Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SHEAR”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

On the spatial instability of piecewise linear free shear layers

The main goal of this paper is to clarify the spatial instability of a piecewise linear free shear flow. This is done by obtaining numerical solutions to the Orr-Sommerfeld equation of high Reynolds numbers. The velocity profile chosen is very much like a piecewise linear one, with the exception that the corners have been rounded so that the entire profile is infinitely differentiable. It is found that the (viscous) spatial instability of this modified profile is virtually identical to the inviscid spatial instability of the piecewise linear profile and agrees qwalitatively with the inviscid results for the tanh profile when the shear layers are convectively unstable. The unphysical features, previously identified for the piecewise linear velocity profile, arise only when the flow is absolutely unstable. It is concluded that there is nothing wrong with the inviscid spatial instability of piecewise linear shear flows.

Balsa, T. F.↗
NASA NTRS1987

Effects of large deflection and transverse shear on response of rectangular symmetric composite laminates subjected to acoustic excitation

Nonlinear equations of motion of symmetrically laminated anisotropic plates are derived accounting for von Karman strains. The effect of transverse shear is included in the formulation. Using a single-mode Galerkin procedure, the nonlinear modal equation is obtained. The direct equivalent linearization method is employed for solution of this equation. The response to acoustic excitation of moderately thick composite panels is studied. Further, the effects of transverse shear on large deflection vibration of laminates under random excitation are studied. Mean-square deflections and mean-square inplane stresses are obtained for symmetric graphite-epoxy laminates. Using equilibrium equations and the continuity requirements, the mean-square transverse shear stresses are calculated. The results obtained will be useful in the sonic fatigue design of composite aircraft panels. The analysis is presented in detail for simply supported plates. The analogous equations for a clamped case are also obtained.

Mei, Chuh↗
NASA NTRS1987

Further development of the losipescu shear test method

Recent activities by the present investigators to further develop the losipescu-shear-test method for use with composite materials are summarized. Finite-element analyses used to predict the stress states in the specimen are described, with particular emphasis on how they are influenced by the specific test-fixture configuration used. These same analytical tools were also used to predict the influence of specimen notch depth, notch angle, and notch-root radius. The result was a redesign of the original Wyoming version of the losipescu-shear-test fixture, and the establishment of guidelines for preparing specimens. These are discussed in some detail. Many references to available literature are included. An attempt has been made to put the work performed to date into perspective, to aid the potential user of the losipescu-shear-test method in establishing proper test procedures.

Adams, D. F.↗
NASA NTRS1987

Coronal magnetic fields produced by photospheric shear

The magneto-frictional method is used for computing force free fields to examine the evolution of the magnetic field of a line dipole, when there is relative shearing motion between the two polarities. It found that the energy of the sheared field can be arbitrarily large compared with the potential field. It is also found that it is possible to fit the magnetic energy, as a function of shear, by a simple functional form.

Sturrock, P. A.↗
NASA NTRS1988

Response of wind shear warning systems to turbulence with implication of nuisance alerts

The objective was to predict the inherent turbulence response characteristics of candidate wind shear warning system concepts and to assess the potential for nuisance alerts. Information on the detection system and associated signal processing, physical and mathematical models, wind shear factor root mean square turbulence response and the standard deviation of the wind shear factor due to turbulence is given in vugraph form.

Bowles, Roland L.↗
NASA NTRS1987

Shear-layer structures in near-wall turbulence

The structure of internal shear layer observed in the near-wall region of turbulent flows is investigated by analyzing flow fields obtained from numerical simulations of channel and boundary-layer flows. It is found that the shear layer is an important contributor to the turbulence production. The conditionally averaged production at the center of the structure was almost twice as large as the long-time mean value. The shear-layer structure is also found to retain its coherence over streamwise distances on the order of a thousand viscous length units, and propagates with a constant velocity of about 10.6 u sub rho throughout the near wall region.

Johansson, A. V.↗
NASA NTRS1988

Resolved shear stress intensity coefficient and fatigue crack growth in large crystals

Fatigue crack growth in large grain Al alloy was studied. Fatigue crack growth is caused primarily by shear decohesion due to dislocation motion in the crack tip region. The crack paths in the large crystals are very irregular and zigzag. The crack planes are often inclined to the loading axis both in the inplane direction and the thickness direction. The stress intensity factors of such inclined cracks are approximated from the two dimensional finite element calculations. The plastic deformation in a large crystal is highly anisotropic, and dislocation motion in such crystals are driven by the resolved shear stress. The resolved shear stress intensity coefficient in a crack solid, RSSIC, is defined, and the coefficients for the slip systems at a crack tip are evaluated from the calculated stress intensity factors. The orientations of the crack planes are closely related to the slip planes with the high RSSIC values. If a single slip system has a much higher RSSIC than all the others, the crack will follow the slip plane, and the slip plane becomes the crack plane. If two or more slip systems have a high RSSIC, the crack plane is the result of the decohesion processes on these active slip planes.

Chen, QI↗
NASA NTRS1988

Intelligent guidance and control for wind shear encounter

The principal objective is to develop methods for assessing the likelihood of wind shear encounter, for deciding what flight path to pursue, and for using the aircraft's full potential for combating wind shear. This study requires the definition of both deterministic and statistical techniques for fusing internal and external information, for making go/no-go decisions, and for generating commands to the aircraft's cockpit displays and autopilot for both manually controlled and automatic flight. The program has begun with the development of a real-time expert system for pilot aiding that is based on the results of the FAA Windshear Training Aids Program. A two-volume manual that presents an overview, pilot guide, training program, and substantiating data provides guidelines for this initial development. The Expert System to Avoid Wind Shear (ESAWS) currently contains over 140 rules and is coded in the LISP programming language for implementation on a Symbolics 3670 LISP machine.

Stengel, Robert F.↗
NASA NTRS1988

Study of toluene rotary fluid management device and shear flow condenser performance for a space-based organic Rankine power system

Management of two-phase fluid and control of the heat transfer process in microgravity is a technical challenge that must be addressed for an orbital Organic Rankine Cycle (ORC) application. A test program was performed in 1-g that satisfactorily demonstrated the two-phase management capability of the rotating fluid management device (RFMD) and shear-flow condenser. Operational tests of the RFMD and shear flow condenser in adverse gravity orientations, confirmed that the centrifugal forces in the RFMD and the shear forces in the condenser were capable of overcoming gravity forces. In a microgravity environment, these same forces would not have to compete against gravity and would therefore be dominant. The specific test program covered the required operating range of the Space Station Solar Dynamic Rankine Cycle power system. Review of the test data verified that: fluid was pumped from the RFMD in all attitudes; subcooled states in the condenser were achieved; condensate was pushed uphill against gravity; and noncondensible gases were swept through the condenser.

Havens, Vance↗
NASA NTRS1987

Coherent motion induced fluctuations in the primary transition region of a plane shear layer

The naturally occurring large scale motions in a single stream shear layer (that is initiated from a fully turbulent boundary layer) are made evident by the induced velocities in the entrainment region beyond the active shear layer. The distinctive attributes of these induced motions are particularly evident in the Michigan State Univerity Free Shear Flow Facility since the total test section length (3m) is nominally the same as the location of the first, fully formed, coherent motion, ca/x theta (0) = 400 (or 2.5 m). Hence, detailed studies of the induced motions can be executed. Individual coherent motions are identified by the induced velocity signatures and conditional-ensemble statistics are used to represent the irrotational field properties. Clusters of such motions exist; some of their properties are substantially different from the unconditionally averaged values.

Foss, J. F.↗
NASA NTRS1987

Control of free shear layers

The fundamental aspects of controlled multiple coherent mode presence in turbulent shear flows is first discussed, including the supplementary averaging procedures in addition to the Reynolds average and the nonlinear energy transfer mechanisms coupling the coherent modes, mean flow and fine-grained turbulence. Then the problem of a fundamental mode and its subharmonic in a developing mixing layer, the prototype problem of subharmonic cascade, is examined. An integral method is presented which allows the determination of the coherent wave envelope or amplitude simultaneously with the mean flow growth rate and turbulence energy. This is then generalized to the presence of multiple subharmonics using a binary-frequency interaction argument. Free shear layer control is discussed in terms of initial coherent mode amplitudes, dimensionless initial frequencies, phase angle between the modes and fine-grained turbulence levels, in particular, how these parameters could enhance or suppress the shear layer spreading rate and the levels of fine-grained turbulence.

Liu, J. T. C.↗
NASA NTRS1988

Experimental investigation of non-planar sheared outboard wing planforms

The outboard planforms of wings have been found to be of prime importance in studies of induced drag reduction. This conclusion is based on an experimental and theoretical study of the aerodynamic characteristics of planar and nonplanar outboard wing forms. Six different configurations; baseline rectangular, planar sheared, sheared with dihedral, sheared with anhedral, rising arc, and drooping arc were investigated for two different spans. Span efficiencies as much as 20 percent greater than baseline can be realized with nonplanar wing forms. Optimization studies show that this advantage can be achieved along with a bending moment benefit. Parasite drag and lateral stability estimations were not included in the analysis.

Naik, D. A.↗
NASA NTRS1988

Structure of a reattaching supersonic shear flow

A Mach 1.83 fully developed turbulent boundary layer with boundary layer thickness, free stream velocity, and Reynolds number of 7.5 mm, 476 m/s, and 6.2 x 10 to the 7th/m, respectively, was separated at a 25.4-mm backward step and formed a shear layer. Fast-response pressure transducers, schlieren photography, and LDV were used to study the structure of this reattaching shear flow. The preliminary results show that large-scale relatively organized structures with limited spanwise extent form in the free shear layer. Some of these structures appear to survive the recompression and reattachment processes, while others break down into smaller scales and the flow becomes increasingly three-dimensional. The survived large-scale structures lose their organization through recompression/reattachment, but regain it after reattachment. The structures after reattachment form a 40-45-degree angle relative to the free stream and deteriorate gradually as they move downstream.

Samimy, M.↗
NASA NTRS1988

Migration arising from gradients in shear stress: Particle distributions in Poiseuille flow

Experimental evidence for the existence of shear induced migration processes is reviewed and the mechanism by Leighton and Acrivos (1987b) is described in detail. The proposed mechanism is shown to lead to the existence of an additional shear induced migration in the presence of gradients in shear stress such as would be found in Poiseuille flow, and which may be used to predict the amplitude of the observed short-term viscosity increase. The concentration and velocity profiles which result from such a migration are discussed in detail and are compared to the experimental observations of Karnis, Goldsmith and Mason (1966).

Leighton, D. T., Jr.↗
NASA NTRS1988

Structure of wind-shear turbulence

The statistical characteristics of wind-shear turbulence are modelled. Isotropic turbulence serves as the basis of comparison for the anisotropic turbulence which exists in wind shear. The question of how turbulence scales in a wind shear is addressed from the perspective of power spectral density.

Trevino, G.↗
NASA NTRS1989

Structure of wind-shear turbulence

The statistical characteristics of wind shear turbulence are modelled. Isotropic turbulence serves as the basis of comparison for the anisotropic turbulence which exists in wind shear. The question of turbulence scales in wind shear is addressed from the perspective of power spectral density.

Trevino, G.↗
NASA NTRS1989

Coherent structures in transitional and turbulent free shear flows

The development of a quantitative understanding of large-scale coherent structures in shear flows has led to the recognition of their evolutionary features and 'rules' of nonlinear interaction among each other. These determinations, in conjunction with the study of fine-grained turbulence and mean motion, constitute a general view of hydrodynamical instabilities that has resulted in useful concepts for the achievement of shear-flow control. The dynamical role of longitudinal structures in free shear flows is presently exemplified by the axisymmetric and helical modes in a round jet, which resemble the two-dimensional and spanwise-periodic three-dimensional modes in a two-dimensional mean flow.

Liu, J. T. C.↗
NASA NTRS1989

Sheared wing-tip aerodynamics - Wind-tunnel and computational investigation

Computational and experimental performance benefits are presented for a high-aspect-ratio unswept wing configuration with sheared tips. The sheared tip is a highly swept and highly tapered surface located in the same plane as the inboard wing panel to which it is attached. The compuational results were obtained with an inviscid surface panel method that models the nonlinear influence of the trailing wake. Both wind-tunnel and calculated results were obtained for a 12-ft span wing model with various wing-tip configurations. The computational and experimental data are in fair agreement and demonstrate that sheared wing tips can reduce induced drag at cruise and climb lift coefficients. The drag reduction is the result of wake deformation effects and changes in spanwise load distribution. Wind-tunnel measured longitudinal and lateral directional stability characteristics are also presented for the various wing-tip layouts.

Vijgen, P. M. H. W.↗