatures is analyzed. With the introduction of a phenomenological heating term, temperature and density profiles are calculated for several different cases. It is found that, under certain circumstances, the electron and proton temperatures may differ significantly.
Temporal and radial profiles are obtained 30 cm downstream from the anode for two peak arc currents (11.2 kA and 20 kA) and for various auxiliary magnetic fields (0, 1.0 T, and 2.0T) using the Thomson scattering technique. Average density and temperature are relatively constant for over 100 microseconds with significant fluctuations. Radial profiles obtained are relatively flat for 4 cm from the axis. Compared to earlier 20 cm data, the exhaust density has decreased significantly, the average temperature (4.6 eV) has not changed, and the density hole with an auxiliary magnetic field has enlarged.
Temporal and radial profiles are obtained 30 cm downstream from the anode for two peak arc currents (11.2 kA and 20 kA) and for various auxiliary magnetic fields (0, 1.0 T, and 2.0 T) using the Thomson scattering technique. Average density and temperature are relatively constant for over 100 microseconds with significant fluctuations. Radial profiles obtained are relatively flat for 4 cm from the axis. Compared to earlier 20 cm data, the exhaust density has decreased significantly, the average temperature has not changed, and the density ?hole' with an auxiliary magnetic field has enlarged.
The electron density and positive-ion composition above Wallops Island were measured on August 12, 1976, about 12 hours after the maximum of the Perseid shower. At launch time, 4.5 MHz was recorded for fbEs, corresponding to an electron density of 2.4 x 10 to the 5th power per cu cm. Electron profile and ion composition measurements confirmed the presence of a sporadic E-layer with two maxima at 101.3 and 105.4 km. The electron density was measured with a pair of boom-mounted probes at fixed potential. The positive ion composition above 77 km was measured with a magnetic mass spectrometer employing a liquid He cryopump. Some of the salient results of the (still incomplete) analysis are discussed.
Electron momentum distributions from Compton profiles of Li-Mg polycrystalline samples, exhibiting discontinuity at free electron value of Fermi momentum
The Mariner-6 and -7 occultation experiments provide sets of Doppler residuals from which physical properties of the Martian atmosphere, such as the ionospheric electron-density distribution and the lower-atmosphere temperature profile, may be derived. The Doppler residuals contain both systematic and random errors. The former are removed during the data reduction, and the latter are analyzed to yield error limits on the derived physical properties of the atmosphere.
Measurements of mesospheric small scale turbulence and associated larger scale wave structures were obtained from rocket probe flights during equinox in spring 1985. The measurements were verified by data from the mesosphere-stratosphere-troposphere radar at Poker Flat, Alaska. Electron density irregularities down to an altitude of about 62 km and fluctuations in positive ion density in the altitude region from 50 to 90 km were measured. Turbulence in the inertial subrange was observed at heights where the fluctuations generally were largest. Measurement of background electron density exhibited gradients relative to the monotonically increasing density profile, suggesting the presence of large amplitude wave motions transporting the plasma by mixing. The radar detected the occurrence of 1-3 km wavelike perturbations superimposed on a 7-km wave in the wind velocity field. It is suggested that the 1-3 km waves are more important in the transport of energy and momentum and in the production of turbulence in the lower mesosphere.
A computer model of Comet P/Giacobini-Zinner is presented which contains photoprocesses, gas-phase chemical kinetics, energy balance, multifluid hydrodynamics with a transition to free molecular flow, and solar wind interaction. Recently the physics for electrons in the model has been improved by including electron impact ionization and dissociation and separately accounting for electron energetics. Electron heating and cooling mechanisms include photoprocesses, recombination processes, inelastic and elastic collisions with heavy molecules, and expansion cooling. The model incorporates an internally consistent interaction of the solar wind with the coma gas using the axisymmetric ideal fluid dynamic equations. The nuclear size and composition have been chosen to make the calculations relevant to the September 11, 1985 International Cometary Explorer (ICE) encounter with Comet P/Giacobini-Zinner. Model profiles of the temperature, velocity, and number density of the electrons are in good agreement with measurements along ICE's trajectory. The results indicate the probe passed through a region of the coma at the onset of the plasma tail.
GNSS-LEO radio links from Precise Orbital Determination (POD) and Radio Occultation (RO) antennas have been used increasingly in studying and monitoring the global ionospheric electron density (Ne). In this study we developed an optimal estimation (OE) method to retrieve Ne profiles from the slant total electron content (hTEC) measurements acquired by the GNSS-POD links at negative elevation angles. The hmF2 and NmF2 from the OE retrieval are validated against ground-based ionosondes and radar observations, showing generally good agreements in NmF2 from all sites. Nighttime hmF2 measurements tend to agree better than the daytime when the ionosonde heights tend to be slightly lower. The OE algorithm has been applied to all GNSS-POD data acquired from the COSMIC-1 (2006-2019), COSMIC-2 (2019-present), and Spire (2019-present) constellations, showing a consistent ionospheric Ne morphology. A detailed analysis of the frequency-wavenumber spectra is made for the Ne variability at different heights. In the lower ionosphere (~150 km) we found significant spectral power in DE1, DW6, DW4, SW5, and SE4 wave components, in addition to well-known DW1, SW2 and DE3 waves. In the upper ionosphere (~450 km), additional wave components are still present, including DE4, DW4, DW6, SE4 and SW4. The co-exist of eastward and westward propagating WN4 components implies the presence of a stationary planetary wave4 (sPW4), as suggested by other earlier studies.
The addition of phase difference measurements to differential absorption experiments is shown to be both feasible and desirable. The phase information can provide a more sensitive measurement of electron density above about 75 km. The differential phase shift is only weakly dependent on collision frequency in this range, and so an accurate collision frequency profile is not a prerequisite. The differential phase shift and differential absorption measurements taken together can provide both electron density and collision frequency data from about 70 to 90 km.
Within 100,000 km of comet Giacobini-Zinner's nucleus, strong plasma wave turbulence was detected by the ICE electric and magnetic field wave instruments. The spatial profiles of the wave amplitudes are compared with measurements of the heavy ion fluxes of cometary origin, the plasma electron density, and the magnetic field strength. The general similarity of the wave and heavy ion profiles suggest that the waves might be generated by free energy in the pick-up ion distribution function. However, the expected parallel streaming instability of electrostatic modes generates waves with frequencies that are too low to explain the observations. The observed low frequency magnetic turbulence is plausibly explained by the lower hybrid loss-cone instability of heavy ions.
Doppler and ranging measurements using the radio signal of the Giotto spacecraft were taken before, during, and after the encounter with Comet Halley on Mar. 13, 14, 1986. The spacecraft velocity was found to decrease by a total of 23.3 cm/s due to impacting gas and (primarily) dust in the cometary atmosphere. A preliminary dust production rate of 1000 kg/s is found to be consistent with this deceleration. Power spectra of the carrier phase fluctuations reveal an increase in level and a flattening of the spectrum just prior to encounter, presumably associated with the enhanced dust impact rate. Finally, simulated Doppler time profiles are computed using the radial dependence of plasma density observed by the Giotto in situ investigations. It is shown that the cometary electron content profile would have been clearly seen if a dual-frequency downlink radio configuration had been available at encounter.
Equatorial electrojet cross section profile, describing longitudinal variations, current density, magnetic field produced and electron drift velocity
Cesium-filled thermionic energy converters are examined as candidate electrical energy sources in spacecraft requiring tens to hundreds of kilowatts of electric power. The high operating temperatures necessary for a large specific power and high efficiency inevitably impose stringent constraints on the converter fabrication to achieve the desired reliability of the power system. The converter physics for reducing operating temperatures and cesium plasma losses are studied to achieve high reliability without sacrificing the power performance of the converters. Various cesium parameters which affect the converter performance are: (1) electron temperatures, (2) plasma ion densities, and (3) electric potential profiles. These were investigated using a Langmuir probe in a simulated converter. The parameters were measured in different cesium discharge modes.
Cesium-filled thermionic energy converters are considered as electrical energy sources in future spacecraft requiring tens to hundreds of kilowatts of electric power. The high operating temperatures necessary for a large specific power and high efficiency impose stringent constraints on the converter fabrication. The converter physics for reducing operating temperatures and cesium plasma losses are being studied to achieve high reliability without sacrificing the power performance of the converters. Various cesium parameters which affect the converter performance are: (1) electron temperatures, (2) plasma ion densities, and (3) electric potential profiles. These were investigated using a Langmuir probe in a simulated converter. The parameters were measured in different cesium discharge modes.
New designs, and materials appropriate for such designs, are under investigation in an effort to develop coronagraph occulting masks having broad-band spectral characteristics superior to those currently employed. These designs and materials are applicable to all coronagraphs, both ground-based and spaceborne. This effort also offers potential benefits for the development of other optical masks and filters that are required (1) for precisely tailored spatial transmission profiles, (2) to be characterized by optical-density neutrality and phase neutrality (that is, to be characterized by constant optical density and constant phase over broad wavelength ranges), and/or (3) not to exhibit optical- density-dependent phase shifts. The need for this effort arises for the following reasons: Coronagraph occulting masks are required to impose, on beams of light transmitted through them, extremely precise control of amplitude and phase according to carefully designed transmission profiles. In the original application that gave rise to this effort, the concern has been to develop broad-band occulting masks for NASA s Terrestrial Planet Finder coronagraph. Until now, experimental samples of these masks have been made from high-energy-beam-sensitive (HEBS) glass, which becomes locally dark where irradiated with a high-energy electron beam, the amount of darkening depending on the electron-beam energy and dose. Precise mask profiles have been written on HEBS glass blanks by use of electron beams, and the masks have performed satisfactorily in monochromatic light. However, the optical-density and phase profiles of the HEBS masks vary significantly with wavelength; consequently, the HEBS masks perform unsatisfactorily in broad-band light. The key properties of materials to be used in coronagraph occulting masks are their extinction coefficients, their indices of refraction, and the variations of these parameters with wavelength. The effort thus far has included theoretical predictions of performances of masks that would be made from alternative materials chosen because the wavelength dependences of their extinction coefficients and their indices of refraction are such that that the optical-density and phase profiles of masks made from these materials can be expected to vary much less with wavelength than do those of masks made from HEBS glass. The alternative materials considered thus far include some elemental metals such as Pt and Ni, metal alloys such as Inconel, metal nitrides such as TiN, and dielectrics such as SiO2. A mask as now envisioned would include thin metal and dielectric films having stepped or smoothly varying thicknesses (see figure). The thicknesses would be chosen, taking account of the indices of refraction and extinction coefficients, to obtain an acceptably close approximation of the desired spatial transmittance profile with a flat phase profile
GNSS-LEO radio links from Precise Orbital Determination (POD) and Radio Occultation (RO) antennas have been used increasingly in characterizing the global 3D distribution and variability of ionospheric electron density (N e ). In this study, we developed an optimal estimation (OE) method to retrieve N e profiles from the slant total electron content (hTEC) measurements acquired by the GNSS-POD links at negative elevation angles (ε < 0°). Although both OE and onion-peeling (OP) methods use the Abel weighting function in the N e inversion, they are significantly different in terms of performance in the lower ionosphere. The new OE results can overcome the large N e oscillations, sometimes negative values, seen in the OP retrievals in the E-region ionosphere. In the companion paper in this Special Issue, the HmF2 and NmF2 from the OE retrieval are validated against ground-based ionosondes and radar observations, showing generally good agreements in NmF2 from all sites. Nighttime hmF2 measurements tend to agree better than the daytime when the ionosonde heights tend to be slightly lower. The OE algorithm has been applied to all GNSS-POD data acquired from the COSMIC-1 (2006–2019), COSMIC-2 (2019–present), and Spire (2019–present) constellations, showing a consistent ionospheric N e morphology. The unprecedented spatiotemporal sampling of the ionosphere from these constellations now allows a detailed analysis of the frequency–wavenumber spectra for the N e variability at different heights. In the lower ionosphere (~150 km), we found significant spectral power in DE1, DW6, DW4, SW5, and SE4 wave components, in addition to well-known DW1, SW2, and DE3 waves. In the upper ionosphere (~450 km), additional wave components are still present, including DE4, DW4, DW6, SE4, and SW4. The co-existence of eastward- and westward-propagating wave4 components implies the presence of a stationary wave4 (SPW4), as suggested by other earlier studies. Further improvements to the OE method are proposed, including a tomographic inversion technique that leverages the asymmetric sampling about the tangent point associated with GNSS-LEO links.
The profile of the forbidden line of C III (1909) is the same in two pseudo-trailed, low-resolution SWP spectra of the nucleus of the Seyfert galaxy NGC 4151 obtained with the IUE in November 1980 and December 1982, respectively. In the 1980 spectrum, the C III forbidden line profile is also very nearly the same as that of the resonance line C IV (1550). In the 1982 spectrum, the continuum is 5 times higher and C IV is both much broader and much brighter. In the difference spectrum, which is interpreted to be the spectrum of a time-variable component, C IV (1550) is the only strong emission feature. The profile of this line closely resembles that of a spherical shell surrounding a less dense gas uniformly expanding from a central opaque object. From values of the profile parameters and from the observed time variability of the object, it is inferred that the shell has a radius of about 10 to the 15th cm, a mass of 0.25 solar mass, an expansion velocity of 13,000 km/s, and an electron density of 10 to the 11th per cu cm. From the line profile and the continuum, it is inferred that the opaque central source has approximate radius of 10 to the 14th cm and temperature 23,000 K.