Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Transitional flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 451 records · Page 25
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Subcritical transition to turbulence in plane channel flows

A linear three dimensional mechanism for the transition of plane Poiseuille flows to turbulence is presented which provides good agreement with experimental observations. The mechanism is based on the evolution of states within a band of quasi-equilibria which slowly approach the stable upper branch solutions for the evolution of flow energy but which are strongly unstable to infinitesimal three-dimensional disturbances. Numerical simulation has shown that if two-dimensional flow persists long enough for the three-dimensional perturbations to attain finite amplitude, the resulting three dimensional flow quickly develops a turbulent character with nonperiodic behavior, and thus transition can be predicted from knowledge of the initial two- and three-dimensional energies and time scales. The mechanism predicts transition to turbulence at Reynolds numbers greater than 1000, as observed in experiments, and implies higher threshold three-dimensional energies in plane Couette flow.

Orszag, S. A.↗
NASA NTRSDate not supplied

Laminar-Turbulent Transition in High Mach-Number Flows

Accurate prediction of laminar-turbulent transition is critical for the design and characterization of high-speed flight systems. Presently, laminar-turbulent transition prediction in computational fluid dynamics (CFD) is accomplished using PDE-based models coupled to the governing equations of the flow system. Current industrial models suffer significant performance issues when analyzing high-speed systems because they were developed for lower speed flows. Current research focuses on multiple solutions to this problem. The coupling of physics-based stability analysis tools which produce quality transition predictions for high-speed flows to NASA’s OVERFLOW CFD solver is being pursued, as well as the implementation and improvement of emerging models developed specifically for high-speed flow.

High-Speed Flow↗
NASA NTRS1990

Numerical simulation of transition in a rotating disk flow

An investigation of the laminar-turbulence transition process in a three-dimensional boundary layer on a rotating disk is initiated. Preliminary results from a direct numerical simulation using spectral collocation method are presented. The simulation results in the linear regime is tested against linear stability theory. Saturation of the primary disturbance energy suggests the importance of modal interaction in initiating transition.

Balachandar, S.↗
NASA NTRS1988

Navier-Stokes calculations of transonic flows past open and transitional cavities

Computational simulations of deep and transitional cavities at transonic regimes were performed. The three-dimensional unsteady separation on the cavity floor was analyzed, and computational flow visualization inside the cavity was done. A parametric study was performed to investigate the effects of varying Mach number and the ratio delta/D, where delta is the instantaneous boundary layer thickness at the upstream lip and D is the depth. Both time-averaged and instantaneous solutions were obtained. Comparison of the solutions with experimental data were generally favorable; some discrepancies are explained.

Srinivasan, S.↗
NASA NTRS2004

Transitional Bubble in Periodic Flow Phase Shift

One particular characteristic observed in unsteady shear layers is the phase shift relative to the main flow. In attached boundary layers this will have an effect both on the instantaneous skin friction and heat transfer. In separation bubbles the contribution to the drag is dominated by the pressure distribution. However, the most significant effect appears to be the phase shift on the transition process. Unsteady transition behaviour may determine the bursting of the bubble resulting in an un-recoverable full separation. An early analysis of the phase shift was performed by Stokes for the incompressible boundary layer of an oscillating wall and an oscillating main flow. An amplitude overshoot within the shear layer as well as a phase shift were observed that can be attributed to the relatively slow diffusion of viscous stresses compared to the fast change of pressure. Experiments in a low speed facility with the boundary layer of a flat plate were evaluated in respect to phase shift. A pressure distribution similar to that on the suction surface of a turbomachinery aerofoil was superimposed generating a typical transitional separation bubble. A periodically unsteady main flow in the suction type wind tunnel was introduced via a rotating flap downstream of the test section. The experiments covered a range of the three similarity parameters of momentum-loss-thickness Reynolds-number of 92 to 226 and Strouhal-number (reduced frequency) of 0.0001 to 0.0004 at the separation point, and an amplitude range up to 19 %. The free stream turbulence level was less than 1% .Upstream of the separation point the phase shift in the laminar boundary layer does not appear to be affected significantly bay either of the three parameters. The trend perpendicular to the wall is similar to the Stokes analysis. The problem scales well with the wave velocity introduced by Stokes, however, the lag of the main flow near the wall is less than indicated analytically. The separation point comes closest to the Stokes analysis but the phase is still 20 degrees lower at the wall.

Talan, M.↗
NASA NTRS1989

Three-dimensional flow simulation about the AFE vehicle in the transitional regime

The direct-simulation Monte Carlo technique is used to analyze the hypersonic rarefied flow about the three-dimensional NASA Aeroassist Flight Experiment vehicle. Results are given for typical transitional flows encountered during the vehicle's atmospheric entry from altitudes of 200-100 km with an entry velocity of 9.9 km/s. It is found that dissociation is important at altitudes of 110 km and below, and that transitional effects are significant even at an altitude of 200 km.

Celenligil, M. Cevdet↗
NASA NTRS1994

Modeling the transition region

The calculation of engineering flows undergoing laminar-turbulent transition presents special problems. Mean-flow quantities obey neither the fully laminar nor the fully turbulent correlations. In addition, local maxima in skin friction, wall temperature, and heat transfer often occur near the end of the transition region. Traditionally, modeling this region has been important for the design of turbine blades, where the transition region is long in relation to the chord length of the blade. More recently, the need for better transition-region models has been recognized by designers of hypersonic vehicles where the high Mach number, the low Reynolds number, and the low-disturbance flight environment emphasize the importance of the transition region. Needless to say, a model that might work well for the transitional flows typically found in gas turbines will not necessarily work well for the external surface of a hypersonic vehicle. In Section 2 of this report, some of the important flow features that control the transition region will be discussed. In Section 3, different approaches to the modeling problem will be summarized and cataloged. Fully turbulent flow models will be discussed in detail in Section 4; models specifically designed for transitional flow, in Section 5; and the evaluation of models, in Section 6.

Singer, Bart A.↗
NASA NTRS1983

Effects of flow separation and cove leakage on pressure and heat-transfer distributions along a wing-cove-elevon configuration at Mach 6.9

External and internal pressure and cold-wall heating-rate distributions were obtained in hypersonic flow on a full-scale heat-sink representation of the space shuttle orbiter wing-elevon-cove configuration in an effort to define effects of flow separation on cove aerothermal environment as a function of cove seal leak area, ramp angle, and free-stream unit Reynolds number. Average free-stream Mach number from all tests was 6.9; average total temperature from all tests was 3360 R; free-stream dynamic pressure ranged from about 2 to 9 psi; and wing angle of attack was 5 deg (flow compression). For transitional and turbulent flow separation, increasing cove leakage progressively increased heating rates in the cove. When ingested mass flow was sufficient to force large reductions in extent of separation, increasing cove leakage reduced heating rates in the cove to those for laminar attached flow. Cove heating-rate distributions calculated with a method that assumed laminar developing channel flow agreed with experimentally obtained distributions within root-mean-square differences that varied between 11 and 36 percent where cove walls were parallel for leak areas of 50 and 100 percent.

Deveikis, W. D.↗
NASA NTRS1990

Transition delay and relaminarization of turbulent flow

Several techniques used for delaying transition both in air and water are overviewed, among them uniform surface heating, localized surface heating, and the application of broad-band disturbance-wave cancellation using the wave superposition principle. It is pointed out that localized heating, in air, can effectively delay transition along a flat plate and reduce viscous drag. Attention is focused on an experiment where the feasibility of relaminarizing turbulent flow over a flat plate with an upstream concave-convex curvature, in air, has been demonstrated using localized heating on the concave part of the curved surface. The flow over the curved surface investigated by thermal mapping using an infrared technique is also covered.

Maestrello, Lucio↗
NASA NTRS1995

Two-phase flow in helical and spiral coils

Coiled tube heat exchangers involving two-phase flows are used in a variety of application areas, extending from the aerospace industry to petrochemical, refrigeration land power generation industries. The optimal design in each situation requires a fundamental understanding of the heat, mass and momentum transfer characteristic of the flowing two-phase mixture. However, two-phase flows in lengths of horizontal or vertical straight channels with heat transfer are often quite difficult in themselves to understand sufficiently well to permit accurate system designs. The present study has the following general objectives: (1) Observe two-phase flow patterns of air-water and R-113 working fluids over a range of flow conditions, for helical and spiral coil geometries, of circular and rectangular cross-section; (2) Compare observed flow patterns with predictions of existing flow maps; (3) Study criteria for flow regime transitions for possible modifications of existing flow pattern maps; and (4) Measure associated pressure drops across the coiled test sections over the rage of flow conditions specified.

Keshock, Edward G.↗
NASA NTRS2020

Gas-Liquid Flows Through Porous Media in Microgravity: The International Space Station Packed Bed Reactor Experiment

Experimental results on pressure drop and flow patterns for gas-liquid flow through packed beds obtained in the International Space Station with two types of packing are presented and analyzed. It is found that the pressure drop depends on the packing wettability in the viscous-capillary (V-C) regime and this dependence is compared with previously published results developed using short duration low-gravity aircraft tests. Within the V-C regime, the capillary contribution is the dominant force contributing to the pressure drop for the wetting case (glass) versus the viscous contribution dominating for the non-wetting case (Teflon). Outside of the V-C regime, it is also found that hysteresis effects that are often strong in normal gravity gas-liquid flows are greatly diminished in microgravity and pressure drop is nearly independent of packing wettability. A flow pattern transition map from bubble to pulse flow is also compared with the earlier aircraft data.

Viscous-capiliary regime↗
NASA NTRSDate not supplied

Flow Boiling and Condensation Experiment (FBCE): Summary of Findings for Flow Boiling based on Completed ISS Experiments

Since 2011, researchers from Purdue University and NASA Glenn Research Center (GRC) have been collaborating to investigate the effects of gravity on several aspects of flow boiling and flow condensation. This massive research endeavor, termed the Flow Boiling and Condensation Experiment (FBCE), has culminated in development of NASA’s largest and most complex facility for investigation of two-phase fluid physics onboard the ISS. FBCE consists of two separate studies: flow boiling, using the Flow Boiling Module (FBM), and flow condensation, using the Condensation Module for Heat Transfer Measurements (CM-HT); this presentation concerns the FBM portion of FBCE. Fitted with FBM, FBCE was launched to the ISS in August 2021 and experiments were successfully performed starting in February 2022 to amass a large microgravity-flow-boiling database supported by extensive visualization of interfacial behavior using high-speed video. Based on FBCE experiments performed previously in Earth gravity and parabolic flight, along with the new ISS data, several empirical correlations, theoretical models, and CFD models have been developed, enabling the prediction of crucial flow boiling parameters, including heat transfer coefficient and critical heat flux (CHF). These predictive tools, which will be summarized in this presentation, are expected to serve as foundation for design of future space systems involving flow boiling.

Two-phase flow and phase transition↗
NASA NTRS1989

Generation of circumferential velocity contours associated with pulsed point suction on a rotating disk

Numerous experimental studies were conducted on the steady, three-dimensional boundary layer over a disk rotating at constant angular speed in an otherwise undisturbed fluid. The subject flow geometry is of interest because it provides a relatively simple way to study the cross-flow instability phenomenon which occurs in three-dimensional boundary layers, as on swept wings. This flow instability results in the formation of a stationary spiral vortex flow field over the disk, as shown by Wilkinson and Malik. Using a hot-wire probe, the spatial wave pattern of stationary vortices, which filled the entire circumference of the disk was mapped. The subject flow instability caused transition-to-turbulent flow as the periphery of the disk was approached. The effect on receptivity and transition of discrete disturbance modes, such as three-dimensional toughness elements and acoustic excitation was investigated. The present study (an extension of the work of Wilkinson and Malik) is focused on the effect of pulsed point suction on flow instability and transition, and consequently, on the classical stationary vortical flow pattern.

Selby, Gregory V.↗
NASA NTRS1989

Transition to turbulence in laminar hypersonic flow

Progress in a recently started project aimed at the prediction of transition to turbulence in hypersonic flow is briefly discussed. The prediction of transition to turbulence is a very important issue in the design of space vessels. Two space vehicles currently under investigation, namely the aeroassisted transfer vehicle (AOTV) and the trans-atmospheric vehicle (TAV), suffer from strong aerodynamic heating. This heating is strongly influenced by the boundary layer structure. These aerospace vehicles fly in the upper atmospheric layer at a Mach number between 10 and 30 at very low atmospheric pressures. At very high altitudes the flow is laminar, but when the space vessel returns to a lower orbit, the flow becomes turbulent and the heating is dramatically increased. The prediction of this transition process is commonly done by means of experiments. The experimental facilities available nowadays cannot model the hypersonic flow field accurately enough by limitations in Mach and Reynolds number. These facilities also have a large free stream disturbance level which makes it very difficult to investigate transition accurately. An alternative approach is to study transition by theoretical means. Up to now numerical studies of hypersonic flow only discussed steady laminar or turbulent flow. This theoretical approach is extended to the study of transition in hypersonic flow by means of direct numerical simulations and additional theoretical investigations to explain the mechanisms leading to transition. A brief outline of how this research is to be performed is given.

Vandervegt, Jaap↗