SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Pulse autocorrelator electronic system discriminates between the dispersion effect of a disturbed laser signal and background noise by detecting multipath arrivals of Gaussian-shaped signal pulses. The autocorrelation function is time-dependent and can be determined by integrating the product of a received pulse and its delayed replicas.
The antenna studies were performed in a large magnetized plasma source, a schematic drawing of which is shown. The plasma diagnostics consist of a 70 GHz (4 mm) microwave interferometer for density measurements and of various Langmuir probes for spatially resolved measurements of t sub e, n sub e and the shape of the electron distribution function. All diagnostic data are time-resolved by sample-and-hold techniques so as to yield information about the plasma build-up, the steady-state discharge, and the plasma decay in the afterglow. Whistler waves are excited and detected with various antennas which are inserted into the center of the plasma column through one axial and two orthogonal radial ports. The antennas were tested for their proper dipole response and then calibrated in a known field geometry in air. For the electric dipole, a parallel plate capacitor field was used; the magnetic loop is calibrated in the near-zone field of a long linear conductor of known radio frequency current distribution. Results are presented and discussed.
Using Mariner 9 results on the shapes, rotation periods, and photometric functions of Phobos and Deimos, approximate orbital light curves are calculated for the two Martian satellites. The prediction is that both Phobos and Deimos should show orbital brightness fluctuations detectable from earth. For Phobos, the detectable amplitude is predicted to be about 0.1 mag; for Deimos, 0.2 mag.
The circulation theory of airfoil lift has been applied to calculate the performance of thrust augmenting ejectors. The ejector shroud is considered to be 'flying' in the secondary velocity field induced by the entrainment of the primary jet, so that the augmenting thrust is viewed as analogous to the lift on an airfoil. Vortex lattice methods are utilized to compute the thrust augmentation from the force on the flaps. The augmentation is shown to be a function of the length and shape of the flaps, as well as their position and orientation. Predictions of this new theory are compared with the results of classical methods of calculating the augmentation by integration of the stream thrust.
A theory of the Io-independent decameter radiation is developed. The radiation results from excitation of the electromagnetic loss-cone instability by keV electrons, stably trapped near L = 6. The radiation is excited in Band 3 of the extraordinary mode. When the effects of refraction are estimated, it is shown that above 10 MHz radiation is beamed into the equatorial plane in a wide, but thin, conical sheet (Psi approximately equals 80 degrees). When the instability analysis is coupled with one of the octupole models of the Jovian magnetic field, the maximum convective growth of the instability occurs in the directions of the non-Io A, B, and C sources. The shape of the peak radio flux frequency spectrum is found to be a consequence of the loss cone shape of the electron distribution function.
A theory of the Io-independent decameter radiation is developed. The radiation results from excitation of the electromagnetic loss-cone instability by keV electrons, stably trapped near L = 6. The radiation is excited in band III of the extraordinary mode. When the effects of refraction are estimated, it is shown that above 10 MHz radiation is beamed into the equatorial plane in a wide, but thin, conical sheet. When the instability analysis is coupled with one of the octopole models of the Jovian magnetic field, the maximum convective growth of the instability occurs in the directions of the non-Io A, B, and C sources. The shape of the peak radio flux frequency spectrum is found to be a consequence of the loss-cone shape of the electron distribution function.
Solution charts of the Orr-Sommerfeld equation for stationary crossflow disturbances are presented for 10 typical velocity profiles on a swept laminar flow control wing. The critical crossflow Reynolds number is shown to be a function of a boundary layer shape factor. Amplification rates for crossflow disturbances are shown to be proportional to the maximum crossflow velocity. A computer stability program called MARIA, employing the amplification rate data for the 10 crossflow velocity profiles, is constructed. This code is shown to adequately approximate more involved computer stability codes using less than two percent as much computer time while retaining the essential physical disturbance growth model.
The injection molding behavior of a concentrated suspension of Si powder in wax was studied. It was found that the injection molding behavior was a function of the processing techniques used to generate the powder. Dry ball-milled powders had the best molding behavior, while air classified and impact-milled powders demonstrated poorer injection moldability. The relative viscosity of these molding batches was studied as a function of powder properties: distribution shape, surface area, packing density, and particle morphology. The experimental behavior, in all cases, followed existing theories. The relative viscosity of an injection molding composition composed of dry ball-milled powders could be expressed using Farris' relation.
The experimental portion of a joint government/industry/university research study on the vibrational characteristics of twisted cantilevered plates is presented. The overall purpose of the research study was to assess the capabilities and limitations of existing analytical methods in predicting the vibratory characteristics of twisted plates. Thirty cantilevered plates were precision machined at the Air Force's Aero Propulsion Laboratory. These plates, having five different degrees of twist, two thicknesses, and three aspect ratios representative of turbine engine blade geometries, were tested for their vibration mode shapes and frequencies. The resulting nondimensional frequencies and selected mode shapes are presented as a function of plate tip twist. The trends of the natural frequencies as a function of the governing geometric parameters are discussed. The effect of support compliance on the plate natural frequency and its impact on numerically modeling twisted plates is also presented.
It has been suggested that QSOs make up a substantial fraction of the unresolved X-ray background (XRB) in the 0.5-3 keV energy band. The XRB is poorly known at these energies due to contamination by diffuse galactic emission. The XRB spectrum is precisely measured above 3 keV, and the aggregate spectrum of the proposed contributors should match its form. Seyfert galaxies are thought to contribute 20-30 percent (3-10 keV), and they have been shown to have power-law energy indices of roughly 0.7. The 1-15 keV average spectrum of a sample of optically bright QSOs and a 90 percent confidence range is found for a power law index of 0.83 for N(H) of less than 3 x 10 to the 20th atoms per sq cm. It is also found that QSOs with spectra most consistent with these measurements can contribute about 30 percent at most of the 3-10 keV XRB, or else the remaining contributors have intriguing spectra which rise with energy up to 10 keV and fall sharply thereafter. Alternativey, the X-ray spectral shape of QSOs is a function of redshift and/or radio luminosity.
The influence of the shape of atmospheric scattering phase functions on blurring of surface detail in images acquired from space is investigated. The effects are characterized by computing atmospheric transfer functions and by solving the multidimensional equation of radiative transfer using a Fourier transform method. It is predicted that increased forward scattering enhances the detectability of atmospheric blurring near reflectance boundaries. Results for off-nadir viewing are also presented.
A planar endfire slotted-line antenna structure was investigated. It was found that the H-plane beamwidths are basically dependent upon the substrate properties, whereas the E-plane beamwidths are more strongly a function of the slot's shape and size. It is shown that these antennas produce symmetrical E and H-plane beamwidths while following Zucker's standard traveling-wave antenna beamwidth curves over some range of antenna normalized length. An empircally derived design formula for effective substrate thickness is shown to predict this range for linearly tapered slotted-line antennas. The experimental imaging properties of these arrays are presented and imaging theory is discussed. It is shown that a minimum spacing of elements is necessary for exact reconstruction for a sampled image in a diffraction limited system. Because these LTSA elements employ the traveling-wave mechanism of radiation, they can be spaced two times closer than a conical feed horn of comparable beamwidth.
A Monte Carlo technique is used to investigate the effects of a hot electron scattering cloud surrounding a time-dependent X-ray source. Results are presented for the time-averaged emergent energy spectra and the mean residence time in the cloud as a function of energy. Moreover, after Fourier transforming the scattering Green's function, it is shown how the cloud affects both the observed power spectrum of a time-dependent source and the cross spectrum (Fourier transform of a cross correlation between energy bands). It is found that the power spectra intrinsic to the source are related to those observed by a relatively simple frequency-dependent multiplicative factor (a transmission function). The cloud can severely attenuate high frequencies in the power spectra, depending on optical depth, and, at lower frequencies, the transmission function has roughly a Lorentzian shape. It is also found that if the intrinsic energy spectrum is constant in time, the phase of the cross spectrum is determined entirely by scattering. Finally, the implications of the results for studies of the X-ray quasi-periodic oscillators are discussed.
The phase-conjugate signal observed in resonant degenerate four-wave mixing on the 6 3P2 to 7 3S1 transition of atomic Hg in an Hg-Ar discharge is investigated. At a fixed Ar pressure the variation of the signal with pump powers is explained by a model that includes the effects of velocity-changing collisions (VCCs). As the Ar pressure was varied from 0 to 1 torr, an increase in the phase-conjugate signal was observed and is ascribed to a change in the discharge dynamics with Ar pressure and to the influence of VCCs. To further clarify the role of collisions and optical pumping, degenerate four-wave mixing spectra are examined as a function of pump power. Line shapes are briefly discussed.
Four separate lunar occultations of the Galactic center in the infrared K-band have been observed, and the results are used to estimate the size of the sources and to derive photometry. It is found that IRS 16NE, 16NW, and IRS 29 are smaller than about 510 AU and IRS 16SW-W and C are smaller than 85 AU. All sources brighter than K = 10 mag in the central pc are smaller than 510 AU and therefore seem to be stars. IRS 7 is smaller than about 100 AU. IRS 1W and 13, resolved into pairs of stars, are probably the exciting stars for these H II regions. The shape of the differential luminosity function of the stars in the central sq pc is similar to that of stars in the central 150 sq pc. There is a steady increase in star density toward the central few arcsec of the Galaxy.
An approach to the integrated design of linear controlled structures, which is being investigated as part of NASA's controlled structures interaction (CSI) methodology development program, is presented. The approach is integrated in the sense that the structure and its controller are simultaneously designed. The design methodology uses constrained nonlinear optimization procedures based on analytically obtained gradients of the structural responses. Design of the controller is based on the so-called Q-parameterization theory, which parameterizes all closed-loop input/output maps achievable with stabiizing linear controllers. Very general objective and constraint functions are possible, and structural shape can be included in the design variables. This method has been partially implemented and demonstrated; early findings are reported.
Predictions of a CFD program calculating a fluid-free surface shape and motion as a function of imposed acceleration are validated against the drop-tower test data collected to support design and performance assessments of the Saturn S-IVB stage liquid-hydrogen tank. The drop-tower facility, experimental package, and experiment procedures are outlined, and the program is described. It is noted that the validation analysis confirms the program's suitability for predicting low-g fluid slosh behavior, and that a similar analysis could examine the effect of incorporating baffles and screens to impede initiation of any unwanted side loads due to slosh. It is concluded that in actual vehicle applications, the engine thrust tailoff profile should be included in computer simulations if the precise interface versus time definition is needed.
'Gaussian Windows' is a method for exploring a set of multivariate data, in order to estimate the shape of the underlying density function. The method can be used to find and describe structural features in the data. The method is described in two earlier papers. I assume that the reader has access to both of these papers, so I will not repeat material from them. The program described herein is written in BASIC and it runs on an IBM PC or PS/2 with the DOS 3.3 operating system. Although the program is slow and has limited memory space, it is adequate for experimenting with the method. Since it is written in BASIC, it is relatively easy to modify. The program and some related files are available on a 3-inch diskette. A listing of the program is also available. This user's manual explains the use of the program. First, it gives a brief tutorial, illustrating some of the program's features with a set of artificial data. Then, it describes the results displayed after the program does a Gaussian window, and it explains each of the items on the various menus.