Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “LONGITUDINAL STABILITY”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 469 records · Page 26
All sourcesNASA NTRSDOE OSTI
NASA NTRS1957

Static Longitudinal and Lateral Stability Characteristics at Low Speed of 45 Degree Sweptback-midwing Models Having Wings with an Aspect Ratio of 2, 4, or 6

Results are presented of tests conducted in the Langley stability tunnel to determine the effects of various components and combinations of components on the static longitudinal and lateral stability characteristics at low speed of a series of 45 degree sweptback-midwing-airplane configurations having wings with an aspect ratio of 2, 4, or 6. The tests were made at a dynamic pressure of 24.9 pounds per square foot which corresponds to a Mach number of 0.13 and Reynolds numbers of 1.00 x 10(exp 6), 0.71 x 10 (exp 6), and 0.58 x 10 (exp 6) based on the respective wing mean aerodynamic chords. The angle-of-attack range covered was from -4 degrees to 32 degrees and the sideslip angles used for the lateral-derivative tests were 5 degrees and -5 degrees. An increasing loss in tail contribution to directional stability both with increasing wing aspect ratio and increasing angle of attack was found to be a principal cause of all the complete models becoming directionally unstable in the high angle-of-attack range.

STABILITY, LONGITUDINAL - STATIC↗
NASA NTRS1977

Utilization of separate surface control systems on general aviation aircraft

The application of separate surface control systems to general aviation aircraft is discussed. Block diagrams of a conventional control system with autopilot tie-in and of a separate surface control system are presented, and the advantages and disadvantages of the two systems are compared. Theoretical descriptions of pilot-in-the-loop operation and operation in the autopilot mode are presented. The application of separate surface stability augmentation in yaw dampers, wing levelers, and static longitudinal stability augmentation is examined. The state-of-the-art of separate control surface technology is summarized.

Roskam, J.↗
NASA NTRS1977

Effects of external stores on the air combat capability of a delta wing fighter

Delta wing point-design fighters with two pylon mounted missiles and aft tail controls (similar to several Soviet designs) have been investigated for a Mach number range from about 0.6 to 2.0. Whereas minimum drag penalties that are expected with the addition of external stores do occur, the effects at higher lifts, corresponding to maneuvering flight, are less severe and often favorable. The drag-due-to-lift factor is less with stores on although the lift curve slope is unaffected. The longitudinal stability level is reduced by the addition of stores while the pitch control effectiveness is unchanged. The directional stability was generally reduced at subsonic speeds and increased at supersonic speeds by the addition of stores but sufficiently high stability levels are obtainable that are compatible with the longitudinal maneuvering limits. Some examples of the potential maneuvering capability in terms of normal acceleration and turn radius are included.

Spearman, M. L.↗
NASA NTRS1933

Pressure Distribution Tests on a Series of Clark Y Biplane Cellules with Special Reference to Stability

The pressure distribution data discussed in this report represents the results of part of an investigation conducted on the factors affecting the aerodynamic safety of airplanes. The present tests were made on semispan, circular-tipped Clark Y airfoil models mounted in the conventional manner on a separation plane. Pressure readings were made simultaneously at all test orifices at each of 20 angles of attack between -8 degrees and +90 degrees. The results of the tests on each wing arrangement are compared on the bases of maximum normal force coefficient, lateral stability at a low rate of roll, and relative longitudinal stability. Tabular data are also presented giving the center of pressure location of each wing.

Noyes, Richard W↗
NASA NTRS1945

An Experimental Investigation of the Effect of Propellers Used as Aerodynamic Brakes on Stability and Control

Tests were made of a model representative of a single-engine tractor-type airplane for the purpose of determining the stability and control effects of a propeller used as an aerodynamic brake. The tests were made with single-and dual-rotation propellers to show the effect of type of propeller rotation, and with positive thrust to provide basic data with which to compare the effects of negative thrust. Four configurations of the model were used to give the effects of tilting the propeller thrust axis down 5 deg., raising the horizontal tail, and combining both tilt and raised tail. Results of the tests are reported herein. The effects of negative thrust were found to be significant. The longitudinal stability was increased because of the loss of wing lift and increase of the angle of attack of the tail. Directional stability and both longitudinal and directional control were decreased because of the reduced velocity at the tail. These effects are moderate for moderate braking but become pronounced with full-power braking, particularly at high values of lift coefficient. The effects of model configuration changes were small when compared with the over-all effects of negative-thrust operation; however, improved stability and control characteristics were exhibited by the model with the tilted thrust axis. Raising the horizontal tail improved the longitudinal characteristics, but was detrimental to directional characteristics. The use of dual-rotation propeller reduced the directional trim charges resulting from the braking operation. A prototype airplane was assumed and handling qualities were computed and analyzed for normal (positive thrust) and braking operation with full and partial power. The results of these analyses are presented for the longitudinal characteristics in steady and accelerated flight, and for the directional characteristics in high- and low-speed flight. It was found that by limiting the power output of the engine (assuming the constant-speed propeller will function in the range of blade angles required for negative thrust) the stability and control characteristics may be held within the limits required for safe operation. Braking with full power, particularly at low speeds, is dangerous, but braking with very small power output is satisfactory from the standpoint of control. The amount of braking produced with zero power output is equal to or better than that produced by conventional spoiler-type brakes.

AIRPLANES, MILITARY↗
NASA NTRS1921

A Mechanical Device for Illustrating Airplane Stability

An instrument is described which will illustrate completely in a qualitative sense the longitudinal stability characteristics of an airplane. The instrument is primarily of use for the lecture room, but it is hoped that ultimately it will be possible to obtain quantitative results from it.

Norton, F H↗
NASA NTRS1959

Dynamic Longitudinal and Directional Stability Derivatives for a 45 deg. Sweptback-Wing Airplane Model at Transonic Speeds

An investigation was made at transonic speeds to determine some of the dynamic stability derivatives of a 45 deg. sweptback-wing airplane model. The model was sting mounted and was rigidly forced to perform a single-degree-of-freedom angular oscillation in pitch or yaw of +/- 2 deg. The investigation was made for angles of attack alpha, from -4 deg. to 14 deg. throughout most of the transonic speed range for values of reduced-frequency parameter from 0.015 to 0.040 based on wing mean aerodynamic chord and from 0.04 to 0.14 based on wing span. The results show that reduced frequency had only a small effect on the damping-in-pitch derivative and the oscillatory longitudinal stability derivative for all Mach numbers M and angles of attack with the exception of the values of damping coefficient near M = 1.03 and alpha = 8 deg. to 14 deg. In this region, the damping coefficient changed rapidly with reduced frequency and negative values of damping coefficient were measured at low values of reduced frequency. This abrupt variation of pitch damping with reduced frequency was a characteristic of the complete model or wing-body-vertical-tail combination. The damping-in-pitch derivative varied considerably with alpha and M for the horizontal-tail-on and horizontal-tail-off configurations, and the damping was relatively high at angles of attack corresponding to the onset of pitch-up for both configurations. The damping-in-yaw derivative was generally independent of reduced frequency and M at alpha = -4 deg. to 4 deg. At alpha = 8 deg. to 14 deg., the damping derivative increased with an increase in reduced frequency and alpha for the configurations having the wing, whereas the damping derivative was either independent of or decreased with increase in reduced frequency for the configuration without the wing. The oscillatory directional stability derivative for all configurations generally decreased with an increase in the reduced-frequency parameter, and, in some instances, unstable values were measured for the model configuration with the horizontal tail removed.

Bielat, Ralph P.↗
NASA NTRS1978

An aerodynamic analysis of several hypersonic research airplane concepts from M = 0.2 to 6.0

Several conceptual hypersonic research airplanes, designed within the constraints of a B-52 launch aircraft, have been studied experimentally and analytically at Mach numbers from 0.2 to 6.0. Vehicles built to these criteria for Mach 6 cruise were shown to be feasible, if careful attention was paid to the low speed lift, drag, and high angle of attack stability to assure successful landings and transonic pitch angle maneuvers. The integrated scramjet engine drag was high at subsonic speeds and appears to be constant with Reynolds number. The variable geometry airfoil used previously to improve directional stability was shown to be equally adaptable to the improvement of longitudinal stability. The vortex lattice theory gave good subsonic predictions of lift, drag due to lift, and pitching moments. Wind tunnel tests must be relied on for the drag at zero lift, trim, static margins and lateral-directional stability. The Gentry Hypersonic Arbitrary Body Program gave good predictions of the trends of lift, drag, and pitching moments with angle of attack at Mach numbers above 3, but the level of the values were not consistently predicted. No currently available theory or program gave accurate predictions of directional stability or dihedral effects at hypersonic speeds.

Penland, J. A.↗
NASA NTRS1949

Preliminary Results of a Free-Flight Investigation of the Static Stability and Aileron Control Characteristics of 1/6 Scale Models of the Bell MX-776

An investigation of the static longitudinal stability, static directional stability, and aileron control characteristics at transonic and supersonic speeds is being made of 1/6 scale rocket-propelled model of the Bell MX-776. A stability investigation has been made of two symmetrical models with controls undeflected and centers of gravity one-half and one-body diameter, respectively, ahead of the equivalent design center-of-gravity location of the full-scale version. Both models developed large normal-force coefficients in both the subsonic and supersonic ranges which indicated longitudinal instability at low angles of attack. The side-force coefficients were small for both models and indicated that the models were directionally stable. A possible tendency toward dynamic directional instability in the transonic region was indicated by short-period oscillations of the side forces. The results showed a partial-span inboard aileron to be ineffective or to cause negative control in the the transonic region when deflected approximately 5 deg but not when deflected 10 deg. An investigation of drag showed it to increase with a rearward movement of the center of gravity. This indicates an increase in the trim angle of attack as could be caused by a decrease in static stability.

Michal, David H.↗
DOE OSTI2024

LINAC Longitudinal Simulation and Measurement of Output Energy

The Linac at Fermilab, one of the oldest accelerators on-site, plays a crucial role in delivering 400 MeV proton beams to other accelerating facilities. The beam traveling through Linac needs to be carefully monitored for better accelerator operation. One of the key factors of efficient Linac operation is its longitudinal stability. The stability can minimize Linac loss and maximize beam current. For this purpose, I examined the beam's longitudinal profile, which is crucial for proper beam transfer between its two sections. After careful monitoring of the beam through Linac, we need to ensure that it leaves with desired parameters. The beam coming out from the Linac is subsequently injected into the Booster, a synchrotron that relies on dipole magnets to bend the beam at injection. If the output energy of the beam deviates from the expected value, the beam will bend at an incorrect radius, leading to potential beam loss. Therefore, precise regulation of the output energy is critical for the efficient operation of the accelerator. To address this, I have conducted a thorough examination of the Linac longitudinal simulations and data from Beam Position Monitors (BPMs). My objective is to measure and stabilize the output energy and verify its correspondence with the predicted simulation results. All these analyses are important for efficient operation of the accelerator.

Safaryan, Milena↗
NASA NTRS1979

Stability and control characteristics of a monoplanar elliptic missile model at Mach numbers from 1.60 to 2.86

An investigation was conducted of a monoplanar maneuverable missile concept having a nose forebody with a circular cross section and a centerbody and afterbody with elliptical cross sections. The tests involved several component changes and were conducted in the low Mach number test section of the Langley Unitary Plan wind tunnel at Mach numbers of 1.60, 2.16, and 2.86, at angles of attack ranging from -4 degs to 28 degs and at sideslip angles ranging from -4 degs to 8 degs. The most significant result was that at the highest Mach number (2.86), the configuration with the infrared nose produced nearly twice the axial force as the same configuration with the radar nose. The cranked wing had a destabilizing effect on the longitudinal stability and had no effect on the lateral-directional stability. The nose strakes had no effect longitudinally and were detrimental to the lateral-directional stability.

Sawyer, W. C.↗
NASA NTRS1983

Integrated Application of Active Controls (IAAC) technology to an advanced subsonic transport project: Test act system description

The engineering and fabrication of the test ACT system, produced in the third program element of the IAAC Project is documented. The system incorporates pitch-augmented stability and wing-load alleviation, plus full authority fly-by-wire control of the elevators. The pitch-augmented stability is designed to have reliability sufficient to allow flight with neutral or negative inherent longitudinal stability.

Source record↗
NASA NTRS1986

An experimental study of a three lifting surface configuration

The aerodynamic ramifications of utilizing three lifting surfaces as opposed to the conventional or canard lifting configurations have been studied on a theoretical basis by previous researchers. This paper presents an experimental investigation of various configuration modifications for an unyawed typical business jet at a Reynolds number of 1.3 million. The three surface has better lift and high-lift drag characteristics than either the canard or tail-aft configurations, but the cruise drag is more. The induced drag at cruise is highest for the canard and lowest for the tail-aft configuration. The pitching moment characteristics are somewhat between those of the canard and tail-aft configurations. A decrease in gap adversely affects the pitching moment characteristics. A smaller stagger leads to better aerodynamic and stability characteristics. A decrease in span of the forward wing gives better cruise drag and longitudinal stability characteristics, but has adverse effects on high-lift drag. A variation in the incidence angles of either or both the forward and aft wings changes the zero-lift moments of the configuration, while marginally affecting overall lift and drag. At cruise, the lift to drag ratio is highest for the conventional and lowest for the three surface. For high lift conditions, the order is reversed.

Ostowari, C.↗